• The Journal of the Acoustical Society of Korea
• /
• v.18 no.5
• /
• pp.68-77
• /
• 1999

The paper looked into the effects of the spectral properties (waveform) of the high intensity focused ultrasound on suppression of the ultrasonic cavitation. Three different types of ultrasound were considered in the study, which were sinusoidal (1 MHz, 5 MPa), frequency modulated (from 1 MHz to 6 MHz for 10 ㎲, 5 MPa), asymmetrically shocked (fundamental frequency 1 MHz, peak positive pressure 12 MPa, peak negative pressure -4 MPa). The temporal response of an air bubble in water initially 1 ㎛ in radius to each type of the ultrasound was predicted using Gilmore bubble dynamic model and Church's rectified gas diffusion equation. It was shown that the radially pulsating amplitude of the bubble was greatly reduced for the frequency modulated wave and was little decreased for the shock wave, compared to the case that the bubble was exposed to the sinusoidal wave. It is interesting that the bubble response to the frequency modulated wave remains similar when the frequency component of the modulated ultrasound is beyond the bubble resonant frequency 3 MHz. This implies that, although the ultrasound is modulated up to 3MHz rather than up to the present 6 MHz, it is likely to produce similar cavitation suppression effects. In practice, it means that a typical narrow band ultrasonic transducer can be taken to generate an appropriate frequency modulated ultrasound to reduce cavitation activity. The present study indicates that ultrasonic cavitation may be suppressed to some extent by a proper spectral modification of high intensity ultrasound.

• Journal of Korean Association for Spatial Structures
• /
• v.13 no.1
• /
• pp.97-104
• /
• 2013

Recent tall buildings tend to have unconventional shapes as a prevailing, which is effective for suppressing across-wind responses. Suppression of across-wind responses is a major factor in tall building projects, and the so called aerodynamic modification method is comprehensively used. The purpose of the present study is to investigate the pressure fluctuations on tapered and setback tall buildings, including peak pressures, power spectra and coherences through the synchronous multi-pressure sensing system techniques. And flow measurements around the models were conducted to investigate the condition of vortex shedding. The results show that by tapering and setback, different distributions of mean pressure coefficients at leeward surface were found, which is caused by the geometric characteristics of the models. And the power spectra of wind pressures at sideward surface become wideband and the peak frequencies are different depending on heights, which makes the correlation near the Strouhal component low or even negative. The differences in shedding frequencies were also confirmed by the flow fields around the models.

• Progress in Superconductivity
• /
• v.2 no.1
• /
• pp.43-46
• /
• 2000

We report on the tunneling spectroscopy of tunnel junctions using d-wave superconductor in relation to Andreev reflection. The zero bias conductance peak (ZBCP) which has maximum on [110] direction of ab-plane is observed on metal $Au/YBa_2Cu_3O_y$ tunnel junctions while it is suppressed on the ferromagnetic $Co/Au/YBa_2Cu_3O_y$ tunnel junctions. The effects of Andreev reflection on the differential conductance of each junction are dependent on the tunnel direction. For the $Co/Au/YBa_2Cu_3O_y$ junction, the suppression of Andreev reflection takes place by spin-polarized quasiparticles tunneling from a ferromagnetic material to a d-wave superconductor. By comparing these experimental results with recent theoretical works on Andreev reflection, the existence of Andreev bound state due to the d-wave symmetry of the pair potential is verified in high-$T_c$ superconductor.

• Korean Journal of Materials Research
• /
• v.13 no.12
• /
• pp.769-774
• /
• 2003

In this paper, we report on the DC characteristics of the AlGaN/GaN HFETs using physical models on piezoelectric and thermal effects. Employing the models was found to be essential for a realistic prediction of the DC current-voltage characteristics of the AlGaN/GaN HFETs. Though use of the implementation of the physical models, peak drain current, transconductance, pinch-off voltage, and most importantly, the negative slope in the current were accurately predicted. The importance of the heat sink effect was demonstrated by the comparison of the DC characteristics of AlGaN/GaN HFETs fabricated from different substrates including sapphire, Si and SiC. Highest peak current was achieved from the device with SiC by an effective suppression of heat sink effect.

