• Proceedings of the KAIS Fall Conference
• /
• 2012.05b
• /
• pp.481-485
• /
• 2012

차량 통신 네트워크(VANET, Vehicular Ad Hoc Network)는 운전자 안전 정보 및 ITS(Intelligent Transp ortation System) 서비스를 지원하기 위해 IEEE 1609.4와 IEEE 802.11p를 활용한다. 그러나 차량 노드들의 숫자가 증가할 경우에는 트래픽 경합 문제(Traffic Contention Problem), 숨은 터미널 문제(Hidden Terminal Problem), 전송 지연 문제, 경합으로 인한 패킷 손실 문제, 처리량 감소 문제, MAC의 동적 채널 할당 방법 등 많은 문제점이 발생한다. 따라서 본 논문에서는 IEEE 1609.4와 IEEE 802.11p 기반 차량 통신 네트워크의 특징을 살펴봄으로써 기존 제안되었던 차량 통신 네트워크를 위한 MAC 및 멀티채널 기술의 특징의 장단점을 분석한다. 또한 분석된 문제점을 해결하기 위한 연구 방향을 제시한다.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.25 no.5
• /
• pp.526-531
• /
• 2014

Vehicular communications have been receiving much attention in intelligent transport systems(ITS) by combining communication technology with automobile industries. In general, vehicular communication can be used for vehicle-to-vehicle(V2V) and vehicle-to-infrastructure( V2I) communication by adopting IEEE802.11p/1609 standard which is commonly known as wireless access in vehicular environment(WAVE). WAVE system transmits signal in 5.835~5.925 GHz frequency band with orthogonal frequency division multiplexing(OFDM) signaling. In this paper, after 32 bit processed the channel monitoring in MAC(Media Access Control) layer of WAVE system implemented according to IEEE 802.11p standard, data were received and we evaluated the performance, we built the test bed consisting of OBU(On Board Unit) in the real expressway. We transmitted WSM(WAVE Short Message) and received WSM between OBU wirelessly. And then, we calculated channel occupancy time per one frame and throughput, and evaluated the performance.

• Journal of Advanced Navigation Technology
• /
• v.13 no.6
• /
• pp.933-942
• /
• 2009

In this paper, the WAVE technology for IT based on Intelligent Transport System(ITS) which using by IEEE 802.11a PHY, IEEE 802.11p MAC(Medium Access Control) and IEEE P1609.3 was implemented. The WAVE system was designed that has maximum 0.5km communication range for RSU(Road Side Equipment) between vehicle, 12Mbps transfer speed when downlink at maximum 120km/h vehicle speed. To verify suitableness of the WAVE system for ITS, we measured several parameters on the real road: communication range when low and high speed, link establishment time, data transfer speed, PER (Percent Error Rate), and latency. From the experiment results, we demonstrated that WAVE is a suitable technology for IT based on ITS.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.15 no.1
• /
• pp.95-101
• /
• 2016

Vehicular communications is system which can be applied for transmission of various safety messages or Intelligent Transportation Systems(ITS) applications by combining vehicle/road technology with Information and Communication Technology(ICT). In recent years, a variety of ITS services are available such as driving information, road conditions, V2X messages as well as navigation and traffic jams notification. In general, vehicular communications can be used for vehicle-to-vehicle and vehicle-to-infrastructure communication by adopting IEEE802.11p/1609 standard which is commonly known as wireless access in vehicular environments. In this paper, WAVE communication standard based on the IEEE802.11p is explained and signal characteristics in WAVE communication is introduced. Also, The H/W and S/W characteristics in Road Side Station and On Board Equipment for the Vehicle to Everything communication are analyzed. Received Signal Strength which is power of receiving signal of communication equipment is measured in test road to estimate the real WAVE communication's performance. It is shown that the implemented WAVE communication technology is satisfactory to provide ITS services.

