• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.44 no.8
• /
• pp.9-16
• /
• 2007

Currently, the measurement of RF parameters for a base station in operation is typically limited to easily measured forward path items. In this paper, the forward monitoring ports of base stations are used to measure the reverse RF performance. The system has been implemented and effectiveness has been proven on an operating base station. The receiver sensitivity is measured using an internal CDMA modem which is used to monitor the output power based on closed loop power control when the modem is connected to the base station via a voice call. In order to improve accuracy, in addition to the modem Tx adjust(TxAdj) parameter, the detector's actual measurement is used. For accurate receiver sensitivity, the measurement should be made when there is no traffic which is not possible on an operating base station. Therefore, pilot channel chip energy to received signal power spectral density ratio$(E_c/I_o)$ compensation method is used to offset the receiver sensitivity degradation with voice traffic increase.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.9 no.12
• /
• pp.1337-1344
• /
• 2014

The objective of an echo canceller connected to any end of a communication line such as digital subscriber line (DSL) is to compensate the outgoing transmit signal in the receiving path that the hybrid circuit leaks. The echo canceller working in a full duplex environment is an adaptive system driven by the local signal. Conventional echo canceller that implement the least mean square (LMS) algorithm provides a low computational burden but poor convergence properties. The length of the echo canceller will directly affect both the degree of performance and the convergence speed of the adaptation process. To cancel long time-varying echoes, the number of tap coefficients of a conventional echo canceller must be large, which decreases the convergence speed of the adaptive filter. This paper proposes an alternative technique for the echo cancellation in a telecommunication channel. The new technique employs the bi-directional least mean square (LMS) algorithm for adaptively computing the optimal set of the coefficients of the echo canceller, which is composed of weighted combination of both feedforward and feedback algorithms. Finally, Simulation results as well as mathematical analysis demonstrates that the proposed echo canceller has faster convergence speed than the conventional LMS echo canceller with nearly equivalent complexity of computation.

• The Journal of Korean Academy of Prosthodontics
• /
• v.56 no.2
• /
• pp.154-160
• /
• 2018

When making conventional removable partial denture for the remaining teeth where the remaining teeth are only on one side, rotation of the denture occurs -in function- on the axis of the connected remaining teeth. If the edentulous portion is long, it becomes harder to obtain retention and stability for the abutment as the importance of the mucous membrane support is elevated. Such movements of denture decrease denture retention and stability, put excessive stress on the abutment, and give bad influence on periodontal health. Therefore, additional implant placement can be of a good choice in gaining additional retention and stability for partial denture. Thus hereby we report this clinical case as successful results were obtained by placing implants symmetrical to the remaining teeth and putting implant-supported surveyed crowns on the implants, allowing the partial denture to be designed to accept varying components and to have suitable path of insertion.

• The Journal of the Korea Contents Association
• /
• v.10 no.2
• /
• pp.120-129
• /
• 2010

MANET(Mobile Ad Hoc NETwork) is a collection of mobile nodes that are free to move and organize themselves in an arbitrary manner without any fixed infrastructures. These mobile nodes are connected by wireless links and act as routers for all other nodes in the network. As a router each node in MANET consumes its batteries when forwarding a message, and the selection of the best path to minimize the total power needed to route packets is needed to maximize the lifetime of all nodes. In this paper, we propose a routing protocol considering the remaining battery capacity of nodes in the routing paths. The proposed scheme prevents the battery of each node from being overused and increases the lifetime of the network.

• Fire Science and Engineering
• /
• v.30 no.6
• /
• pp.71-77
• /
• 2016

The electrolyte of the capacitor in mobile phone chargers leaks to the power input terminal resulting in tracking on the PCB board to form a carbonized conductive path. As a result of structural analysis of the cause of the tracking, It occurred when the power input terminal and the PCB board were connected directly using the connector. The larger the amount of electrolyte leaked from the capacitor into the power input terminal, or the lower the height of the partition provided between the plug pins of the power input terminal, the higher the tracking occurrence rate. Accordingly, to lower the occurrence rate of tracking in the charger, it is necessary to provide a partition on the capacitor or increase the height of the partition provided on the power input terminal so that the leaked electrolyte does not flow to the power input terminal. In addition, the tracking occurrence rate will be reduced further if the shape of the PCB board touching ther power connection terminal is changed to ${\Pi}$.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.45 no.3
• /
• pp.46-52
• /
• 2008

BGP is an exterior routing protocol which exchanges routing information between ASs in ISP or large networks. It is necessary for the BGP to provide traffic enforcement among ASs, for an End-to-End traffic engineering capability in the Internet. However, traditional BGP-4 is lack of end-to-end traffic engineering capability because the policy-based routing affects the traffic only between directly-connected neighbor ASs. This paper proposes an extended BGP routing algorithm to achieve an End-to-End traffic engineering capability. This new method does not require an additional BGP message type, nor change a structure of existing routing table. It only extended the operation of UPDATE message with AS_PATH attribute, which is well-known mandatory. Simulation shows that the new BGP algorithm improves the packet delay and packet loss without the problem of backward compatibility.

