• Korean Journal of Hydrosciences
• /
• 제8권
• /
• pp.31-40
• /
• 1997

Flow carrying capacity of water distribution systems is getting reduced by deterioration of pipes in the systems. The objective of this paper is to present a managerial decision-making model for the rehabilitation of water distribution systems with a mininum cost. The decisions made by the model also satisfy the requirements for discharge and pressure at demanding nodes in the systems. Replacement cost, pipe break repair cost, and pumping cost are considered in the economic evaluation of the decision along with the break rate and the interest rate to determine the optimal replacement time for each pipe. Then, the hydraulic integrity of the water distribution system is checked for the decision by a pipe network simulator, KYPIPE, if discharge and pressure requirements are satisfied. In case the system does not satisfy the hydraulic requirements, the decision made for the optimal replacement time is revised until the requirments are satisfied. The model is well applied to an existing water distribution system, the Seoul Metropolitan Water Supply System (1st Phase). The results show that the decisions for the replacement time determined by the economic analysis are accepted as optimal and hydraulic integrity of the system is in good condition.

• 산업공학
• /
• 제12권1호
• /
• pp.114-120
• /
• 1999

A system consisting of two continuously and independently operating equipment subject to breakdown and repair, is considered. It is assumed that both equipment age only when in operation, and a group replacement policy is in effect, that is, both equipment are replaced simultaneously by new identical ones as soon as either of them reaches a specified replacement age. First, a system of partial differential equations based on enumerating the various probabilistic events, is derived. Then, solutions of such system of equations for a model considered in the steady-state are obtained. Finally, an economic analysis is performed to determine the optimal replacement ages of both equipment.

• 산업경영시스템학회지
• /
• 제17권30호
• /
• pp.51-57
• /
• 1994

This paper considers the problem of equipment replacement A equipment replacement problem is treated in a thchnological development environment. Our model assumes that the costs associated with the presently available thchnology and future technology is known, but the appearance times of future technology is uncertain. A cost model is presented, and method is suggested for finding the optimal operating time for replacement A numerical example is shown.

• 통합자연과학논문집
• /
• 제17권2호
• /
• pp.43-51
• /
• 2024

Jung et al.(2015) suggest the two-phase warranty model, which is a general type of warranty model. Under the two-phase warranty, the warranty period is divided into two intervals, one of which is for renewing replacement warranty, and the other is for minimal repair warranty. And warranty policies play a very important role in product marketing. In this paper, we suggest the optimal warranty policy for free extended two-phase warranty. To determine the optimal warranty period, we adopt the expected profit per unit product. So, the expressions for the total expected cost, the sale price and the expected profit per unit product from the manufacturer's point of view are derived. Also, we discuss the optimal warranty period and the numerical examples are provided to illustrate the proposed the warranty policy.

• 대한안전경영과학회:학술대회논문집
• /
• 대한안전경영과학회 2004년도 추계학술대회
• /
• pp.115-123
• /
• 2004

Replacement problems can be classed as either deterministic of stochastic. Deterministic problems are those in which the timing and the outcome of the replacement action are assumed to be known with certainty. Before proceeding with development of replacement models it is important to note that preventive replacement actions, that is, ones taken before equipment reaches a failed state, require two necessary conditions: (1) The total cost of the replacement must be greater after failure than before. (2) The failure rate of the equipment must be increasing. Equipment is subject to failure. On failure, one of two possible actions can be taken : repair or complete replacement of the failed equipment. In this paper, we proposed optimal overhaul, repair, replacement maintenance model with two-state.

• 한국건축시공학회지
• /
• 제5권2호
• /
• pp.153-159
• /
• 2005

This study is to choose the optimal mixture and to analyze the sensibility properties of High strength concrete and mass concrete to apply the high rising building. The main experimental variables were water/binder ratio $39\%,\;33\%,\;35\%\;and\;37\%$, replacement ratio of fly ash $5\%,\;10\%\;and\;15\%$, in the high strength concrete and water/binder ratio $39\%,\;41\%\;and\;43\%$, replacement ratio of fly ash $10\%,\;20\%\;and\;30\%$, in the man concrete. According to the test results, the principal conclusions are summarized as follows. 1) The slump(or slump flow) and air content of fresh concrete were found to be the highest in the elapsed time 30 minutes. 2) The optimal mixture conditions are W/B $40\%$, FA $25\%$ in the mass concrete and W/B $33.4\%$, FA $15\%$ in the high strength concrete. 3) The ranges of sensibility are satisfied in the moisture content ${\pm}l\%\;and\;S/a\;{\pm}2\%$.

• 품질경영학회지
• /
• 제12권2호
• /
• pp.33-36
• /
• 1984

This paper is concerned with the optimal replacement policy of auto-scale with increasing error-variance. This optimization model is to minimize the sum of the cost of defective and excess weight allowance for a target value. The numerical example for the proposed problem is solved by Golden-Section Search and Simpsons's rule.

• 산업경영시스템학회지
• /
• 제11권18호
• /
• pp.35-39
• /
• 1988

In general, the characteristics of components which consist of multi component system can not be the same. This paper proposes a maintenance model of multi-component system according to the characteristics of each component. In this paper multi-component system is divided into three components-critical component, major component and minor component, respectively. Then we determine the optimal age replacement time of the system which minimizes total maintenance cost. Numerical examples are shown to illustrate the result.

• 한국국방경영분석학회지
• /
• 제25권2호
• /
• pp.144-157
• /
• 1999

In this paper, we consider a new preventive replacement policy for the system which deteriorates while it is in operation with an increasing failure rate. The system is subject to two types of failure. A type 1 failure is repairable while a type 2 failure is not repairable. In the new policy, a system is replaced at the age of $t_p$ or at the instant the$\textsc{k}^{th}$ type 1 failure occurs, whichever comes first. However, if a type 2 failure occurs before a preventive replacement is performed, a failure replacement should be made. We assume that a type 1 failure can be rectified with a minimal repair. We also assume that a replacement takes a non-negligible amount of time while a minimal repair takes a negligible amount of time. Under a cost structure which includes a preventive replacement cost, a failure replacement cost and a minimal repair cost, we develop a model to find the optimal ($\textsc{k},t_p$) policy which minimizes the expected cost per unit time in the long run while satisfying a system availability constraint.

• 정보처리학회논문지A
• /
• 제13A권6호
• /
• pp.511-516
• /
• 2006

데이터 그리드는 대용량의 데이터 어플리케이션 처리를 위해 지리적으로 분산되어 있는 저장 자원을 제공한다. 대용량을 처리해야 하는 데이터 그리드 환경에서는 기존 웹 캐싱 정책이나 가상 메모리 캐쉬 교체 정책과는 다른 파일 교체 정책이 필요하다. LRU(Least Recently Used)나 LCB-K(Least Cost Beneficial based on K), EBR(Economic-based cache replacement), LVCT(Least Value-based on Caching Time) 같은 기존의 파일 교체 전략은 파일 교체를 위해 추가적인 자원이 필요하거나 미래를 예측해야한다. 본 논문은 이를 해결하기 위해 파일의 크기에 기반하여 파일 교체를 수행하는 SBR-k(Sized-based replacement-k)을 제안한다. 성능평가 결과 제안한 정책이 기존의 정책보다 더 나은 성능을 나타낸다는 것을 확인하였다.