• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.22 no.3
• /
• pp.269-276
• /
• 2009

Antimony doped tin oxide ($SnO_2:Sb$) films, which are used as the front contact and back reflector of thin film solar cells, have been deposited by d,c, magnetron sputtering. The dependence of electrical and optical properties of the films on the preparation conditions, such as $O_2$ gas ratio, substrate temperature, annealing temperature was investigated. The sputter gas composition was found to affect the properties of the films. With incorporating $O_2$ gas, the electrical and optical properties of films significantly were improved. The minimum resistivity and optical transmittance over 80 % in visible region were obtained at the oxygen concentration of 30 %, When the substrate temperature was higher, the resistivity of $SnO_2:Sb$ films was decreased, while the absorption edge shifted to shorter wavelength, indicating higher optical band gap. Heat treatment over $600^{\circ}C$ resulted in poorer electrical and optical properties due to SnO phase (102) plane.

• Korean Journal of Materials Research
• /
• v.12 no.12
• /
• pp.947-954
• /
• 2002

HCl concentration and reaction time are the decisive factors in determining the structure of precipitates in the process of synthesis of $TiO_2$ particles from aqueous $TiOCl_2$ solution by precipitation and the volumetric proportion of brookite phase in $TiO_2$ particles can be controlled by these two factors. As reaction rate increases with increase of reaction temperature, the reaction time, at which maximum volumetric proportion of brookite phase in $TiO_2$ particles was obtained, was reduced. The brookite was transformed directly to rutile phase with only increase of reaction time. And precipitation was delayed with increase of HCl concentration because the amount of $H_2$O, which is necessary source of oxygen for conversion of $Ti^{+4}$ to $TiO_2$, was relatively reduced with increase of that. Brookite in the mixture phase powder was finally transformed to rutile phase via anatase through heat-treatment.

• Journal of the Korean institute of surface engineering
• /
• v.47 no.4
• /
• pp.181-185
• /
• 2014

We investigated the structural, electrical and optical characteristics of IGZO thin films deposited by a room-temperature RF reactive magnetron sputtering. The thin films deposited were annealed for 2 hours at various temperatures of 300, 400, 500 and $600^{\circ}C$ and analyzed by using X-ray diffractometer, transmission electron microscopy, atomic force microscope and Hall effects measurement system. The films annealed at $600^{\circ}C$ were found to be crystallized and their surface roughness was decreased from 0.73 nm to 0.67 nm. According to XPS measurements, concentration of oxygen vacancies were decreased at $600^{\circ}C$. Optical band gap were increased to 3.31eV. The carrier concentration and Hall mobility were sharply increased at 600oC. Our results indicate that the IGZO films deposited at a room temperature can show better thin film properties through a heat treatment.

• Journal of the Korean Ceramic Society
• /
• v.26 no.6
• /
• pp.811-819
• /
• 1989

There have been many studies on the biological phenomena of Bioglasses, which nay be used as implant materials in human body. However, not many works on the Bioglass compositions have been reported. In the present study, the effect of Al2O3 substitution for SiO2 in Bioglass of Na2O-CaO-P2O5-SiO2 system on its structure and properties was examined. Infrared and Raman spectroscopic studies for the glass structural analysis, differential thermal analysis and X-ray diffraction analysis for crystallization of the glass were perfomed. Several physical properties, such as thermal expansion coefficient, softening point, microhardness and reaction phenomena, were also measured. The major crystalline phase, after heat treatment of the glasses, was Na2Ca2(SiO2)3 and the crystal was transformed into other phase with increased substitution of Al2O3. The added Al2O3 reduced non-bridging oxygen in glass structure and thermal expansion coefficient, but increased glass density, sofening point and microhardness. When the glasses are reacted in Tris-buffer solution, the substituted Al2O3 inhibited the formation of hydroxyapatite on the Bioglas surface, and no hydroxyapatite was formed for the sample which contained more than 6wt.% of Al2O3 even if they were reacted for 600 hours.

• Journal of the Korean Ceramic Society
• /
• v.55 no.4
• /
• pp.358-363
• /
• 2018

To improve the polarization property of cathodes, which is the main factor limiting the performance of protonic ceramic fuel cells (PCFCs), $K_2NiF_4-type$ $Pr_2NiO_{4+{\delta}}$, which is expected to exhibit a triple conducting property (proton, oxygen ion, and hole conductions) was applied to PCFCs and its properties were investigated. Low-temperature microwave heat-treatment was used to achieve both sufficient interface adhesion between the electrolyte and the cathode layers and suppression of the secondary phase formation due to migration of elements such as barium and cerium. Through this fabrication method, a high performance of $0.82W{\cdot}cm^{-2}$ and low ohmic resistance of $0.06{\Omega}{\cdot}cm^2$ were obtained in an $Ni-BaCe_{0.55}Zr_{0.3}Y_{0.15}O_{3-{\delta}}$ | $BaCe_{0.55}Zr_{0.3}Y_{0.15}O_{3-{\delta}}$ | $Pr_2NiO_{4+{\delta}}$ single cell at $650^{\circ}C$. This result verifies that the $K_2NiF_{4+{\delta}}-type$ cathode shows good chemical compatibility which, in turn, will make it a potent candidate as a PCFC cathode.