• Macromolecular Research
• /
• v.16 no.3
• /
• pp.224-230
• /
• 2008

This study examined the photoemission behaviors of isolated chains of poly[2-methoxy, 5-(2'-ethylhexyloxy)-1,4-phenylenevinylene](MEH-PPV) dispersed in various solvents including dichloromethane, chloroform and tetrahydrofuran(THF). A change in polymer-solvent interactions in these solutions caused the MEH-PPV chains to adopt different local conformations, which in turn affected their radiative de-excitation pathways. For the polymer in dichloromethane and chloroform, in which the conjugated chains are relatively extended, photoemission occurs mostly at the long chromophores with lowest HOMO-LUMO energy gap. Their emission spectra showed a main peak at ${\sim}560\;nm$. Dual photoemission of high- and low-energy chromophores was observed when the conjugated chains were forced to partially collapse in a poor solvent THF. Novel high-energy peaks and a typical low-energy peak were detected at ${\sim}414\;nm$ and ${\sim}554\;nm$, respectively. The observation of the high-energy peaks indicates significant suppression of the intrachain energy transfer process, which was attributed to the increase in conformational disorder in the partially collapsed coils. An analysis of the excitation spectra suggests that the high-energy peaks belong to short chromophores constituting of one or two repeat units. This study systematically investigated the effects of polymer concentration, temperature and single bond defects along the backbone on the photoemission of the high-energy chromophores.

• ETRI Journal
• /
• v.43 no.2
• /
• pp.209-220
• /
• 2021

The filtered orthogonal frequency division multiplexing (F-OFDM) system has been recommended as a waveform candidate for fifth-generation (5G) communications. The suppression of out-of-band emission (OOBE) and asynchronous transmission are the distinctive features of the filtering-based waveform frameworks. Meanwhile, the high peak-to-average power ratio (PAPR) is still a challenge for the new waveform candidates. Partial transmit sequence (PTS) is an effective technique for mitigating the trend of high PAPR in multicarrier systems. In this study, the PTS technique is employed to reduce the high PAPR value of an F-OFDM system. Then, this system is compared with the OFDM system. In addition, the other related parameters such as frequency localization, bit error rate (BER), and computational complexity are evaluated and analyzed for both systems with and without PTS. The simulation results indicate that the F-OFDM based on PTS achieves higher levels of PAPR, BER, and OOBE performances compared with OFDM. Moreover, the BER performance of F-OFDM is uninfluenced by the use of the PTS technique.

• Proceedings of the KSR Conference
• /
• 2011.10a
• /
• pp.2021-2030
• /
• 2011

This thesis paper is on the management of Energy Storage System for the catenary source stabilization of KTX's high-speed train section. It is the algorism that is to utilize on the voltage drop at the end and peak power suppression of the substation by supplying from the end, compensating consuming energy when the KTX retrogresses, by installing Energy Storage System at the end of the substation where is the section post. The algorism which this thesis is to utilize is verified through the catenary voltage modeling and simulation of the power conversion system, and the system validity of the Korail's Yongjeong section post which is currently in management is in the application review phase.

• Wind and Structures
• /
• v.4 no.1
• /
• pp.19-30
• /
• 2001

This paper concerns computational response predictions when a tuned mass damper is intended to be used for the suppression of vortex shedding induced vibrations of e.g., a bridge deck. A general frequency domain theory is presented and its application is exemplified on a suspension bridge (where vortex shedding vibrations have been observed and where such an installation is a possible solution). Relevant load data are taken from previous wind tunnel tests. In particular, the displacement response statistics of the tuned mass damper as well as the bridge deck are obtained from time domain simulations, showing that after the installation of a TMD peak factors between three and four should be expected.

• Journal of information and communication convergence engineering
• /
• v.12 no.2
• /
• pp.83-88
• /
• 2014

The simultaneous suppression of sidelobes and the sharpening of the central peak in the process of diffraction pattern detection based on asymmetric apodization have been investigated. Asymmetric apodization is applied to a semicircular array of two-dimensional (2D) aperture functions, which is a series of 'coded-phase arrays of semicircular rings randomly distributed over the central circular region of a pupil function' and is similar to that used in the field of diffractive optics. The point spread function (PSF) of an imaging system with asymmetric apodization of the discrete type has been found to possess a good side with suppressed sidelobes, whereas its bad side contains enhanced sidelobes. Further, the diffracted field characteristics are obtained in the presence of these aperture functions. Asymmetric apodization is helpful in improving the performance of the optical gratings or 2D arrays used in real-time imaging techniques.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.11 no.2
• /
• pp.162-166
• /
• 1998

Synthetic fluid, class 7 group 2, as an insulating and cooling material is selected as. specimen, arid it is studied for the physical and electrical properties. Also, Benzotriazole(following as BT A) known as a suppressant of streaming electrification is added to it, and the change of physical and electrical properties by addition of BT A is investigated. From the spectrum of FT-IR, it is confirmed that the absorption peak in wavenumbers $3400{\sim}3450[cm^{-1}]$ is small or disappears when BTA is added. AC breakdown strength and volume resistivity of each specimen are investigated. It is considered that the effective content of BTA is about 10[ppm] for the suppression of electrification in this experiment.