• Journal of Korea Foundry Society
• /
• v.17 no.5
• /
• pp.502-509
• /
• 1997

The mechanical behavior and microstructural evolution in the ignition-proof Mg-Zn-Ca-Zr alloy produced by the semisolid squeeze casting are clarified and the mechanical properties are also compared with those of squeeze cast Mg-Zn-Ca-Zr alloy. The tensile strength and elongation increase slightly as the solid fraction depending on temperature decreases, while the 0.2% proof stress decreases. The size of primary crystal increases with increasing holding time. The tensile strength and 0.2% proof stress of the semi-solid squeeze cast Mg-Zn-Ca-Zr alloy decrease as the size of primary crystal increases, indicating the dependence of strength on the size of primary crystal. The elongation of the semi-solid squeeze cast Mg-Zn-Ca-Zr alloy is two times as large as the squeeze cast Mg-Zn-Ca-Zr alloy and the tensile strength is unchanged despite the growth of primary crystal, resulting from the refining of the melted ${\alpha}Mg$ phase and the brittle eutectic compound as well as the reduction of solidification shrinkage and porosities.

• Korean Journal of Metals and Materials
• /
• v.50 no.7
• /
• pp.477-485
• /
• 2012

The effect of aging heat treatment on microstructure evolution of the Ti-6Al-4Fe-0.25Si alloy with an initial microstructure of an elongated alpha was investigated. Aging treatments of the samples were carried out at $550^{\circ}C$ for up to 100 hours. The microstructure of the 5 hours heat-treated sample consisted of alpha grains, beta matrix and some TiFe intermetallic compounds that were precipitated from the beta matrix. Increasing the aging time to 10 hours, most of the beta matrix was decomposed to very fine alpha grains (${\sim}0.5{\mu}m$) and TiFe, and thus the volume fraction of the beta matrix was significantly decreased. EBSD analysis revealed that newly formed tertiary-alpha-grains in the vicinity of TiFe had high angle boundaries with respect to the primary and secondary alpha grains. As a result of these phase transformations during aging, the fraction of the alpha/alpha grain boundary was increased while that of the alpha/beta phase boundary was decreased.

• Journal of Korea Foundry Society
• /
• v.29 no.5
• /
• pp.220-224
• /
• 2009

In order to investigate the microstructural morphology of the sulfide expected from the Fe-FeS phase diagram, a vacuum-sealed quartz tube where pure iron (99.9%) and sulfur (99.99%) powders were charged was heated upto $1000^{\circ}C$ in the electric resistance furnace, held for 96 hours and quenched in cold water and then, rod specimen was produced. Compositional difference of the sulfur between upper and lower parts of the rod was 7.5wt.% and segregation of the sulfur was gradually increased from the lower part to the upper one of the rod. The rod specimen was divided into three parts by the microstructural morphology of the sulfide. The upper part of the rod specimen revealed single phase FeS intermetallic. In the middle part of the specimen, hyper-eutectic microstructure where primary FeS was precipitated first and then, eutectic of $\alpha$-Fe and FeS was formed in the inter-dendritic region of the FeS. Especially, hypo-eutectic microstructure was appeared in the lower part of the specimen. After primary dendrite of $\alpha$-Fe solidified, FeS dendrite which included small amount of $\alpha$-Fe and FeS eutectic in the inter-dendritic region was formed.

• Nuclear Engineering and Technology
• /
• v.30 no.6
• /
• pp.518-530
• /
• 1998

A natural analogue study has been performed for the Koongarra uranium ore deposit in Australia as an international agreement of the Analogue Studies in the Alligator Rivers Region (ASARR). Rocks obtained from the Koongarra deposit, Northern Territory of Australia, were examined in order to understand uranium migration processes of primary and secondary ore-body in both weathered and unweathered zones. Total alpha activities of rock samples were measured to compare the relative amount of uranium in the sample. Uranium distributions have been investigated by means of both the alpha-autoradiography and the fission track registration technique after irradiation in a flux of thermal neutrons (~10$\times$$10^{13}$nㆍ$cm^{-2}$ㆍs$^{-1}$) for 2 minutes. The mineral phases corresponding to the registered alpha-tracks and fission tracks were identified by petrological observation with optical microscope as well as X-ray diffraction and electron microprobe analysis (EPMA). Uranium was found mostly inside of the fracture of the quartzite and its mineral phase was identified as sklodowskite. The mineral phase associated with high uranium concentration was found as illeminite by petrological observation with optical microscope as well as EPMA.

