• Journal of Korean Society of Environmental Engineers
• /
• v.33 no.7
• /
• pp.523-529
• /
• 2011

This study has been performed to examine the influence of the size of particles on the stabilization in the aerobic stabilization equipment connected with MBT system. The biodegradable waste inside the reactor (60% of food waste, 25% of paper waste, 2% of wood waste and 5% of compost) has been charged in same composition. The degree of stabilization was compared and analyzed after charging with adjustment of particle size in 5 mm, 10 mm, 20 mm, 50 mm, 100 mm and state of no separation. The experiment revealed that highest temperature beyond $65^{\circ}C$ was shown in the particle size of less than 50 mm in change of temperature and the highest temperature was about $50^{\circ}C$ in reactor of 100 mm and no separation. The proportionality between generated quantity of $CO_2$ and particle size was not observed, even the highest in generated quantity was shown in over 100 mm. The weight changes based on wet and dry conditions in the reaction process showed the 30% and 46% of reduction in the smallest particle size of 5 mm and it showed the trend of the lower reduction rate at the bigger particle size. The water soluble $COD_{Cr}$ and TOC showed the reduction rate of 60% in reactor of particle size in 100 mm and no separation while the reduction rate comparing to the initial stage of reaction in the reactor of less than 50 mm was 80%. Such result derived the conclusion of acceleration in the decomposing stabilization of biodegradable material due to the decomposing rate of organic substance as the particle size of biodegradable waste gets smaller. It is concluded as necessary to react in adjustment under 50 mm of particle size as much as possible.

• Korean Journal of Food Science and Technology
• /
• v.2 no.2
• /
• pp.8-16
• /
• 1970

Exploitation of leaf protein concentrates for human consumption is very important. Leaf protein concentrates can be easily prepared by mechanically mincing leaves material and press it for getting the juice. Crude protein can be separated from the juice by aging, adjusting the pH, or heating to $75-80^{\circ}C$ etc. This report deals with the extractability of total-N from 69 species of fresh leaves by mechanical process, and then compared the recovery of leaf protein concentrates from leaf extracts by treating with TCA, pH adjustment and heating. Results are summarized as follows. 1. In general, the greater the content of total-N of leaves the greater the percentage extraction. Extraction of the juice from leaves is needed at least two times. The simple equations are constituted between the total-N (T; %) and the first and second extractability ($E_1,\;E_2;\;%$) of the total-N of leaves, as follows: $E_1=0.8168T\;E_2=0.1830T$ 2. The optimum pH value for coagulating protein from extracts is considered to be 3.5 to 4.5. However, the products of leaf protein concentrate by the pH adjustment of extracts are generally dull in color with rich elasticity. 3. Recoveries of the leaf protein concentrate from extracts by treating methods were in the following order of TCA treatment> pH 4 treatment> pH 3 treatment> heat treatment. The yield of leaf protein concentrates decreased bout 10% with pH 4 treatment, 11.4% with pH 3 treatment, and 14.8% with heat treatment compared with the TCA treatment. 4. The heat treatment is the most benifitial method for the production of leaf protein concentrates with regard to properties of texture, color and yield of products and easiness of the treatment method.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.32 no.6
• /
• pp.999-1011
• /
• 2008

To most of the students studying fashion related major, the graduation fashion show is a big challenge. They have to put together all they learn and show what they can do to their future employers. They design, pattern work, and make up garments for the show all by themselves. Unfortunately. while they make up their garments, they usually don't Dow exactly body measurements of the models. So quite often they have to alter their art works up to the last minute of the fashion show opening. Sometimes such unadequate work process ruins their work. The purpose of this study is to suggest block patterns of Korean fashion models measurements for basic items, such as jacket and pants for male models and torso length block pattern, skirt and pants for female models. 20 male and 20 female professional models were measured. The block patterns were based on their measurements. After the first fitting test, patterns were corrected by their body characteristic. For both male and female models, it was found desirable to fix the shoulder width and make an adjustment to the patterns with a deviation of width and girth items. In case of the resultant patterns the satisfaction was made better. Model sizes proposed in this study are considered closer to the size of average models, since they were based on A-grade models who are currently working in Korea. The resultant patterns can be produced by simply making a slight adjustment to the width of the proposed pattern in this study.

