• 한국안전학회지
• /
• 제12권3호
• /
• pp.38-44
• /
• 1997

6063-T5 alloys are tested in laboratory air, water and 3% NaCl solution to investigate the effects of corrosive environment on the retardation behavior through single overload fatigue test. Also, the fatigue crack propagation and the crack closure behavior are studied. The results obtained in this experimental study are summarized as follows. 1) Behaviors of fatigue crack growth retardation are observed in water and 3% NaCl solution as they do in air. The number of delay cycles and the size of affected region by single overload decrease greatly in water and 3% NaCl compared with those in air. 2) In fractographic results, the overload marking by single overload appear remarkably in air, but indistinctly in water and 3% NaCl solution. 3) The effect of crack closure on crack propagation is most remarkable in the beginning of crack propagation. With crack propagation, the crack closure level and its effect decrease greatly.

• ETRI Journal
• /
• 제34권6호
• /
• pp.911-921
• /
• 2012

In high-speed wireless communications, an analysis of the propagation characteristics is an important process. Information on the propagation characteristics suitable for each environment significantly helps in the design of mobile communications. This paper presents the analysis results of radio propagation characteristics in outdoor environments for a new mobile wireless system at 781 MHz. To avoid the interference of Korean DTV broadcasting, we measure the channel characteristics in urban, suburban, and rural areas on Jeju Island, Republic of Korea, using a channel sounder and $4{\times}4$ antenna. The path loss (PL) measurement results differ from those of existing propagation models by more than 10 dB. To analyze the frequency characteristics for Korean propagation environments, we derive various propagation characteristic parameters: PL, delay spread, angular spread, and K-factor. Finally, we verify the validity of the measurement results by comparing them with the actual measurement results and 3D ray-tracing simulation results.

• 디지털콘텐츠학회 논문지
• /
• 제8권4호
• /
• pp.459-465
• /
• 2007

본 논문에서는 다중 벽면 구조의 실내 환경에서 전파의 전달특성을 모델링하기 위해 ray-launching 기반의 광선추적법을 이용한 2차원 ray-tracing 시뮬레이터를 구현하였고, 이를 통해 ray의 전파 경로를 분석하고 평가하였다. 실험 결과, 구현된 광선추적법의 경로 패턴 및 시간지연 분포는 동일한 무선 환경에서 수행된 이전의 실험 결과와 비슷한 결과가 나타남을 확인하였으며, 송수신 거리 및 방사각에 따른 수신반경의 조정이 타당함을 확인하였다. 특히 비가시거리 송수신 환경에서 다중 벽면을 투과한 ray가 반사와 투과를 형성하여 수신기에 도달할 때까지의 ray의 impulse response는 기존 연구의 실험 결과와 대부분 일치하였으며, 송신기에서 발사되는 ray의 방사각을 $1^{\circ}$에서 $7^{\circ}$까지 달리하여 실험한 경우 도출된 channel profile이 서로 유사함을 확인하였다.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 1998년도 추계종합학술대회 논문집
• /
• pp.779-782
• /
• 1998

This paper describes a high-speed Dual-modulus Prescaler (DMP) for RF mobile communication systems with pulse remover using selective latch technique. This circuit achieves high speed and low power consumption by reducing full speed flip-flops and using a selective latch. The proposed DMP consists of only one full speed flip-flop, a selective latch, conventional flip-flops, and a control gate. In order to ensure the timing of control signal, duty cycle problem and propagation delay must be considered. The failling edgetriggered flip-flops alleviate the duty cycle problem andthis paper shows that the propagation delay of control signal doesn't matter. The maximum operating frequency of the proposed DMP with 0.6um CMOS technology is up to 2.2㎓ at 3.3V power supply and the circuit consumes 5.24mA.

