• Journal of Aquaculture
• /
• v.16 no.1
• /
• pp.37-43
• /
• 2003

The present study reports morphology and developmental pattern off siliquosa cultured in a laboratory condition. The zygote was spherical with a diameter of 85 ${\mu}{\textrm}{m}$. During development the polarized zygote divided horizontally and the lower daughter cell divided horizontally into 2 cells. The upper cell was divided repeatedly in horizontal and vertical directions to form a cylinder-like structure, which subsequently developed into secondary and tertiary dichotomous branches. Optimum temperature for zygote release and fertilization was 25C. Injury inflicted by slicing was cured by epidermal differentiation, and adventitious branches; the branches emerging from the pith cells, however, developed no rhizoid. Adventitious branch formation rate was over 88% in all plates supplemented with 0.5 mg/L IAA and peaked at 98% under 0.5 mg/L IAA plus 0.5-5.0 mg/L NAA treatment. NAA stimulated the differentiation of adventitious branches at a wide range of concentrations, while IAA, 2,4-D and kinetin exhibited dose-dependent stimulation.

• Structural Engineering and Mechanics
• /
• v.60 no.2
• /
• pp.301-312
• /
• 2016

In a concrete member under pure tension, the stress in concrete is uniformly distributed over the whole concrete section. It is supposed that a local bond failure occurs at each crack, and there is a relative slip between steel and surrounding concrete. The compatibility of deformation between the concrete and reinforcement is thus not maintained. The bond transfer length is a length of reinforcement adjacent to the crack where the compatibility of strain between the steel and concrete is not maintained because of partially bond breakdown and slip. It is an empirical measure of the bond characteristics of the reinforcement, incorporating bar diameter and surface characteristics such as texture. Based on results from a series of previously conducted long-term tests on eight restrained reinforced concrete slab specimens and material properties including creep and shrinkage of two concrete batches, the ratio of final bond transfer length after all shrinkage cracking, to THE initial bond transfer length is presented.

• Korean Journal of Veterinary Service
• /
• v.40 no.2
• /
• pp.139-142
• /
• 2017

A six-year-old male captive nutria (Myocastor coypus) maintained in a closed space with a small vent was found dead in his cage. Gross findings showed multifocal nodules in varying sizes, small 0.5 to large 5 cm in diameter, intermixed with normal parenchyma were scattered all over the surface of the lungs and a kidney, which the cut surface was smooth, compact and whitish in color. Microscopically, small round to oval neoplastic cells with modest to slight amounts of cytoplasm formed acinar and gland-like structures. Immunohistochemically, cells were strongly positive for E-cadherin and slightly reactive for thyroid transcription factor-1 (TTF-1). Based on those diagnostic features, the neoplasia was diagnosed as primary pulmonary adenocarcinoma (small cell type) and metastasized into the kidney. This is the first case report of malignant pulmonary tumor and its metastasis in the nutria.

• Animal cells and systems
• /
• v.4 no.1
• /
• pp.9-21
• /
• 2000

A taxonomic and floristic account for Korean Elachista is provided. All previously reported taxa from Korea are reappraised. Elachista in Korea consists of five species: E. falcata Lee sp. nov., E. nipponica Umezaki, E. okamurae Yoshida, E. orbicularis (Ohta) Skiner, and E. tenuis Yamada. Elachista fucicola (Vell.) Aresch. 1. typica Rosenvinge sensu Kang (1966) that was previously recorded in Korean flora was assigned to another taxon, E. okamurae Yoshida. Elachista taeniaeformis Yamada is transferred to the new genus, Proselachista Lee et Garbary. Elachista falcata is characterized by having a pseudoparenchymatous medulla, assimilatory filaments with equal diameter over their entire length and small projections on the lower portion, falcate paraphyses, and gourd-shaped unilocular sporangia.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.21 no.1
• /
• pp.1-8
• /
• 2017

