• 전력전자학회논문지
• /
• 제18권4호
• /
• pp.322-332
• /
• 2013

Conventional single-phase series quasi Z-source voltage compensator can not compensate for voltage sag less than 50% that frequently occurs in the industrial field. In this study, single-phase series quasi Z-source voltage sag-swell compensator which can compensate the voltage variation of entire range is proposed. The proposed system is composed of two quasi Z-source AC-AC converters connected in series with output terminal stage. Voltage sag less than 50% could be compensated by the intersection switching control of the upper converter duty ratio and of the upper converter duty ratio. Also the compensation voltage and its flowchart for each compensation mode are presented for entire sag-swell region. To confirm the validity of the proposed system, a DSP(DSP28335) controlled experimental system was manufactured. As a result, the proposed system could compensate for the voltage sag/swell of 20% and 60%. Finally, voltage compensation factor and THD(Total Harmonic Distortion) according to voltage variation and load change were measured, and voltage quality shows a good results.

• 대한전자공학회논문지SD
• /
• 제42권5호
• /
• pp.47-54
• /
• 2005

본 논문에서는 Crosstalk에 의한 coupling capacitance의 변화량, ${\Delta}Cc$이 기본값인 Cc보다 더 커질 수 있음을 제안한 테스트 회로를 이용하여 실험적으로 증명하였다. 또한 ${\Delta}Cc$가 Aggressive line의 위상에 매우 의존함을 보였으며 위상이 같은 경우보다 반대인 경우에 ${\Delta}Cc$가 크게 됨을 보였다. 실험 결과의 타당성을 검증을 위해 HSPICE 시뮬레이션을 수행하여 실험치와 잘 맞음을 나타내었다.

• Journal of Pharmaceutical Investigation
• /
• 제22권4호
• /
• pp.317-321
• /
• 1992

A high-performance liquid chromatographic (HPLC) method was developed for the determination of diltiazem (DTZ) and its major metabolite, deacetyldiltiazem (DAD), in rat plasma. DTZ, DAD and imipramine, the internal standard, were selectively fractionated from plasma on a $C_{18}$ reversedphase column $({\mu}-Bondapak,\;10\;{\mu}m\;silica,\;300{\times}3.9\;mm\;ID)$. The composition of the mobile phase was methanol: acetonitrile: 0.04 M ammonium bromide: triethylamine (40:24:36:0.06 in volume). The pH of the mobile phase of their method was lowered to 6.4. The eluents from the column were detected for DTZ and DAD using a UV detector at 237 nm. The recovery was >85% for DTZ and DAD, and average intra-day and inter-day coefficients of variation were <6% for DTZ and DAD at the concentration ranges of 20-1000 ng/ml. Detection limit of DTZ and DAD in plasma was 20 ng/ml with signal-to-noise ratio of 3. This method would be applicable to practical pharmacokinetic studies without detriment to the HPLC column.

• 센서학회지
• /
• 제17권4호
• /
• pp.289-294
• /
• 2008

The purpose of this study is to materialize the viscosity sensor by using the SH-SAW sensor of which the center frequency is operated at higher than 50 MHz. In order to measure the viscosity, SAW sensor of which the center frequency is operated at 100 MHz is developed. By using the developed sensor, phase shift, delay time, insertion loss, and frequency variation are measured at different viscosity. The result shows that the phase shift difference between the viscosity variations is such that the difference between the distilled water and the 100 % glycerol solution is approximately $45^{\circ}$, the change of the insertion loss is approximately 9 dB, and the difference of frequency variation is approximately 5.9 MHz. Therefore, it is shown that viscosity of unknown solution can be measured with the surface acoustic wave sensor.

• 설비공학논문집
• /
• 제28권11호
• /
• pp.444-449
• /
• 2016

The main objective of this work is to experimentally investigate the effect of angle variation and intrusion depth of channels on the distribution of two-phase flow at header-channel junctions. The dimensions of the header and the channels in cross-section were fixed at $16mm{\times}16mm$ and $12mm{\times}1.8mm$, respectively. Air and water were used as the test fluids. Two different header-channel positions were tested : a vertical header with horizontal channels (case VM-HC) and a horizontal header with horizontal channels (case HM-HC). In all cases, the intrusion depths of the channels are 0 mm, 2 mm, and 4 mm. For the case of the intrusion depth of VM-HC, the flow distribution became more uniform. However, the intrusion depth negatively affected the flow distribution for the case of HM-HC because liquid separation delay occurred.

• 항공우주기술
• /
• 제12권2호
• /
• pp.140-146
• /
• 2013

본 연구는 파라볼릭 반사기의 체적을 줄일 수 있는 프린트 리플렉터어레이 안테나 설계에 대한 연구이다. 이를 위해 시뮬레이션과 제작된 도파관 시뮬레이터 측정을 통해 리플렉트어레이 안테나 단일소자의 위상변위 특성을 확인하였다. 그 결과, 10GHz에서 시뮬레이션시 최대 $298^{\circ}$의 위상 변위를 나타내었으며, 제작 측정시 $309^{\circ}$의 평균 위상변위 특성이 나타남을 확인하였다. 또한, 프린트 리플렉트어레이 안테나 이득은 28.3dBi, 3dB 빔폭은 E-plane $5.1^{\circ}$, H-plane $5.2^{\circ}$, 부엽은 E-plane -11.4dB, H-plane -17.6dB를 나타내었다.

