• Journal of Korean Academy of Nursing Administration
• /
• v.9 no.2
• /
• pp.217-232
• /
• 2003

Purpose : This paper was attempted to identify the job stress related factors among the staff nurses and to provide the basic data concerning development of stress management program focused on hospitals. Method : The subjects were 309 staff nurses at two general hospitals in Seoul. Data were collected with self-reported questionnaires and analyzed by SPSS-PC+10.0 for descriptive analysis, ANOVA, stepwise multiple regression, factor analysis. Results : The subjects exhibit significantly highest level of 'the participation in decision making factor'. The mean score of 'control coping strategies' was higher than 'avoid coping strategies'. The mean scores of social support and stress responses were high. The main factor that affected the stress responses was 'the job characteristic factor' and it was explained 23.0% out of the total variance of the stress responses. Also, it would be explained 42.6% out of the total variance of the stress responses with 'the control coping strategies, work overload factors, social support, and participation in decision making factors'. Conclusion: For developing the hospital- focused stress management program for staff nurses, 'the participation in decision making factors' and 'the job characteristics' should be considered. Also, the organizational efforts and supports should be required to support and use of 'control coping strategies' of nurses

• Journal of Korea Multimedia Society
• /
• v.9 no.7
• /
• pp.844-853
• /
• 2006

The IEEE 802.17 Resilient Packet Ring (RPR) for future Local, Metropolitan, and Wide Area Networks was recently standardized, but it still suffer from delay jitter deterioration and even some bandwidth loss under unbalanced overload. In order to overcome these drawbacks, this paper proposes a bandwidth redistribution based fairness control method, compatible with the legacy one, in which each congested node measures the amount of available bandwidth of its bottleneck link resulted from regulating upstream nodes' shares of the link bandwidth, calculates optimal fair rate with the number of uptream nodes requiring more bandwidth, and then redistributes the available bandwidth to the upstream nodes by advertising the rate. The performance evaluation results show that the proposed method fairly redistributes 95% of the bottleneck link bandwidth with even only two redistributions.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.19 no.5
• /
• pp.1176-1181
• /
• 1995

Microdrilling is one of the most difficult operations because of the poor chip discharge and the weakness of tool. This study is concerned about the development of a microdrilling monitoring system that is useful for minimizing the tool breakage and enhancing the machinability in the air spindle based microdrilling. The system is composed of a drilling state detection unit and an adaptive step-feed control unit that controls the micro-stepping motor driven spindle axis. Drilling states such as overload, tood breakage are recognized by the change of the air spindle speed which is measured via the reflective photo sensor. Based on the monitoring results, the adaptive step-feed control algorithm adjusts the step increment to keep the decrease of spindle speed within a specified range. The results of evaluation tests have shown that the developed system is very effective to prevent the breakage of microdrill and improves the productivity in comparison with the conventional microdrilling.

• Fisheries and Aquatic Sciences
• /
• v.7 no.1
• /
• pp.23-28
• /
• 2004

Olive flounder (Paralichthys olivaceus) was exposed to waterborne iron (0.1, 0.5, 1, 5 and 10 mg/L) for 50 days. The effects of iron on blood iron status and iron binding capacity were studied. The serum iron concentration was significantly higher than in the group exposed to iron (1, 5 and 10 mg/L) in comparison to the control after 30 days of exposure to iron. A significant decrease in unsaturated iron binding capacity was found between the control and the group exposed to iron (5 and 10 mg/L, respectively) at 40 and 50 days, respectively. The total iron binding capacity of serum in the fish exposed to iron concentrations (5 and 10 mg/L) showed a significant decrease compared to that of the control at 40 days after iron exposure. Serum iron saturation values increased in the flounder exposed to iron concentration (5 and 10 mg/L) at 50 days. Our data suggest that sub-lethal exposure of waterborne iron alters the blood iron concentration and iron binding capacity, and these parameters seems to be valuable factors for screening and diagnosis of iron overload syndromes in fish.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.64 no.8
• /
• pp.1161-1167
• /
• 2015

Distribution Management System(DMS) ienhancing distribution automation system-based operation efficiency is an optimized system by various operational applications in a distribution network. DMS employs various applications like topology reconfiguration, volt/var control, and restoration at events such as overload, voltage violation, and a fault in a distribution system. An operation efficiency to employ multi-applications as restoration with short-term load forecasting is higher than a performance by a single application; and the applications are accomplished by an operator’s control. Applications’ combination is determined by various alarm information which means critical issues in order to operate a distribution system. Thus, this paper proposes an application management system which can configure application combination, control applications depending on alarm information and check their performance condition. The proposed application management system can be customized by operator easily and have high operation efficiency and reliability because it is worked by reviewed alarm information from operator.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.10 no.2
• /
• pp.289-296
• /
• 2015

Wireless multimedia sensor network senses and transfers mass multimedia data. Also, it is sensitive to latency. This thesis proposes a routing technique based on traffic priority in order to improve the network efficiency by minimizing latency. In addition, it proposes a congestion control mechanism that uses packet service time, packet inter-arrival time, buffer usage, etc. In this thesis, we verified the reduction of packet latency in accordance with the quality level of packet as a result of the performance analysis through the simulation method. Also, we verified that the proposed mechanism maintained a reliable network state by preventing packet loss due to network overload.