Three small scale hollow circular reinforced concrete columns with aspect ratio 4.5 were tested under cyclic lateral load with constant axial load. Diameter of section is 400 mm, hollow diameter is 200 mm. The selected test variable is transverse steel ratio. Volumetric ratios of spirals of all the columns are 0.302~0.604% in the plastic hinge region. It corresponds to 45.9~91.8% of the minimum requirement of confining steel by Korean Bridge Design Specifications, which represent existing columns not designed by the current seismic design specifications or designed by seismic concept. The longitudinal steel ratio is 2.017%. The axial load ratio is 7%. This paper describes mainly crack behavior, load-displacement hysteresis loop, seismic performance such as equivalent damping ratio, residual displacement and effective stiffness and flexural over-strength of circular reinforced concrete bridge columns with respect to test variable. The regulation of flexural over-strength is adopted by Korea Bridge Design Specifications (Limited state design, 2012). The test results are compared with nominal strength, result of nonlinear moment-curvature analysis and the design specifications such as AASHTO LRFD and Korea Bridge Design Specifications(Limited state design).

• Journal of the Korean Mathematical Society
• /
• v.45 no.6
• /
• pp.1647-1659
• /
• 2008

Let R be a ring with identity, X the set of all nonzero, nonunits of R and G the group of all units of R. First, we investigate some connected conditions of the zero-divisor graph $\Gamma(R)$ of a noncommutative ring R as follows: (1) if $\Gamma(R)$ has no sources and no sinks, then $\Gamma(R)$ is connected and diameter of $\Gamma(R)$, denoted by diam($\Gamma(R)$) (resp. girth of $\Gamma(R)$, denoted by g($\Gamma(R)$)) is equal to or less than 3; (2) if X is a union of finite number of orbits under the left (resp. right) regular action on X by G, then $\Gamma(R)$ is connected and diam($\Gamma(R)$) (resp. g($\Gamma(R)$)) is equal to or less than 3, in addition, if R is local, then there is a vertex of $\Gamma(R)$ which is adjacent to every other vertices in $\Gamma(R)$; (3) if R is unit-regular, then $\Gamma(R)$ is connected and diam($\Gamma(R)$) (resp. g($\Gamma(R)$)) is equal to or less than 3. Next, we investigate the graph automorphisms group of $\Gamma(Mat_2(\mathbb{Z}_p))$ where $Mat_2(\mathbb{Z}_p)$ is the ring of 2 by 2 matrices over the galois field $\mathbb{Z}_p$ (p is any prime).

• The Korean Journal of Ecology
• /
• v.26 no.2
• /
• pp.71-74
• /
• 2003

Effects of nitrogen addition on the growth of Indigofera pseudo-tinctoria (Leguminosae) in the waste landfill site was investigated. Nitrogen fertilization in the nitrogen poor soils of waste landfill may influence the growth of nitrogen fixing plants beneficially or detrimentally. When I. pseudo-tinctoria was fertilized with three different levels of nitrogen, the coverage of plants treated with 46 g N/$m^2$ and 460 g N/$m^2$ was significantly less than that of plants treated with 23 g N/$m^2$. The growth rates of plant height treated with 46 g N/$m^2$ and 460 g N/$m^2$ were significantly less than those of plants treated with 23 g N/$m^2$. The growth rates of plant diameter treated with 46 g N/$m^2$ and 460 g N/$m^2$ were significantly less than those of plants treated with 23 g N/$m^2$. Dry weights of whole plants in control sites were higher than those of all the others nitrogen treatment sites. Nodule numbers were higher in control plants than those of plants in all the other nitrogen treatment sites. It is suggested that nitrogen fertilizer addition over 23 g N/$m^2$ affect the growth of some nitrogen fixing plants, such as I. pseudo-tinctoria, negatively.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.21 no.6
• /
• pp.67-73
• /
• 2017

Recently, the demand for large diameter piles has been rapidly increased in order to secure the allowable bearing capacity of pile foundation due to the increase of large structures such as high rise buildings. In this study, to improve the shear capacity of a conventional PHC pile, a large diameter composite PHC pile strengthened by in-filled concrete and shear reinforcement was manufactured. All the piles were tested according to the shear strength test method of Korean Standard. As a result of the shear test, the F-type piles which are produced without shear reinforcement occurred abrupt horizontal cracks after flexural and inclined shear cracks occurred. On the contrary, the FT-type piles which are produced with shear reinforcement exhibited stable flexural and inclined shear cracks uniformly over the entire pile without abrupt horizontal cracks. Furthermore, the maximum load of the large diameter composite PHC pile improved to 2.9 times in the F series, and more than 3.3 times in the FT series compared to the conventional PHC pile. This result indicated that FT-type piles had excellent composite behavior due to the shear reinforcement and effectively prevented the unstable growth of inclined shear cracks.