• Journal of Life Science
• /
• v.29 no.2
• /
• pp.265-271
• /
• 2019

In general, specific gravity (SG) and urinary creatinine (CR) have been used to adjust urinary cadmium (Cd) concentrations. However, the validity of correction methods has been controversial. We compared the two adjustments to evaluate associations between urinary Cd and various renal damage markers and to evaluate the relationship between urinary Cd concentration and renal disease markers, such as estimated glomerular filtration rate (eGFR), in a relatively large general population sample. Among the 1,086 volunteers who were enrolled in this study, 862 healthy volunteers who did not have kidney disease were included in the final analysis. Urinary Cd, malondialdehyde (MDA), and N-acetyl-${\beta}$-D-glucosaminidase (NAG) concentrations were measured, the creatinine-based eGFR was calculated, and the relationships between these markers were subsequently analyzed. This study showed the use of urinary Cd concentration adjusted with SG rather than with urinary creatinine may be appropriate in studies evaluating renal function based on Cd exposure. Urinary Cd concentration adjusted with SG had a positive correlation with urinary MDA levels and a negative correlation with eGFR. This relationship was relatively stronger in women than in men. This study showed that urinary Cd level was associated with decreased eGFR in the general population, and oxidative stress was likely to act as an intermediator in this process. These results suggest that eGFR can be a very good indicator of kidney damage caused by Cd exposure in the general population.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.28 no.1
• /
• pp.153-160
• /
• 2010

It is necessary to determine accurate 3-dimensional coordinates of the building corner points that could be control or check points in order to verify the accuracy of 3D digital maps in the near future. The usual process of obtaining the coordinates of the building corner points is to set up the ground control points with a GPS and then to practice terrestrial survey such as distance or angle measurements. However, since an error in the ground control points can be propagated through the terrestrial survey into the final coordinates of the buildings, accurately should be considered as much as possible. The actual effect of the GPS-derived ground control point error on the estimates of the unknowns through the terrestrial survey is mathematically analyzed, and the simulation data is tested numerically. The error of the ground control points is tested in the cases of 1-4 cm for the horizontal components and 2-8 cm for the vertical component. The vertical component error is assigned twice the horizontal ones because of the characteristics of the GPS survey. The distance measurement is assumed for convenience and the precision of the estimated coordinates of the building corner points is almost linearly increased according to the errors of the ground control points. In addition, the final estimates themselves can vary by the simulated random errors depending on the precision of the survey instrument, but the precision of the estimates is almost independent of survey accuracy.

• Environmental and Resource Economics Review
• /
• v.13 no.4
• /
• pp.735-761
• /
• 2004

As a possible alternative to Traditional Discounted Cash Flow Method, "Option Pricing Model" has drawn academic attentions for the last a few decades. However, it has failed to replace traditional DCF method practically due to its mathematical complexity. This paper introduces an option pricing valuation model specifically adjusted for the natural resource development projects. We add market information and industry-specific features into the model so that the model remains objective as well as realistic after the adjustment. The following two features of natural resource development projects take central parts in model construction; product price is a unique source of cash flow's uncertainty, and the projects have cost structure from capital-intense industry, in which initial capital cost takes most part of total cost during the projects. To improve the adaptability of Option Pricing Model specifically to the natural resource development projects, we use Two-Factor Model and Long-term Asset Model for the analysis. Although the model introduced in this paper is still simple and reflects limited reality, we expect an improvement in applicability of option pricing method for the evaluation of natural resource development projects can be made through the process taken in this paper.

