• The Journal of the Acoustical Society of Korea
• /
• v.31 no.7
• /
• pp.419-426
• /
• 2012

The pitch searching is a vital process in a vocoder. Generally, the method of pitch searching is employed after highlighting the periodicity, where a correlation is identified with the signal by changing the interval of two pulses. When the correlation value reaches the peak, the pitch can be found by the pulse interval because it is the repetition interval with most striking period. However if the identified period happens to be one of half period, double period or triple period, this cannot be considered as the pitch period. Many methods were suggested to solve this problem. An inaccurate pitch could be obtained as well, when there is an interval where signal amplitude is not constant but varies abruptly in the frame. To solve this matter, searching the pitch by dividing a frame into various subframes is adopted, but too much calculation has to be followed while it leads the correct value. This paper suggests an algorithm to resolve these two problems. First, to search the pitch after advance correction of the signal energy level with an estimated overall energy change ratio in the frame before pitch search to reduce half period, double period and triple period is suggested. Second, to vary the number of subframes by predicting the amplitude change rate in the frame by the energy ratio obtained by the above-mentioned method is advised. If these two methods are applied, the pitch searching time can be reduced and the general pitch searching performance can be improved without affecting the sound quality in the synthesized signal.

• Journal of the Korean Geosynthetics Society
• /
• v.18 no.4
• /
• pp.115-127
• /
• 2019

The low-flow grouting injection technique, the target construction method for this study, is a method of pouring mortar into the ground by non-emission replacement principle, which can be expected to increase the density of the ground, and, in some cases, be used as a base file using the strength of the high injection solids, along with low noise, low pollution, and high durability. To verify that the dynamic characteristics of the ground are improved by the low-flow injection technique, the test work was conducted on the site and physical tests were performed, and the quality of the improvement formed in the ground was verified through the indoor test on the core and core recovery rate was analyzed. The density logs test layer calculated the volume density of the ground layer by using the Compton scattering of gamma-rays, and the sonic logs was tested on the ground around the drill hole using a detector consisting of sonar and receiver devices inside the drill hole. As a result of the measurement of the change in physical properties (density and sonic logs) before and after grouting, both properties were basically increased after infusion of grout agent. However, the variation in density increase was greater than the increase in speed after grouting, and the ground density measurement method was thought to be effective in measuring the fill effect of the filler. Strength and core recovery rates were measured from specimens taken after the age of 28 days, and the results of the test results of the diffusion and strength test of the improved products were verified to satisfy the design criteria, thereby satisfying the seismic performance reinforcement.

• Journal of Veterinary Clinics
• /
• v.32 no.5
• /
• pp.422-425
• /
• 2015

This study evaluated the myocardial performance on echocardiography after the sedation/anesthesia of medetomidine (D), the combination of medetomidine and tiletamine/zolazepam (DZ), and the combination of medetomidine, tiletamine/zolazepam and tramadol (DZT) in Beagle dogs. Ten healthy adult Beagle dogs (weighing $8.6{\pm}1.0kg$) were enrolled in this study. Heart rate (HR), fractional shortening (%FS), left ventricular ejection fraction (%LVEF), stroke volume (SV), cardiac output (CO), left ventricular internal diameter in systole (LVIDs) and left ventricular internal diameter in diastole (LVIDd) using M-mode echocardiography were measured prior to anesthesia, then every 10 min for 60 min. The HR, %FS, %LVEF, SV and CO were significantly decreased during sedation/anesthesia with D, DZ and DZT combination of anesthesia. Although those anesthetic protocols provided acceptable quality of sedation/anesthesia, levels of cardiovascular suppression were substantial and persistent and thus the continuous monitoring on vital signs should be accompanied in any situation. Close attention is required for dogs with pre-existing heart diseases, when those anesthetic protocols were applied.