• Asian-Australasian Journal of Animal Sciences
• /
• v.18 no.11
• /
• pp.1609-1616
• /
• 2005

Ninety advanced Catla catla fingerlings (av. wt. 16 g) were randomly distributed in six treatment groups with three replicates each for an experimental period of 60 days to study the effect of dietary lipid source on growth, enzyme activities and immuno-hematological parameters. Six isoprotein (40.0-41.9%) and isocaloric (4,260 kcal $kg^{-1}$) semi-purified diets were prepared with varying levels of soybean oil (SBO) and cod liver oil (CLO) within a total of 8% lipid viz., $D_1$ (Control), $D_2$ (8% SBO), $D_3$ (6% SBO and 2% CLO), $D_4$ (4% SBO and 4% CLO), $D_5$ (2% SBO and 6% CLO) and $D_6$ (8% CLO). Highest SGR was noted in $D_5$ (0.73${\pm}$0.03) group, which was similar with $D_3$ (0.71${\pm}$0.02) and $D_4$ (0.69${\pm}$0.01) groups. Activity of intestinal lipase, hepatic glucose-6-phosphate dehydrogenase (G6PDH) and aspartate amino transferase (AST) of the lipid treatment groups were significantly higher (p<0.05) than the control group. The respiratory burst activity of the phagocytes (Nitroblue tetrazolium (NBT)) was highest in $D_2$ (1.95${\pm}$0.21) followed by $D_3$ (1.19${\pm}$0.15) group, which were significantly (p<0.05) higher than the other groups. Globulin level was significantly higher in $D_3$ (1.29${\pm}$0.08) than in the other groups expect $D_4$. Hemoglobin content and total erythrocyte count did not show any significant difference. From this study, it is concluded that a diet containing 6% soybean oil and 2% cod liver oil ($D_3$) yields higher growth and immune response in Catla catla fingerlings and would be cost effective.

• Proceedings of the KIEE Conference
• /
• 2011.07a
• /
• pp.1608-1609
• /
• 2011

In this study, in order to develop the evaluation method for XLPE materials for HVDC cables, DC/Impulse superposition testing system was builded up. Throughout the P-spice simulation, optimal values of the protection resistor for the DC generation system and the blocking capacitor for the Impulse generator were calculated. DC/Impulse superposition system showed good result maintaining their proper wave shapes and amplitudes. This system would be planned to apply to the evaluation of XLPE materials for HVDC cables.

• Journal of Environmental Science International
• /
• v.24 no.12
• /
• pp.1609-1616
• /
• 2015

The objective of this study was to make a SBR+MBR complex process to evaluate the possible use of the advanced water treatment system for ships (SBR+MBR complex process) in accordance with the amendments MAPOL 73/78 that went into effect. The conditions 1 and 2 did not show the quick reduction in anaerobic condition while in the precipitation and stirring stages of the SBR treatment which was determined to be ineffective denitrification, same as with the ORP. Removal of organic matters such as $BOD_5$ and $COD_{Cr}$ in the SBR treatment was observed to happen smoothly and going through the MBR treatment as well would provide a stable water quality. However, the results were not satisfactory in accordance with $BOD_5$ 25 mg/L and $COD_{Cr}$ 125 mg/L. Thus, the operating conditions improvement is deemed necessary. Likewise for the nutrients (T-N and T-P), the nitrification in bioreactor, denitrification and phosphorus absorption in aerobic tank due to phosphorus release in anaerobic tank had not been proceeded effectively. It was concluded that the improved operating conditions and structural changes would provide more effective treatments since the removal rates of T-N and T-P were less than 70% and 80%, respectively, which were standards specified by the MEPC. 227(64).