• Journal of the Korean Ceramic Society
• /
• v.34 no.11
• /
• pp.1187-1197
• /
• 1997

Dry gel composed of primary particles more homogeneous than starting boehmite powder was prepared by dispersing and gelling the boehmite powder. The transformation temperatures of boehmite powder, dry gel seeded with 0, 1, 3, 5 wt% $\alpha$-Al2O3, and ball milled gel were 1192$^{\circ}C$, 1184$^{\circ}C$, 1141$^{\circ}C$, 1119$^{\circ}C$, 1117$^{\circ}C$, and 1106$^{\circ}C$, respectively. Sintering behavior of dry gel without seed was similar to that of boehmite powder, but the sintered density of dry gel was improved as much as 10%~15% than boehmite powder. In the case of dry gel seeded with 5 wt% $\alpha$-Al2O3, sintering behavior was much improved. The relative density of the gel seeded with 5 wt% $\alpha$-Al2O3 was 96% when sintered at 140$0^{\circ}C$ for 1h. On the other hand, ball milling of the non-seeded sol for 48h resulted in the relative density of 97% when sintered at 130$0^{\circ}C$ for 1h. The size and amount of $\alpha$-Al2O3 particles added by ball milling were 0.107 ${\mu}{\textrm}{m}$ and 0.5 wt%.

• Corrosion Science and Technology
• /
• v.13 no.2
• /
• pp.70-80
• /
• 2014

Duplex stainless steels with nearly equal fraction of the ferrite(${\alpha}$) phase and austenite(${\gamma}$) phase have been increasingly used for various applications such as power plants, desalination facilities due to their high resistance to corrosion, good weldability, and excellent mechanical properties. Hyper duplex stainless steel (HDSS) is defined as the future duplex stainless steel with a pitting resistance equivalent (PRE=wt.%Cr+3.3(wt.%Mo+0.5wt.%W)+30wt.%N) of above 50. However, when HDSS is welded with gas tungsten arc (GTA), incorporation of nitrogen in the Ar shielding gas are very important because the volume fraction of ${\alpha}$-phase and ${\gamma}$-phase is changed and harmful secondary phases can be formed in the welded zone. In other words, the balance of corrosion resistance between two phases and reduction of $Cr_2N$ are the key points of this study. The primary results of this study are as follows. The addition of $N_2$ to the Ar shielding gas provides phase balance under weld-cooling conditions and increases the transformation temperature of the ${\alpha}$-phase to ${\gamma}$-phase, increasing the fraction of ${\gamma}$-phase as well as decreasing the precipitation of $Cr_2N$. In the anodic polarization test, the addition of nitrogen gas in the Ar shielding gas improved values of the electrochemical parameters, compared to the Pure Ar. Also, in the erosion-corrosion test, the HDSS welded with shielding gas containing $N_2$ decreased the weight loss, compared to HDSS welded with the Ar pure gas. This result showed the resistance of erosion-corrosion was increased due to increasing the fraction of ${\gamma}$-phase and the stability of passive film according to the addition $N_2$ gas to the Ar shielding gas. As a result, the addition of nitrogen gas to the shielding gas improved the resistance of erosion-corrosion.

• Nuclear Engineering and Technology
• /
• v.30 no.6
• /
• pp.609-616
• /
• 1998

Cast duplex stainless steels are extensively used for primary pressure boundary components. These components are, however, embrittled due to the precipitation of $\alpha$' phase by spinodal decomposition and other processes when exposed to reactor operating temperature for a design lifetime or life extension conditions. This report presents a procedure for estimating the current condition and the residual life of safety-related stainless steel components by using ANL database and correlations. The database of Charpy impact energy suggests that CF-8M grade is the most susceptible to thermal aging and CF-3 grade is the least. Thus, the integrity of CF-8M alleys may be degraded seriously and the degree of deterioration may exceed acceptance limit after several years of service in the nuclear reactors.

