• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.27 no.7
• /
• pp.612-619
• /
• 2016

In this paper, a dual band electrical beam tilting array antenna with bi-directional directivity is designed. Radiating element operates at dual-resonance frequencies and is designed as planar dipole using PCB. In order to tilt the main beam, the phase delay line is designed by use of only the phase shifting line of a $50\Omega$ microstrip line for broadband. The designed antenna has tilting angle of $0^{\circ}$ to ${\pm}8^{\circ}$. For validation of the designed antenna specification, the array antenna is fabricated and the performances are measured. Comparison between theory and experiment shows good agreement.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.25 no.2
• /
• pp.135-143
• /
• 2022

In this paper, the compact waveguide slot array antenna for interferometric radar altimeter is proposed. The proposed antenna structure consist of corrugation structure which is applied between each channel to improve isolation, three-channel waveguide slot array antenna and feeder. In addition, to reduce the occurrence of phase ambiguity, the baseline spacing of the three-channel antenna is analyzed and the results are applied to the design. For compact design, reduced height and SMP connector structure are used and the dip brazing method which is the conjugation method after dipping to flux is used for the fabrication of the lightweight antenna. The measurement result of the proposed antenna shows less than 1.41 : 1 (VSWR) and 48.3 dBc (isolation). The antenna gain is higher than 20.2 dBi and the side lobe levels are lower than 18.8 dB (vertical plane) and 10.0 dB (horizontal plane).

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.3 no.4
• /
• pp.76-82
• /
• 2010

For the purpose of controlling the beam tilt angle of the base station sector array antenna, phase shifter is used. Phase angles of this antenna depending on the tilt angles are designed, and the patterns on the vertical and horizontal planes are simulated and analyzed for the evaluation of base station antenna. This analysis is used in the optimal design of base station antenna because of maximum cell coverage and incremented traffic capacity, decreased interference.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.17 no.1
• /
• pp.23-30
• /
• 2022

The active phased array antenna system performs beam steering, multi-beam formation and adaptive beam forming by controlling the amplitude and phase of signals fed to each radiating element. In order to obtain the desired radiation characteristics using an active phased array antenna system, the accurate amplitude and phase of the signal must be fed to each radiating element; however, due to various causes, the signal errors occurs in each radiating element. In this paper, a signal error estimation method of each radiating element is proposed. The proposed method simplifies the process of signal error estimation, and can quickly and accurately calculate the signal error.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.14 no.9
• /
• pp.2157-2163
• /
• 2010

This paper includes the study of DOA(Direction of Arrival). CVDF(Correlative Vector Direction Finding) algorithm using at the phase difference each antenna needs to obtain ideal sinusoidal phase difference patterns. However, the phase difference patterns of circular array antennas may be interfered on a specific frequency band and to particular angle. The effect of installing each array antenna circularly and the effect of the interference by center pole (located in the center of a circular array antennas) may distort the phase difference patterns. This paper propose how to change the combination of antennas to measure phase difference patterns in real-time and how to use antenna beam patterns for minimizing the degradation phenomena with old CVDF algorithm. According to the test result, the capability of direction finding is improved.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.1A
• /
• pp.18-30
• /
• 2004

In this paper, the calibration problem of an asynchronous CDMA-based antenna array is studied. A new iterative calibration algorithm for antenna array in the presence of frequency offset error is presented. The algorithm is applicable to a non-linear array and does not require a prior knowledge of the (direction of arrivals) DOAs of the signals of any user, and it only requires the code sequence of a reference user. The algorithm is based on the two step procedures, one for estimating both channel and frequency offset and the other for estimating the unknown array gain and phase. Consequently, estimates of the DOAs, the multi-path impulse response of the reference signal sources, and the carrier frequency offset as well as the calibration of antenna array are provided. The performance of the proposed algorithm is investigated by means of computer simulations and is verified by using field data measured through a custom-built W-CDMA test-bed.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.17 no.7 s.110
• /
• pp.694-705
• /
• 2006

In this paper, the linear active phased array antenna system operated in Ku DBS band was designed and experimented. The antenna system was composed of sixteen radiating active channels and Wilkinson power combiners with 16-channel inputs, a stabilizing DC bias and phase control board. Electrical beams of the antenna system can be formed by controling the phase-states of 3-bit digital phase shifter inside each active channel by virtue of the phase control board. The amplitude and phase deviations measured between active channels were less than ${\pm}0.8dB$ and ${\pm}15^{\circ}$, respectively, and the noise figure of each active channel was measured less than 1.2 dB in the operating band. The measured performances of the overall antenna system showed the antenna gain of more than 23.07 dBi and the sidelobe level of less than -11.17 dBc, and the bore-sight cross-polarization level of less than -12.75 dBc in the operating band. Also, by phase-controlling active channels, the beam scan patterns at $10^{\circ},\;20^{\circ},\;30^{\circ}$ were measured, and the losses caused by the corresponding beam scanning were 1.1 dB, 2.5 dB and 3.6 dB from the measurements, respectively.

• Journal of Positioning, Navigation, and Timing
• /
• v.3 no.2
• /
• pp.37-44
• /
• 2014

The most effective method to overcome GPS jamming problem is to use an adaptive array antenna which has the capability of beamforming or nulling to a certain direction. In this paper, Space Time Adaptive Processing (STAP) beamforming algorithm of four elements array antenna will be designed and the anti-jamming performance will be analyzed. According to the analysis, the signal to noise ratio (SNR) and anti-jamming performance can be enhanced by beamforming algorithm. Also, the time tap effect of STAP algorithm will be analyzed theoretically and verified with array antenna modeling and simulation. Specially, the cautious selection of reference time tap in STAP can prevent the degradation of position accuracy performance.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.64 no.3
• /
• pp.438-444
• /
• 2015

A new approach to the active phased arrays for the second harmonic generation is presented. Phase variation between the second harmonic oscillators by the mutual synchronization is analyzed theoretically. In this coupling, the active antenna consists of the FET oscillator which plays two roles in fundamental oscillation and frequency multiplying, and the patch antenna resonated at the second harmonic frequency. The radiated second harmonic wave was scanned by varying the free-running oscillation frequencies of the active antennas. In the experiment using the 2-elements array and the 4-elements array, the radiated beam of the second harmonic wave was scanned more widely compared with the case of the fundamental wave radiation.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2010.05a
• /
• pp.535-539
• /
• 2010

This paper include to study DoA(Direction of Arrival) for radio collection and monitoring system. The direction finding calculated by applying the CVDF (Correlation Vector Direction Finding) algorithm for the five circular dipole antenna over V / UHF band. To improve the accuracy of direction finding by applying CVDF algorithm needs to obtain ideal phase difference each antennas. However, a circular array antenna phase difference pattern may be distorted on a specific frequency band or to particular direction. The effect of installing each array antennas circularly and the effect of the interference of center pole (located in the center of a circular array antenna mount) may make the distortion of phase pattern. If you use an active antenna instead of passive antenna to obtain good sensitivity, you would measure the more distortion. This paper propose how to change combination of antennas to measure the phase in real-time and how to use antenna beam patterns for minimizing the degradation phenomena at applying simple CVDF algorithm and increasing the direction finding capability.