• Journal of Electrical Engineering and Technology
• /
• 제12권3호
• /
• pp.1101-1107
• /
• 2017

In this paper, a robust and fast grid synchronization method of a three-phase power converter is proposed. The amplitude and phase information of grid voltages are essential for power converters to be properly connected into the utility. The phase-lock-loop in synchronous reference frame has been widely adopted for the three-phase converter system since it shows a satisfactory performance under balanced grid voltages. However, power converters often operate under abnormal grid conditions, i.e. unbalanced by grid faults and frequency variations, and thus a proper active and reactive power control cannot be guaranteed. The proposed method adopts a second order generalized integrator in synchronous reference frame to detect positive sequence components under unbalanced grid voltages. The proposed method has a fast and robust performance due to its higher gain and frequency adaptive capability. Simulation and experimental results show the verification of the proposed synchronization algorithm and the effectiveness to detect positive sequence voltage.

• 한국광학회지
• /
• 제16권1호
• /
• pp.21-26
• /
• 2005

40 Gbit/s 광 시분할 신호(OTDM:optical time-division-multiplexed)로부터 클럭 재생된 10 GHz 신호를 얻기 위해 고조모드잠금된 광섬유 레이저와 TOAD(Terahertz Optical Asymmetric Demultiplexer)를 이용하여 광 위상 동기 회로를 구성하였다. 입력된 40Gbit/s 광 신호 펄스로부터 TOAD를 통과한 펄스의 위상 정보를 이용하여 10 GHz로 위상 동기된 신호를 추출하였다. 추출된 10GHz RF 신호와 주변의 잡음 신호의 비는 40 dB 이상으로 측정되었다. 또한 TOAD에서 위상 정보 추출 과정에 대한 시뮬레이션을 수행하였다. 위상 동기 주파수의 작동범위는 입력 광 펄스의 기본 주파수를 중심으로 10 kHz 이내에서 측정되었다.

• JSTS:Journal of Semiconductor Technology and Science
• /
• 제16권6호
• /
• pp.860-866
• /
• 2016

An injection-locked ring phase-locked loop (ILRPLL) using a charge-stored complementary switch (CSCS) injection technique is described in this paper. The ILRPLL exhibits a wider lock range compared to other conventional ILRPLLs, owing to the improvement of the injection effect by the proposed CSCS. A frequency calibration loop and a device mismatch calibration loop force the frequency error to be zero to minimize jitter and reference spur. The prototype chip fabricated in 65-nm CMOS technology achieves a $285-fs_{rms}$ integrated jitter at GHz from the reference clock of 52 MHz while consuming 7.16 mW. The figure-of-merit of the ILRPLL is -242.4 dB.

• 대한전자공학회논문지SD
• /
• 제45권12호
• /
• pp.65-72
• /
• 2008

이 논문은 seamless 주파수 트래킹 방법을 이용한 새로운 이중 루프 디지털 PLL(DPLL)을 제안한다. Coarse 루프와 fine 루프로 구성되는 이중 루프 구조는 빠른 획득 시간과 스위칭 잡음 억제를 위하여 successive approximation register기법과 TDC 회로를 사용하였다. 제안된 DPLL은 입력 주파수의 long-term 지터에 따른 지터 특성을 보상하기 위하여 Coarse와 fine의 코드 변환 주파수 트래킹 방법을 새로이 추가하였다. 또한, 제안된 DPLL은 넓은 주파수 동작 범위와 낮은 지터 특성 위하여 전류 제어 발진기와 V-I 변환기로 구성되는 전압제어 발진기를 채택하였다. 제안된 DPLL은 동부 하이텍 $0.18-{\mu}m$ CMOS 공정으로 구현하였으며 1.8V의 공급전압에서 0.4-2GHz의 넓은 동작 주파수 범위와 $0.18mm^2$의 적은 면적을 가진다. H-SPICE 시뮬레이션을 통하여, DPLL은 2GHz의 동작 주파수에서 18mW 파워소비와 전원잡음이 없는 경우 3psec이하의 p-p period 지터를 확인하였다.

• 조명전기설비학회논문지
• /
• 제20권8호
• /
• pp.88-95
• /
• 2006

본 논문은 분산전원의 주파수 변동에 적응하는 아날로그형의 능동 전력 필터를 제안하였다. 주파수 변동이 심한 분산전원에서 비선형부하에 의해 발생한 고조파의 제거를 위해 전원의 고조파 전류와 주파수가 같고 위상차가 $180[^{\circ}]$인 보상 전류를 투입함으로써 전원의 고조파를 제거하였다. 이때 보상전류의 생성을 위한 기준전류 검출회로는 변동하는 전원 주파수를 추적하고 적응하도록 PLL과 VCGIC(Voltage Controlled Generalized Impedance Converter)를 사용하였다. 시뮬레이션과 실험을 통해 제안된 시스템이 주파수가 변동하는 분산전원의 고조파 전류를 효과적으로 제거함을 증명하였다.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2015년도 전력전자학술대회 논문집
• /
• pp.95-96
• /
• 2015

본 논문에서는 왜곡된 전원 전압과 주파수 변동 하에서도 입력 전류를 정현적으로 제어하도록 하는 단상 PWM 컨버터의 동기좌표계 전류 제어 기법을 제안한다. 왜곡된 전원 전압은 PWM 컨버터 제어를 위한 제어 위상각을 왜곡시켜 입력 전류에 고조파를 발생시키며, 전원 주파수의 변동 역시 입력 전류의 제어 성능을 저하시킨다. 본 논문에서는 위상각의 왜곡 성분을 이용하여 지령 전류를 보상하고 동기좌표계 PLL (Phase Lock Loop) 제어기의 출력으로부터 주파수 변동분을 검출하여 왜곡된 전원 전압과 주파수하에서도 정현적인 전류 제어가 가능하도록 하였다. 제안된 기법의 유용성은 실험을 통해 확인하였다.