• Journal of Power Electronics
• /
• v.15 no.6
• /
• pp.1609-1618
• /
• 2015

DC microgrids are considered as prospective systems because of their easy connection of distributed energy resources (DERs) and electric vehicles (EVs), reduction of conversion loss between dc output sources and loads, lack of reactive power issues, etc. These features make them very suitable for future industrial and commercial buildings' power systems. In addition, the bipolar-type dc system structure is more popular, because it provides two voltage levels for different power converters and loads. To keep voltage balanced in such a dc system, a bidirectional dual buck-boost voltage balancer with direct coupling is introduced based on P-cell and N-cell concepts. This results in greatly enhanced system reliability thanks to no shoot-through problems and lower switching losses with the help of power MOSFETs. In order to increase system efficiency and reliability, a novel burst-mode control strategy is proposed for the dual buck-boost voltage balancer. The basic operating principle, the current relations, and a small-signal model of the voltage balancer are analyzed under the burst-mode control scheme in detail. Finally, simulation experiments are performed and a laboratory unit with a 5kW unbalanced ability is constructed to verify the viability of the bidirectional dual buck-boost voltage balancer under the proposed burst-mode control scheme in low-voltage bipolar-type dc microgrids.

• Proceedings of the KAIS Fall Conference
• /
• 2011.05a
• /
• pp.428-432
• /
• 2011

차량 통신 네트워크(VANET, Vehicle Ad hoc NETwork)는 ITS(Intelligent Transport System)의 발전과 함께 운전자의 안전 및 교통 정보, 긴급 메시지 등과 같은 서비스를 실시간으로 가능하게 할 수 있는 차세대 네트워크 기술이다. 이러한 차량 통신 네트워크는 현재 IEEE P1609에서 정의하고 있으며, WAVE(Wireless Access Vehicular Environment)로 알려져 있다. WAVE는 차량에 설치된 OBU(Onboard Unit)와 주변시설에 설치된 RSU(Road Side Unit)을 통하여 통신하며, 차량 간 통신을 지원하는 V2V(Vehicle to Vehicle)와 차량과 주변시설과의 통신을 지원하는 V2I(Vehicle to Infrastructure)로 나뉘어져 있다. 하지만 WAVE에서 정의하고 있는 네트워크 서비스(IEEE P1609.4)는 OBU와 RSU 간의 네트워크 서비스에 초점을 맞추고 있기 때문에 전체 네트워크의 QoS를 보장하기에는 미흡한 상태이다. 따라서 본 논문에서는 차량 통신 네트워크에서 End-to-End 간의 QoS 보장을 위한 무선 메쉬 네트워크 기반의 라우팅 알고리즘을 제안한다. 제안하는 알고리즘은 무선 메쉬 네트워크 노드의 호스트 라우터 기능을 통하여 차량 노드와 이기종 간의 네트워크 서비스를 가능하게 하며, 무선 메쉬 네트워크의 다중 채널을 이용하여 데이터의 중요도에 따른 차등 서비스를 지원한다. ns-2를 이용한 시뮬레이션 결과 제안하는 알고리즘이 QoS를 보장함으로써 차량 통신 네트워크의 성능을 향상시킬 수 있음을 입증하였다.

• Journal of Internet Computing and Services
• /
• v.15 no.3
• /
• pp.63-69
• /
• 2014

For the safety messages in IEEE 802.11p vehicles network environment(WAVE), strict periodic beacon broadcasting requires status advertisement to assist the driver for safety. WAVE standards apply multiple radios and multiple channels to provide open public road safety services and improve the comfort and efficiency of driving. Although WAVE standards have been proposed multi-channel multi-radio, the standards neither consider the WAVE multi-radio environment nor its effect on the beacon broadcasting. Most of beacon broadcasting is designed to be delivered on only one physical device and one control channel by the WAVE standard. also conflict-free channel assignment of the fewest channels to a given set of radio nodes without causing collision is NP-hard, even with the knowledge of the network topology and all nodes have the same transmission radio. Based on the latest standard IEEE 802.11p and IEEE 1609.4, this paper proposes an interference aware-based channel assignment algorithm with Nash bargaining solution that minimizes interference and increases throughput with wireless mesh network, which is deigned for multi-radio multi-cahnnel structure of WAVE. The proposed algorithm is validated against numerical simulation results and results show that our proposed algorithm is improvements on 8 channels with 3 radios compared to Tabu and random channel allocation algorithm.