• Journal of Intelligence and Information Systems
• /
• v.9 no.1
• /
• pp.227-249
• /
• 2003

Prediction of corporate failure using past financial data is a well-documented topic. Early studies of bankruptcy prediction used statistical techniques such as multiple discriminant analysis, logit and probit. Recently, however, numerous studies have demonstrated that artificial intelligence such as neural networks can be an alternative methodology for classification problems to which traditional statistical methods have long been applied. In building neural network model, the selection of independent and dependent variables should be approached with great care and should be treated as model construction process. Irrespective of the efficiency of a teaming procedure in terms of convergence, generalization and stability, the ultimate performance of the estimator will depend on the relevance of the selected input variables and the quality of the data used. Approaches developed in statistical methods such as correlation analysis and stepwise selection method are often very useful. These methods, however, may not be the optimal ones for the development of neural network model. In this paper, we propose a genetic algorithms approach to find an optimal or near optimal input variables fur neural network modeling. The proposed approach is demonstrated by applications to bankruptcy prediction modeling. Our experimental results show that this approach increases overall classification accuracy rate significantly.

• Korean Journal of Poultry Science
• /
• v.19 no.3
• /
• pp.125-136
• /
• 1992

This study was conducted to estimate the effect of dietary alfalfa meal on the contents of egg yolk cholesterol, the levels of egg yolk pigmentation and the performance of laying hens. Alfalfa meal which was alternated wheat bran was supplied 0, 3.5 and 7%, respectively. Total 192 brown laying pullets of 47 weeks old were randomly assigned to the wire cages from July 23 to October 7, 1991 for 10 weeks. The results obtained were summarized as follows ： 1. The egg production was highest at 3.5% alfalfa meal level during the entire period. But there was no significant difference among treatments. 2. Egg weight increased in treatments 3.5 and 7% alfalfa meal supplementation significantly. (P<0.01). 3. Even though there was no significant difference, the daily egg mass was the highest at 3.5% of alfalfa meal level. 4. Daily feed intake was the highest at 3.5% of alfalfa meal level. However, feed conversion rate was the lowest among treatments. 5. The feed cost per kg egg mass in the treatment of 3.5% alfalfa meal was significantly lower than the other treatments. (P<0.05). 6. Shell thickness and shell weight in terms of egg shell quality were increased as the levels of alfalfa meal were increased. But there was no significant difference among treatments. 7, The egg yolk Pigmentation was improved significantly as the level of alfalfa meal was increased (P<0.01). 8.899 yolk cholesterol contents were decreased in the treatments of 3.5 and 7% alfalfa meal supplementation compared with those in the treatment of wheat bran only(P >0.05). The results of this study indicate that 3.5% alfalfa meal level was most effective and economical in laying hen.

• Journal of Electrical Engineering and Technology
• /
• v.8 no.5
• /
• pp.1021-1028
• /
• 2013

The frequency of a power system should be kept within limits to produce high-quality electricity. For a power system with a high penetration of wind generators (WGs), difficulties might arise in maintaining the frequency, because modern variable speed WGs operate based on the maximum power point tracking control scheme. On the other hand, the wind speed that arrives at a downstream WG is decreased after having passed one WG due to the wake effect. The rotor speed of each WG may be different from others. This paper proposes an algorithm for assigning the droop of each WG in a wind power plant (WPP) based on the rotor speed for the virtual inertial control considering the wake effect. It assumes that each WG in the WPP has two auxiliary loops for the virtual inertial control, i.e. the frequency deviation loop and the rate of change of frequency (ROCOF) loop. To release more kinetic energy, the proposed algorithm assigns the droop of each WG, which is the gain of the frequency deviation loop, depending on the rotor speed of each WG, while the gains for the ROCOF loop of all WGs are set to be equal. The performance of the algorithm is investigated for a model system with five synchronous generators and a WPP, which consists of 15 doubly-fed induction generators, by varying the wind direction as well as the wind speed. The results clearly indicate that the algorithm successfully reduces the frequency nadir as a WG with high wind speed releases more kinetic energy for the virtual inertial control. The algorithm might help maximize the contribution of the WPP to the frequency support.

