• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.29A no.2
• /
• pp.63-67
• /
• 1992

Shallow $p^{+}-n,n^{+}-p$ diodes have been fabricated using rapid thermal diffusion by solid diffusion source and rapid thermal alloying with pure Aluminum. Diode area and junction depth are designed about 2.83$[\times}10^{-3}cm^{2}$ and 250nm, respectively. Electrical characteristics of $p^{+}-n$ diode show that the ideality factor is 1.04 and reverse current density is 29.3nA/$cm^{2}$, respectively. On the other hand, those of $n^{+}-p$ diode show that the ideality factor is 1.05 and reverse current density is 85.2pA/$cm^{2}$. The reverse currents are measured at 5V reverse bias after rapid thermal alloying for all the measurement.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.10 no.1
• /
• pp.7-13
• /
• 2010

We have investigated effects of the rapid thermal annealing of GaN epilayers by molecular beam epitaxy in nitrogen atmosphere. The improvement of structural properties of the samples was observed after rapid thermal annealing under optimum conditions. This improvement in crystal quality is due to a reduction of the spread in the lattice parameter in epilayers. The annealing has been performed in a rapid thermal annealing furnace at $950^{\circ}C$. The effect of rapid thermal annealing on the structural properties of GaN was studied by x-ray diffraction. The Bragg peak shifts toward larger angle as the annealing time increases. As the thermal treatment time increases, FWHM(full width at half maximum) of the peak slightly increase with its decreases followed and it increases again. Results demonstrate that rapid thermal annealing did not always promote qualities of GaN epilayers. However, rapid thermal annealing under optimum conditions improve structural properties of the samples, elevating their crystal quality with a reduction of inaccuracy in the lattice parameter of the epilayers.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.26 no.1
• /
• pp.18-21
• /
• 2013

$SiO_2$ layer grown by rapid thermal oxidation and $SiN_x$ layer were used for passivating the surface of n-type silicon solar cell, instead of only $SiN_x$ layer generally used in photovoltaic industry. The rapid thermal oxidation provides the reduction of processing time and avoids bulk life time degradation during the processing. Improvement of 30 mV in Voc and $2.7mA/cm^2$ in Jsc was obtained by applying these two layers. This improvement led to fabrication of a large area ($239cm^2$) n-type solar cell with 17.34% efficiency. Internal quantum efficiency measurement indicates that the improvement comes from the front side passivation, but not the rear side, by using $SiO_2/SiN_x$ stack.

• Journal of the Korean Society of Safety
• /
• v.34 no.4
• /
• pp.111-118
• /
• 2019

Accidents occurring due to natural disasters in chemical process facilities where technologies are concentrated can cause secondary damage. The concept of the relationship between natural disasters and highly intensive technologies has evolved into the Natech (Natural Hazards Triggered Technological Disaster) research. Currently, the number of earthquakes is increasing all over the Korean peninsula. To assess the risk of Natech when an earthquake has occurred in South Korea, the Rapid Natech Risk Assessment Tool (RAPID-N) developed by the European Commission's Joint Research Center (EC JRC) was used in the present study. The RAPID-N can be used for Natech risk assessment based on mapping and can be utilized for sufficient preparation for reduction of the effects of Natech accidents. A total of 261 chemical facilities actually existing in Pohang were initially analyzed to select eight facilities and the Pohang earthquake that occurred in 2017 was implemented in the RAPID-N utilizing the shake map. High risk areas were selected through Natech risk assessments for the selected eight work places and countermeasures for the areas were suggested. High risk areas exist depending on the location, since the damage influence ranges could be overlapped and each chemical facility has an independent probability of Natech. Therefore, studies on Natech emergency plans and emergency evacuation routes should be actively conducted considering such high risk areas. The present study was conducted to demonstrate the feasibility of Natech risk assessment in South Korea through the RAPID-N. These findings can be used as a reference material to lay a foundation for Natech risk assessment and related policies in South Korea.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.8 no.6
• /
• pp.105-110
• /
• 2008

We have investigated the high temperature rapid thermal annealing of GaN epilayers in nitrogen atmosphere. Annealing has been performed in a rapid thermal annealing furnace at $950^{\circ}C$. The effect of rapid thermal annealing of GaN was studied by x-ray diffraction. The Bragg peak shifts toward larger angle as the annealing time increases. The full width at half maximum (FWHM) of the peak slightly increase, followed by decreases, and increases again as the thermal treatment time increases. The improvement of structural properties of the samples was observed after rapid thermal annealing under optimum conditions. This improvement in crystal quality is due to a reduction of the spread in the lattice parameter in epilayers.

• 한국연소학회:학술대회논문집
• /
• 2013.06a
• /
• pp.25-28
• /
• 2013

This study presents both experimental and numerical investigation of ignition characteristics of n-heptane and n-butanol mixture. The $O_2$ concentration was fixed to 9-10% to make high exhaust gas recirculation(EGR) rate condition. Experiments were performed using a rapid compression machine. In addition, a numerical study of the ignition delay time was performed using CHEMKIN codes to validate experimental results and predict chemical species after combustion process. The results showed that the ignition delay time increased with increasing n-butanol ratio and the reactivity decreased by low $O_2$ concentration.

