• Journal of Environmental Health Sciences
• /
• v.28 no.1
• /
• pp.51-65
• /
• 2002

This study was carried out to apply some basic physical and chemical treatment options including Fenton's oxidation, and to evaluate the performances and the characteristics of organic and nitrogen removal using lab-scale biological treatment system such as complete-mixing activated sludge and sequencing batch reactor(SBR) processes for the treatment of leachate from a municipal waste landfill in Gyeongnam province. The results were as follows: Chemical coagulation experiments using aluminium sulfate, ferrous sulfate and ferric chloride resulted in leachate CO $D_{Cr}$ removal of 32%, 23% and 21 % with optimum reaction dose ranges of 10,000～15,000 mg/$\ell$, 1,000 mg/$\ell$ and 500～2,000 mg/$\ell$, respectively. Fenton's oxidation required the optimum conditions including pH 3.5, 6 hours of reaction time, and hydrogen peroxide and ferrous sulfate concentrations of 2,000 ～ 3,000 mg/$\ell$ each with 1:1 weight ratio to remove more than 50% of COD in the leachate containing CO $D_{Cr}$ between 2,000 ～ 3,000 mg/$\ell$. Air-stripping achieved to remove more than 97% of N $H_3$-N in the leachate in spite of requiring high cost of chemicals and extensive stripping time, and, however, zeolite treatment removing 94% of N $H_3$-N showed high selectivity to N $H^{+}$ ion and much faster removal rate than air-stripping. The result from lab-scale experiment using a complete-mixing activated sludge process showed that biological treatability tended to increase more or less as HRT increased or F/M ratio decreased, and, however, COD removal efficiency was very poor by showing only 36% at HRT of 29 days. While COD removal was achieved more during Fenton's oxidation as compared to alum treatment for the landfill leachate, the ratio of BOD/COD after Fenton's oxidation considerably increased, and the consecutive activated sludge process significantly reduced organic strength to remove 50% of CO $D_{Cr}$ and 95% of BO $D_{5}$ . The SBR process was generally more capable of removing organics and nitrogen in the leachate than complete-mixing activated sludge process to achieve 74% removal of influent CO $D_{Cr}$ , 98% of BO $D_{5}$ and especially 99% of N $H_3$-N. However, organic removal rates of the SBR processes pre-treated with air-stripping and with zeolite were not much different with those without pre-treatment, and the SBR process treated with powdered activated carbon showed a little higher rate of CO $D_{Cr}$ removal than the process without any treatment. In conclusion, the biological treatment process using SBR proved to be the most applicable for the treatment of organic contents and nitrogen simultaneously and effectively in the landfill leachate.e.

• Journal of the Korean Chemical Society
• /
• v.35 no.6
• /
• pp.689-698
• /
• 1991

Activated oxidation catalysts are generated by the treatment of pentadentate Schiff base cobalt(Ⅱ) complexes with the oxygen saturated DMF solution. Oxidation of 2,6-di-tert-butylphenol by homogeneous oxidation catalysts of superoxo type pentadentate schiff base cobalt(Ⅲ) complexes yields 2,6-di-tert-butylbenzoquinone(BQ) as a major product. And $O_2$/Co mole ratio of homogeneous oxidative catalysts such as [Co(Ⅲ)(sal-DET)]$O_2$ and [Co(Ⅲ)(sal-DPT)]$O_2$by PVT method of the oxygen absorption in DMSO and pyridine solution was 1:1, 1:1.52 in DMF solution and ${\mu}$-peroxo type cobalt(Ⅲ) complexes formed at solid state. The redox reaction processes of superoxo type cobalt(Ⅲ) complexes as homogeneous oxidation catalysts were investigated by cyclic voltammetry and DPP method at a glassy carbon electrode. As a result of electrochemical measurements the reduction processes of oxygen adducted superoxo type cobalt(Ⅲ) complexes occurred to four steps including prewave of $O_2$-in 0.1M TEAP-DMSO and 0.1 M TEAP-Pyridine as supporting electrolyte solution.