• 한국정보통신학회논문지
• /
• 제3권4호
• /
• pp.787-794
• /
• 1999

본 논문에서는 기존의 동적 CMOS 논리회로보다 동작속도가 타르고 면적이 작은 새로운 EMMODL (enhanced NORA MODL)의 설계방법을 제시하고, 이를 이용하여 32 비트 CLA(carry lookahead adder)를 구현하였다. 제안된 회로는 MODL(multiple output domino logic)의 출력 인버터를 제거하여 면적을 줄이고 동작속도를 증가시킬 수 있다. 0.8um 이중금속 CMOS 공정으로 구현된 CLA는 시차문제가 발생하지 않았고, 3.9nS 이내에 32 비트 연산이 가능하였다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2005년도 심포지엄 논문집 정보 및 제어부문
• /
• pp.194-196
• /
• 2005

The command processor in satellite handles the capability of the process of command transmitted from ground station and deliver the processed data to on board computer in satellite. The command processor is consisted of redundant box to increase the reliability and availability of the capability. At each command processor, the processing time of each command processor is different, so the mismatch of processing time makes it difficult to timely synchronize the reception to on board computer and even will be became worse under the command processor's fault. To minimize the tine loss induced by the command processor's fault on board computer must analyze the time distribution of command propagation. This paper presents the logic of minimizing the delay error of command propagation the logic of analyzing the output of command processor.

• 한국정보통신학회논문지
• /
• 제1권1호
• /
• pp.105-111
• /
• 1997

This Paper Proposes a new efficient system design strategies for the acoustic-based underwater multiple modem and media access control protocol. The system aims to establish the acoustic-based communication network of an underwater vehicles for deep sea mining, which ensures a certain level of maximum throughput regardless of the propagation delay of acoustic and allows fast data transmission through the acoustic-based multiple channel. A media access control protocol for integrated communication network and it's acoustic-based communication modems that allows 'peer-to-peer' communication between a surface mining plant multiple underwater system is designed, and the proposed media access control protocol is implemented for its verification. Furthermore, a proposed design strategies which make it possible to control the multiple vehicle for an underwater mining is presented in this paper.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2003년도 하계종합학술대회 논문집 I
• /
• pp.314-317
• /
• 2003

In this paper, a measurement and analysis program is developed, that can be utilized to measure and analyze radio propagation characteristics. This program is able to control the measurement instruments including spectrum analyzer through a GPIB interface, and analyze the measured data to yield mean excess delay and RMS delay spread. The measured path loss can be compared with theoretical path loss in free space or inside tunnels. The measured and analyzed results can also be presented in the forms of graphs. As those tasks can be conducted on the measurement spot, this program is very helpful for performing and verifying measurements.

• 터널과지하공간
• /
• 제4권1호
• /
• pp.38-46
• /
• 1994

This paper concerns the design of blasts adjacent to structures and facilities. In order to investigate the site characteristics, measurements of in-situ wave propagation and laboratory tests of rock cores taken from the boreholes were carried out. Effects of rock media and delay intervals on ground vibration levels were identified from over sixty measurements of three times of test blasts. For practical use in the field, an empirical propagation equation was derived so as to reflect the characteristics of rock media and delay effects. Safe limits of vibration level for structures were conservatively established based on various suggested criteria. Safe limits for facilities were adopted so that vibration levels induced by blasting should not exceed the allowable limits specified in the manufacturer's installation condition. Suggested were blast pattern and operation to enhance the rock fracturing and to reduce the ground vibration levels under the restricted conditions.

• 한국정보통신학회:학술대회논문집
• /
• 한국정보통신학회 2017년도 춘계학술대회
• /
• pp.621-624
• /
• 2017

본 논문에서는 수중음향 네트워크에서 긴 전파지연 시간, 낮은 전송속도, 높은 패킷 손실율 등과 같은 제약 환경을 고려한 패킷트레인방식의 동기화 프로토콜을 제안한다. 제안되는 동기화프로토콜은 단방향 전파지연측정방식을 적용하며 연속해서 전송된 패킷의 수신시각 차이를 통해 전파지연 시간 추정에 의한 오류 영향을 최소화한다. 제안한 동기화 프로토콜은 노드 간 통신거리, 메시지 전송횟수에 따른 시뮬레이션을 통해 기존 프로토콜과의 성능을 비교하고, 제안한 동기화 프로토콜의 우수성을 보인다.