• Transactions of the Society of Information Storage Systems
• /
• v.8 no.2
• /
• pp.44-49
• /
• 2012

We measured the surface flatness of both sides for refractive media using the transmitted digital holography method. To enhance the accuracy of the result, phase-shifting system was used. With two different phase modulation of reference beam, the phase profile of object can be easily obtained. Thus, we proposed the surface measurement method which can measure large area fast, compared with conventional methods. To guarantee the reliability of obtained result, we compared with Zygo measurement system. With the proposed method, the surface flatness of $3.45{\mu}m$ resolution could be obtained.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.16 no.4
• /
• pp.387-394
• /
• 2016

This paper presents a fully digital delay locked loop (DLL) that can acquire lock in four clock cycles with a resolution of a 1/4 NAND-delay. The proposed DLL with a multi-dither-free phase detector acquires the initial lock in four clock cycles with 1/2 NAND-delay. Then, it utilizes a multi-dither-free phase detector, a region accumulator, and phase blenders, to improve the resolution to a 1/4 NAND-delay. The region accumulator which continuously steers the control registers and the phase blender, adaptively controls the tracking bandwidth depending on the amount of jitter, and effectively suppresses the dithering jitter. Fabricated in a 65 nm CMOS process, the proposed DLL occupies $0.0432mm^2$, and consumes 3.7 mW from a 1.2-V supply at 2 GHz.

• Journal of Auto-vehicle Safety Association
• /
• v.14 no.3
• /
• pp.48-59
• /
• 2022

A V2X system can be a candidate as a means to increase the stability of autonomous vehicles. In particular, in order to implement a Level 4 or higher autonomous driving system, the application of the V2X system is essential. Wireless communication technologies applicable to the V2X system include WAVE and C-V2X. Currently, the V2X service most used by autonomous driving systems is a service that provides signal phase and timing information and since real-time characteristic is a very important, verification of this service must be done. In this paper, we measured the time delay characteristics for providing signal phase and timing information using WAVE and LTE communication, and proposed a TOD-based signal phase and timing information generation method without using V2X communication system. To analyze the time delay characteristics, RTT (Round Trip Time) was measured as a result of the measurement. Average RTT using WAVE communication was 5.84ms and was 104.15ms with LTE communication. As a result of measuring the error between the signal phase and timing information generated based on TOD and the actual traffic light state, it was measured to be -0.284~3.784sec.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.5 no.6
• /
• pp.1116-1121
• /
• 2001

Phase shifter has been used as a means of power-flow control and for transient stability improvement in AC transmission system. Until now, phase shifters have been based on an injection transformer. Conventional phase shifters with tap changers require regular maintenance and allow only step-like control of the phase angle. This paper propose a three-phase phase shifter using PWM AC/AC converter, which can improve system response and control stability in the applications. This paper deals with the circuit topology, operating principle so that the features of the phase shifter will be shown through computer simulation, especially using PSIM software.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.6 no.8
• /
• pp.1297-1304
• /
• 2002

The phase locked oscillator having a low phase noise and high output in Ku-band was designed. To obtain the low phase noise and high output characteristics of oscillator, the nonlinear equivalent circuits of p-HEMT was analyzed by TOM method and we have decided the trade-off bias point between the low phase noise and the output power of oscillator. The designed phase locked oscillator with prescaler for stable operation, experiment results exhibits output power of 1003m with phase noise in the phase locked state of -824BC/HB at 10mz offset from 13.250Hz, and simulation result of 1003m output power in the phase noise -840Bc/Hz at 10KHz offset frequency respectively. a good agreement has been obtained between simulations and experiments results.

• Proceedings of the KIPE Conference
• /
• 2004.07a
• /
• pp.6-10
• /
• 2004

This paper newly proposes the SRM drive system based on DC-link current information, from which the phase currents can be estimated in accuracy and also they can be used in driving SRM instead of the phase currents. Comparing to the general drive system based on the phase current information, it is verified through the simulation(which are peformed by RMxprt and Simplorer) that the proposed SRM drive system has the good performance in dynamic and steady-state responses of the speed control. Using the DC-link current information, all of the multi-phase currents can be easily estimated in driving the SRM.

• Proceedings of the IEEK Conference
• /
• 2002.07c
• /
• pp.1681-1684
• /
• 2002

A multilevel modulation with selectable constellations is adopted in the downlink subframe modulation of the IEEE 802.16 standard to increase the total throughput. One of the decision factors of the modulation is the location of SS(Subscriber Station) . Also, for the 802.16, low phase noise of local oscillator is needed due to high operating frequency and severe loss in the propagation channel. We investigate the BER of down-link subframe with the phase jitter under the standard's specified LOS(line of sight) and multipath environment with randomly generated SS locations. Simulation results show BER performance degradation for the modulation corresponding to selected constellations and additionally required SNR to achieve 10$\^$-3/ BER under various phase jitter.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.28 no.4C
• /
• pp.384-391
• /
• 2003

Blind channel identification and equalization attempt to identify the communication channel and to remove the inter-symbol interference caused by a communication channel without using any known trainning sequences. In this paper, we propose a blind adaptive channel identification and equalization algorithm with phase offset compensation for single-input multiple-output (SIMO) channel. It is based on the one-step forward multichannel linear prediction error method and can be implemented by an RLS algorithm. Phase offset problem, we use a blind adaptive algorithm called the constant modulus derotator (CMD) algorithm based on condtant modulus algorithm (CMA). Moreover, unlike many known subspace (SS) methods or cross relation (CR) methods, our proposed algorithms do not require channel order estimation. Therefore, our algorithms are robust to channel order mismatch.

• Proceedings of the Korea Information Processing Society Conference
• /
• 2012.11a
• /
• pp.552-555
• /
• 2012

The main goal of this paper is to develop a robust visual tracking algorithm with particle filtering. Visual Tracking with particle filter technique is not easy task due to cluttered environment, illumination changes. To deal with these problems, we develop an efficient observation model for target tracking with particle filter. We develop a robust phase correlation combined with motion information based observation model for particle filter framework. Phase correlation provides straight-forward estimation of rigid translational motion between two images, which is based on the well-known Fourier shift property. Phase correlation has the advantage that it is not affected by any intensity or contrast differences between two images. On the other hand, motion cue is also very well known technique and widely used due to its simplicity. Therefore, we apply the phase correlation integrated with motion information in particle filter framework for robust tracking. In experimental results, we show that tracking with multiple cues based model provides more reliable performance than single cue.

• KIEE International Transactions on Electrophysics and Applications
• /
• v.11C no.4
• /
• pp.150-154
• /
• 2001

In this paper, we presented a novel structure of microstrip directional coupler for realizing the high directivity characteristic and tight coupling. The achievement of the high directivity with microstrip configuration was carried out by matching the even and odd mode effective phase velocities. By using 2-dimensional finite element (FE) calculations, the phase velocity for each mode and design parameters were extracted for given dimensions. Based on the extracted design parameter with phase-matched condition, we designed and fabricated 3dB and 4.7dB directional coupler at 2.0GHz. Experimental results of microstrip coupler show good performance with excellent isolation characteristics.