• Macromolecular Research
• /
• v.12 no.3
• /
• pp.258-262
• /
• 2004

We have developed facile and rapid polycondensation reactions of N-trimellitylimido-L-leucine diacid chloride 1 with eight different derivatives of hydantoin compounds 2a-h, in the presence of a small amount of a polar organic medium, such as Ο-cresol, by using a domestic microwave oven. The polycondensation reactions proceeded rapidly-they were complete within 7-9 min-to produce a series of novel optically active poly(amide-imide)s (3a-h) in high yield with inherent viscosities of 0.33-0.51 dL/g. We characterized the resulting poly(amide-imide)s by elemental analysis, thermal gravimetric analysis (DSC, TGA, and DTG), and FTIR spectroscopy, and by measuring their viscosities, specific rotations, and solubilities. All of the polymers were soluble at room temperature in polar solvents such as N ,N-dimethylacetamide, N,N-dimethylformamide, dimethylsulfoxide, tetrahydrofuran, and N-methyl-2-pyrrolidone.

• Journal of Veterinary Science
• /
• v.22 no.3
• /
• pp.40.1-40.12
• /
• 2021

Background: The microsporidian parasite Nosema ceranae is a global problem in honeybee populations and is known to cause winter mortality. A sensitive and rapid tool for stable quantitative detection is necessary to establish further research related to the diagnosis, prevention, and treatment of this pathogen. Objectives: The present study aimed to develop a quantitative method that incorporates ultra-rapid real-time quantitative polymerase chain reaction (UR-qPCR) for the rapid enumeration of N. ceranae in infected bees. Methods: A procedure for UR-qPCR detection of N. ceranae was developed, and the advantages of molecular detection were evaluated in comparison with microscopic enumeration. Results: UR-qPCR was more sensitive than microscopic enumeration for detecting two copies of N. ceranae DNA and 24 spores per bee. Meanwhile, the limit of detection by microscopy was 2.40 × 10⁴ spores/bee, and the stable detection level was ≥ 2.40 × 10⁵ spores/bee. The results of N. ceranae calculations from the infected honeybees and purified spores by UR-qPCR showed that the DNA copy number was approximately 8-fold higher than the spore count. Additionally, honeybees infected with N. ceranae with 2.74 × 10⁴ copies of N. ceranae DNA were incapable of detection by microscopy. The results of quantitative analysis using UR-qPCR were accomplished within 20 min. Conclusions: UR-qPCR is expected to be the most rapid molecular method for Nosema detection and has been developed for diagnosing nosemosis at low levels of infection.

• Journal of the Korean Ceramic Society
• /
• v.30 no.4
• /
• pp.332-338
• /
• 1993

TiN/Ti is the best buffer layer between PZT thin film and si substrate among the Ti, TiN, ZrN, TiN/Ti, ZrN/Ti. The amorphous PZT films deposited on TiN/Ti buffer layer directly transform into perovskite phase when rapid thermal annealed for 30sec above 55$0^{\circ}C$. As Rapid Thermal Annealing(RTA) temperature increased, the remanent polarization(Pr) and dielectric constant($\varepsilon$r) increased and then showed Pr=21 $\varepsilon$r=593 when rapid thermal annealed 80$0^{\circ}C$ for 30sec. On the contrary the leakage current increased with increasing RTA temperature due to the formation of void made by Pb evaporationand grain cohesion.

• Clinical and Experimental Pediatrics
• /
• v.54 no.10
• /
• pp.405-408
• /
• 2011

Purpose: In autumn 2009, the swine-origin influenza A (H1N1) virus spread throughout South Korea. The aims of this study were to determine the clinical characteristics of children infected by the 2009 H1N1 influenza A virus, and to compare the rapid antigen and realtime polymerase chain reaction (PCR) tests. Methods: We conducted a retrospective review of patients ${\geq}18$ years of age who presented to Soonchunhyang University Hospital in Seoul with respiratory symptoms, including fever, between September 2009 and January 2010. A real-time PCR test was used to definitively diagnose 2009 H1N1 influenza A infection. Medical records of confirmed cases were reviewed for sex, age, and the time of infection. The decision to perform rapid antigen testing was not influenced by clinical conditions, but by individual factors such as economic conditions. Its sensitivity and specificity were evaluated compared to real-time PCR test results. Results: In total, 934 patients tested positive for H1N1 by real-time PCR. The highest number of patients (48.9%) was diagnosed in November. Most patients (48.2%) were aged between 6 and 10 years. Compared with the H1N1 real-time PCR test results, the rapid antigen test showed 22% sensitivity and 83% specificity. Seventy-eight patients were hospitalized for H1N1 influenza A virus infection, and fever was the most common symptom (97.4%). Conclusion: For diagnosis of 2009 H1N1 influenza A virus infection, the rapid antigen test was inferior to the real-time PCR test in both sensitivity and specificity. This outcome suggests that the rapid antigen test is inappropriate for screening.