• Journal of Environmental Science International
• /
• v.28 no.11
• /
• pp.971-981
• /
• 2019

This study evaluated the photocatalytic oxidation efficiency of volatile organic compounds by $Cu_2O-TiO_2$ under visible-light irradiation. $Cu_2O-TiO_2$ was synthesized by an ultrasonic-assisted method. The XRD result indicated successful p-n type photocatalysts. However, no diffraction peaks belonging to $TiO_2$ were observed for the $Cu_2O-TiO_2$. The Uv-vis spectra result revealed that the synthesized $Cu_2O-TiO_2$ can be activated under visible-light irradiation. The FE-TEM/EDS result showed the formation of synthesized nanocomposites in the commercial P25 $TiO_2$, the undoped $TiO_2$, and $Cu_2O-TiO_2$ and componential analysis in the undoped $TiO_2$ and $Cu_2O-TiO_2$. The photocatalytic oxidation efficiencies of benzene, toluene, ethylbenzene, and o-xylene with $Cu_2O-TiO_2$ were higher than those of P25 $TiO_2$ and undoped $TiO_2$. These results indicate that the prepared $Cu_2O-TiO_2$ photocatalyst can be applied effectively to control gaseous BTEX.

• Journal of the Korean institute of surface engineering
• /
• v.52 no.4
• /
• pp.187-193
• /
• 2019

Electroless Ni-P coatings are widely used in the chemical, mechanical, and electronic industries because of their excellent wear and abrasion resistance. In this study, the effect of $TiO_2$ particles of composite coating was investigated. To improve the corrosion resistance, electroless $Ni-P-TiO_2$composite coating was studied by varying the $TiO_2$ content. The morphology and phase structure of $Ni-P-TiO_2$ composite coatings were analyzed by scanning electron microscopy(SEM), X-ray diffractometry(XRD) and X-ray photoelectron spectroscopy(XPS). The result showed that $Ni-P-TiO_2$composite coating is composed of Ni, P, Ti and O. It exhibits an amorphous structure, high hardness and good corrosion resistance to the substrate. $Ni-P-TiO_2$ composite coatings have higher open circuit potential than that of the substrate, which obtained at $TiO_2$ content of 5.0 g/L optimal integrated properties.

• Journal of the Korean Ceramic Society
• /
• v.23 no.6
• /
• pp.45-51
• /
• 1986

$SrTiO_3$ reaction mechanism formed from $TiCl_4$ and $SrCl_2$ solution by direct-wet-process was studied. Through this study it is identified that crystalline $SrTiO_3$ is formed above pH 13.8 amorphous $SrTiO_3$ above pH7 and crystallization temperature of amorphous $SrTiO_3$ is at 37$0^{\circ}C$. the final products are composed of 60% crystalline $SrTiO_3$ and 40% amorphous $SrTiO_3$ The amorphous $SrTiO_3$ is identified with the IR absorption spectrum of Sr-Ti-O by FT-IR spectrometer. Under pH 7 gelationus metatitanate (H2TiO3) is formed from TiCl4 but above pH7 the activity by the formation of metatitnic acid ion $[TiO_3]^{2-}$ is so high that $SrTiO_3$is formed more easily through the reaction with $Sr^{2+}$.

• Korean Journal of Crystallography
• /
• v.10 no.1
• /
• pp.51-55
• /
• 1999

Cesium titanium(III) pyrophosphate 화합물인 CsTiP2O7을 합성하고 X절 회절법을 이용하여 그 결정구조를 해석하였다. 이물질은 단사정계의 P21/a 공간군으로 결정화되었고 a=8.369(2) , b=10.208(2) , c=7.752(1) , β=104.77(2)o, V=640.4(2) 3, and Z=4이다. 이 물질의 구조는 모서리를 공유하고 있는 TiO6 팔면체와 P2O7 pyrophosphate group들로 구성된 framework로 구성되어 있으며 그 결과로 형성된 tunnel 안에는 Cs+이온이 존재한다. CsTiP2O7은 ATiP2O7(A=K, Rb)와 KAIP2O7 그리고 AMoP2O7(A=K, Rb, Cs)등 다른 +3금속 pyrophosphate들로 유사한 구조를 가지고 있다. 이 물질은 [Cs+][Ti3+][P2O74-]의 식으로 표현할 수 있다.

• Journal of Korean Society of Environmental Engineers
• /
• v.32 no.12
• /
• pp.1147-1153
• /
• 2010

To evaluate the solar photocatalytic degradation efficiency of chloroform in a real solar-light driven compound parabolic concentrators (CPCs) system, $TiO_2$ was irradiated with a metalhalide lamp (1000 W), which has a similar wavelength to sunlight. The results were applied to a pilot scale reactor system by converting the data to a standardized illumination time. In addition, the effects of initial pH and the $TiO_2$ dose on the photocatalytic degradation of chloroform were investigated. The results were compared with the specific surface area (S.S.A) and particle size of $TiO_2$, which changed according to the pH, to determine the relationship between the S.S.A, particle size and the photocatalytic degradation of chloroform. The experiment was carried out at pH 4~7 using 0.1, 0.2, 0.4 g/L of $TiO_2$. The particle size and specific surface area of $TiO_2$ were measured. There was no significant difference between the variables. However, pH affects the particle size distribution and specific surface area of $TiO_2$. Inaddition, the activation of a photocatalyst did not show a linear relationship with the specific surface area of $TiO_2$ in the photocatalytic degradation of chloroform.

