• Journal of the Korean Chemical Society
• /
• v.6 no.2
• /
• pp.133-142
• /
• 1962

This study was carried out to investigate the lead-bismuth-sodium ternary system which a basis of the Dittmer method as a part of "the fundamental study of pyrometallurgical debismuthizing of lead". Thermodynamic properties of each liquid Pb-Bi, Pb-Na binaries as well as liquid Pb-Bi-Na ternary solution were measured by e.m.f. of these concentration cells, and those of each component were also determined. Furthermore, iso-activity lines including Pb rich side composition of Pb-Bi-Na ternary solution were determined. The relationship between those thermodynamic characteristics and tendency of intermetallic compound formation was discussed through the above experiments.

• Journal of the Korean Ceramic Society
• /
• v.34 no.6
• /
• pp.569-576
• /
• 1997

Electrically-induced strain and polarization studies of the (1-x)Pb(Mg1/3Nb2/3)O3-PbZrO3 crystalline solutions have been done. Dielectric constants with temperature were investigated for 0$\leq$x$\leq$0.95. With increasing PbZrO3 content the transition maxima were found to move to higher temperature region and DPT (Diffused Phase Transition) properties were decreased for x$\leq$0.60. Phase transition between ferroelectric states and antiferroelectric states was confirmed for 0.93$\times$10-3 for 0.4

• KSBB Journal
• /
• v.13 no.4
• /
• pp.444-448
• /
• 1998

Biosorption of Pb and Cu was evaluated for 23 species of marine algae collected from a Korean coast. Among a variety of species for biosorbent potential, Hypnea charoides showed the highest capacity for Pb. An adsorption equilibrium was reached in about 2 hr for Pb and 30 min for Cu. The uptake capacity was 192.8 mg Pb/g biomass and 256 mg Cu/g biomass, respectively. The adsorption parameters for Pb and Cu were determined according to Langmuir model. With an increase in pH value, more negative sites are becoming avaliable for adsorption of pH and Cu, thus the removal of Pb and Cu increases at alkaline conditions. The selectivity of mixture solution shows the uptake order of Pb>Cu>Cr>Cd. When Ca concentration increases in Pb solution, Pb was selectively adsorbed.

• Proceedings of the Korean Powder Metallurgy Institute Conference
• /
• 2006.09a
• /
• pp.158-159
• /
• 2006

Ultrafine Au-Pb particles prepared by two method, (1) simultaneous evaporation of Au and Pb in inert gas and (2) subsequent vapor condensation of Pb in a differentially evacuated tube onto flying Au nanoparticles prepared by gasevaporation technique, were observed by electron microscopy. In the method (1), the particles that grew at the region where the two smoke masses converged, consisted of alloy phases. In the method (2), the particles consisted of two or three phases of Au, $Au_2Pb$, $AuPb_2$ and Pb phases in turn from the inner part, Pb-rich particles being composed of only two phases of $AuPb_2$ and Pb.

• Journal of the Korean Chemical Society
• /
• v.55 no.3
• /
• pp.454-462
• /
• 2011

A study on the adsorption characteristics of Pb(II) and Cr(III) cations onto C-methylcalix[4]resorcinarene (CMCR) has been conducted. CMCR was produced by one step synthesis from resorcinol, acetaldehyde, and HCl. Most parameters in batch system confirm that CMCR is a good adsorbent for Pb(II) and Cr(III). Cr(III) uptake was bigger than that of Pb(II), but Cr(III) adsorption rate was slower than Pb(II). The adsorption kinetic of Pb(II) and Cr(III) adsorptions in batch followed pseudo $2^{nd}$ order kinetics model, but the kinetic of Pb(II) adsorption in fixed bed column system followed first order model. Desorption studies to recover the adsorbed Pb(II) was performed sequentially with distilled water and HCl, and the results showed that the adsorption was dominated by chemisorption.

• 대한예방의학회:학술대회논문집
• /
• 1994.02a
• /
• pp.577-584
• /
• 1994

The relation between lead in air (PbA) and lead in blood (PbB), concentrations was investigated among 44 workers in five major operations in a United States high volume, lead acid battery plant. The study covered a 30 month period in which workers received frequent PbA and PbB determinations, workers remained in a single job, and PbA concentrations averaged below the US Occupational Safety and Health Administration (OSHA) permissible exposure limit of $50{\mu}g/m^{3}$. In both univariate and multivariable linear regressions, longitudinal analyses averaging PbA concentrations over the 30 month study period appeared superior to cross sectional analyses using only six month PbA averages .to model PbB concentrations. The covariate adjusted coefficient ($\alpha$ value) for PbA($\mu/m^{3}$) in models of PbB (${\mu}g/100\;g$) was 1-14. This figure is strikingly higher than that reported in previous studies in the lead acid battery industry in all of which PbA concentrations were substantially higher than in the current study. Plausible explanations for the differences in a: values include non-linearity of the PbA-PbB curve, a higher fraction of large size particulate associated with higher PbA concentrations, survivor bias among workers exposed to higher PbA concentrations, and the cross sectional designs of most previous studies. Despite previously reported problems with the model used by OSHA to predict PbA-PbB relations, the findings of this study are in good agreement with the predictions of that model.

