• Journal of IKEEE
• /
• v.21 no.2
• /
• pp.115-122
• /
• 2017

In vehicular safety service, every vehicle broadcasts Basic Safety Message (BSM) periodically to inform neighbor vehicles of host vehicle information. However, this can cause network congestion in a region that is crowded with vehicles resulting in a reduction in the message delivery ratio and an increase in the end-to-end delay. Therefore, it could destabilize the vehicular safety service system. In this paper, in order to improve the congestion control and to consider the hidden node problem, we propose a congestion control scheme using entire network congestion level estimation combined with transmission power control, data rate control and time slot based transmission control algorithm. The performance of this scheme is evaluated using a Qualnet network simulator. The simulation result shows that our scheme mitigates network congestion in heavy traffic cases and enhances network capacity in light traffic cases, so that packet error rate is perfectly within 10% and entire network load level is maintained within 60~70%. Thus, it can be concluded that the proposed congestion control scheme has quite good performance.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.11A
• /
• pp.831-843
• /
• 2009

In this paper, we propose a new adaptive cooperation scheme with multi-relay nodes which achieves higher performance and spectral efficiency than that of some conventional cooperative schemes. The relay-selection is applied to choose the most potential relay among K ones. Afterward, the instantaneous signal-to-noise ratio (SNR) differences between S-D, S-R and R-D channels are considered for adaptive selection between the direct and the cooperation transmission strategy. In the proposed adaptive protocol, if the direct link is of high quality, the source will transmit to destination directly with all power consumption. Otherwise, the source broadcasts the signal with a lower power and requires the help of the chosen relay if it decodes correctly, else the source will transmit again with remaining power. Firstly, the spectral efficiency is derived by calculating the probability of each mode. Subsequently, the BER performance for the adaptive cooperation scheme is analyzed by considering each event that one of K relays is selected and then making the summation of all. Finally, the numerical results are presented to confirm the performance enhancement offered by the proposed schemes.

• Journal of the Korea Society of Computer and Information
• /
• v.18 no.12
• /
• pp.35-43
• /
• 2013

This paper suggests a way to implement a system that broadcasts compressed JPEG images obtained from a webcam to multiple users on their smartphones. The system was implemented to maintain a suitable image quality so that things are identifiable while using the minimal amount of data, in order to deliver as many frames as possible to as many users as possible. Also, the suggested way was applied and various tests were done, including on: the performance of the server that provides image information; the performance of the client that receives the image information and displays it on the smartphone; and the max. number of simultaneous users supported by the system. When a broadcasting system is implemented using webcams and smartphones, the results of this paper can be used in estimating the suitable system parameters depending on network performance, including the max. number of simultaneous clients supported, the client smartphone performance required, and the number of frames that can be transmitted per second.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.22 no.10
• /
• pp.941-950
• /
• 2011

In this paper, we analysis the end-to-end performance of the incremental cooperative communication with relay selection. In the conventional cooperative scheme, the source(S) broadcasts the signal to the relay(R) and the destination(D) at 1st phase, and the R forwards the signal to the D at 2nd phase. Although this scheme can improve performance and provide diversity gain, it suffers from decreasing spectrum efficiency. In order to overcome this problem, the incremental cooperative model can be used. In this paper, we study two incremental cooperative method : the first uses ARQ with threshold SNR and the second uses HARQ with channel coding. we also evaluated performance of the incremental cooperative communication based on the R arrangement by using both methods.

• Journal of Institute of Control, Robotics and Systems
• /
• v.18 no.5
• /
• pp.426-432
• /
• 2012

The positions of vessels in JTIDS where each vessel broadcasts its position, can be found using the relative navigation method. Besides positioning, the relative navigation could be adopted for identification friend or foe, tracking targets, monitoring battle field and etc. In this paper, we have explained the fundamental operation and technical structure for the relative navigation and implemented the simulation platform to evaluate the basic function and performance of the system in arbitrary environment. Using platform, the availability of relative navigation within the group network and the characteristic of the algorithm for position prediction was verified. Based on the simulation result, it was verified that EKF based navigation algorithm could produce great initial error and need quite convergence time. To improve the performance, we proposed a new navigation algorithm which uses the minimum norm estimation algorithm until the EKF converges. The simulation results reveal the relative navigation can be effectively used in the formation flight and collision avoidance system.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.49 no.4
• /
• pp.41-46
• /
• 2012

