• Journal of Korean Physical Therapy Science
• /
• v.25 no.2
• /
• pp.47-54
• /
• 2018

Purpose: The purpose of this study was to investigate the most effective exercise position of Latissimus dorsi's activities during Pull up, Push up and Lat pull down among few positions of hand grips(pronation, Supination and neutral grip) and grip widths(30cm, 60cm) based on EMG activities. Method: 10 healthy adults were participated in this study and the surface EMG activities of the Latissimus dorsi were measured during Pull up, Push up and Lat pull down exercise according to specific hand grip and grip width positions. The maximum and mean value of Latissimus dorsi's EMG activities at all positions were recorded and analysed by ONE-WAY REAPTED ANOVA. Results: The showed that the most Latissimus dorsi's activities is during Pull up exercise. Main results are as follows 1)maximum value: For Pull up, among all studied positions, Rt Latissumus dorsi, position of Supinated grip and 60cm grip width showed strongest muscle activation based on maximum EMG value. Statistical significance was assumed at p<.05. 2)mean value: For Pull up, among all studied positions, Both Latissimus dorsi, position of pronated grip and 60cm grip width showed strongest muscle activation based on mean EMG value. Statistical significance was assumed at p<.05. Conclusion: Therefore, taking the results of this study, Pull up exercise would be the best exercise of Latissimus dorsi's activation. It is recommended to do in pronated grip position and 60cm grip width during Pull up to make body fit.

• Korean Journal of Bronchoesophagology
• /
• v.2 no.1
• /
• pp.63-70
• /
• 1996

Reconstruction for hypopharynx and cervical esophagus after wide resection of extensive hypopharynx and larynx cancers have been used various methods including myocutaneous flaps, gastric pull up, md jejunal or large bowel free graft. Recently, the authors had experienced hypopharynx and larynx cancers with extension to the posterior hypopharyngeal wall and thoracic esophagus. Of course, these reconstructive methods should be selected in accordance with the patient's age, physical status, extend of prim.:W lesion, and defect after on block resection, however, gastric pull up was performed in hypopharynx cancer which had skipped lesion in the thoracic esophagus and jejunal free grafts were performed in case 2, 3 which had a extended lesions to the posterior pharyngeal wall. Some complications were noted, which were successfully stabilized by conservative managements. The gastric pull up and jejunal free graft were considered suitable methods for reconstrunction of hypopharynx and cervical esophagus, however, further studies are necessary about it.

• Korean Journal of Head & Neck Oncology
• /
• v.26 no.1
• /
• pp.30-32
• /
• 2010

Tracheo-gastric fistula is a very rare late complication of total laryngopharyngoesophagectomy with gastric pull-up procedure. It usually occurs after transhiatal esophagectomy, but it has only rarely been reported after total laryngopharyngoesophagectomy with gastric pull-up procedure. Chronic irritation and gastric ulcer may be the cause of tracheogastric fistula. To prevent fistula formation, active management of gastric ulcer and avoidance of mucosal irritation are necessary. We report a case of a tracheogastric fistula which occurred two years after total laryngopharyngoesophagectomy with gastric pull-up procedure that maybe occurred by chronic irritation and gastric ulcer.

• Korean small business review
• /
• v.42 no.3
• /
• pp.221-243
• /
• 2020

The purpose of this study is to research the effects of desire for independence, possibility of start-up success and employment stability to the push-entrepreneurship through the push-entrepreneurship by a survey of employees in the middle age. The purpose of the creating start-up environment was encouraged the qualitative expansion of opportunity-driven start-up rather than the quantitative expansion of necessity-driven start-up for the economic growth and expanding employment. In spit of the employees had their own careers, skills, opportunities and market-experiences, In reality it is necessity-driven start-up that the quantitative expansion. The purpose of this study was to reflect process change by desire for independence, push-entrepreneurship and pull-entrepreneurship based on the possibility of start-up success and employment stability perceived by individual founders, changed process factor rather than the fixed result factor. The results are as follows. First, it was found that desire for independence makes a positive (+) effect on the pull-entrepreneurship and the push-entrepreneurship. Second, it was found that the possibility of start-up success makes a positive (+) effect on the pull-entrepreneurship and not effect on push-entrepreneurship. third, it was found that the employment stability makes a positive (+) effect on the pull-entrepreneurship and not effect on the push-entrepreneurship. Forth, it was found that desire for independence makes a positive (+) effect on the pull-entrepreneurship and mediating negative (-) effect on the push-entrepreneurship. The implication of this study was that potential entrepreneurs with desire for independence, rather than necessity-driven start-up due to unemployment, could be developed as pull-entrepreneurship improved the situation of push-entrepreneurship. In addition, it seems that entrepreneurship education and activation of entrepreneurship programs for employee with desire for independence expand opportunity-driven start-up after retirement.

