• Korean Chemical Engineering Research
• /
• v.50 no.1
• /
• pp.155-161
• /
• 2012

A dynamic biofilter model was suggested to integrate the effect of biofilter-medium adsorption capacity on the removal efficiency of volatile organic compound (VOC) contained in waste air. In particular, the suggested biofilter model is composed of four components such as biofilm, gas phase, sorption volume and adsorption phase and is capable of predicting the unsteady behavior of biofilter-operation. The process-lumping model previously suggested was limited in the application for the treatment of waste air since it was derived under the assumption that the adsorbed amount of VOC equilibrated with biofilter-media would be proportional to the concentration of dissolved VOC in the sorption volume of biofilter-media. Therefore a Freundlich adsorption isotherm was integrated into a robust biofilter process-lumping model applicable to a wide range of VOC concentration. The values of model parameters related to biofilter-medium adsorption were obtained from the dynamic adsorption column experiments in the preceding article and literature survey. Furthermore a separate biofilter experiment was conducted to treat waste air containing ethanol and the experimental result was compared with the model predictions with various values of Thiele modulus (${\phi}$). The obtained value of Thiele modulus (${\phi}$) was close to 0.03.

• Journal of the Korean Electrochemical Society
• /
• v.23 no.3
• /
• pp.57-65
• /
• 2020

It is crucial to investigate the thermal degradation of lithium-ion batteries (LIBs) to understand the possible malfunction at high temperature. Herein, we investigated the effects of surface film formation on the thermal degradation of lithium cobalt oxide (LiCoO₂, LCO) cathode that is one of representative cathode materials. Cycling test at 60℃ exhibited poorer cycleability compared with the cycling at 25℃. Cathodes after the initial 5 cycles at 60℃ (60-LCO) exhibited higher impedance compared to the cathode after initial 5 cycles at 25℃ (25-LCO), resulting in the lower rate capability upon subsequent cycling at 25℃, although the capacity values were similar at the lowest C-rate of 0.1C. In order to understand degradation of the LCO cathode at the high temperature, we analyzed the cathodes surface using X-ray photoelectron spectroscopy (XPS). Among various peaks, intensity of lithium hydroxide (LiOH) increased substantially after the operation at 60℃, and the C-C signal that represents the conductive agent was distinctly lower on 60-LCO compared to 25-LCO. These results pointed to an excessive formation of cathode-electrolyte interphase including LiOH at 60℃, leading to the increase in the resistance and the resultant degradation in the electrochemical performances.

• Nuclear Engineering and Technology
• /
• v.42 no.5
• /
• pp.582-589
• /
• 2010

As a part of the back-end fuel cycle, transportation of spent nuclear fuel (SNF) from nuclear power plants (NPPs) to a fuel storage facility is very important in establishing a nuclear fuel cycle. In Korea, the accumulated amount of SNF in the NPP pools is troublesome since the temporary storage facilities at these NPP pools are expected to be full of SNF within ten years. Therefore, Korea cannot help but plan for the construction of an interim storage facility to solve this problem in the near future. Especially, a decision on several factors, such as where the interim storage facility should be located, how many casks a transport ship can carry at a time and how many casks are initially required, affect the configuration of the transportation system. In order to analyze the various possible candidate scenarios, we assumed four cases for the interim storage facility location, three cases for the load capacity that a transport ship can carry and two cases for the total amount of casks used for transportation. First, this study considered the currently accumulated amount of SNF in Korea, and the amount of SNF generated from NPPs until all NPPs are shut down. Then, how much SNF per year must be transported from the NPPs to an interim storage facility was calculated during an assumed transportation period. Second, 24 candidate transportation scenarios were constructed by a combination of the decision factors. To construct viable yearly transportation schedules for the selected 24 scenarios, we created a spreadsheet program named TranScenario, which was developed by using MS EXCEL. TranScenario can help schedulers input shipping routes and allocate transportation casks. Also, TranScenario provides information on the cask distribution in the NPPs and in the interim storage facility automatically, by displaying it in real time according to the shipping routes, cask types and cask numbers that the user generates. Once a yearly transportation schedule is established, TranScenario provides some statistical information, such as the voyage time, the availability of the interim storage facility, the number of transported casks sent from the NPPs, and the number of transported casks received at the interim storage facility. By using this information, users can verify and validate a yearly transportation schedule. In this way, the 24 candidate scenarios could be constructed easily. Finally, these 24 scenarios were compared in terms of their operation cost.