• Journal of Chest Surgery
• /
• v.42 no.1
• /
• pp.79-86
• /
• 2009

Background: Background: Computed tomography (CT) is the main tool for detecting abnormalities of the thoracic aorta, but conventional CT only shows the cross-sectional images. These CT images have some limitations fo accuratly measuring the thoracic aortic diameters at various levels. Multidetector computed tomography (MDCT) overcomes these limitations. We measured the thoracic aortic diameter perpendicular to the loop-shaped thoracic aortic course and this was studied in relation to age, gender, height, weight, the body surface area, the body mass index and the presence of hypertension. Material and Method: Thirty hundred thirty one patients (males: 141 patients and females: 190 patients) who had no abnormalities of the thoracic aorta were investigated using MDCT aortography. They were divided into three age categories: 20~39 years old, 40~59 years old and over age 60. The image was reformed with multiplanar reconstruction and the diameter of the aorta was measured perpendicular to the aortic course at 5 anatomic segments. Level A was the mid-ascending aorta, level B was the distal ascending aorta, level C was the aortic arch, level D was the aortic isthmus and level E was the mid-descending aorta. Result: The mean age was 49.5 years old for males and 54.9 years old for females (p<0.05). The mean diameter of the thoracic aorta at level A was 31.1 mm, that at level B was 30.2 mm, that at level C was 26.5 mm, that at level D was 24.0 mm and that at level E was 22.6 mm. The diameters at all the levels were gradually increased with age. Hypertensive patients had larger diameters than did the non-hypertensive population. There was a positive correlation between the ascending aortic diameter (levels A&B) and height and the body surface area, but there were no statistical differences at the aortic arch (level C) and the descending aorta (levels D&E). There were no statistical differences of the weight and body mass index at all levels. Conclusion: The diameters of the thoracic aortas were directly correlated with gender, age and hypertension. Height and the body surface area were only correlated with the ascending aorta. Weight and the body mass index have no statistical difference at all levels. We measured the age related thoracic aortic diameters and the upper normal limits and we provide this data as reference values for the thoracic aortic diameter in the Korean population.

• Journal of Embryo Transfer
• /
• v.12 no.1
• /
• pp.111-116
• /
• 1997

The present study was carried out to produce in vitro fertilized embryos with immature follicular oocytes collected by transvaginal aspiration from Holstein cows. A simple aspiration apparatus consists of two stainless steel tubes, an inner tube (needle holder; 1.2cmdiameter, 55cm long) and an outer tube (1.5cm diameter, 4Scm long), and a hand-operated vacuum pump was used. Under epidural anesthesia, the needle guide was passed into the vagina of the cow to a point next to the cervix. An ovary was placed against the wall of the vagina over the end of the aspiration needle by rectal manipulation. As the needlepassed into the ovary, an assistant was asked to apply vacuum(l00mrnHg) and the ovary was manipulated back and forth in all directions over the needle. When all sites of the ovary was aspirated, the needle was withdrawn and the needle guide was moved to the other side of ovary and the procedure was repeated. When the oocyte aspiration procedure was finished, collected fluid was transported to laboratory. Oocytes surrounded with at least 1 layer of cumulus cells were matured, fertilized and cultured in vitro. The results were as follows; Ninety seven oocytes were collected by transvaginal aspiration from seventeen Holstein cows(5.7 /head). The number of oocytes surrounded with at least 1 layer of cumulus cells were 60(61.9%). Following in vitro maturation, fertilization and culture, the cleavage and development rate to morula+blastocyst were 83.3% and 30.0%, respectively. From this study, transferable in vitro fertilized embryos could be produced with imma- ture follicular oocytes collected by transvaginal aspiration from Holstein cows using a simple aspiration apparatus.