• Journal of the Korean Ceramic Society
• /
• v.40 no.2
• /
• pp.178-183
• /
• 2003

Electrical conductivity of$50Li_2O-xTiO_2-(50-x)P_2O_5$ glasses has been studied with an increase of the intermediate$TiO_2$content. Thermal properties were observed from TG-DTA measurement and the variation of glass structure was investigated by FT-IR. The density and glass transition temperature increased with an increase of the $TiO_2$ content. These results were attributed to the fact that bond strengthening was occurred because of the formation of P-O-Ti cross linkages in the glass. The ionic conductivity increased with $TiO_2$ content and a maximum value, $1.2{imes}10^{-6}$S/cm showed at x=20. The ionic conductivity showed a large increasement as a result that the pyrophosphate group become the predominant structural unit. This result can explain that Li ions mobility increased as a number of non-bridging oxygen on phosphate units increased.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.31 no.4
• /
• pp.166-173
• /
• 2021

The rutile phase of TiO₂ forms a stable phase at high temperatures compared to anatase phase, but the stable temperature range of anatase changes depending on the synthesis conditions. In this study, nano-sized TiO₂ was synthesized by the Sol-gel method using TiOSO₄ and a mixed solvent of ethanol and distilled water, and the phase change of anatase and rutile according to pH and heat treatment temperature was investigated. Changes in the ratio of anatase and rutile were observed by changing the pH (3, 5, 7, 9) and heat treatment temperature (500, 600, 700, 800, 900℃) conditions of the prepared TiO₂. As a result of observing these changes through XRD and FE-SEM analysis, anatase TiO₂ at 500℃ and rutile TiO₂ at 900℃ were observed. According to the pH, at these intermediate temperatures of 600, 700 and 800℃, the ratio of anatase and rutile changes. At 700℃, it was concluded that pH = 3~5 had a larger ratio of anatase TiO₂, and pH = 7~9 had a larger ratio of rutile TiO₂.

• Journal of the Korean institute of surface engineering
• /
• v.35 no.6
• /
• pp.383-390
• /
• 2002

To investigate behaviors of Ti and O elements and microstructures of anodic titanium oxide films, the films were prepared by anodizing pure titanium in $H_2$S $O_4$, $H_3$P $O_4$, and $H_2O$$_2$ mixed solution at 180V. The microstructures and chemical states of the elements were analyzed using SEM, X-ray mapping, AFM, XRD, XPS (depth profile). The films formed on a titanium substrate showed porous layers which were composed of pore and wall, And with increasing anodizing time a hexagonal shape of cell structures were dominant and solace roughness increased. From the XRD result the structure of the Ti $O_2$ layer was anatase type of crystal on the whole. In the XPS spectra it was found that Ti and O were chemically binded in forms of Ti $O_2$, TiOH, $Ti_2$ $O_3$ at Ti 2p, and Ti $O_2$, $Ti_2$ $O_3$, $P_2$ $O_{5}$, S $O_4^{2-}$ at O ls respectively. Concentration of Ti $O_2$ decreased as the depth increased from the surface of the oxide film towards the substrate, but to the contrary concentrations of TiOH and $Ti_2$ $O_3$ increased.d.

• Analytical Science and Technology
• /
• v.20 no.4
• /
• pp.302-307
• /
• 2007

The reaction morphology was investigated depending on the amounts of HCl and $NH_4OH$, and the effect of pH was studied on the preparation of $TiO_2$ nanopowders. $TiO_2$ nanopowder was prepared using a titanium tetra-isopropoxide. Subsequently, the effect of pH on the characteristics of the prepared $TiO_2$ nanopowder was evaluated depending on the amounts of the catalysts such as HCl and $NH_4OH$. The morphology and phase transformation of $TiO_2$ powder prepared by hydrolysis of titanium tetra-isopropoxide were strongly influenced by the presence of the catalysts. In the case of using $NH_4OH$, the morphology of the $TiO_2$ powder exhibited powder form. For the HCl catalyst, it showed bulk or granule form. The phase transformations of amorphous $Ti(OH)_4$ to anatase $TiO_2$ and the anatase to rutile was significantly influenced by the kind and amount of thecatalysts.

• Journal of the Korean Applied Science and Technology
• /
• v.34 no.4
• /
• pp.746-755
• /
• 2017

In this study, $CeO_2/TiO_2$ nanoparticle with structure of core and shell was synthesized by growing $TiO_2$ onto the surface of $CeO_2$ according to hydrolysis of $Ti(SO_4)_2$. Reaction time, temperature, concentration of $CeO_2$ slurry, pH control of $Ti(SO_4)_2$ were optimized about synthesis of $CeO_2/TiO_2$ core-shell nanoparticle. It was found that optimal mole ratio range of $CeO_2:TiO_2$ was 1:0.2~1.1, the optimal concentration of $CeO_2$ slurry was 1 %, and the optimal reaction temperature was $50^{\circ}C$. The optimal concentration of $CeO_2$ slurry could be increased up to 10 % by adjusting the pH of $Ti(SO_4)_2$ to 1 using $NH_4OH$ and adding to $CeO_2$ slurry. If reaction was carried at $80^{\circ}C$ or higher, the separated $TiO_2$ particles were obtained instead of $CeO_2/TiO_2$ core-shell nanoparticles. The optimal reaction temperature was $50^{\circ}C$ at which good shaped core-shell structure of $CeO_2/TiO_2$ was obtained.