• The KIPS Transactions:PartA
• /
• v.16A no.6
• /
• pp.481-488
• /
• 2009

GIS is used to isolate large power electrical equipment using SF6 gas. While GIS has simple structure, it has few break down, relatively high reliability. But it is hard to check up faults for reason of pressure. Faults of GIS should have a ripple effect on community and be hard to recovery. Consequently, GIS imports a preventive diagnostic system to find internal faults in advance. It is most important that reliability on the GIS preventive diagnostic system, because it estimates abnormality of system by analysis result of collected data. But, exist system which used central data management is low efficiency, and hard to guarantee timeliness and accuracy of data. To guarantee timeliness and accuracy, the GIS preventive diagnostic system needs accordingly to use a real-time middleware. So, in this paper, to improve reliability of the GIS preventive diagnostic system, we use a middleware based on TMO for guaranteeing timeliness of real-time distributed computing. And we propose an improved GIS preventive diagnostic system applying data acquisition, monitoring and control methods based on the TMO model. The presented system uses the Communication Control Unit(CCU) for distributed data handling which is supported by TMO. CCU can improve performance of the GIS preventive diagnostic system by guaranteeing timeliness of data handling process and increasing reliability of data through the TMO middleware. And, it has designed to take full charge of overload on a data acquisition task had been processed in an exist server. So, it could reduce overload of the server and apply distribution environment from now. Therefore, the proposed system can improve performance and reliability of the GIS preventive diagnostic system and contribute to stable operation of GIS.

• Journal of Internet Computing and Services
• /
• v.3 no.3
• /
• pp.67-74
• /
• 2002

Asynchronous transfer mode (ATM) can be efficiently used to transport packet data services. The switching system will support voice and packet data services simultaneously from end to end applications. To guarantee quality of service (QoS) of the offered services, source rate to send packet data is needed to control the network overload condition. Most existing control algorithms are shown to provide the threshold-based feedback control technique. However, real-time voice calls can be dynamically connected and released during data services in the network. If the feedback control information delays, quality of the serviced voice can be degraded due to a time delay between source and destination in the high speed link, An adaptive algorithm based on the optimal least mean square error technique is presented for the predictive feedback control technique. The algorithm attempts to predict a future buffer size from weight (slope) adaptation of unknown functions, which are used for feedback control. Simulation results are presented, which show the effectiveness of the algorithm.

• The Transactions of the Korea Information Processing Society
• /
• v.7 no.4
• /
• pp.1211-1216
• /
• 2000

Asynchronous transfer mode (ATM) can be efficiently used to transport packet data services. The switching system will support voice and packet data services simultaneously from end to end applications. To guarantee quality of service (QoS) of the offered services, source rateot send packet data is needed to control the network overload condition. Most existing control algorithms are shown to provide the threshold-based feedback control technique. However, real-time voice calls can be dynamically connected and released during data services in the network. If the feedback control information delays, quality of the serviced voice can be degraded due to a time delay between source and destination in the high speed link. An adaptive algorithm based on the optimal least mean square error technique is presented for the predictive feedback control technique. The algorithm attempts to predict a future buffer size from weight (slope) adaptation of unknown functions, which are used fro feedback control. Simulation results are presented, which show the effectiveness of the algorithm.

• 제어로봇시스템학회:학술대회논문집
• /
• 2004.08a
• /
• pp.1291-1295
• /
• 2004

This paper proposed a new approach for endpoint detection of isolated speech, which proves to significantly improve the endpoint detection performance. The proposed algorithm relies on the root mean square energy (rms energy), zero crossing rate and spectral characteristics of the speech signal where the Euclidean distance measure is adopted using cepstral coefficients to accurately detect the endpoint of isolated speech. The algorithm offers better performance than traditional energy-based algorithm. The vocabulary for the experiment includes English digit from one to nine. These experimental results were conducted by 360 utterances from a male speaker. Experimental results show that the accuracy of the algorithm is quite acceptable. Moreover, the computation overload of this algorithm is low since the cepstral coefficients parameters will be used in feature extraction later of speech recognition procedure.