• Journal of Environmental Science International
• /
• v.7 no.4
• /
• pp.559-564
• /
• 1998

The effects of temperature, initial $Pb^{2+}$concentration and initial sludge concentration on the initial $Pb^{2+}$ removal rate and maximal $Pb^{2+}$removal amounts in activated sludge, respectively, were investigated. The removal of $Pb^{2+}$ in activated sludge was proved to be temperature-dependent process. The initial $Pb^{2+}$ removal rate increased from 187.5 to 261.4 mg $Pb^{2+}$/g sludge dry weight min, in response to the promoted temperature from 1$0^{\circ}C$ to 6$0^{\circ}C$, while the maximal $Pb^{2+}$removal amount (78.5 mg $Pb^{2+}$/g sludge dry weight) occurred at 30t . As the initial $Pb^{2+}$concentration increased from 36 to 228 mg $Pb^{2+}$/L at the constant temperature of 30C and initial sludge concentration of 1.5 g sludge dry weight/L, the time to reach an equilibrium state was almost independent of the initial $Pb^{2+}$concentration and the equilibrium $Pb^{2+}$/removal amount was increased Irom 41.9 to 73.6 mg $Pb^{2+}$/g sludge dry weight. On the contrary, the equilbrium $Pb^{2+}$ emoval amount was decreased from 87.7 to 65.3 mg $Pb^{2+}$/g sludge dry weight as the in- crease of initial sludge concentration from 0.22 to 1.76 g sludge dry weight/L.

• Journal of the Korean Magnetic Resonance Society
• /
• v.22 no.4
• /
• pp.107-114
• /
• 2018

In this exploration, the nuclear magnetic resonance of the $^{207}Pb$ nucleus in $PbWO_4:Mn^{2+}$ and $PbWO_4:Dy^{3+}$ Single Crystals using FT-NMR spectrometer is investigated. The line width of the resonance line for the $^{207}Pb$ nucleus decreases as temperature increases due to motional narrowing. The chemical shift of $^{207}Pb$ NMR spectra also increases as temperature decreases for both crystals. The spinlattice relaxation times $T_1$ of $^{39}K$ nucleus were calculated as a function of temperature (180 K~400 K). The $T_1$ of $^{207}Pb$ nucleus decreases as temperature increases. The dominant relaxation mechanism at the studied temperature range can be deduced as the Raman process, which is the coupling between lattice vibrations and the nuclear spins. This deduction is substantiated by the fact that the nuclear spin-lattice relaxation rate $1/T_1$ of the $^{207}Pb$ nucleus in $PbWO_4:Mn^{2+}$ and $PbWO_4:Dy^{3+}$ single crystal is proportional to $T^2$, or temperature squared. The activation energies for the $^{207}Pb$ nucleus in $PbWO_4:Mn^{2+}$ and $PbWO_4:Dy^{3+}$ single crystals are $E_a=49{\pm}1meV$ and $E_a=47{\pm}2meV$, respectively.

• Nuclear Engineering and Technology
• /
• v.53 no.2
• /
• pp.423-429
• /
• 2021

The investigation of the utilization of enriched ²⁰⁸Pb as a coolant to enhance the performance of a long-life fast reactor with a Modified CANDLE (Constant Axial shape of Neutron flux, nuclide densities, and power shape During Life of Energy production) burnup scheme has performed. The analyzes were performed on a reactor with thermal power of 800 MegaWatt Thermal (MWTh) with a refueling process every 15 years. Uranium Nitride (enriched ¹⁵N), ²⁰⁸Pb, and High-Cr martensitic steel HT-9 were employed as fuel, coolant, and cladding materials, respectively. One of the Pb-nat isotopes, ²⁰⁸Pb, has the smallest neutron capture cross-section (0.23 mb) among other liquid metal coolants. Furthermore, the neutron-producing cross-section (n, 2n) of ²⁰⁸Pb is larger than sodium (Na). On the other hand, the inelastic scattering energy threshold of ²⁰⁸Pb is the highest among Na, ^natPb, and Bi. The small inelastic scattering cross-section of ²⁰⁸Pb can harden the neutron energy spectrum. Therefore, ²⁰⁸Pb is a better neutron multiplier than any other liquid metal coolant. The excess neutrons cause more production than consumption of ²³⁹Pu. Hence, it can reduce the initial fuel loading of the reactor. The selective photoreaction process was developing to obtain enriched ²⁰⁸Pb. The neutronic was calculated using SRAC and JENDL 4.0 as a nuclear data library. We obtained that the modified CANDLE reactor with enriched ²⁰⁸Pb as coolant and reflector has the highest k-eff among all reactors. Meanwhile, the ^natPb cooled reactor has the lowest k-eff. Thus, the utilization of the enriched ²⁰⁸Pb as the coolant can reduce reactor initial fuel loading. Moreover, the enriched ²⁰⁸Pb-cooled reactor has the smallest power peaking factor among all reactors. Therefore, the enriched ²⁰⁸Pb can enhance the performance of a long-life Modified CANDLE fast reactor.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.17 no.3
• /
• pp.629-637
• /
• 2016

This study examined the purchasing behavior and satisfaction of people with convenience store PB foods. The factors affecting the purchasing behavior and the overall satisfaction with the convenience store PB foods were examined. This study first found that the purchasing motivation of PB foods is the cheaper price than NB foods. Second, age is a statistically effective variable for the visit frequency at the convenience store and gender and age are effective variables for the purchase frequency of PB foods. Third, there is a statistically positive correlation of convenience store brand preference with the PB food brand preference for 6 food categories. Next, in terms of the attribute-level satisfaction, the most satisfied areas are diverse food groups and diverse food taste and the least satisfied areas is price. This is followed by taste and design/packaging influence overall satisfaction. From this analysis, the following suggestions were drawn. First, because consumers are likely to be matched convenience store brand preference and PB food brand preference, advertising is necessary to ensure that the consumers continue to visit the convenience store. Second, product improvement by increasing the quality should be designed to motivate the major consumer group of people in their 20s and 30s. Finally, to boost PB food satisfaction, the industry should improve the taste and design/packaging.