• ETRI Journal
• /
• 제39권4호
• /
• pp.582-591
• /
• 2017

To address the wire complexity problem in large-scale globally asynchronous, locally synchronous systems, a current-mode ternary encoding scheme was devised for a two-phase asynchronous protocol. However, for data transmission through a very long wire, few studies have been conducted on reducing the long propagation delay in current-mode circuits. Hence, this paper proposes a current steering logic (CSL) that is able to minimize the long delay for the devised current-mode ternary encoding scheme. The CSL creates pulse signals that charge or discharge the output signal in advance for a short period of time, and as a result, helps prevent a slack in the current signals. The encoder and decoder circuits employing the CSL are implemented using $0.25-{\mu}m$ CMOS technology. The results of an HSPICE simulation show that the normal and optimal mode operations of the CSL achieve a delay reduction of 11.8% and 28.1%, respectively, when compared to the original scheme for a 10-mm wire. They also reduce the power-delay product by 9.6% and 22.5%, respectively, at a data rate of 100 Mb/s for the same wire length.

• 비파괴검사학회지
• /
• 제21권6호
• /
• pp.612-617
• /
• 2001

본 연구에서는 Al-Si 합금 열간단조품 내부 판상 결함을 탐지하기 위한 초음파평가 기법을 확립하였다. 이를 위하여 내부에 존재하는 여러 가지 판상 결함의 초음파 특성을 실험적으로 구하였으며, 펄스-반사법을 적용하여 초음파 탐상신호에 대한 내부 판상 결함의 각도 등이 초음파 수신신호의 형태에 미치는 영향을 평가하였다. 한편 결함위치에 따른 초음파 신호특성을 규명하기 위하여 단조품 가장자리 부위에 존재하는 내부 판상 결함의 초음파 수신신호 특성을 평가하였으며, 본 시험편에 대한 초음파 투과법 적용 한계에 대하여 고찰하였다. 나아가 500개 이상의 파단 실험을 통해 제시된 초음파 평가기법의 신뢰성을 확인하였다.

• Bulletin of the Korean Chemical Society
• /
• 제23권2호
• /
• pp.309-314
• /
• 2002

The ablation dynamics and cluster formation of $C_n^+$ ions ejected from 355 nm laser ablation of a graphite target in vacuum are investigated using a reflectron time-of-flight (RTOF) mass spectrometer. At low laser fluence, odd-numbered cluster ions with $3{\leq}n{\leq}15$ are predominantly produced. Increasing the laser fluence shifts the maximum size distribution towards small cluster ions, implying the fragmentation of larger clusters within the hot plume. The temporal evolution of $C_n^+$ ions was measured by varying the delay time of the ion extraction pulse with respect to the laser irradiation, providing significant information on the characteristics of the ablated plume. Above a laser fluence of $0.2J/cm^2$ , large cluster ions ($n{\geq}30$) are produced at relatively long delay times, indicating that atoms or small carbon clusters aggregate during plume propagation. The dependence of the intensity of ablated $C_n^+$ ions on delay time after laser irradiation shows that the most probable velocity of each cluster ion decreases with cluster size.

• 한국추진공학회:학술대회논문집
• /
• 한국추진공학회 2006년도 제26회 춘계학술대회논문집
• /
• pp.11-16
• /
• 2006

본 연구는 이종 접착 재질의 접착계면에서 미접착 결함을 검출하기 위한 새로운 시험 기법을 개발하기 위함이다. 접착계면과 미접착계면에서의 초음파 전달 현상을 이론적으로 해석하여 초음파 신호를 모델링하였고, 이론적 분석에 기초하여 미접착계면에서의 위상 반전 현상을 애용한 검사 방법을 FRP/고무 시편에 적용하였다. 정량적으로 결함의 최소 검출 능력을 평가하기 위하여 알루미늄/고무 시편에 평저공을 가공하여 제작하였고 일반적으로 사용하고 있는 펄스에코반사법과 새로운 시험 기법인 위상반전법을 상호 비교하였으며 이론적으로 예측한 초음파 신호와 실험에서 얻은 초음파 신호를 근거로 위상반전법으로 미접착 결함을 검출할 수 있다고 판단하였다.

• 대한전기학회논문지:전기물성ㆍ응용부문C
• /
• 제49권1호
• /
• pp.44-51
• /
• 2000

In this paper, using a wide-band AE sensor with the frequency range from 100[kHz] to 1.5[kHz], the frequency spectra of AE signals generated from the corona discharges of the needle-plane gap and from the partial discharges of an epoxy void were analyzed to determine the proper ultrasonic sensor with optimum frequency range according to the patterns of corona discharges. We also examined the propagation characteristics of AE signals in oil and the relationship between the magnitude of corona discharge and the magnitude of AE signals in peak-to-peak value under the application of 60[Hz] ac high-voltage. From these results, the main frequency spectra of AE signals emitted from the corona discharges of the needle-plane gap were about 130[kHz] by the fast fourier transform, but the main frequency spectra appeared to be 230[kHz] in the partial discharges of an epoxy void. The magnitude of AE signals was proportional to the magnitude of corona discharge and discharge current pulse with increasing the applied voltages.

