• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.24 no.2
• /
• pp.167-175
• /
• 2011

The purpose of this study is to examine the impact that change in speed and modeling methods has on maglevs' runnability. The study constructed equations of motion on 4-DOF, 6DOF, and 10-DOF vehicles respectively and carried out numerical analysis, applying 4th Runge Kutta method, in order to run six different model maglev as changing the vehicles speed on the same bridge that had 2000 to 1 deflection. The analysis revealed that maglev's runnability improved as speed was lower and the specific model had higher number of bogey and EMS.

• Journal of Magnetics
• /
• v.16 no.2
• /
• pp.108-113
• /
• 2011

The electron spin resonance lineshape (ESRLS) function for the electron spin resonance linewidth (ESRLW) of $Cr^{3+}$ (S = 3/2) in ferroelectric lithium niobate single crystals doped with 0.05 wt% of Cr, is obtained by using the projection operator technique (POT), developed by Argyres and Sigel. The ESRLS function is calculated to be axially symmetric about the c - axis and analyzed by using the spin Hamiltonian $H_{SP}={\mu}_B(B{\cdot}{^\leftrightarrow_{g}}{\cdot}S)+S{\cdot}{^\leftrightarrow_{D}}{\cdot}S$ with the parameters g = 1.972 and D = $0.395\;cm^{-1}$. In the ca plane, the linewidths show a strong angular dependence, whereas in the ab plane, they are independent of the angle. This result implies that the resonance center has an axial symmetry along the c - axis. Further, from the temperature dependence of the linewidths that is shown, it can be seen that the linewidths increase as the temperature increases, at a frequency of v = 9.27GHz. This result implies that the scattering effect increases with increasing temperature. Thus, the POT is considered to be more convenient to explain the scattering mechanism as in the case of other optical resonant systems.

• Journal of the Society of Disaster Information
• /
• v.7 no.3
• /
• pp.229-239
• /
• 2011

The private investigator service in Korea is to protect our legal market from personal right, creation of job, legal opening via OECD and FTA as well as the prevention of negative private investigation such as service center and private investigator operated without any control. Therefore, this study compares the civil research systems of advanced countries, reviews the legal process to introduce private investigator service as well as considers the previous studies to suggest the work sectors of private investigator service appropriate to Korea. As a result, it distinguished the private investigation work into corporate, finance, insurance, medical service, Cyber, traffic accidents, intellectual property right, lost and forensic science.

• Journal of Institute of Control, Robotics and Systems
• /
• v.7 no.3
• /
• pp.246-254
• /
• 2001

In this paper, we described an approach to the automation of visual inspection of BGA solder joint defects of surface mounted components on printed circuit board by using neural network. Inherently, the BGA solder joints are located underneath its own package body, and this induces a difficulty of taking good image of the solder joints by using conventional imaging systems. To acquire the cross-sectional image of BGA sol-der joint, X-ray cross-sectional imaging method such as laminography and digital tomosynthesis has been cur-rently utilized. However, the cross-sectional image obtained by using laminography or DT methods, has inher-ent blurring effect and artifact. This problem has been a major obstacle to extract suitable features for classifi-cation. To solve this problem, a neural network based classification method is proposed int his paper. The per-formance of the proposed approach is tested on numerous samples of printed circuit boards and compared with that of human inspector. Experimental results reveal that the method provides satisfactory perform-ance and practical usefulness in BGA solder joint inspection.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2009.10a
• /
• pp.899-901
• /
• 2009

The magnesium fluoride ($MgF_2$) has very higher optical transmission than oxide or nitride material applied for gas barrier, so we manufactured Mg-Zn-F films with Mg-Zn-F target mixed in the various ratio of $MgF_2$ to Zn and characterized films' properties. Zn is used to increase packing density of barrier film. Thickness and optical transmission of Mg-Zn-F are 200 nm and over 90 %, respectively. The result of water vapor transmission rate at 38, RH 90 ~ 100% of the Mg-Zn-F film deposited with 4 : 6 ($MgF_2$ : Zn) ratio target reached below $1{\times}10^{-3}g$/($m^2{\cdot}day$), measuring limit of instrument.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2009.10a
• /
• pp.794-797
• /
• 2009

