• 대한자기공명의과학회:학술대회논문집
• /
• 대한자기공명의과학회 1999년도 제4차 추계학술대회 초록집
• /
• pp.113-113
• /
• 1999

• 한국자기학회:학술대회 개요집
• /
• 한국자기학회 2008년도 Asian Magnetics Conference
• /
• pp.244.2-244.2
• /
• 2008

• 한국전자파학회논문지
• /
• 제18권6호
• /
• pp.648-655
• /
• 2007

본 논문에서는 유도결합을 이용한 RFID 시스템에서 주변의 RF 잡음의 영향을 감소할 수 있는 이중 코일 안테나를 새로이 제안하고 실험하였다. 이중 코일 안테나는 동일한 구조의 코일 2개가 직렬로 연결되어 있으며 두 코일에 유도되는 잡음 전압의 크기가 같고 극성이 반대가 되어 서로 상쇄되도록 고안된 구조이다. RFID 리더에 이중 코일 안테나를 사용한 경우에 단일 코일 안테나에 비하여 RF 유도 잡음이 약 15 dB 감소하였다.

• 한국초전도ㆍ저온공학회논문지
• /
• 제14권1호
• /
• pp.44-47
• /
• 2012

The substantial improvement of the signal-to-noise ratio (SNR) can be achieved with small-size samples or low-field MRI system by high-temperature superconducting(HTS) RF coil. The typical HTS RF coil made of HTS thin film is expensive and is limited the coil geometry to planar surface coil. In this study, commercial Bi-2223 HTS tapes was used as RF coil for a 0.35T permanent MRI system. It has advantages of both much lower cost and easier fabrication over HTS thin film coil. SNR gain of the image obtained from the HTS RF coil over a conventional Cu RF coil at room temperature was about 2.4-fold and 1.9-fold using the spin echo pulse sequence and gradient echo pulse sequence respectively.

• 한국항행학회논문지
• /
• 제22권2호
• /
• pp.148-153
• /
• 2018

본 논문에서는 복수 수신기에 전력을 전송하기 위한 SIMO (single-input multiple-output) 자기공진방식 무선전력전송 시스템을 제안하고, 이에 따른 시뮬레이션 및 측정결과를 제시하였다. 지름 600 mm 의 송신 단일루프 및 송신 헬리컬 공진 코일, 외경 900 mm 스파이럴 수신 공진 코일을 사용하고, $80{\times}60mm^2$ 평판 사각 코일을 수신으로 활용하여 600mm 떨어진 테이블 형태 구조로 무선전력전송 시스템을 구성하였다. 최적의 특성을 위해 무선전력전송 코일을 설계하고 3차원 전자계해석 및 등가회로 해석 시뮬레이션을 진행하고 이를 제작하여 전송 특성을 측정하였다. 스파이럴 공진코일의 중심부에서 거리에 따른 효율변화를 해석하였으며, 구성한 시스템의 측정결과 수신기가 1개일 경우의 효율은 57 % 이며, 2개로 수신될 경우 각각 37 %의 전송 효율을 나타내었다.

• 대한자기공명의과학회:학술대회논문집
• /
• 대한자기공명의과학회 2002년도 제7차 학술대회 초록집
• /
• pp.76-76
• /
• 2002

Purpose： The purpose of this study is to optimize the configuration of body RF coil composed of 4 planar subcoils for low field open MRI. Method： Our low field RE coil is composed of 4 subcoils assumed to be located at both the bottom and top sides of permanent magnet. Each subcoils has 3 main strips. The coil system has mirror inversion symmetry. First, the currents on the strips are obtained by inductance calculation and circuit analysis, Second, all the strips are divided into line strip elements across the strips, the self Inductances of line strip elements and the mutual inductances among the line strip elements are calculated, and current distributions of strip are obtained by circuit analysis, where each strip is considered as parallel combination of line strip elements. Finally all the line strip elements are segmented, magnetic field has been calculated by pseudo electric dipole radiation method, where the current elements are regarded as pseudo electric dipole radiation sources. We have performed above procedures for various configurations of RE coil. The field homogeneity is calculated in the 25 cm DSV.

• 한국진공학회지
• /
• 제8권3B호
• /
• pp.368-375
• /
• 1999

The Maxwell equation and the transformer equivalent-circuit model are applied to a radio frequency planar inductively coupled plasma. The spatial distribution of the vector potential, the magnetic field, and the electric field are obtained analytically. As a result, the plasma current, the mutual inductance between the coil and the plasma, and the self inductance of plasma are found to increase with increasing skin depth. The spatial distribution of absorbed power has maximum where the antenna coil exists, and has a similar profile to that of the induced electric field. The power transfer efficiency is found to increase with increasing gas pressure before a saturation around p+ 20mTorr, while it shows an increase with the plasma density before a slight decrease around a density of $5\times10^{11}/\textrm{cm}^3$.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1993년도 정기총회 및 추계학술대회 논문집 학회본부
• /
• pp.195-197
• /
• 1993

In this paper, a planar vibratory gyroscope is designed and fabricated in macro model. Elementary experiment and test are done for micro model. This gyroscope has a double gimbal structure with an active dimension $80{\times}120{\times}1\;mm^3$. Outer gimbal vibration is generated by electromagnetic force using ferrite E-core wounded by coil. Inner gimbal vibration is detected by inductive sensor. It is demonstrated' that mechanical and electrical symmetries are important for improvement of vibratory gyroscope.

• 한국소성가공학회:학술대회논문집
• /
• 한국소성가공학회 1999년도 춘계학술대회논문집
• /
• pp.30.1-33
• /
• 1999

Finite element simulation with experimental analysis of Taguchi's orthogonal array was carried out to know the effects of material and forming parameters on the cup earing and skewness. It was revealed that the planar anisotropy was the most influencing factor in the cup ear formation whereas blank holding force and material properties such as strength and thickness deviation at the coil edge had a relatively high effect on the cup skewness.

• 대한의용생체공학회:학술대회논문집
• /
• 대한의용생체공학회 1996년도 추계학술대회
• /
• pp.165-168
• /
• 1996

Though the planar gradient coils, designed by the magnetic energy minimization procedure, have smaller inductance than conventional gradient coils, the planar gradient oils often suffer from their poor magnetic field linearity. Scaling the spatial frequencies of the current density function designed by the magnetic energy minimization procedure, magnetic field linearity of the planar gradient coils can be featly improved with small sacrifice of gradient coil inductance.