• Clean Technology
• /
• v.7 no.1
• /
• pp.75-80
• /
• 2001

In this study, hexavalent chromium (Cr(VI)) plating wastewater in strong acidic condition was treated by reduction and alkalization. Ferrous sulfate ($FeSO_4$), known to reduce Cr(VI) to Cr(III) rapidly at acidic pH, was used as a reductant of Cr(VI). The optimum reduction condition of Cr(VI) was observed at iron to chromium dose ratio of 3:1 by mole concentration. The precipitation of Cr(III) as $Cr(OH)_3$, was achieved by the pH adjustment in the limestone aeration bed. The precipitates were removed less than the upper limit of chromium for effluent at pH over 5.0. The continuous removal of Cr(VI) was performed using the process consisting of reduction vessel, limestone aeration bed, and sedimentation tank coupled with metal screen membrane. As pH was maintained around 5.0 in the limestone aeration bed, insoluble chromic hydroxide flocs was formed continuously. Most chromic hydroxide flocs were filtered by the metal screen membrane with 1450 mesh size, and the treated water to meet the upper limits of chromium for effluent (Cr Conc. 0.25~0.90 mg/l) was obtained in 30 minutes. Periodic backwashing decreased the fouling on the membrane rapidly.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.17 no.6
• /
• pp.255-261
• /
• 2016

$CaCO_3$ was applied in various industries including rubber, plastics, paint, paper, food additives, and acid neutralizer, etc., owing to its excellent physical and chemical characteristics as well as various appearances of crystals and many reserves. In particular, research on controlling the structure and shape of $CaCO_3$ has attracted considerable attention recently, because the whiteness and physical characteristics of $CaCO_3$ depend on the size and shapes of the particles. In this study, $CaCO_3$ was synthesized using $CaCl_2$ and $(NH4)_2CO_3$, which has multi-shapes and structures, using a self-assembly method with a hydrothermal method. The structure and morphology of the $CaCO_3$ could be controlled by adjusting the pH and precursor concentration. In particular, the pH adjustment appeared to be a critical factor for the morphology and crystal form. In addition, the calcite and cubic shape were obtained at pH 7, while the mixed calcite, aragonite structure, and rod shapes appeared at pH 7 and over. Through an analysis of the particle formation process, the formation of the calcium carbonate particles was confirmed. The physicochemical properties of the synthesized $CaCO_3$ were analyzed by SEM, XRD, EDS, FTIR, and TG/DTA.

• Fire Science and Engineering
• /
• v.30 no.2
• /
• pp.68-74
• /
• 2016

In semi-transverse ventilation system applied for road tunnel, adjustment of the port opening ratio is an essential part for uniform airflow rate per unit length over the entire tunnel. However, it has not been considered decently throughout the design process and operating of the tunnel. Therefore, in this study, we developed a program for the calculation of the opening size ratio of supply or exhaust port in transverse ventilation system and carried out the research to present a management plan for the port. In supply duct system, the opening size of the port had a tendency to increase and then decrease later when it gradually becomes closer toward the bulkhead at the beginning of the duct the minimum opening degree is to appeared as 56%. In the exhaust system, port size is the smallest at the beginning of duct as 15%, has shown a tendency to increase towards the bulk head. As results of estimating the air flow rate for 300 m intervals, the exhaust flow rate in the center of tunnel appeared to be extremely low as 8.1% and 12.5% when port size is constant and is adjusted supply type. Thus, even if the normal ventilation efficiency is declines, yet it is highly recommend adjusting the port size in order to obtain a uniform flow rate at fire accidents.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.11 no.9
• /
• pp.3353-3357
• /
• 2010

The purpose of this study is to investigate the effect of visual rhythmic stimulation in gait ability and proprioception in chronic stroke patients. Twenty-one persons after six months post stroke participated in pre and post test control. The subjects were randomly assigned to a rhythmic visual stimulation(RVS) group (n=10) and control group (n=11). Training process was practiced with exercise on thirty minutes a day, three days a week for four weeks. To find out the effect, inspected the proprioception test and gait characteristics by gait analysis. In gait characteristics, the walking speed, cadence and the TUG time were significantly different from RVS group. The proprioception were significantly different RVS and control group. This study showed that the RVS training increased better functional activity by postural adjustment and gait learning of chronic stroke patients than that of control group. And so, the RVS training of hemiplegic patients was very important to successive rehabilitation. A continuous examination of RVS training could be practical use of physical therapy with exercise.