We manufactured a novel gas permeation thin film passivation by using inorganic Mg-Zn-F target which has better optical characteristics and high electronegativity. We fabricated targets in various composition ratio and formed about 200nm which is limited thickness of the flexible display. Applied to PLED device, the target which composed of $MgF_2$ and Zn at the ratio of 4:6, WVTR was reached the measurement limit of the equipment, $10^{-3}g/m^2{\cdot}day$ and the life time was increased 25 times better than PLED device which is non-passivation.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.10A
• /
• pp.1159-1166
• /
• 2004

This paper follows up the previous work on the linearly constrained, modified minimum mean-squared error(MMSE) detection for direct-sequence code-division multiple-access DS-CDMA) systems in fading channels. We find a condition to avoid the breakdown of joint modified MMSE detection and pilot symbol-aided channel estimation (PSACE). The linearly constrained, modified MMSE solution is theoretically shown to be robust against time variations in Rayleigh fading channels. This fact is consistent with the simulation results. We also show that under some conditions the linearly constrained, modified MMSE detection maximizes the output signal-to-interference-plus-noise ratio.(SINR)

• Proceedings of the KIEE Conference
• /
• 2000.07c
• /
• pp.1794-1796
• /
• 2000

Oxides of the form $Mn_{3}O_4$-$Co_{3}O_4$-NiO present properties that make them useful as multilayer chip NTC thermistor for mobile communication telephone. When $Mn_{2}Ni_{x}CO_{1-x}O_4$ composition with the X = 0.12$\sim$0.24 at sintered temperature 1250$^{\circ}C$, resistivity and B-constant were 300$\sim$450[${\Omega}-cm$] and 3250$\sim$3450, respectively. Multilayer chip NTC(Negative Temperature Coefficient) resistor were fabricated with 4 layer by a conventional multilayer capacitor techniques, using 100 pd paste as internal electrode and $Mn_{2}Ni_{0.20}CO_{0.8}O_4$ composition as NTC materials. In particular, resistance change ratio (${\Delta}R$), the important factor for reliability, varied within $\pm$3%, indicating the compositions of multilayer chip NTC thermistor products could be available for mobile communication telephone.

• Journal of the East Asian Society of Dietary Life
• /
• v.16 no.5
• /
• pp.607-614
• /
• 2006

This study was performed to investigate the soldiers' preference for meals provided and their satisfaction with military food service. The average daily calorific intake was 3,976 kcal, representing an extra 467 kcal over the 3,500 kcal state as the minimum daily kcal needed for each soldier based on the manual of the Korea Ministry of Defence. The soldiers preferred Korean food to Western food. The soldiers' overall satisfaction was researched in 7 areas such as quality and hygiene. They were pleased with two facts: holiday food is provided occasionally and the food is served quickly. However, they were dissatisfied with two issues: the poor nutritional information of the food, and the low frequency of special meals. The variety of choice needs to be improved and the cooks need to be better trained. When providers plan the food time table, a sensational menu needs to be considered to satisfy the soldiers' taste. To improve the quality of military meal food, new systems aye necessary such as food schedule, nutritional goal and different systems with independent food providing for the company's involvement.

• Journal of Information Display
• /
• v.4 no.2
• /
• pp.35-42
• /
• 2003

The field emission and luminescent properties of carbon nanotubes (CNTs) that were straightened by argon ion irradiation were investigated. Argon ion irradiation permanently straightened both as-grown and screen-printed CNTs (SP-CNTs) in the presence of a strong electric field. The straightening process enhanced the emission properties of as-grown CNT films by showing a decrease in turn-on field, an increase in total emission current, and a stable emission. Recurring problems associated with SP-CNTs, such as bent or/and buried CNTs and the degradation in binder-residue-induced emission, were improved by the permanent straightening of CNTs and protruding CNTs from binders by the irradiation treatment, in addition to its surface cleaning effect. Furthermore, we confirmed that the number of emission sites increases by observing the luminescent properties of CNT films after the straightening. These findings here suggest that ion irradiation treatment is an effective method for achieving uniform field emission and to reduce the electrical aging time.