• Proceedings of the KSR Conference
• /
• 2000.11a
• /
• pp.250-257
• /
• 2000

The speed-up of conventional trains is considered as one of the efficient methods to relieve traffic jam and to increase the capacity of transportation. In this study, we measured and analyzed the ride comfort of a push-pull Saemaeul Train with speed-up of 5km/h in curves and 10km/h on straight tracks as compared with present operation speed of the push-pull Saemaeul Trains. Four main lines-Honam, Kyungboo, Janghang, Kyungjeon- were chosen as representative lines for speed-up feasibility study. The increase of mean ride comfort index in case of speed-up is 0.5-2㏈. The mean ride comfort index of vertical direction in case of speed-up is 107-110㏈ for Honam line, 104-112㏈ for Kyungboo line, 108-112㏈ for Janghang line and 105-108㏈ for Kyungjeon line, which are rather high as compared with German trains of similar grade with maximum vehicle speed of 160km/h.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.26 no.2
• /
• pp.102-111
• /
• 1989

In this paper two new non-inverting type BiCMOS drivers are proposed. These are characterized by the use of pMOSFET's in charging the bases of pull-down bipolar transistors. The delay time in pull-up transition of the proposed drivers is 20%-47% shorter than that of the drivers of current using. The proposed drivers use 1-3 fewer MOSFET's in comparison with the drivers of current using.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.32A no.12
• /
• pp.198-208
• /
• 1995

BiCMOS circuit consist of CMOS part which constructs logic function, and bipolar part which drives output load. Test to detect stuck-open faults in BiCMOS circuit is important, since these faults do sequential behavior and are represented as transition faults. In this paper, proposes a method for efficiently detecting transistor stuck-open faults in BiCMOS circuit by transforming them into slow-to=rise transition and slow-to-fall transition. In proposed method, BiCMOS circuit is transformed into equivalent gate-level circuit by dividing it into pull-up part which make output 1, and pull-down part which make output 0. Stuck-open faults in transistor are modelled as transition fault in input line of gate level circuit which is transformed from given circuit. Faults are detceted by using pull-up part gate level circuit when expected value is '01', or using pull-down part gate level circuit when expected value is '10'. By this method, transistor stuck-open faults in BiCMOS circuit are easily detected using conventional gate level test generation algorithm for transition fault.

• Korean Journal of Bronchoesophagology
• /
• v.9 no.2
• /
• pp.69-73
• /
• 2003

Various flaps are using for reconstruction of esophageal defect. The choice of reconstruction is depended to the oncologic needs of the situation. If the entire esophagus or significant part of the thoracic esophagus is involved by tumor, then total esophagectomy and gastric pull-up or colon transposition is indicated. But for most hypopharyngeal tumors, laryngopharyngeal tumors, and cervical esophageal tumors, segmental resection of these area and replacement with a jejunal fee or forearm free flap has become the standard technique. The authors have experienced a case of total pharyngo-laryngo-esophago-gastrectomy and colon transposition in a patient of esophageal cancer following partial esophagectomy and gastic pull-up due to corrosive esophageal stricture. We report this case with brief review of the literatures.

• International Journal of Concrete Structures and Materials
• /
• v.11 no.1
• /
• pp.69-84
• /
• 2017

This paper presents results of an experimental investigation on the behaviour of bond between external glass fibre reinforced polymer reinforcement and concrete exposed to three different environmental conditions, namely, temperature cycles, wet-dry cycles and outdoor environment separately for extended durations. Single shear tests (pull-out test) were conducted to investigate bond strengths (pull-out strengths) of control (unexposed) and exposed specimens. Effect of the exposure conditions on the compressive strength of concrete were also investigated separately to understand the effect of changing concrete compressive strength on the pull-out strength. Based on the comparison of experimental results of exposed specimens to control specimens in terms of bond strengths, failure modes and strain profiles, the most significant degradation of pull-out strength was observed in specimens exposed to outdoor environment, whereas temperature cycles did not cause any deterioration of strength.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.15 no.1 s.94
• /
• pp.29-38
• /
• 2005

The track pull-in behavior analysis in an optical disk drive (ODD) using plane phase and the evaluations for effecting parameters of it are discussed. Track pull-in, track capture procedure to do track following control, is a key factor to increase data transfer rate. First, the relative velocity between the beam spot of an optical pick-up and the target track of an optical disk is analyzed during the track pull-in procedure. In this process, it is showed that the track error signal has nonlinear characteristics which are depending on the time. Second, Runge-Kutta method to solve the nonlinear equation is applied to find the track pull-in behavior, and some optimal parameters to get stable and fast pull-in condition are obtained. Then, the phase plane analysis for track pull-in procedure is presented. Finally, some comments for the simulated results are discussed briefly.