• The Transactions of the Korean Institute of Power Electronics
• /
• v.4 no.6
• /
• pp.554-560
• /
• 1999

In this paper, a vibration suppression method using an energy stored in winding inductance and an induced v voltage of the Linear Stepping Motor(LSM) is shown, and it is applied to a new one-phase excitation method A And a magnetic equivalent circuit is based on the structure of the LSM, and then the electric equivalent circuit of the LSM is derived by solving equations for the magnetic equivalent circuit. Several dynamic characteristics of the LSM are analyzed by the ACSL with the voltage equations, the force equations and the kinetic equation, a and are measured by experimental system.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.65 no.7
• /
• pp.1257-1262
• /
• 2016

The purpose of this study is to evaluate whether to take a medicine based on a measuring data using textile proximity sensor. We developed a proximity sensor of ring type using conductive textile, and acquired a data in accordance with the quantity of each pills. To evaluate our approach, we designed an experimental protocol that is counting pills subtracting the one which contains range of 0 T(Tablet, 4,100mg) from 20 T. And, The experiments were performed a nine times in the same way. In order to remove a noise and smoothen data, data preprocessing were performed using resampling method and moving average filter which has ten points. Then, we calculated a linear trend line equation, and analyzed a correlation between pill quantity and trend line equation. As a results, correlation coefficient was shown at 0.833 through using a Spearman's correlation method and we could be determined that data was continuos decreases when take a medicine.

• Coupled systems mechanics
• /
• v.8 no.2
• /
• pp.129-146
• /
• 2019

The main goal of this work is to develop a numerical simulator to study an isothermal single-phase two-component flow in a naturally fractured oil reservoir, taking into account advection and diffusion effects. We use the Peng-Robinson equation of state with a volume translation to evaluate the properties of the components, and the discretization of the governing partial differential equations is carried out using the Finite Difference Method, along with implicit and first-order upwind schemes. This process leads to a coupled non-linear algebraic system for the unknowns pressure and molar fractions. After a linearization and the use of an operator splitting, the Conjugate Gradient and Bi-conjugated Gradient Stabilized methods are then used to solve two algebraic subsystems, one for the pressure and another for the molar fraction. We studied the effects of fractures in both the flow field and mass transport, as well as in computing time, and the results show that the fractures affect, as expected, the flow creating a thin preferential path for the mass transport.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.27 no.6
• /
• pp.782-786
• /
• 1994

Integrated finite difference method (IFDM) is used to solve one dimensional free oscillation problem in the coastal area. To evaluate the solution accuracy of IFDM in free oscillation analysis, two finite difference equations based on area discretization method and point discretization method are derived from the governing equations of free oscillation, respectively. The difference equations are transformed into a generalized eigenvalue problem, respectively. A numerical example is presented, for which the analytical solution is available, for comparing IFDM to conventional finite difference equation (CFDM), qualitatively. The eigenvalue matrices are solved by sub-space iteration method. The numerical results of the two methods are in good agreement with analytical ones, however, IFDM yields better solution than CFDM in lower modes because IFDM only includes first order differential operator in finite difference equation by Green's theorem. From these results, it is concluded that IFDM is useful for the free oscillation analysis in the coastal area.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.19 no.4
• /
• pp.981-989
• /
• 1995

A new weight function approach to determine SIF(stress intensity factor) using single-layer potential has been presented. The crack surface displacement field was represented by one boundary integral term whose kernel was modified from Kelvin's fundamental solution. The proposed method enables the calculation of SIF using only one SIF solution without any modification for the crack geometries symmetric in two-dimensional plane such as a center crack in a plate with or without an internal hole, double edge cracks, circumferential crack or radial cracks in a pipe. The application procedure to those crack problems is very simple and straightforward with only one SIF solution. The necessary information in the analysis is two reference SIFs. The analysis results using present closed-form solution were in good agreement with those of the literature.

• Journal of Welding and Joining
• /
• v.18 no.6
• /
• pp.74-82
• /
• 2000

The fluxless wetting properties of UBM-coated Si-wafer to the binary lead-free solders(Sn-Ag, Sn-Sb, Sjn-In, Sn0Bi) were estimated by wetting balance method. With the new wettability indices from the wetting curves of one side coated specimen, the wetting property estimation of UBM-coated Si-wafer was possible. For UBM of Si-chip, Au/Cu/Cr UBm was better than au/Ni/TI in the point of wetting time/ At general reflow process temperature, the wettability of high melting point solders(Sn-Sb, Sn-Ag) was better than that of low melting point one(Sn-Bi, Sn-In). The contact angle of the one side coated Si-plate to the solder could be calculated from the force balance equation by measuring the static state force and the tilt angle.

