• Membrane and Water Treatment
• /
• v.14 no.2
• /
• pp.95-106
• /
• 2023

In the developing country like India, groundwater is the main sources for household, irrigation and industrial use. Its contamination poses hydro-geological and environmental concern. The hazardous waste sites such as landfills can lead to contamination of ground water. The contaminants existing at such sites can eventually find ingress down through the soil and into the groundwater in case of leakage. It is necessary to understand the process of migration of pollutants through sub-surface porous medium for avoiding health risks. On this backdrop, the present paper investigates the behavior of pollutants' migration through porous media. The laboratory experiments were carried out on a soil-column model that represents porous media. Two different types of soils (standard sand and red soil) were considered as the media. Further, two different solutes, i.e., non-reactive and reactive, were used. The experimental results are simulated through numerical modeling. The percentage variation in the experimental and numerical results is found to be in the range of 0.75- 11.23 % and 0.84 - 1.26% in case of standard sand and red soil, respectively. While a close agreement is observed in most of the breakthrough curves obtained experimentally and numerically, good agreement is seen in either result in one case.

• Journal of Korean Society of Environmental Engineers
• /
• v.30 no.4
• /
• pp.453-458
• /
• 2008

Laboratory experiments were conducted to investigate disinfection as well as removal of color and residual organics from reclaimed municipal wastewater by electrochemical processes with Nb/Pt anode installed. RNO was rapidly bleached by OH$\cdot$ and the second order rate constants of RNO removal were $\frac{0.223l}{mg{\cdot}min}$, $\frac{1.679l}{mg{\cdot}min}$ and $\frac{2.322l}{mg{\cdot}min}$ with for 5 A, 10 A, and 15 A, respectively, with r$^2$ of > 96%. In batch electrochemical processes, after 15 min at currency of 15 A and initial pH of 5, 7,5 and 9, COD$_{Mn}$ was below 4 mg/L, color unit below 5 degree and general bacteria was not detected, the concentration of which are suitable for drinking water regulation. In the continuous electrochemical process, with HRT of 3.7$\sim$49.2 min, free chlorine were 0.2$\sim$0.7 mg/L, general bacteria was not detected, color unit below 5 degree and THMs was 0.017 mg/L. Therefore, electrochemical process with Nb/Pt anode was employed satisfactory to meet for reusing biologically treated water as well as disinfection.

• Environmental Engineering Research
• /
• v.10 no.5
• /
• pp.213-226
• /
• 2005

To treat wastewater efficiently by a one-step process of nitrogen removal, a new bacterial strain producing $N_2$ gas from ${NH_4}^+$ under an aerobic condition was isolated and identified. The cell was motile and a Gram-negative rod, and usually occurred in pairs. By 16S-rDNA analysis, the isolated strain was identified as Enterobacter asburiae with 96% similarity. The isolate showed that the capacity of $N_2$ production under an oxic condition was approximately three times higher than that under an anoxic condition. Thus, the consumption of ${NH_4}^+$ by the isolate was significantly different in the metabolism of $N_2$ production under the two different environmental conditions. The optimal conditions of the immobilized isolate for $N_2$ production were found to be pH 7.0, $30^{\circ}C$ and C/N ratio 5, respectively. Under all the optimum reaction conditions, $N_2$ production by the immobilized isolate resulted in reduction of ORP with both the consumption of DO and the drop of pH. The removal efficiencies of $COD_{Cr}$, and TN were 56.1 and 60.9%, respectively. The removal rates of $COD_{Cr}$, and TN were the highest for the first 2.5 hrs with the removal $COD_{Cr}/TN$ ratios of 32.1, and afterwards the rates decreased as reaction proceeded. For application of the immobilized isolate to a practical process of ammonium removal, a continuous operation was executed with a synthetic medium of a low C/N ratio. The continuous bioreactor system exhibited a satisfactory performance at 12.1 hrs of HRT, in which the effluent concentrations of ${NH_4}^+$-N was measured to be 15.4 mg/L with its removal efficiency of 56.0%. The maximum removal rate of ${NH_4}^+$-N reached 1.6 mg ${NH_4}^+$-N/L/hr at 12.1 hrs of HRT(with N loading rate of $0.08\;Kg-N/m^3$-carrier/d). As a result, the application of the immobilized isolate appears a viable alternative to the nitrification-denitrification processes.