This paper suggested that the frequency adaptive antenna matching network design between AP and WLAN(Wireless Local Area Network) terminal for improving performance. The internet data service of the WLAN terminal is communicated through the AP and AP broadcasts the beacon signal including the assigned frequency channel. at that time the antenna matching network path is controlled beacon information after the WLAN terminal searching and synchronization a beacon information. and then the WLAN terminal communicate with AP. controlling the antenna matching network path according to channel information, The WLAN terminal is expected to improve RF output power and sensitivity performance. The VSWR(Voltage Standing Wave Ratio) performance of the designed antenna matching network is measured to about 1.1 ~ 1.2 and then it is operated by the channel information of the AP.

• Journal of KIISE:Databases
• /
• v.32 no.4
• /
• pp.416-428
• /
• 2005

In the paper we propose an index method for XML streaming services, where a server broadcasts XML data to a lot of clients in wireless information systems. In order to control the access and tuning time of mobile clients, the proposed method constructs the XML stream through replicating partial index intermixed with parts of data. For this purpose, we propose a two-level tree structure for separating index and XML data into two parts: replicated vs. non-replicated. We analyze the performance of the proposed method with respect to access time and tuning time. With the analysis result, we derive the optimal level value.

• Journal of Korea Multimedia Society
• /
• v.19 no.3
• /
• pp.567-572
• /
• 2016

N-screen is an emerging technology to support multimedia multicasting, content sharing and content mobility. N-screen service providers should obtain the technology that provides the highest quality content seamlessly. Distributed nature of WiMedia distributed-MAC protocol can provide full mobility support, and achieves seamless medium access method in contrast to IEEE 802.15.3. So, in this paper, WiMedia distributed-MAC protocol is adopted and an asynchronous multicast transmission (AMT) technology is proposed to enhance performance of seamless N-screen wireless service based on distributed-MAC. The ACK frame transmissions are not required for multicast transmissions. By using this property in AMT, if a device is a multicast receiver, its reserved time slots can be reserved by the other devices with 1-hop distance. Furthermore, each N-screen device broadcasts and shares the information including an order in asynchronous traffic reservations to reduce conflicts in determining the transmission order of asynchronous N-screen packets. Therefore, AMT scheme expands the number of time slots available and throughputs for multicast and asynchronous traffic reservations when comparing with the distributed-MAC standard system. N-screen communications based on distributed-MAC with the proposed AMT shows a new framework for realizing N-screen wireless service with the full content mobility.

• Journal of IKEEE
• /
• v.10 no.2 s.19
• /
• pp.123-127
• /
• 2006

An Ad-hoc network which is composed of mobile nodes only should be able to distribute the traffic load evenly to the network so that the network could utilize its resources effectively However, most of researches have been concentrated in channel establishment level, not in channel reestablishment level. In this paper, the existing AODV routing protocol has been modified and upgraded to disperse the traffic load more quickly A node which uses the modified AODV routing protocol proposed in this paper broadcasts a control message to adjacent nodes, which announces congestion around the node. In order to verify the performance improvement of the proposed protocol, simulation study has been carried out by using ns2 simulator.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.15 no.2
• /
• pp.77-85
• /
• 2015

This paper presents our performance evaluation after the way of minimizing waiting times between channel switching for eMBMS(evolved Multimedia Broadcast/Multicast Services) technique in LTE-Advanced systems. Existing composition of MBMS using IGMP(Internet Group Management Protocol) transfers the data with Multicast from BM-SC(Broadcast Multicast Service Center) to eNB(evolevd Node B) and with Broadcast from eNB to UE(User Equipment). Therefore, in case of channel switching, IGMP Join report should be transferred to BM-SC and then wait user's contents to be retransferred from eNB. To achieve this, Subscriber Channel technique of priorities is used for minimizing waiting times between channel switching as UE broadcasts favorite channels in advance.