• The Journal of Engineering Geology
• /
• v.24 no.3
• /
• pp.311-322
• /
• 2014

Limestone bodies under the tectonic environment have experienced various tectonic processes, and also changed the stress state. In this study, calcite twins found in limestones of the Joseon Supergroup and Pyeongan Supergroup in the northeastern part of the Ogcheon Belt, South Korea were measured, then the paleostress (i.e., the maximum shortening axis) was reconstructed using the new calcite strain gauge (NCSG) technique. The average twin thickness and average twin intensity increase as the total twin strain increases. We utilize the appearance of twins, the average twin thickness and average twin intensity, and the total twin strain to estimate that the observed calcite twins were produced at temperatures of < $200^{\circ}C$ in the Joseon Supergroup and $170^{\circ}C$ in the Pyeongan Supergroup. In the Joseon Supergroup, the dominant direction of the maximum shortening axis WNW-ESE to NW-SE; NE-SW shortening is also observed. The maximum shortening axes in the Pyeongan Supergroup are oriented NW-SE and NE-SW. The NE-SW direction of maximum shortening is associated with the occurrence of the Songrim orogeny of the Paleozoic to Early Jurassic, and the NW-SE direction of maximum shortening correlates to the Daebo orogeny of the Early Jurassic to Late Jurassic. It is thus concluded that the paleostress across the study area changed from NE-SW to NW-SE during the Mesozoic.

• Journal of the Korean earth science society
• /
• v.30 no.1
• /
• pp.19-32
• /
• 2009

Paleostress was interpreted by analyzing the healed microcracks and the secondary fluid inclusions in quartz of the Jurassic granites distributed in the southwestern Ogcheon Folded Belt, South Korea. The most dominant direction of healed microcracks in the study area was oriented $N30^{\circ}W$, and $N70^{\circ}W$ direction was also recognized. The formation temperatures of fluid inclusions were ranged $380-550^{\circ}C$ and the age of healed microcrack formations might have been approximately 166-200 Ma. Comparing the paleostress orientation obtained from the direction of healed microcracks to the formation age of healed microcracks estimated from the secondary fluid inclusions, it is considered that granitic rock body in study area was subject to a maximum horizontal principal stress along the NNW-SSE and WNW-ESE directions in the early Jurassic to middle Jurassic.

• Economic and Environmental Geology
• /
• v.40 no.4
• /
• pp.461-471
• /
• 2007

A temperature of deformation and the state and direction of paleostress at that time when twins in calcite grains had been produced were observed, using analysis of calcite twins as indicators of paleostress history. The study was performed with the target of carbonate rocks distributed randomly small size in the southern area of south Korea. Considering the appearance of twins (thin or thick straight twins with one or two twin sets), average twin strain (1.235-7.453%), thickness ($0.77-1.94{\mu}m$) and intensity (25.26-41.99 twins/mm) from the results of calculated calcite twins, it is estimated that calcite twins were produced under temperatures lower than approximately $150-200^{\circ}C$. In the magnitudes and directions of principal strains, the maximum shortening strain axis ($e_3\leftrightarrow{\sigma}_1$) is approximately N-S direction in the GS-1 area in the southern Gyeongsang Basin as well as in the BS-1 area in the southern Yongnam Massif, whereas E-W direction in the NR-1 area in the southwestern Ogcheon Fold Belt. In case of the maximum extension strain axis ($e_1\leftrightarrow{\sigma}_3$), it is oriented in NW-SE and NE-SW directions in the GS-1 and BS-1 area, respectively, and in N-S direction in the NR-1 area. That is, it is suggested that the paleostress which produced the calcite twins may be applied at least more than two times in the study area.

• Proceedings of the Korean Radioactive Waste Society Conference
• /
• 2017.10a
• /
• pp.147-148
• /
• 2017

• Proceedings of the Earthquake Engineering Society of Korea Conference
• /
• 1997.10a
• /
• pp.49-56
• /
• 1997

Most large strike-slip faults do not rupture their entire length during single faulting but generally break in segments which are different in location and time of faulting. Studies related to the development of the Yangsan fault have been reported based on partial results from characteristics of geolgocial distribution, geophysical prospecting and paleostress analyses. This paper shows, based on preliminary results, that the Yangsan fault could be divided into four structural areas along entire length. These areas are different in geological distribution, bedding attitude measured from sedimentary rocks, strike of main fault, geometry of small faults, termination types of fault tips, cyclic variation of fault zone width, and arrangement of paleostress. Therefore, the Yangsan fault could be divided into at least four segments.

• Journal of the Earthquake Engineering Society of Korea
• /
• v.2 no.4
• /
• pp.41-52
• /
• 1998

The Dongnae Fault in the southeastern part of the Korean Peninsular is not a single fault but a complex fault zone composed of numerous minor faults. In order to deduce the paleostress tensor evolving the Dongnae Fault, we measured 329 faults in outcrops around the fault zone and analyzed the geometries of them. Most of them are steeply dipping(>65˚) and fall into three groups striking N10E, N30E and N70E. More than one half of them show the rakes less than 30˚ Paleostress tensor analysis using the collected fault data has been conducted with the Angelier's direct inversion method and the Choi's method. As result, four different principal paleostress axes each of which subtends an independent tectonic event are found. They are; (1) NNE-SSW compression and ESE-WNW extension (Event I), (2) NNE-SSW extension (Event II), (3) ESE-WNW extension (Event III) and (4) ENE-WSW compression and NNW-SSE extension (Event IV) in chronology. Therefore, the tectonic movement around the Dongnae Fault was firstly governed by strike-slip faulting related to Event I. Afterward, normal faults were formed by Event II and Event III. Finally, the dextral strike-slip faults along the major trace of the Dongnae Fault were formed in NNE direction related to Event IV.