• 한국생물공학회:학술대회논문집
• /
• 2005.10a
• /
• pp.450-455
• /
• 2005

To treat wastewater efficiently by a one-step process of nitrogen removal, a new strain of $N_2-producing$ bacteria from $NH{_4}{^+}$ under an aerobic condition was isolated and identified. By 16S-rDNA analysis, the isolate was identified as Enterobacter asburiae with 96% similarity. The isolate shows that the capacity of $N_2$ production under an oxic condition was approximately three times higher than that under an anoxic condition. The optimal conditions (pH, temperature and C/N ratio) of the immobilized isolate for $N_2$ production were found to be 7.0, $30^{\circ}C$ and 5, respectively. Under all the optimum reaction conditions, the removal efficiency of $COD_{Cr}$ and TN reached 56.1 and 60.9%, respectively. The removal rates of $COD_{Cr}$ and TN were highest for the first 2.5 hrs (with the removal $COD_{Cr}$ ratios of 32.1), and afterwards the rates decreased as reaction proceeded. For application of the immobilized isolate to a practical process of ammonium removal, a continuous bioreactor system exhibited a satisfactory performance at HRT of 12.1 hr, in which the effluent concentrations of $NH{_4}{^+}-N$ was measured to be 15.4 mg/L with its removal efficiency of 56.0%. The maximum removal rate of $NH{_4}{^+}-N$ reached 1.6 mg $NH{_4}{^+}-N/L/hr$ at HRT of 12.1 hr (with N loading rate of 0.08 $Kg-N/m^3-carrier/d)$. As a result, the application of the immobilized isolate appears a viable alternative to the nitrification-denitrification processes.

• Journal of Communications and Networks
• /
• v.12 no.2
• /
• pp.168-173
• /
• 2010

Error concealment techniques are significant due to the growing interest in imagery transmission over error-prone channels. This paper presents a spatial error concealment technique for losslessly compressed images using least significant bit (LSB)-based data hiding to reconstruct a close approximation after the loss of image blocks during image transmission. Before transmission, block description information (BDI) is generated by applying quantization following discrete wavelet transform. This is then embedded into the LSB plane of the original image itself at the encoder. At the decoder, this BDI is used to conceal blocks that may have been dropped during the transmission. Although the original image is modified slightly by the message embedding process, no perceptible artifacts are introduced and the visual quality is sufficient for analysis and diagnosis. In comparisons with previous methods at various loss rates, the proposed technique is shown to be promising due to its good performance in the case of a loss of isolated and continuous blocks.

• Transactions of Materials Processing
• /
• v.25 no.6
• /
• pp.402-408
• /
• 2016

A manufacturing technology of carbon fiber composites with thermoplastic polymer pellets and continuous woven fiber was investigated using a compression molding process. To secure the impregnation of resin into the porosity of fabric the composite specimens were prepared with general injection-molding grade polypropylene pellets and low viscosity polycarbonate pellets. Tensile tests of polypropylene and polycarbonate composites were performed. Polycarbonate composites showed higher fracture strength than that of polypropylene composites because of the difference of matrix properties. However, the increase rate of strength was lower than that of polypropylene composites due to the difference of coherence between matrix and reinforcement. To investigate the effect of carbon fiber volume fraction on the fracture strength variation polypropylene composites with different volume fraction were compression molded and tensile tests were performed together. It was shown that the fracture strength of the polypropylene composites increased by 3.2, 5.4 and 6.9 times with the increase of carbon fabric volume fraction of 0.256, 0.367, and 0.480, respectively.

• Geomechanics and Engineering
• /
• v.38 no.1
• /
• pp.45-56
• /
• 2024

The weakening effect of water on rocks is one of the main factors inducing deformation and failure in rock engineering. To clarify this weakening effect, immersion tests and post-immersion triaxial compression tests were conducted on sandstone and mudstone. The results showed that the strength of water-immersed sandstone decreases with increasing immersion time, exhibiting an exponential relationship. Similarly, the strength of water-immersed mudstone decreases with increasing environmental humidity, also following an exponential relationship. Subsequently, a statistical damage model for water-weakened rocks was proposed, changes in elastic modulus to describe the weakening effect of water. The model effectively simulated the stress-strain relationships of water-affected sandstone and mudstone under compression. The R² values between the theoretical and experimental peak values ranged from 0.962 to 0.996, and the MAPE values fell between 3.589% and 9.166%, demonstrating the model's effectiveness and reliability. The damage process of water-saturated rocks corresponds to five stages: compaction stage - no damage, elastic stage - minor damage, crack development stage - rapid damage increase, post-peak residual stage - continuous damage increase, and sliding stage - damage completion. This study provides a foundational reference for researching the fracture characteristics of overlying strata during coal mining under complex hydrogeological conditions.