• 한국항해항만학회:학술대회논문집
• /
• 한국항해항만학회 2006년도 International Symposium on GPS/GNSS Vol.2
• /
• pp.385-390
• /
• 2006

This paper examines the sampling and jitter specifications and considerations for Global Navigation Satellite Systems (GNSS) software receivers. Software radio (SWR) technologies are being used in the implementation of communication receivers in general and GNSS receivers in particular. With the advent of new GPS signals, and a range of new Galileo and GLONASS signals soon becoming available, GNSS is an application where SWR and software-defined radio (SDR) are likely to have an impact. The sampling process is critical for SWR receivers, where it occurs as close to the antenna as possible. One way to achieve this is by BandPass Sampling (BPS), which is an undersampling technique that exploits aliasing to perform downconversion. BPS enables removal of the IF stage in the radio receiver. The sampling frequency is a very important factor since it influences both receiver performance and implementation efficiency. However, the design of BPS can result in degradation of Signal-to-Noise Ratio (SNR) due to the out-of-band noise being aliased. Important to the specification of both the ADC and its clocking Phase- Locked Loop (PLL) is jitter. Contributing to the system jitter are the aperture jitter of the sample-and-hold switch at the input of ADC and the sampling-clock jitter. Aperture jitter effects have usually been modeled as additive noise, based on a sinusoidal input signal, and limits the achievable Signal-to-Noise Ratio (SNR). Jitter in the sampled signal has several sources: phase noise in the Voltage-Controlled Oscillator (VCO) within the sampling PLL, jitter introduced by variations in the period of the frequency divider used in the sampling PLL and cross-talk from the lock line running parallel to signal lines. Jitter in the sampling process directly acts to degrade the noise floor and selectivity of receiver. Choosing an appropriate VCO for a SWR system is not as simple as finding one with right oscillator frequency. Similarly, it is important to specify the right jitter performance for the ADC. In this paper, the allowable sampling frequencies are calculated and analyzed for the multiple frequency BPS software radio GNSS receivers. The SNR degradation due to jitter in a BPSK system is calculated and required jitter standard deviation allowable for each GNSS band of interest is evaluated. Furthermore, in this paper we have investigated the sources of jitter and a basic jitter budget is calculated that could assist in the design of multiple frequency SWR GNSS receivers. We examine different ADCs and PLLs available in the market and compare known performance with the calculated budget. The results obtained are therefore directly applicable to SWR GNSS receiver design.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2001년도 하계종합학술대회 논문집(2)
• /
• pp.53-56
• /
• 2001

With the ever increasing clock frequency and integration level of CMOS circuits, I/O(input/output) and interconnect issues are becoming a growing concern. In this thesis, we propose the 2.5Gbps high speed input driver This driver consists of four different blocks, which are the high speed serializer , PECL(pseudo emitter coupled logic) Line Driver, PLL(phase lock loop) and pre-emphasis signal generator. The proposed pre-emphasis block will compensate the high frequency components of the 2.5Gbps data signal. Using the pre-emphasis block, we can obtain 2.5Gbps data signal with differential peak to peak voltage about 900 m $V_{p.p}$ This driver structure is on fabrication in 2.5v/10.25um 1poly, 5metal CMOS process.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1998년도 추계학술대회 논문집 학회본부 B
• /
• pp.582-584
• /
• 1998

IEEE1394 is an international standard that will integrate entertainment, communication, and computing electronics into consumer multimedia. IEEE1394 is a hardware and software for transporting data at 100,200, or 400Mbps. There are efforts to create speed improvements to 800 and muti-Gigabit speed s. An 980Mhz frequency synthesizer is proposed for high speed transport and designed by a 0.35um CMOS process.

• 한국항해항만학회:학술대회논문집
• /
• 한국항해항만학회 2006년도 International Symposium on GPS/GNSS Vol.2
• /
• pp.235-240
• /
• 2006

Ionospheric scintillation induces a rapid change in the amplitude and phase of radio wave signals. This is due to irregularities of electron density in the F-region of the ionosphere. It reduces the accuracy of both pseudorange and carrier phase measurements in GPS/satellite based Augmentation system (SBAS) receivers, and can cause loss of lock on the satellite signal. Scintillation is not as strong at mid-latitude regions such that positioning is not affected as much. Severe effects of scintillation occur mainly in a band approximately 20 degrees on either side of the magnetic equator and sometimes in the polar and auroral regions. Most scintillation occurs for a few hours after sunset during the peak years of the solar cycle. This paper focuses on estimation of the effects of ionospheric scintillation on GPS and SBAS signals using a software receiver. Software receivers have the advantage of flexibility over conventional receivers in examining performance. PC based receivers are especially effective in studying errors such as multipath and ionospheric scintillation. This is because it is possible to analyze IF signal data stored in host PC by the various processing algorithms. A L1 C/A software GPS receiver was developed consisting of a RF front-end module and a signal processing program on the PC. The RF front-end module consists of a down converter and a general purpose device for acquiring data. The signal processing program written in MATLAB implements signal acquisition, tracking, and pseudorange measurements. The receiver achieves standalone positioning with accuracy between 5 and 10 meters in 2drms. Typical phase locked loop (PLL) designs of GPS/SBAS receivers enable them to handle moderate amounts of scintillation. So the effects of ionospheric scintillation was estimated on the performance of GPS L1 C/A and SBAS receivers in terms of degradation of PLL accuracy considering the effect of various noise sources such as thermal noise jitter, ionospheric phase jitter and dynamic stress error.