• Informatization Policy
• /
• v.27 no.3
• /
• pp.56-81
• /
• 2020

The purpose of this research is to empirically examine the effects of motivation and skill for digital devices and the Internet on the use of online services in the severely disabled people. In addition to the general effect of digital divide, particularly for the case of severely disabled people, the effects of physical and mental inconvenience of individuals were taken into account and the moderating effect was confirmed by classifying the groups that need help with online activities and those that do not. The 2018 Digital Divide Survey data of the National Information Society Agency was used for the study. As a research method, path analysis and multi-group analysis using a sequence access model to Internet use were performed. As a result, it was confirmed that even in the case of the disabled, the motivational factor affects the skill for digital device operation and Internet use, and this access skill sequentially affects the use of online services. In particular, it was found that the effect of strategic and technical skill for internet use is the most important for the use of online services for the disabled rather than the motivation or a simple operational skill for digital devices. In addition, it was found that even in the disabled group, those requiring help in using the Internet was more passive in using the online service than the rest in the group. The results of this study suggest the need for stronger capacity for physical access as well as support in building strategic and technical skills that enhance responsibilities and protect from risks in using the Internet among the people with disabilities.

• Journal of Korea Water Resources Association
• /
• v.48 no.5
• /
• pp.367-377
• /
• 2015

ADCPs have been highlighted so far for measuring steramflow discharge in terms of their high-order of accuracy, relatively low cost and less field operators driven by their easy in-situ operation. While ADCPs become increasingly dominant in hydrometric area, their actual measurement accuracy for velocity and bathymetry measurement has not been sufficiently validated due to the lack of reliable bench-mark data, and subsequently there are still many uncertain aspects for using ADCPs in the field. This research aimed at analyzing inter-comparison results between ADCP measurements with respect to the detailed ADV measurement in a specified field environment. Overall, 184 ADV points were collected for densely designed grids for the given cross-section that has 6 m of width, 1 m of depth, and 0.7 m/s of averaged mean flow velocity. Concurrently, ADCP fixed-points measurements were conducted for each 0.2m and 0.02m of horizontal and vertical spacing respectively. The inter-comparison results indicated that ADCP matched ADV velocity very accurately for 0.4~0.8 of relative depth (y/h), but noticeable deviation occurred between them in near surface and bottom region. For evaluating the capacity of measuring bathymetry of ADCPs, bottom tracking bathymetry based on oblique beams showed better performance than vertical beam approach, and similar results were shown for fixed and moving-boat method as well. Error analysis for velocity and bathymetry measurements of ADCP can be potentially able to be utilized for the more detailed uncertainty analysis of the ADCP discharge measurement.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.16 no.4
• /
• pp.91-97
• /
• 2008

The objective of this research is to investigate the effect of the addition of granular activated carbon (GAC) and granular sludge on the performance of upflow anaerobic sludge blanket (UASB) reactors for treating leachate. For the control reactor, sludge obtained from an anaerobic digester was used as a seed material. On the other hand, GAC and granular sludge were incorporated with the seed sludge in the GAC reactor and the Granule reactor, respectively. The shortest acclimation period was observed in the Granule reactor. The GAC reactor also gave comparable performance to the Granule reactor at the beginning of operation. However, as the adsorptive capacity of GAC was exhausted, the effluent COD concentration increased gradually. Once the systems were stabilized, the GAC reactor showed slightly better results than the other two reactors in terms of chemical oxygen demand (COD) removal. COD removal in all reactors was more than 90% at hydraulic retention time of 1.0 day. Furthermore, GAC reactor showed little variation in COD removal rate and remained at 95% with organic loading rate (OLR) of 4.0 to $8.2kg\;COD/m^3.d$. Initial operating period was reduced by the addition of granular sludge, while the treatment efficiency was enhanced by the addition of GAC.