• Korean Journal of Environmental Biology
• /
• v.36 no.1
• /
• pp.90-97
• /
• 2018

This study assessed the effect of ozone to control pathogenic bacteria in inlet water flowing to flounder farms, establishing operational parameters of ozonation at seawater conditions. Hydraulic retention time in a reaction pipeline after ozonation was fixed at 3 minutes in a flow through system. Concentrations of total residual oxidant (TRO) by ozonation were measured according to different ozonation intensities. The oxidant reduction potential (ORP), which is indirect but enables real-time measurement, was measured in relation to TRO values. TRO values were $0.01{\pm}0.01mg\;L^{-1}$ at an ORP range of 320-410 mV, $0.07{\pm}0.02mg\;L^{-1}$ at 600 mV, and $0.16{\pm}0.03mg\;L^{-1}$ at 700 mV. A heterotrophic marine bacteria colony was reduced by 80.6-97.9%, showing the suppression effect of ozonation on total bacteria in inlet water. At an ORP range of 400-500 mV, colonies of heterotrophic marine bacteria, Vibrio spp., and gram negative bacteria were significantly reduced in outlet water from a culture tank with ongrowing flounder (230 g) at a stocking density of $8kg\;m^{-2}$. Especially, Vibrio spp. and gram negative bacteria were seldom found at 400-500 mV. The daily feeding rate was from over 0.7% to total body weight at 300-500 mV, showing better performance than that in the control. The pathogenic bacteria entering the flounder farm were effectively removed when the ORP range to 400 mV or less.

• Journal of Korean Society of Environmental Engineers
• /
• v.28 no.6
• /
• pp.613-619
• /
• 2006

The objectives of this research are to evaluate the effect of membrane materials, particulate matter and membrane pore size on permeate flux. It was shown that the removal efficiency of high MW organic matter more than 10 kDa was lower than that of low MW organic matter for $MIEX^{(R)}$ process. For the change of permeate flux by the pretreatment process, $MIEX^{(R)}+UF$ process showed high removal efficiency of organic matter as compared with coagulation+UF processes, but high reduction rate of permeate flux was presented through the reduction of removal efficiency of high MW organic matter. The pretreatment of the raw water significantly reduced the fouling of the hydrophilic membrane, but did not decrease the flux reduction of the hydrophobic membrane. Flux decline on MF process increased due to the pore clogging, while the permeate flux decline of UF process decreased due to the formation of cake layer. It was shown that particle matter was not effect on MIEX+membrane process. But, for coagulation+membrane process, particle matter was important factor on permeate flux.

• Journal of KIISE:Information Networking
• /
• v.31 no.5
• /
• pp.501-510
• /
• 2004

While the Internet keeps its permeation into every aspect of human life, two things stand out. One is the requirement for high quality of services to support multimedia data service.'The other is the desire for ubiquitous network connection. Combining the two things makes the Internet possible in supporting multimedia communications for nomadic users on the locomotion. To support QoS communication for mobile users by applying RSVP to Mobile IP, RSVP Tunnel, which specifies building separately a RSVP session between the home agent and the foreign agent, was proposed. However, the RSVP Tunnel method breeds bandwidth overhead and association problems in tunnel because of duplicated RSVP messages use. To resolve these problems, in this paper, we propose the new encapsulation method, the RSVP-in-IP Encapsulation (RIPE) that can support QoS guaranteed service efficicntly in Mobile IP networks. The proposed method supports RSVP mobility to Mobile If tunneling mechanism efficiently without any additional session as the RSVP Tunnel scheme. Moreover it removes the critical problems of bandwidth overhead in a tunnel and association by duplicated messages. We compared the performance of our proposed scheme with RSVP Tunnel scheme in term of mean delay, mean data rate and bandwidth overhead in tunnel.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.28 no.9C
• /
• pp.868-875
• /
• 2003

In this paper, enhanced multiresolution motion estimation(MRME) using reduction of one-pixel shift in wavelet domain is proposed. Conventional multiresolution motion estimation using hierarchical relationship of wavelet coefficient has difficulty for accurate motion estimation due to shift-variant property by decimation process of the wavelet transform. Therefore, to overcome shift-variant property of wavelet coefficient, two level wavelet transform is performed. In order too reduce one-pixel shift on low band signal, S$_4$ band is interpolated by inserting average value. Secondly, one level wavelet transform is applied to the interpolated S$_4$ band. To estimate initial motion vector, block matching algorithm is applied to low band signal S$_{8}$. Multiresolution motion estimation is performed at the rest subbands in low level. According to the experimental results, proposed method showed 1-2dB improvement of PSNR performance at the same bit rate as well as subjective quality compared with the conventional multiresolution motion estimation(MRME) methods and full-search block matching in wavelet domain.