• Bulletin of the Society of Naval Architects of Korea
• /
• v.24 no.3
• /
• pp.25-34
• /
• 1987

Whereas the finite element method is well established today, the boundary element method is a fairly recent development. Both are general-purpose methods for the solution of various structural analysis problem. The B.E.M has several potential advantages relative to the F.E.M. One of them is that the number of unknowns in algebraic system obtained by discretization is proportional to the number of boundary nodes. Anothor advantage is the ease of discretization and input data preparation. However, the B.E.M. always leads to a fully populated and unsymmetric system of equations. Even though the number of degree-of-freedom is reduced as compared with F.E.M, since nodes exist on the boundary only in the B.E.M, to follow that the effort to solve the equations can be greater. It has been shown also that the time spent in setting up the coefficient matrix is a significant and can, in some cases, be greater than the time required to solve the equation. Thus, one can naturally consider the idea that two methods should be coupled, then the advantages of both methods can be taken. And further, by using this coupling method the HATCH CORNER was analyzed to give initial design data.

• Journal of Elementary Mathematics Education in Korea
• /
• v.17 no.1
• /
• pp.105-128
• /
• 2013

One of the biggest changes in 2007 Curriculum Revision is introduction of letter, equation, direct proportion and inverse proportion in fifth and sixth grade of mathematics. The purpose of this study is to provide some implications about teaching-learning method for introduction of letters, teaching and learning activities of equation between the 6th Curriculum and 2007 Curriculum Revision. The below conclusions were drawn from findings obtained in this study. First, the letter and expression were learned in fifth and sixth grade until 6th Curriculum and were learned in seventh grade in middle school of 7th Curriculum. But letter, equation are introduced in 2007 Curriculum Revision again. The overall contents of letter and expression were learned on the 'Relationship' domain in the 6th Curriculum, it were learned on the 'Letter and expression' domain in the 7th Curriculum and is learned on the 'Regularity and problem-solving' domain in the 2007 Curriculum Revision. Second, teaching method of these contents was to promise some definitions at first and then to solve exercises in the 6th Curriculum. But leaning was forced to improve student's problem-solving in the 7th Curriculum. To reduce student's pressure offers at a minimum mathematics terms and to provide problem situations to students who contact daily, it is emphasized on learner's communication in the 2007 Curriculum Revision. We want to be easily connected elementary mathematics and higher mathematics through this study about letter, equation. We recognized how we teach the letter and expression to reduce misconceptions and draw a transition from arithmetic thinking to algebraic thinking and want to be continue of another studies.

• Steel and Composite Structures
• /
• v.17 no.1
• /
• pp.123-131
• /
• 2014

In this paper we have considered the vibration of parametrically excited oscillator with strong cubic positive nonlinearity of complex variable in nonlinear dynamic systems with forcing based on Mathieu-Duffing equation. A new analytical approach called homotopy perturbation has been utilized to obtain the analytical solution for the problem. Runge-Kutta's algorithm is also presented as our numerical solution. Some comparisons between the results obtained by the homotopy perturbation method and Runge-Kutta algorithm are shown to show the accuracy of the proposed method. In has been indicated that the homotopy perturbation shows an excellent approximations comparing the numerical one.

• ETRI Journal
• /
• v.38 no.4
• /
• pp.714-723
• /
• 2016

Considerable attention has been given to processing graph data in recent years. An efficient method for computing the node proximity is one of the most challenging problems for many applications such as recommendation systems and social networks. Regarding large-scale, mutable datasets and user queries, top-k query processing has gained significant interest. This paper presents a novel method to find top-k answers in a node proximity search based on the well-known measure, Personalized PageRank (PPR). First, we introduce a distribution state transition graph (DSTG) to depict iterative steps for solving the PPR equation. Second, we propose a weight distribution model of a DSTG to capture the states of intermediate PPR scores and their distribution. Using a DSTG, we can selectively follow and compare multiple random paths with different lengths to find the most promising nodes. Moreover, we prove that the results of our method are equivalent to the PPR results. Comparative performance studies using two real datasets clearly show that our method is practical and accurate.