• International Journal of Advanced Culture Technology
• /
• v.12 no.3
• /
• pp.309-316
• /
• 2024

Due to rapid socio-economic development and environmental changes, particularly autism spectrum disorder (ASD) in the context of Attention Deficit Hyperactivity Disorder (ADHD) and high-functioning autism, has become a significant social issue. This issue is increasingly recognized from a societal perspective rather than just an individual or family problem. But there remains a lack of information in frontline education. Traditionally, treatment for ASD has been conducted in specialized institutions, or by professional doctors, therapists, and counselors. There are still several challenges such as 1) accessibility to hospitals and transportation for children with ASD, 2) the maturity and competence of therapists, and 3) the lack of appropriate educational content. To solve these problems, we propose a supplementary 3D educational game process for children with high-functioning autism that utilize speech recognition technology and games designed for continuous and repetitive learning. Our proposed game content can be used at home, which incorporates Speech-To-Text (STT) technology and mini-games to help children indirectly experience and learn to handle unexpected real-life situations. With this approach, we will expect that the children can develop social skills and enhance the efficiency of their treatment.

• The Journal of Korean Academic Society of Nursing Education
• /
• v.27 no.2
• /
• pp.197-209
• /
• 2021

Purpose: The purpose of this study is to evaluate the validity and reliability of the Korean Bereavement Care Confidence Scale (K-BCCS). Methods: The Perinatal Bereavement Care Confidence Scale (PBCCS) was translated into Korean according to an algorithm of cultural adaptation process and excluded six items which were specific to perinatal bereavement. A total of 229 clinical nurses participated in the study. Construct validity, convergent validity, discriminant validity, and group comparison validity were evaluated, and Cronbach's α was calculated to estimate the reliability of the K-BCCS. Results: The K-BCCS consisted of 31 items in 7 factors, including knowledge and skills for bereavement care (12 items), organizational support (6 items), awareness of the needs (3 items), interpersonal skills (3 items), workload influence (2 items), continuous education (2 items), and understanding the grief process (3 items). The factor loading of 31 items within the 7 factors ranged from .60 to .86. For the convergent validity, the construct reliability (CR) ranged from .74 to .94, and the average variance extracted (AVE) ranged from .49 to .73, which is considered acceptable. The discriminant validity showed that the AVEs of the subscales were greater than the square of the correlation coefficient r. The nurses who had experience providing bereavement care (t=4.94, p<.001) or had received bereavement education (t=6.64, p<.001) showed higher K-BCCS values those without experience. The Cronbach's α of 31 items was .93 and ranged from .60 to .94 per subscale. Conclusion: The K-BCCS is a valid and reliable tool for evaluating nurses' confidence in bereavement care.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.12 no.2
• /
• pp.120-131
• /
• 2009

This study measured the centripetal force and effective scope of the population spread from urban center and subcenters in order to diagnose the urban spatial structure of the formation of a multicentric city structure in Busan. The study analyzed the variability of the determination coefficient value (R square) with a negative exponential function derived from the population density model by extending the circular region into 5-km units. The aim of this study was to measure changes in the effective scope of the population centripetal force of the urban center and subcenter in 5-year intervals from 1995 to 2005 using census data. The explanatory adequacy of the population density function was examined with the bias of the function to calculate the distance error between the real location of the urban center and the optimal location, according to the population density function. To summarize the results, the value for the area of Jungangdong showed a continuous reduction, whereas Seomyeon (Bujeondong) maintained explanatory adequacy without a large change. As a whole, Busan was in the process of continuous diversification, in spite of its reduced population. Therefore, it appears necessary to strengthen the function of the urban center and subcenter and to supply adequate dwelling zones close to downtown to form a more efficient urban spatial structure. The results of the present study will be utilized as basic data for the formulation of a political approach to the efficient reorganization of spatial structure by correlating concrete spatial information with the population variability of Busan's urban center and subcenter.