• 대한전자공학회논문지
• /
• 제21권4호
• /
• pp.65-71
• /
• 1984

초음파 B스캔너의 경우 광대역 펄스를 사용하기 때문에 광학에서 사용되는 집속 계산식으로는 초음파 집속 시스템을 정확하게 설계할 수 없다. 본 연구에서는 초음파 다중소자에 광대역 펄스가 여기될 때 초음파의 전파모양을 정확하게 계산할 수 있늘 방법이 연구되었다. 계간된 초음차의 전파 모양을 이용하여 고해상력을 갖는 다이나믹 집속(dynamic focusing)시스템의 구동소자수, 집속치로 지연값 및 집속점 위치등을 설계하도록 하였다. 저잡음 스튀칭 특성을 갖는 다이나믹 집속 시스템을 구성하여 실험에 의해 3.5MHz선형소자로써 18cm의 깊이까지 2∼3mm의 해상도가 얻어짐을 확인하였다.

• Composites Research
• /
• 제31권5호
• /
• pp.246-250
• /
• 2018

본 연구에서는 곡면 복합재 구조물의 모서리에 위치한 결함을 검사하고 가시화하기 위해 제안된 레이저 초음파 기반 회전식 검사 기법을 소개한다. 모서리 부위에 결함이 위치한 L 형 복합재 구조물을 레이저 초음파 기반 회전식 검사 기법을 이용하여 검사하였다. L 형 시편은 층간분리 손상을 모사하기 위해 각기 다른 세 가지 깊이에 위치한 인공 결함을 포함하고 있다. 모든 인공 결함이 각각의 위치한 깊이에 따라 다른 시간대에 선명하게 탐지되었다. 검사결과는 제안된 방법이 어떠한 특별한 도구 없이도 곡면 복합재 구조물의 모서리 부위의 검사에 적합하다는 것을 보여준다.

• 비파괴검사학회지
• /
• 제35권6호
• /
• pp.381-388
• /
• 2015

The speed and oscillation directions of elastic waves propagating in the [ab0] direction of a silicon single crystal were obtained by solving Christoffel's equation. It was found that the quasi waves propagate in the off-principal axis, and hence, the directions of the phase and group velocities are not the same. The maximum deviation of the two directions was $7.2^{\circ}$. Two modes of the pure transverse waves propagate in the [110] direction with different speeds, and hence, two peaks were observed in the pulse echo signal. The amplitude ratio of the two peaks was dependent on the initial oscillating direction of the incident wave. The pure and quasi-transverse waves propagate in the [210] direction, and the oscillation directions of these waves are perpendicular to each other. The skewing angle of the quasi wave was calculated as $7.14^{\circ}$, and it was measured as $9.76^{\circ}$. The amplitude decomposition in the [210] direction was similar to that in the [110] direction, since the oscillation directions of these waves are perpendicular to each other. These results offer useful information in measuring the crystal orientation of the silicon single crystal.

• 대한기계학회논문집B
• /
• 제26권1호
• /
• pp.1-11
• /
• 2002

Flow of fluid has been studied in various fields of fluid engineering. To hydraulic engineers, the unsteady flow such as pulsation and liquid hammering in pipes has been considered as a serious trouble. So we are supposed to approach the formalized mathematical model by using more exact momentum equation for fluid transmission lines. Most of recent studies fur pipe line have been studied without considerations of variation of viscosity and temperature, which are the main factors of pressure loss causing the friction of fluid inside pipe line. Frequency response experiments are carried out with use of a rotary sinusoidal flow generator to investigate wave equation take into account viscosity and temperature. But we observed that measured value of gains are reduced as temperature increased. And it was respectively observed that the measured value of gains are reduced and line width of gain is broadened out, when temperature was high in the same condition. As we confessed, pressure loss and phase delay are closely related with the length, diameter and temperature of pipe line. In addition, they are the most important factors, when we decide the momentum energy of working fluid.

• 대한전기학회논문지:전기물성ㆍ응용부문C
• /
• 제48권4호
• /
• pp.247-252
• /
• 1999

In this paper, in order to investigate availability of the OW-PD measurement method which has been proposed as an alternative of AC-PD measurement method to an after laying test and/or diagnosis for the power cable system, partial discharges owing to the needle-type defect integrated into the cable have been measured using AC and OW(Oscillating Wave) voltages. In the AC-PD measurement, the magnitude, phase and pulse number of partial discharges have been changed with the duration of voltage application, which can be analyzed through the relation with the process of the electrical tree initiation and propagation. In addition, the characteristics of partial discharges using OW voltage are appeared to be similar to those in case of AC-PD measurement and to be different with the shapes of electrical tree. From these results, it is concluded that the OW-PD measurement method is available to the tests for the cable system.