• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2002.11a
• /
• pp.285-289
• /
• 2002

In this paper, microstrip line-probe feeding patch array antenna with center frequency 5.8㎓ is designed and manufactured. The microstrip line - probe feeding structure has broadband characteristic and be able to modify the array structure for improving antenna gain. In this result, microstrip line-probe feeding patch array antenna has 17.6% bandwidth and 8㏈i antenna gain, respectively.

• Nuclear Engineering and Technology
• /
• v.54 no.10
• /
• pp.3614-3619
• /
• 2022

To operate the ion cyclotron resonance heating (ICRH) antennas in a better heating state and produce relatively low impurities, it is necessary to control the antenna spectrum by changing the antenna phasing. As the electrical length of the antenna feeding transmission lines is changing as a matter of the standing wave pattern at the ceramic supports, 90° elbows, T-connectors and antenna loops, we chose to measure the current at the grounding points of the antenna loops by antenna strap probe. The voltage drops along a small, several millimeter-long paths at the end of the antenna loops give a signal that is proportional to the current in the antenna loop. Through the simulation of the antenna strap probe and the actual measurement of the antenna phasing under vacuum conditions, the reliability of the antenna strap probe based diagnostic system have been successfully proved. Moreover, this system was successfully applied to the ICRH daily experiments in the spring of 2021. In the near future, the active real-time feedback control of the antenna phasing system will be developed based on this diagnostic system in the EAST tokamak.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.11 no.6
• /
• pp.859-867
• /
• 2000

In order to analyze the effect of a cover layer or radome for an antenna, the moment method is applied to the analysis of the circular microstrip patch antenna with dielectric superstrate fed by coaxial probe. The probe feed is modeled as a attachment mode method which can solve more exact analysis. In case of a ideal probe feed modeling, the probe self-impedance as well as the rapidly-varying patch current at the vicinity of the feed point was neglected. But a rigorous probe feed model which overcomes these deficiencies are developed, and used in the analysis of isolated circular patches. Measurements were performed to validate the numerical results. These are good agreement with each other.

• Proceedings of the IEEK Conference
• /
• 2002.07a
• /
• pp.545-548
• /
• 2002

This paper proposes a unidirectional beam antenna using a probe excited circular ring near the reflector. The antenna structure is simple. The radiation characteristics of the antenna fur various spacing between a probe excited circular ring and the reflector are analyzed. These characteristics are also compared with the conventional single aperture near the reflector. It is found that the proposed structure yields better characteristics than the conventional structure. The numerical results of the radiation pattern, elevational beam peak, beamwidth, and maximum directivity are investigated. The result of the analysis is very useful to design the antenna of the high directivity with unidirectional beam.

• Journal of Sensor Science and Technology
• /
• v.10 no.4
• /
• pp.214-221
• /
• 2001

The use of an asymmetric Mach-Zehnder interferometric amplitude modulator to measure a relatively low frequency electric field strength is described. The sensitivity of an electric field sensor using a $Ti:LiMbO_3$ optical modulator is strongly affected by the shape of a electrode(probe antenna). To measure the low frequency electric field, a probe antenna of wide effective area is more useful than the usual dipole antenna. As a proof of this, the optical modulator was fabricated with a plate-type probe antenna and the usefulness of this antenna tested for measuring low frequency electric field strength. Measurements were performed in the range 0.1 V/cm to 60 V/cm at 60Hz through 100 kHz. Using a probe antenna of $10\;mm{\times}10\;mm$, the output voltage of $10^{-2}\;mV$ was measured with respect to the electric field strength of 0.1 V/cm at 60 Hz. By increasing the effective area of the probe antenna, better sensitivity is obtainable over the measured range.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.39 no.6
• /
• pp.1-7
• /
• 2002

The use of an asymmetric Mach-Zehnder interferometric amplitude modulator to measure a relatively low frequency electric field strength is described. The sensitivity of an electric field sensor using a Ti:LiNbO$_3$ optical modulator is strongly affected by the shape of a electrode(probe antenna). To measure the low frequency electric field, a probe antenna of wide effective area is more useful than the usual dipole antenna. As a proof of this, the optical modulator was fabricated with a plate-type probe antenna and the usefulness of this antenna tested for measuring low frequency electric field strength. Measurements were performed in the range 0.1V/cm to 60V/cm at 60Hz through 100KHz. Using a probe antenna of 10mm$\times$10mm, the output voltage of 10㎷ was measured with respect to the electric field strength of 0.1V/cm at 60Hz. By increasing the effective area of the probe antenna, better sensitivity is obtainable over the measured range.

• International Journal of Contents
• /
• v.6 no.2
• /
• pp.6-9
• /
• 2010

Using symplectic relation and reaction concept, we propose a planar near-field antenna measurement method. A generalized probe compensation equation is deduced to obtain the probe correction formulation. To verify our approach, a reflector antenna with $1{\times}2$ horn array is fabricated and measured in the near-field measurement facility. The near-field measurement results are compared with the physical optics (PO) simulation. The results of measurement and simulation agree very well near to the mainbeam.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.13 no.7
• /
• pp.687-692
• /
• 2002

The design of broadband patch antenna with the new feeder structure is proposed in this paper. The antenna operates in the center frequency 5.8 GHz. Proposed the new feeder structure has also broadband characteristic and reduced antenna size. To confirm broadband characteristic, compared with probe feeder antenna. After designing and manufacturing, the antenna bandwidth enhanced by 34.5 % and the patch size reduced by 45 %.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.15 no.7
• /
• pp.635-643
• /
• 2004

In this paper, dual-polarized 2${\times}$2 array antenna is designed and fabricated for the polarization diversity applications in wireless LAN system. For the improved bandwidth and isolation characteristics, the aperture coupled feeding and the L-shaped probe feeding are employed for each polarization. The measured bandwidths of the fabricated antenna are 210MHz for aperture coupled feeding and 280MHz for L-shaped probe feeding. The isolation for two ports is -40dB and the antenna gain is measured as 14.3${\pm}$0.2dBi in the operating frequency band of wireless LAN.

• Journal of the Korea Society of Computer and Information
• /
• v.18 no.3
• /
• pp.27-34
• /
• 2013

A wideband patch antenna fed by an L-strip feeder is studied. The objective of this paper is to design small wideband antenna for 3G and 4G wireless mobile communication service. The enhanced features were confirmed and proved by comparing the proposed antenna with the antennae that have been reported in the relevant literatures. Measurement results confirm that an impedance bandwidth($VSWR{\leq}2$) of 636MHz(32.5%, fo=1,960MHz) is achieved at 3G and 4G frequency band for L-strip-fed triangular patch antenna. In general, probe feed has only the parasitic reactance caused by the probe, which reduces the bandwidth performance of the antenna. The experimental results proved that the effects of improvement could be achieved because the proposed antenna is capable of compensating the parasitic reactance from the feeding mechanism. The studied antenna can be designed easily for extension of array because it has simple structure.