• The Transactions of the Korean Institute of Electrical Engineers
• /
• v.40 no.6
• /
• pp.619-625
• /
• 1991

Phenomena of streaming electrification of insulting oil(T.O) is studied where the oil is contacted with solid insulating materials when it is pumped through a circulating system in a large power transformer. The leakage current, the electrical potential at the neutral terminal point of the transformer and the surface electrical potential of the oil are investigated. And the leakage current from the neutral terminal point is measured as a function of a bias polarity applied to a transformer case to investigate the polarty of ion which is absorbed in the case at the interface between the case and oil. As a result, it is found that insulating materials, and it is suggested that the leakage current is the sum of the relaxation current by positive charge from insulating oil to the neutral terminal point and by electrification current from negative charge electrified by the contact with solid insulating materials.

• The Transactions of the Korean Institute of Electrical Engineers
• /
• v.43 no.4
• /
• pp.594-600
• /
• 1994

The maximum charge accumulation in transformers caused by streaming electrification is commonly observed on the bottom area of transformer winding(i.e.the oil inlet of transformer winding). It is because turbulent flows occur in this portion of transformers. Consequently, if we are to reduce the maximum charge accumulation of transformers, it is important that we should have a good understanding of the conditions of the occurence of partial turbulent flows in the oil inlet of transformer winding. With this point in mind, a simple flow model was designed in this study in order to simulate oil flow in the insulation ducts of power transformers. As a method for mitigating charge accummulation, attention was given to (a) a flow path design for the improvement of flow conditions, and (b) the charge tendency of the material used this design. The results of this study show that the above method is useful for mitigating charge accumulation.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• 1999.10a
• /
• pp.19-33
• /
• 1999

This paper is concerned with developing a standard costing model based on the case study of PECT and GCT and analysing their profitability in order to improve operation efficiency and design business strategy. In doing so, the model can be a useful tool to analyze current calculation system of lease charge at the two terminals and to judge whether the level of lease charge currently applied to them is justifiable for their profitability. This paper also deals with break-even analysis of container terminal operating companies on the basis of the model and forecast of their profitability. On the top of that, it tries to look into the arguments and to suggest proposals for improving their profitability.

• Journal of the Korean Ceramic Society
• /
• v.48 no.2
• /
• pp.183-188
• /
• 2011

In this article, the effect of the crystal structural environment of $Pr^{3+}$ ions on the photoluminescence (PL) characteristics of double tungstates, such as $A(M_{1-X}Pr_X)W_2O_8$ (A=Li, Cs, M = In, Y, Sc, La; $0.007{\leq}x{\leq}0.1$) and $La_{1.96}Pr_{0.04}W_3O_{12}$ are characterized. By varying the ion radius in A and M sites, the structural environment of $Pr^{3+}$ ions were modified. The structural criteria, that is, the point charge electrostatic potentials V around the $Pr^{3+}$ activator, were calculated using the crystal structural parameters. The point charge potential V can be a valid criterion for $^3P_o$ quenching in various double tungstates. When the calculated V values are large (> 6.0), the luminescence from the $^3P_0$ level becomes dominant. When the calculated V values are about 3.8, the $^1D_2$ line appears weakly but $^3P_0$-level luminescence is absent. When the calculated V values are small (< 2.0), the luminescence from the $^1D_2$ level becomes dominant and $^3P_0$-level luminescence is absent. At 2.0$^3P_o$ quenching to $^1D_2$ level occurs substantially in accordance with the structural criterion of the point charge potential model.

• Environmental and Resource Economics Review
• /
• v.21 no.1
• /
• pp.175-210
• /
• 2012

As London and post-Koyto protocols presumably affect emission of organic waste in Korea in 2012, appropriate treatment of organic waste becomes very important. Organic wastes are regarded as non-point pollutants. It has been criticized that direct emission charges on the emission of non-point pollutants are not effective due to the high uncertainty in the relationship between pollution sources and pollution levels. This study suggests indirect emission charges on production of livestocks or consumption on foods. Furthermore, it is assumed that revenue from the emission charges will be recycled to support biogas production. Biogas can be fueled to produce energy. In order to evaluate potential economic and environmental impacts of recycling the indirect emission charges on organic wastes, a static CGE model was developed. Simulation results of emission charges on the production of livestock show that livestock, agriculture, and food industry will confront relatively high burden while emission charges on consumption of food will affect more broadly and consumers will suffer more. Production charge on livestock sector will lead to higher reduction in GDP and total expenditure relative to the consumption charge. GHGs reduction effect was higher for the consumption charge relative to the production charge. Synthetically, consumption charge on food sector is more desirable as an alternative charge for the emission of organic wastes.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.60 no.1
• /
• pp.142-149
• /
• 2011