• The Journal of Engineering Geology
• /
• v.8 no.1
• /
• pp.75-86
• /
• 1998

Eighteen oriented samples from the Jeongsun limestone of the Joseon Supergroup are collected. The orientations of C-axis of calcite and e twin plane, the average thickness, numbers of twins and the widths of calcite grains in 10 samples are measured. Then, the twin strain, mean width, intensity of twin and relative magnitude and orientations of principal stresses are calculated using Calcite Strain Gauge program. Twin strain, mean width and intensitv rainge between 0.801%~10.927%, $0.43{\mu\textrm{m}}~2.03{\mu\textrm{m}}$, and 33.5~113.4twim/mm, respectively. Metamorphic temperatures calculated from twin show below $70^{\circ}C$, indicating that twins were developed within 2.3km depth. In five samples, two events with different orientations of principal stress produced calcite twins, while only one event produced calcite twins in five samples. The direction of the maximum stress is almost horizontal and the minimum is almost vertical, indicating that the stress regirne is identical with thrust fault. E-W and NW-SE are the most dominant directions of comressive stress and N-S and NE-SW directions are also shown. Comparision between paleostress orientations measured in the study and others indicates that the maximum horizontal stress oriented to E-W may represent the paleostress of period either from the Silurian to the Triassic or from the Silulian to the Permian. Paleostress oriented to NW-SE may be the major direction of stress during the Daeho orogeny.

• Journal of the Korean earth science society
• /
• v.29 no.3
• /
• pp.255-262
• /
• 2008

Late Cretaceous to early Tertiary paleostress was evaluated by analyzing the healed microcracks in the Cretaceous granite of the Goheung area, south Korea. Healed microcracks in five granite samples (GH-1, GH-3, GH-4, GH-5, GH-8) were investigated and measured according to direction. The directions of maximum horizontal principal stress in GH-1, GH-3, and GH-4 are dominantly $N60^{\circ}W\;and\;N70^{\circ}E,\;N20^{\circ}W\;and\;N50^{\circ}W$, while minor directions are N-S and $N30^{\circ}E$. In GH-5 and GH-8, $N40^{\circ}E\;and\;N10^{\circ}E$ are the most dominant directions, while $N40^{\circ}W$ is the minor direction. Thus overall, the most dominant directions of healed microcracks in the study area are oriented $N60^{\circ}W$, while minor directions are oriented $N20^{\circ}W,\;N20^{\circ}E\;and\;N70^{\circ}E$, essentially NE. Combining the paleostress results of this study with other studies, the direction of the maximum horizontal principal stress in the study area during the late Cretaceous to the early Tertiary should perhaps be changed WNW to NE. The reason for this is thought to be the complex tectonic movements which occurred in northeast Asia at that time.

• The Journal of Engineering Geology
• /
• v.28 no.4
• /
• pp.645-660
• /
• 2018

In the southeastern part of the Korean Peninsula, huge fault valleys, including the Yangsan and Ulsan faults, are recognized. These NNE-SSW trending lineaments are called as a whole Yangsan Fault System. However, this fault system is relatively poorly studied except the Yangsan and Ulsan faults. This study deduced the paleostress history based on the mutual cross-cutting relationships between geologic structures developed in the granite body near the Ilgwang fault, which is compared with previous studies. In the study area, four lineaments parallel to the Ilgwang fault are recognized, and three of them show evidences of faulting. In each lineament, both slip-senses of left-lateral and right-lateral are recognized. It indicates that these faults consistently underwent multiple deformations of inversion along the faults. The inferred paleostress directions based on the mutual cross-cutting relationships of the geological structures are as follows: 1) Tensile fractures developed in the late Cretaceous under the ENE-WSW direction of compressive stress, 2) NW-SE trending maximum horizontal principal stress generated conjugate strike-slip faults, and 3) selective reactivations of some structures were derived under the compression by the NE-SW trending principal stress.

• The Journal of Engineering Geology
• /
• v.32 no.1
• /
• pp.13-26
• /
• 2022

Calcite twins were analyzed in six oriented samples of the Pungchon limestone, Joseon Supergroup, to reconstruct the paleostress field. The orientations of c-axis of calcite and e twin plane were measured along with the average thickness and numbers of twins, and the widths of calcite grains. Twin strain, mean width, and intensity of twinning, and the relative magnitude and orientations of principal stresses were calculated using Calcite Strain Gauge program. Twin strain, mean width, and intensity of twinning showed ranges of 1.09-15.36%, 0.53-3.72 ㎛ and 21.0-53.1 twim/mm, respectively. Metamorphic temperatures calculated from the twins were 170-200℃, indicating that the twins developed after the Pungchon limestone was uplifted to at least half of the maximum burial depth. Results for five of the samples indicate that the calcite twins formed during two events with principal stress axes of different orientations, while the remaining sample recorded only one event that produced calcite twins. The axis of maximum compressive stress was oriented mainly WNW-ESE to ENE-WSW, and to a lesser degree NW-SE and NE-SW. Comparison of paleostress orientations measured here and in other studies indicates that most twins were produced during the Songrim orogeny. However, the Daebo orogeny and the Bulguksa orogeny also produced calcite twins in the Punchon limestone.