• Applied Chemistry for Engineering
• /
• v.25 no.4
• /
• pp.418-424
• /
• 2014

The improved thermal stability and anti-oxidation properties of Lyocell fiber were studied based on flame retardant treatment by using NaCl/$H_3PO_4$ solution. The optimized conditions of flame retardant treatment were studied on various maxing ratio of NaCl and $H_3PO_4$ and the mechanism was proposed through experimental results of thermal stability anti-oxidation. The IPDT (integral procedural decomposition temperature), LOI (limited oxygen index) and $E_a$ (activation energy) increased 23, 30 and 24% respectively via flame retardant treatment. It is noted that thermal stability and anti-oxidation improved based on char and carbon layer formation by dehydrogenation and dissociation of C-C bond resulting the hindrance of oxygen and heat energy into polymer resin. The optimized conditions for efficient flame retardant property of Lyocell fiber were provided using NaCl/$H_3PO_4$ solution and the mechanism was also studied based on experimental results such as IDT (initial decomposition temperature), IPDT, LOI and $E_a$.

• Applied Chemistry for Engineering
• /
• v.17 no.1
• /
• pp.22-27
• /
• 2006

Thermal treatment and ozone oxidation methods were examined to reuse waste activated sludge (WAS) produced from a livestock wastewater treatment plant. Analysis of WAS property was made to study usefulness of the recycled waste as fertilizer. From the results of quantitative analysis, WAS particles were found to be composed of 44.25 wt% carbon, 8.43 wt% nitrogen, and 1.35 wt% phosphorus. It was confirmed that the inactivation of pathogenic microorganism was required from the quantitative analysis of microbes. From the results of TSS, COD, SCOD, and pathogenic microorganism measurement, the optimal operating conditions of thermal treatment and ozone oxidation were determined to be 70, 10 min and $0.6L\;O_3/L\;solution{\cdot}min$, 60 min, respectively. The optimized thermal treatment and ozone oxidation represented the efficient pathogen inactivation and particle dissolution, respectively. However, the two methods examined were not themselves sufficient but they need to combine with another treatment for the effective reuse of wastes.

• Fire Science and Engineering
• /
• v.29 no.2
• /
• pp.25-32
• /
• 2015

The improved thermal stability and anti-oxidation properties of lyocell fiber were studied based on flame retardant treatment by using $Na_3PO_4$ solution. The optimized conditions of flame retardant treatment were studied on various concentrations of $Na_3PO_4$ and the mechanism was proposed through experimental results of thermal stability and anti-oxidation. The integral procedural decomposition temperature (IPDT), limiting oxygen index (LOI) and activation energy ($E_a$) increased 30, 160% respectively via flame retardant treatment. It is noted that thermal stability and anti-oxidation improved based on char and carbon layer formation by dehydrogenation and dissociation of C-C bond resulting the hindrance of oxygen and heat energy into polymer resin. The optimized conditions for efficient flame retardant property of lyocell fiber were provided using $Na_3PO_4$ solution and the mechanism was also studied based on experimental results such as initial decomposition temperature (IDT), IPDT, LOI and $E_a$.

• Journal of Korean Society of Environmental Engineers
• /
• v.38 no.9
• /
• pp.521-527
• /
• 2016

Nanoscale zero valent iron (nZVI) has been intensively studied for the treatment of a plethora of pollutants through reductive reaction, however, the nano size should be of concern when nZVI is considered for water treatment, due to difficulties in recovery. The loss of nZVI causes not only economical loss, but also potential risk to human health and environment. Thus, the immobilization onto coarse or structured support is essential. In this study, two representative processes for nZVI immobilization on granular activated carbon (GAC) were evaluated, and optimized conditions for synthesizing Fe/GAC composite were suggested. Both total iron content and $Fe_0$ content can be significantly affected by preparation processes, therefore, it was important to avoid oxidation during preparation to achieve higher reduction capacity. Synthesis conditions such as reduction time and existence of intermediate drying step were investigated to improve $Fe_0$ content of Fe/GAC composites. The optimal condition was two hours of $NaBH_4$ reduction without intermediate drying process. The prepared Fe/GAC composite showed synergistic effect of the adsorption capability of the GAC and the degradation capability of the nZVI, which make this composite a very effective material for environmental remediation.