This paper presents a new state of charge(SOC) estimation of large capacity of Li-ion battery (LIB) based on the multiple model adaptive estimation(MMAE) method. We first introduce an equivalent circuit model of LIB. The relationship between the terminal voltage and the open circuit voltage(OCV) is nonlinear and may vary depending on the changes of temperature and C-rate. In this paper, such behaviors are described as a set of multiple linear time invariant impedance models. Each model is identified at a temperature and a C-rate. These model set must be obtained a priori for a given LIB. It is shown that most of impedances can be modeled by first-order and second-order transfer functions. For the real time estimation, we transform the continuous time models into difference equations. Subsequently, we construct the model banks in the manner that each bank consists of four adjacent models. When an operating point of cell temperature and current is given, the corresponding model bank is directly determined so that it is included in the interval generated by four operating points of the model bank. The MMAE of SOC at an arbitrary operating point (T $^{\circ}C$, $I_{bat}$[A]) is performed by calculating a linear combination of voltage drops, which are obtained by four models of the selected model bank. The demonstration of the proposed method is shown through simulations using DUALFOIL.

• Proceedings of the Korean Magnetic Resonance Society Conference
• /
• 2002.08a
• /
• pp.89-89
• /
• 2002

• Journal of the Korean Chemical Society
• /
• v.21 no.1
• /
• pp.23-31
• /
• 1977

For the metal complex of $d^1$ configuration with the octahedrally coordinated ligands, the crystal field parameter, 10Dq, is calculated from first principles within the framework of the crystal field theory. With the point charge model, the configuration interaction is introduced by use of the Shull-L$\"{o}$wdin functions. Through the Integral Hellmann-Feynman Theorem, the higher order effect is visualized. It is found that the higher order effect on 10Dq is about $50{\%}$ of the first order effect. Since 3d function is angularly undistorted and radially equally distorted in $E_g\;and\;T_{2g}$ states, due to the octahedral potential, the calculated 10Dq is still the unique parameter for the splitting.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.2 no.1
• /
• pp.59-69
• /
• 2002

A semi-analytical model based on exact numerical analysis of the 2DEG channel in pseudo-morphic HEMT (PMHEMT) is presented. The exactness of the model stems from solving both Schrodinger's wave equation and Poisson's equation simultaneously and self-consistently. The analytical modeling of the device terminal characteristics in relation to the charge control model has allowed a best fit with the geometrical and structural parameters of the device. The numerically obtained data for the charge control of the channel are best fitted to analytical expressions which render the problem analytical. The obtained good agreement between experimental and modeled current/voltage characteristics and small signal parameters has confirmed the validity of the model over a wide range of biasing voltages. The model has been used to compare both the performance and characteristics of a PMHEMT with a competetive HEMT. The comparison between the two devices has been made in terms of 2DEG density, transfer characteristics, transconductance, gate capacitance and unity current gain cut-off frequency. The results show that PMHEMT outperforms the conventional HEMT in all considered parameters.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.18 no.2
• /
• pp.432-445
• /
• 1994

From a theoretical analysis point of view, the 2-stage precipitator is decomposed into two units: charging cell and collecting cell. Collection efficiency predictions of the two-stage parallel-plate electrostatic precipitator have been performed theoretically incorporating with the charging and the collecting cells. Particle trajectorise passing the charging cell have been modeled as a simple one. Particle charge distribution at the outlet of the charging cell is calculated through integration of the present unipolar combined charging rate along the entire particle trajectory, and average charge of particles at the outlet of the charging cell is obtained from the particle charge distribution. As for the collecting cell, the diminution of particle concentration along the longitudinal direction of the collecting cell is investigated considering the conventional Deutsch's theory and the laminar theory. One should note that the collection efficiency formula derived is based on monodisperse aerosols. It has been confirmed through the analysis that predictions of particle charge by applying White's unipolar diffusion charging theory overpredict actual cases in the continuum regime, while predictions by Fuch's unipolar diffusion charging theory indicate the reasonable result in the same regime. Theoretical predictions of collection efficiency are also compared with the available experimental results. Comparisons show that the experimental results are consistently located in the collection efficiency region bounded by the two limits, the Deutsch and the laminar collection efficiencies. Finally design parameters of the 2-stage electrostatic precipitator have been investigated systematically through the one-variable-at-a-time method in terms of collection efficiency. Applied voltages on the corona wire of the charging cell and the plate of the collecting cell, and the average air velocity have been selected as the design parameters.