• Korean Journal of Materials Research
• /
• v.10 no.12
• /
• pp.831-837
• /
• 2000

To improve the catalytic activity of platinum on polymer electrolyte fuel cell(PEFC), platinum was alloyed with cobalt and nickel at various temperature. By XRD, it was observed the crystal structure of alloy catalysts were the ordered face centered cubic(f.c.c) due to the superlattice line at $33^{\circ}$. As heat-treatment temperature was increased, the particle size of alloys also were increased and the crystalline lattice parameters were decreased. According to the results from mass activity, specific activity and Tafel slope measured by cell performance test and cyclic voltammogram, the catalyst activities of alloys are higher than that pure platinum.

• Journal of Aquaculture
• /
• v.8 no.1
• /
• pp.21-29
• /
• 1995

Triploid cherry salmon (Oncorhynchus masou) were induced by the heat shocking treatment of fertilized eggs 10 minutes post fertilization at $28^{\circ}C$ for 15 minutes. Haematological and physiological characteristics of diploid and the induced triploid fish were examined just before the spawning period. Triploids had significantly lower concentrations of circulating red blood cells than that of diploids (P<0.01). However, oxygen consumption, hematocrit, hemoglobin, RBC, and mean concentration of hemoglobin within the RBC of triploids were higher than those of diploids. The concentrations of total protein, albumin and cholesterol from triploids were also higher than those from diploids.

• Journal of the Korean Institute of Oriental Medical Informatics
• /
• v.13 no.1
• /
• pp.26-38
• /
• 2007

Interstitial lung disease (ILD) is characterized by progressive scarring of the lung leading to restriction and diminished oxygen transfer. Clinically, the presenting symptoms of ILD are nonspecific (cough and progressive dyspnea on exertion) and are often attributed to other diseases, thus delaying diagnosis and timely therapy. In this study, I analyzed the 10 chinese papers of interstitial lung diseases(ILD). The etiology are body resistance weakness(本虛) and pathogenic factor prevailing(標實). The body resistance weakness(本虛) including deficiency of the lung(肺虛), deficiency of the kidney(腎虛), deficiency of the spleen(脾虛), deficiency of Qi and Yin(氣陰兩虛), pathogenic factor prevailing(標實) including stagnation of phlegm(痰濁), blood stasis(瘀血), noxious heat(熱毒). As an treatment aim at supplementing lung and kidney(益肺腎), resolving phlegm and blood stasis(化痰瘀).

• Journal of Microbiology
• /
• v.33 no.3
• /
• pp.239-243
• /
• 1995

Deinococcus radiophilus, an UV resistant bacterium seemed to contain three issoenzymes of catalase. Among them, the samllest and most abundant species in cell-free extract, catalase-3 which also exhibited peroxidase activity was purified to electrophoretic homogeneity (145-fold purification) by chromatographic procedures. Its molecular weight was 155 kDa composed of four 38 kDa subunits. The $K_{m}$ value of catalase-3 for H$\_$2/O$\_$2/ was approximately 0.5 mM. This enzyme showed a typical ferric heme spectrum with maximum absorption at 405 nm. Upon binding to cyanide, the 405 nm peak shifted to 420 nm. Catalase-3 was very sensitive to inhibitors of heme proteins, such as cyanide, azide and hydroxylamine. A ratio of A$\_$405/A$\_$28O/ was 0.5 Catalase-3 was active over a wide range of pH, between pH 7 and 10. The enzyme was rather heat-labile and partially sensitive to edthanol-chloroform treatment, but resistant to 3-amino-1, 2, 4-triazole. Catalase-3 of D. radiophilus, which is a bifunction catalatic peroxidatic enzyme seemed to share certain molecular properties with the typical catalase and the catalase-[roxidase along with its own unique features.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.35 no.6
• /
• pp.622-625
• /
• 2022

YBa₂Cu₃O_7-y bulk as a high temperature oxide superconducting conductor has the high critical temperature of 92 K. YBa₂Cu₃O_7-y bulk superconductors have been fabricated by a seeded melting growth. Magnetic properties were studied by using superconductor of melted YBa₂Cu₃O_7-y oxides. It was demonstrated that Y₂BaCuO₅ particles acts as a pinning center which plays an important role on the magnetic properties. The thickness of the upper and lower pellets of the YBa₂Cu₃O_7-y bulk was formed at 40 mm with 55 g of the composition, and the YBa₂Cu₃O_7-y superconductor was manufactured through a heat treatment process. Manufacturing the superconducting bulk, it is possible to improve the pore density of the superconducting bulk by providing a path through which oxygen could be emitted.