• Journal of the Society of Naval Architects of Korea
• /
• v.50 no.3
• /
• pp.190-198
• /
• 2013

In order to predict acoustic pressure distributions by exterior incident wave at Cylindrical Hydrophone Array (CHA) sensor's positions, acoustic pressure analysis is performed by using beam tracing method. Beam tracing method is well-known of reliable pressure analysis methods at high-frequency range. When an acoustic noise source is located at the center of rectangular room, acoustic pressure analysis is performed by using both beam tracing method and Power Flow Boundary Element Method (PFBEM). By comparing with results of beam tracing method and those of PFBEM, the accuracy of beam tracing method is verified. We develop the CHA pressure analysis program by verified beam tracing method. The developed software is composed of model input, sensor array creator, analysis option, solver and post-processor. We can choose a model option of 2D or 3D. The sensor array generator is connected to a sonar which is composed of center position, bottom, top and angle between sensors. We also can choose an analysis option such as analysis frequency, beam number, reflect number, etc. The solver module calculates the ray paths, acoustic pressure and result of generating beams. We apply the program to 2D and 3D CHA models, and their results are reliable.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.19 no.2
• /
• pp.297-316
• /
• 1995

The system and symbolizing ideologic meanings of the metallic Kwon in period of the Three-Kingdoms were comsidered by comparing to their cultural path and structal styles throughout the tree and the deer worship ideology. The results of this study are as followings; Firstly, the beginning of the Korean, mostly northern style was originated from metal tools of the Bronze age in BC 6c-7c. The maJ;lufature of the metallic adornment brought the pr-evailing use of metallic objects of craftwork after the supply of ironmongery. Secondly, the cultmal characteristics of the metallic Kwan in the kor-ean Peninsula were influenced f-rom the northern chinese tribes, Momg Go, Hung No, and Sien-pi who were transmitted from the scythian of the southern Russia having a prefenence for gold. Thir-dly, the metallic Kwon of the Kogmgo and the Baekje era was ideologically based on the ar-t of Buddism of the pattern of blazing flame, the carved pattern of flower- of herb, and the honey. sukle which were tramsmitted to china thr-ough the silk noad. Fourthly, the metallic K wam of the silla era consisted of the tree and the antler types in closely nelated to the tree and the deer ideology which were based on the background of shamanism. It should be raid that the metallic Kwan of the silla esa are connected to the type of nor-them ancient K wan. Lasthy, the metallic Kwan-Mo of the Kaja esa was mosthy original type of flower of herb even if kome of these ar-e similiar to the tree adornment type of silla. This type of flower of herb in based on the scythian type with a statue im silveer founded at Alexandnopol in the southern russia.

• Journal of the Korean Society of Groundwater Environment
• /
• v.4 no.2
• /
• pp.73-77
• /
• 1997

Temperature log is an effective method for evaluating the thermal situation and ground water flow path within boreholes. When pumping is proceeding, the continuous temperature logs in a neighboring holt are very helpful to assess connectivity between holes. Mean geothermal gradient is calculated as 26.6$^{\circ}C$/km from 400 bottom hole temperatures, their depths, and the annual mean temperature at each location. Various examples of temperature logs in crystalline rocks are described: first examples show linear increases in homogeneous granitic rocks. Another one illustrates that isolated aquifers have connected each other after a borehole is completed. Slopes of temperature gradient indicate ground water inlet and/or outflow within a borehole. The other log concludes that thermal response in observation borehole induced by pumping is related to the location of interconnected fractures.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.10B
• /
• pp.891-899
• /
• 2006

Generally, a geographical area consists of many regions called cells in wireless networks. Each mobile host(MH) in a cell communicates with a base station(BS) located in the center of the cell. The BSs are connected to each other by a static wired network. Since users are expected to move around during communication sessions, one of the most important QoS factors is related to the handoff. But, the handoff could fail due to unavailability of sufficient bandwidth in the next cell. As the individual cell size gradually shrinks to accommodate increasing the number of MHs, the probability of successful handoffs can be dropped. In this paper, we suppose a bandwidth reservation method to guarantee MHs against connection failure in case of frequent handoffs. This method predicts the mobility based on the geographical information and assigns the bandwidth reservation in proportion to the speed of MHs' motion. As a result, we can expect more exact moving path of MH and to reduce the waste of bandwidth.