• Journal of Sensor Science and Technology
• /
• v.26 no.2
• /
• pp.85-90
• /
• 2017

A wide dynamic range (WDR) CMOS image sensor (CIS) was developed with a specialized readout architecture for realizing high-sensitivity (HS) and low-sensitivity (LS) reading modes. The proposed pixel is basically a three-transistor (3T) active pixel sensor (APS) structure with an additional transistor. In the developed WDR CIS, only one mode between the HS mode for relatively weak light intensity and the LS mode for the strong light intensity is activated by an external controlling signal, and then the selected signal is read through each column-parallel readout circuit. The LS mode is implemented with the column capacitors and a feedback structure for adjusting column capacitor size. In particular, the feedback circuit makes it possible to change the column node capacitance automatically by using the incident light intensity. As a result, the proposed CIS achieved a wide dynamic range of 94 dB by synthesizing output signals from both modes. The prototype CIS is implemented with $0.18-{\mu}m$ 1-poly 6-metal (1P6M) standard CMOS technology, and the number of effective pixels is 176 (H) ${\times}$ 144 (V).

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.9 no.4
• /
• pp.506-514
• /
• 1998

The design and fabrication of X-band(11.7~12 GHz) 2-stage monolithic microwave integrated circuit(MMIC) low noise amplifier (LNA) for active antenna are presented using $0.15{\mu}m\times140{\mu}m$ AlGaAs/InGaAs/GaAs pseudomorphic high electron mobility transistor (P-HEMT). In each stage of the LNA, a series feedback by using a source inductor is used for both input matching and good stability. The measurement results are achieved as an input return loss under -17 dB, an output return loss under -15dB, a noise figure of 1.3dB, and a gain of 17 dB at X-band. This results almost concur with a design results except noise figure(NF). The chip size of the MMIC LNA is $1.43\times1.27$.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.16 no.6
• /
• pp.825-831
• /
• 2016

In this paper, a transimpedance amplifier based on a new DC offset cancellation (DCOC) method is proposed for WCDMA/LTE applications. The proposed method applies a sample and hold mechanism to the conventional DCOC method with a DC feedback loop. It prevents the removal of information around the DC, so it avoids signal-to-noise ratio degradation. It also reduces area and power consumption. It was designed in a $0.13{\mu}m$ deep n-well CMOS technology and drew a maximum current of 1.58 mA from a 1.2 V supply voltage. It showed a transimpedance gain of $80dB{\Omega}$, an input-referred noise current lower than 0.9 pA/${\surd}$Hz, an out-of-band input-referred 3rd-order intercept point more than 9.5 dBm, and an output DC offset lower than 10 mV. Its area is $0.46mm{\times}0.48mm$.

• Proceedings of the KIEE Conference
• /
• 2008.10b
• /
• pp.231-232
• /
• 2008

본 논문은 협업 필터링(Collaborative Filtering)기반의 추천시스템에 필요한 알고리즘을 제안한다. 제안한 알고리즘은 사용자의 선호도를 Implicit Feedback을 통해 예측하는 Implicit Rating과 사용자 선호도와 컨텐츠의 정보를 바탕으로 사용자의 프로파일을 형성하는 Tag 기반의 사용자 프로파일과 P2P망 내에서 자신과 유사한 사용자 그룹을 형성하는 알고리즘으로 구성되어 있다. 제안한 알고리즘을 적용하여 Web Text 기반의 CF기반의 개인화 추천시스템을 구현하였으며 구현된 프로그램을 실제 사용자에게 배포하여 Feasibility를 검증하였다.

• Journal of the Institute of Convergence Signal Processing
• /
• v.13 no.1
• /
• pp.56-62
• /
• 2012

This paper presents design and implementation of the speed controller for DC motor system using Embeded Target for TI C2000 DSP library in Matlab/Simulink is introduced. Speed controller are easily design and implemented by using the Matlab/Simulink program. Feedback of motor speed is processed through eZdsp F2812 AID converter using encoder and pulse meter as speed sensor. Real-time program of controller is drawn using Simulink and converted program code for speed control of P control, PID control and parameter estimation base adaptive control is downloaded into the TI eZdsp 2812 board. Experiments were carried out to examine validity of speed response for implemented controllers. And even if controlled plant becomes alteration studied controller design and implementation easily method.