• 반도체디스플레이기술학회지
• /
• 제15권2호
• /
• pp.32-37
• /
• 2016

Sidewall angle (SWA) of an absorber stack in extreme ultraviolet lithography mask is considered to be $90^{\circ}$ ideally, however, it is difficult to obtain $90^{\circ}$ SWA because absorber profile is changed by complicated etching process. As the imaging performance of the mask can be varied with this SWA of the absorber stack, more complicated optical proximity correction is required to compensate for the variation of imaging performance. In this study, phase shift mask (PSM) is suggested to reduce the variation of imaging performance due to SWA change by modifying mask material and structure. Variations of imaging performance and lithography process margin depending on SWA were evaluated through aerial image and developed resist simulations to confirm the advantages of PSM over the binary intensity mask (BIM). The results show that the variations of normalized image log slope and critical dimension bias depending on SWA are reduced with PSM compared to BIM. Process margin for exposure dose and focus was also improved with PSM.

• Journal of Astronomy and Space Sciences
• /
• 제14권1호
• /
• pp.59-66
• /
• 1997

V711 Tau의 채층활동을 조사하기 위하여 자외선 영역의 Mg II 방출선의 세기와 광도 변화의 상관 관계를 유추하였다. 첫째, 가시광선 영역의 광도곡선의 형태와 자외선 영역의 광도곡선의 형태를 비교하고, 둘째, IUE 고분산 스펙트럼에서 Mg II 방출선의 세기를 위상별로 측정하고 방출선 부근의 연속선을 이용하여 자외선 광도곡선을 완성하였다. 방출선의 세기와 광도곡선을 비교한 결과 방출선이 강하게 나타나는 위상, $0.^{p}4$에서는 광도가 어둡게 나타나 최소가 되고, 방출선의 세기가 약할 때는 광도가 밝아져서 최대가 되었다. 이는 자기장이 강한 위상에서는 채층활동과 흑점의 크기가 증가하고 반대로 자기장이 약한 위상에서는 채층활동과 흑점의 크기가 작다는 것을 뜻한다. 그러므로 자기장, 채층활동, 별 표면의 흑점과의 상관 관계가 밝혀지고, V711 Tau의 변광은 표면의 채층활동과 흑점에 의한 것이다.

• 한국세라믹학회지
• /
• 제26권2호
• /
• pp.157-166
• /
• 1989

The effect of pH variation in starting solution on the characteristics of hydroxyapatite precipitates and powder prepared by the wet method was investigated. Hydroxyapatite precipitates was agglomerated, the average agglomerated particle size was decreased in the range from 2 to 6${\mu}{\textrm}{m}$ with increasing pH values in starting solution. The aspect ratio of rod-shaped hydroxyapatite particle was rapidly increased at pH 11 and 11.5. The maximum specific surface area, 91.1$m^2$/g, was at pH 10.5. Dried powder prepared at high pH values contained more minutes CO2 than that prepared at low pH values. The poor crystallinity was maintained up to $600^{\circ}C$ regardless of the pH values in starting solutions. However, the second phase or high crsytalline hydroxypatite phase appeared above 80$0^{\circ}C$. In pH 9.5 and pH 10, $\beta$-whitlockite transformed to $\alpha$-whitlockite at 120$0^{\circ}C$, while in pH 10.5-11.5, hydroxyapatite phase was maintained up to 120$0^{\circ}C$.

• 한국표면공학회:학술대회논문집
• /
• 한국표면공학회 2015년도 춘계학술대회 논문집
• /
• pp.112-112
• /
• 2015

The purposed of this work was to determine nanotube shape variation on the Ti-xNb alloys with alloying elements and applied potentials. Samples were prepared by arc melting, followed by followed by homogenization for 12 hr at $1000^{\circ}C$ in argon atmosphere. This study was evaluated the phase and microstructure of Ti-xNb alloys using an X-ray diffraction (XRD) and optical microscopy (OM). The morphology of the samples was investigated with a field-emission scanning electron microscope (FE-SEM) and energy dispersive X-ray spectroscopy (EDS). The nanotube on the alloy surface was formed in 1 M $H_3PO_4$ with small additions of NaF 0.8 wt.%. All anodization treatments were carried out using a scanning potentiostat (Model 362, EG&G, USA) at constant voltage 30 V for 120 min, respectively. The morphology of the samples was investigated with a field-emission scanning electron microscope (FE-SEM) and energy dispersive X-ray spectroscopy (EDS). Surface characteristics of nanotbue formed on Ti-xNb alloys was investigated by potentiodynamic test and potentiostatic in 0.9% NaCl solution at $36.5{\pm}1^{\circ}C$. It was observed that the changed ${\alpha}$ phase to ${\beta}$ phase with Nb content.