• Journal of KIISE:Computing Practices and Letters
• /
• v.11 no.3
• /
• pp.224-234
• /
• 2005

As the network-related technology develops the number of both Internet users and the usage are explosively increasing. The networking traffic is increasing in the campus as the networking system inside universities, following the trend, adds more nodes and various networking services. Nonetheless, the quality of services for users has been degraded. Accordingly, core problems, which can cause troubles for network management, design and expansion of the network, and the cost policy, has appeared. To effectively cope with the problems with analyses a great number of technicians, tools, and budget are needed. However, it is not possible for mid and small-sized colleges to spend such a high expenditure for professional consulting. To reduce the cost and investment creating the optimized environment, the analyses on the replacement of the tools, changing the network structure, and performance analysis about capacity planning of networking is necessary. For this reason, in this paper, framework-based performance management tools are used for all steps that are related to the subject of the analysis for the network management. As the major research method, the current data in detailed categories are collected, processed, and analyzed to provide the solution for the problems. As a result we could manage the network, server, and application more systematically and react efficiently to errors and degrading of performance that affect the networking tasks. Also, with the scientific and organized analyses the overall efficiency is upgraded by optimizing the cost for managing the operation of entire system.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.35 no.8
• /
• pp.1045-1050
• /
• 2006

Optimum operation condition for pilot scale of alkaline processing for fish muscle was investigated by measuring protein solubility, yield, texture, and water-holding capacity. Recovered protein yield was 33.2% for whole fish and 61.8% for minced muscle. Optimum homogenized speed and time, using industrial scale homogenizer, were 3,000 rpm and 5 min, respectively. Limited centrifugal force of continuous cylinder type was 4,000 rpm for recovering soluble protein, and 2,000 rpm for recovering precipitated proteins. The pH control agents such as citric acid, sodium phosphate and calcium oxide decreased the breaking force and deformation of recovered protein gel. The breaking force and deformation of the recovered proteins were high compared to conventional surimi. The breaking force and deformation were decreased by addition of salt, starch and bovine plasma proteins. Whiteness of recovered protein gel was lower than that of conventional surimi. Alkaline processing greatly decreased nitrogen content and chemical oxygen demand in waste water. The results suggest that alkaline processing has a potential as industrial production for recovering the proteins from fish muscle.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.42 no.2 s.302
• /
• pp.49-58
• /
• 2005

A new soft switching three-phase PWM rectifier with simple circuit configuration and high efficiency has been developed. The proposed circuit is a kind of the auxiliary resonant commutated Pole(ARCP)converter The conventional ARCP converter requires three-auxiliary reactors and six-auxiliary switches for the soft switching auxiliary circuit and for these switching elements, a gate drive circuit and a control circuit are required, resulting in high part as a disadvantage. In the main circuit proposed in this paper, the auxiliary soft switching circuit is composed of two-auxiliary reactors, two-auxiliary switches and several diodes. In addition, common use of the PWM control circuit for two-switches will make the control circuit of the auxiliary switches simple. By means of function of the soft switching auxiliary circuit, the main switching element performs zero voltage switching operation and the auxiliary switches perform the zero current switching. In this paper, the circuit configuration and the operational analysis of the proposed circuit are described at first and then, experimental results will be reported. By using a prototype with 5[kW] capacity, the conversion efficiency of maximum $98.8[\%]$ and the power factor of $99[\%]$ or higher were obtained.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.19 no.5
• /
• pp.52-69
• /
• 2020

Considering the need for an infrastructure-level review, this study analyzed the impact of truck platooning on freeway traffic flow and the effect of dedicated lanes based on domestic road and traffic conditions. According to the study, the higher traffic volume and truck ratio, the higher ratio of platoons and the greater size of platoons are formed, which results in greater effect of increasing the average speed of the network. Therefore, the routes with heavy traffic and heavy cargo traffic could be positively considered for truck platooning. However, the analysis showed that the effect of increasing the average speed of the entire network is difficult to expect in the event of a queue due to entry and exit, and that the overall network's throughput could be reduced. Therefore, traffic operation strategies associated with the access road, such as securing capacity of the connection, are needed to maximize the effect of truck platooning. When it comes to the effect of dedicated lane, it could have a positive effect only if one lane was fully operated by automated trucks under the condition of 100% MPR, which allowed positive effects in all aspects, such as higher average speed, throughput, and reduced conflict rates.