• Proceedings of the IEEK Conference
• /
• 1998.10a
• /
• pp.319-322
• /
• 1998

A 20 GHz 2-stage MMIC (Monolithic Microwave Integrated Circuits) LNA(Low Noise Amplifiers) has been designed. The pHEMT with gate length of 1.15 um has been used to provide ultra low noise and high gain amplification. Series and Shunt feedback circuits were interted to ensured high stability over frequency range of DC to 60 GHz. The size of designed MMIC LNA is 2285um x 2000um(4.57mm2). The simulated noise figure of MMIC LNA is less than 1.7 dB over frequency range of 20 GHz to 21 GHz.

• Journal of Advanced Navigation Technology
• /
• v.12 no.6
• /
• pp.604-610
• /
• 2008

A 2.4 GHz CMOS RF front-end using for ZigBee application is described The front-end consists of a low noise amplifier and a down-mixer and uses a 2 MHz IF frequency. A common source with resistive feedback and an inductive degeneration are adopted for a low noise amplifier, and a 20 dB gain control step is digitally controlled. A passive mixer for low current consumption is employed. The RF front-end is implemented in 0.18 ${\mu}m$IP6M CMOS process. The measured performance is 4.44 dB NF and -6.5 dBm IIP3 while consuming 3.28 mA current from a 1.8 V supply.

• Journal of Sensor Science and Technology
• /
• v.21 no.6
• /
• pp.413-419
• /
• 2012

A dynamic range extension technique is proposed based on a 3-transistor active pixel sensor (APS) with gate/body-tied p-channel metal oxide semiconductor field effect transistor (PMOSFET)-type photodetector using a feedback structure. The new APS consists of a pseudo 3-transistor APS and an additional gate/body-tied PMOSFET-type photodetector, and to extend the dynamic range, an NMOSFET switch is proposed. An additional detector and an NMOSFET switch are integrated into the APS to provide negative feedback. The proposed APS and pseudo 3-transistor APS were designed and fabricated using a $0.35-{\mu}m$ 2-poly 4-metal standard complementary metal oxide semiconductor (CMOS) process. Afterwards, their optical responses were measured and characterized. Although the proposed pixel size increased in comparison with the pseudo 3-transistor APS, the proposed pixel had a significantly extended dynamic range of 98 dB compared to a pseudo 3-transistor APS, which had a dynamic range of 28 dB. We present a proposed pixel that can be switched between two operating modes depending on the transfer gate voltage. The proposed pixel can be switched between two operating modes depending on the transfer gate voltage: normal mode and WDR mode. We also present an imaging system using the proposed APS.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.18 no.2 s.117
• /
• pp.177-182
• /
• 2007

This paper presents the InGaP/GaAs HBT differential LC VCO with low phase noise performance for adaptive feedback interference cancellation system(AF-lCS). The VCO is verified with enhanced tank structure including filtering technique. The output tuning range for proposed VCO using asymmetric inductor and symmetric capacitors withlow pass filtering technique is 207 MHz. The output powers are -6.68 including balun and cable loss. The phase noise of this VCO at 10 kHz, 100 kHz and 1 MHz are -102.02 dBc/Hz, -112.04 dBc/Hz and -130.40 dBc/Hz. The VCO is designed within total size of $0.9{\times}0.9mm^2$.

• Korean Medical Education Review
• /
• v.20 no.1
• /
• pp.20-31
• /
• 2018

Good assessment is crucial for feedback on curriculum and to motivate students to learn. This study was conducted to perform item analysis on the Medical Education Assessment Consortium clinical knowledge mock examination (MEAC CKME) (2011-2016) and to evaluate several effects to improve item quality using both classical test theory and item response theory. The estimated difficulty index (P) and discrimination index (D) were calculated according to each course, item type, A (single best answer)/R (extended matching) type, and grading of item quality. The cut-off values used to evaluate P were: >0.8 (easy); 0.6-0.8 (moderate); and <0.6 (difficult). The cut-off value for D was 0.3. The proportion of appropriate items was defined as those with P between 0.25-0.75 and D ${\geq}0.25$. Cronbach ${\alpha}$ was used to assess the reliability and was compared with those of the Korean Medical Licensing Examination (KMLE). The results showed the recent mean difficulty and decimation index was 0.62 and 0.20 for the first MEAC CKME and 0.71 and 0.19 for the second MEAC CKME, respectively. Higher grade items evaluated by a self-checklist system had better D values than lower grade items and higher grade items gradually increased. The preview and editing process by experts revealed maintained P, decreased recall items, increased appropriate items with better D values, and higher reliability. In conclusion, the MEAC CKME (2011-2016) is deemed appropriate as an assessment to evaluate students' competence and prepare year four medical students for the KMLE. In addition, the self-checklist system for writing good items was useful in improving item quality.