• Journal of the Korean Society of Safety
• /
• v.18 no.3
• /
• pp.46-53
• /
• 2003

For the tensile tests of the F.E.M., microvoids are created by the boundary separation process at the martensite boundary or neighborhood and at inclusions within the fracture. to grow to the ductile dimple fracture. For the case of the M.E.F., microvoids created at the discontinuities of the martensite phase which exists at the grain boundary of the primary ferrite are grown to coalescence with the cleavage cracks induced at the interior of the ferrite, which as a result show the discontinuous brittle fracture behavior. In spite of their similar tensile strengths, the fatigue limit and the notch sensitivity of the M. E.F. is superior to those of the F.E.M., The M.E.F. is much more insensitive to notch than F.E.M. from the stress concentration factor($\alpha$).

• Asian Pacific Journal of Cancer Prevention
• /
• v.16 no.15
• /
• pp.6491-6499
• /
• 2015

Background: Red-fleshed sweet orange juice (ROJ) comes from a new variety of citrus cultivated in Brazil that contains high levels of ${\beta}$-carotene and lycopene, and similar amounts of hesperidin (HSP) and nutrients, equivalently to blond orange juice (BOJ). Such bioactive compounds are associated with chemopreventive actions in several cancer cell lines. The purpose of this study was to examine the cytotoxicity, cell cycle, apoptosis, and cytokine secretion after BOJ, ROJ, and HSP treatment of a novel T acute lymphoblastic leukemia cell line, Loucy. Materials and Methods: Loucy cells were incubated for 24-h with BOJ, ROJ, and HSP, and the viability was measured using trypan blue. Cell cycling and apoptosis were assessed by propidium iodide (PI) and annexin V-FITC/PI flow cytometry, respectively. Secretion of cytokines $IL-1{\alpha}$, $IL1-{\beta}$, IL-2, IL-4, IL-6, IL-10, IL-17A, $IFN{\gamma}$, $TNF{\alpha}$, $TGF{\beta}$, $MIP{\alpha}$, and $MIP{\beta}$ was determined by ELISA array. Results: BOJ and ROJ treatments promoted Loucy cell cytotoxicity. Additionally, BOJ induced cell cycle arrest in the G0/G1 phase, and decreased the cell accumulation in the G2/M. ROJ decreased only the G0/G1 fraction, while HSP did not change the cell cycle. BOJ led to apoptosis in a different fashion of ROJ, while the first treatment induced apoptosis by increase of late apoptosis and primary necrotic fractions, the second increased early and late apoptosis, and primary necrotic fraction compared to positive controls. HSP had no effect on apoptosis. IL-6 and IL-10 were abrogated by all treatments. Conclusions: Taking together, these results suggest potential chemopreventive effects of BOJ and ROJ on Loucy cells.

• KSBB Journal
• /
• v.27 no.4
• /
• pp.232-236
• /
• 2012

Comparative liquid chromatographic enantiomer separation of ${\alpha}$-amino acids, their esters and primary amino compounds was performed using two chiral stationary phases (CSPs) prepared by covalently bonding (+)-(18-crown-6)-2,3,11,12-tetracarboxylic acid (18-C-6-TA) of the same chiral selector. In general, the separation factors and resolution factors for these analytes on CSP 1 were greater than on CSP 2, while these capacity factors on CSP 2 were quite greater than on CSP 1. Except for leucine methyl ester and phenylalanine methyl ester, the elution orders of all analytes including ${\alpha}$-amino ${\alpha}$-alkyl acids and phenylglycine alkyl esters on CSP 1 are identical to those on CSP 2. This study showed that different connecting structures for these two CSPs might influence their ability to resolve the analytes depending on their structures related to the chiral recognition mechanism.