• Applied Chemistry for Engineering
• /
• v.16 no.2
• /
• pp.257-261
• /
• 2005

The microbial cellulose is in a form of three dimensional net structures that consists of 20~50 nm fibrils. It possesses high crystallinity and orientation. It is difficult to synthesize large amount of fibrous carbon nanomaterials by the carbonization process using raw materials such as polyacrylonitrile (PAN), regenerated cellulose (Rayon) and pitch. However, it seems possible thru the application of microbial cellulose as raw material. The application of such cellulose can be further extended to the synthesis of highly oriented graphite fiber. Out of three different cellulose-producing strains, G. xylinus ATCC11142 was chosen as it has the highest productivity (0.066 g dried cellulose/15 mL medium). Tar is often produced during the carbonization of cellulose that limits the formation fibrous structure of the carbonized sample. In order to solve such a problem, pre-studied purification methods of carbon nanotube such as liquid phase oxidation, gas phase oxidation and filtration associated with ultrasonication were applied at the carbonized cellulose. In that case. only by filtration associated with ultrasonication, improved the formation of fiber structure of the carbonized cellulose.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.28 no.5
• /
• pp.436-442
• /
• 2008

Graphite material has been recognized as a very competitive candidate for reflector, moderator, and structural material for very high temperature reactor (VHTR). Since VHTR is operated up to $900-950^{\circ}C$, small amount of impurity may accelerate the oxidation and degradation of carbon graphite, which results in increased porosity and lowered fracture toughness. In this study, ultrasonic wave propagation properties were investigated for both as-received and degradated material, and the feasibility of ultrasonic testing (UT) was estimated based on the result of ultrasonic property measurements. The ultrasonic properties of carbon graphite were half, more than 5 times, and 1/3 for velocity, attenuation, and signal-to-noise (S/N) ratio respectively. Degradation reduces the ultrasonic velocity slightly by 100 m/s, however the attenuation is about 2 times of as-receive state. The results of probability of detection (POD) estimation based on S/N ratio for side-drilled-hole (SDHs) of which depths were less than 100 mm were merely affected by oxidation and degradation. This result suggests that UT would be reliable method for nondestructive testing of carbon graphite material of which thickness is not over 100 mm. In accordance with the result produced by commercial automated ultrasonic testing (AUT) system, human error of ultrasonic testing is barely expected for the material of which thickness is not over 80 mm.

• Journal of the Korean Chemical Society
• /
• v.42 no.1
• /
• pp.122-134
• /
• 1998

In this review, we describe the electrochemical properties of spinel-type lithium manganese oxides $(Li_xMn_2O_4)$ and their failure modes encountered in 4 V lithium rechargable cells. The long-term cyclability (reversibility) of spinel electrodes is determined partly by the purity, size and distribution of spinel particles, and also by the microstructure of electrode plates. A proper selection of electrolytes is another important task in cyclability enhancements. In the spinel preparation, impurity formation and cation mixing should be minimized. The carbon content in composite cathodes should also be minimized to the extent where the cell polarization does not bring about adverse effects on cell performances. The binder content should be optimized on the basis of dispersion of component materials and mechanical strength of the plates. Cathodic capacity losses arising from solvent oxidation and spinel dissolution can be mitigated by using electrolytes composed of carbonates and/or fluorine-containing lithium salts. The carbon additives may be selected after a trade-off between the cell polarization in composite cathodes and the solvent oxidation on carbon surface.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.24 no.5
• /
• pp.553-568
• /
• 2018

Chromophoric Dissolved Organic Matter (CDOM) plays a dominant role in absorbing UV-VIS light and is also important in the biogeochemical carbon cycle due to the production of carbon dioxide from photo-oxidation at the sea surface in marine environments. Since absorption by CDOM was recently found to be responsible for increasing the energy absorbed in the mixed layer by 40 % over pure seawater, the importance of CDOM absorption in seawater for increasing sea surface temperature has come to be well recognized. We measured aCDOM and the absorption characteristics of CDOM during spring 2012 and 2014 in the southwestern East Sea. Distribution of CDOM in spring 2012 and 2014 was compared and S value was used to find the source of CDOM in the study area. As a result, the average $a_{CDOM}$ was $0.237m^{-1}$ ($0.009{\sim}0.988m^{-1}$) and the average S value was $16{\mu}m^{-1}$,which shows coastal properties. Also a positive correlation between Chl a and CDOM was observed ($r^2=0.34$), with an especially strong correlation near coastal stations. aCDOM in 2014 was about 40 % higher than aCDOM in 2012 during spring in the study area. This difference in aCDOM concentration resulted not only from annual variation but also from stratification and photobleaching in late spring 2012. This observation implies the possibility of flux of carbon dioxide into the atmosphere as a result of photo-oxidation in the East Sea.