• 한국통신학회논문지
• /
• 제33권9C호
• /
• pp.643-651
• /
• 2008

본 논문은 직교 주파수 분할 다중 반송파(OFDM, orthogonal frequency division multiplexing) 시스템의 다이버시티 효과를 향상시키는 순환 지연 다이버시티(CDD, cyclic delay diversity) 기법에서 최적의 순환 지연 값을 결정하는 방법을 제안한다. 순환 지연 다이버시티 기법에서는 순환 지연 값이 증가함에 따라 다이버시티 효과에 의한 SINR (signal to interference and noise ratio) 이득이 커지는 동시에 채널 추정 오류의 증가에 의한 SINR 손실도 커지는 상반 관계(trade-off)가 존재한다. 다이버시티 효과와 채널 추정 오류의 상반 관계가 존재할 때 제안된 방법을 통해 구한 최적의 순환 지연값을 순환 지연 다이버시티 기법에 적용하면, 목표로 하는 프레임 오류율(FER, frame error rate)을 만족시키기 위한 SINR을 최소화한다.

• 한국식품조리과학회지
• /
• 제10권1호
• /
• pp.51-56
• /
• 1994

본 연구에서는 재래식 된장, AsP. oryzae를 이용한 개량식 된장을 만들어 숙성과정 중 지질의 변화와 카보닐화합물의 함량변화를 측정하였다. 1 재래식 된장의 총지질 함량은 숙성에 따라 점차 증가하였고 지질 중의 중성지방은 감소하였으나 유리지방산은 증가하였다. 2. 지방산 조성을 GC로 분석한 결과 포화지방산이 증가하고 불포화 지방산은 감소하였다. 3. 숙성 후 hexane으로 추출한 카보닐의 함량은 증가하였고 monocarbonyl 중 methyl ketone과 alkanal만이 검출되었고 그 함량은 숙성 후 증가하였다.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2012년도 제43회 하계 정기 학술대회 초록집
• /
• pp.384-384
• /
• 2012

We report nonvolatile memory properties of poly (3, 4-ethylenedioxythiophene) (PEDOT) thin films grown by vapor phase polymerization using FeCl3 as an oxidant. Liquid-bridge-mediated transfer method was employed to remove FeCl3 for generation of pure PEDOT thin films. From the electrical measurement of memory device, we observed voltage induced bipolar resistive switching behavior with ON/OFF ratio of 103 and reproducibility of more than 103 dc sweeping cycles. ON and OFF states were stable up to 104 seconds without significant degradation. Cyclic voltammetry data illustrates resistive switching effect can be attributed to formation and rupture of conducting paths due to oxidation and reduction of PEDOT. The maximum current before reset process was found to be increase linearly with increase in compliance current applied during set process.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2000년도 하계종합학술대회 논문집(2)
• /
• pp.111-114
• /
• 2000

Single Electron Transistor Logic (SETL) can be characterized by HSPICE simulation using a SPICE macro model. First, One unit SET is characterized by Monte-carlo simulation and then we fit SPICE macro-modeling equations to its characteristics. Second, using this unit SET, we simulate the transient characteristics of two-input NAND gate in both the static and dynamic logic schemes. The dynamic logic scheme shows more stable operation in terms of logic-swing and on/off current ratio. Also, there is a merit that we can use the SET only as current on-off switch without considering the voltage gain.

• 조명전기설비학회논문지
• /
• 제25권12호
• /
• pp.21-26
• /
• 2011

This is a study to establish regulations against light pollution for lighting on roads. Many kinds of light pollution by luminaire on roads was calculated and analyzed by applying the classification method of luminaires(Cut-off classification of IDA-IESNA, BUG Rating Classification) and the calculation method of Upward Lighting Ratio of CIE among measures to prevent light pollution that international lighting organizations suggest. As a result of the analysis, it was found that the regulation by Cutoff of IESNA and ULR classification of CIE could be one for scattered light of light pollution compared to BUG classification but is not sufficient for the regulation of light tresspass or glare. BUG classification by each lighting zone was suggested as threshold value of the light pollution regulation considering domestic conditions.

• 대한전자공학회논문지
• /
• 제21권4호
• /
• pp.17-23
• /
• 1984

A model analysis of pattern shift in the epitaxial growth of silicon on (111) substrates was performed. The growth rate anisotropy was considered as the most important affecting factor of pattern shift, and for the model establishment the off angle of the substrate and the process temperature were taken as the variables. We derived a theoretical equation of pattern shift by assuming the growth rate anisotropy as the trigonometric sine function of the off angle of the substrate and defining the growth rate anisotropy factor related to the process temperature. The pattern shift ratio calculated by this model had the same tendency with the experimental ones, which, however, were about twice greater than those. It was supposed that this discrepailcy was due to the second order affecting factor such as facetting and step broadening which had been exluded in model establishment.

• E2M - 전기 전자와 첨단 소재
• /
• 제10권9호
• /
• pp.869-875
• /
• 1997

Bi based superconducting thin films were fabricated by 4-target RF magnetron sputtering using the method of controlling the on-off time. These thin films showed better crystal structures. The ratio of Cu/Bi decreased but the critical temperature increased with increasing the temperature of the substrate. High temperature phase low temperature of the substrate. High temperature phase low temperature phase and semiconducting phase can be formed by controlling the on-off time of the shutter respectively.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1999년도 하계학술대회 논문집 E
• /
• pp.2383-2385
• /
• 1999

This paper describes the effect of particles on insulation characteristics of $SF_6-N_2$ mixtures such as breakdown voltages, lift-off voltages and maximum discharge. As a result, the breakdown voltage was increased with the increment of $SF_6$ and the mixture containing 20[%] of $SF_6$ has a breakdown voltage ratio factor better than the other mixtures. The lift-off voltage was nearly constant with all mixtures. Discharge was decreased with the increment of $SF_6$.

• Journal of Power Electronics
• /
• 제12권5호
• /
• pp.708-714
• /
• 2012

This paper presents a new interleaved pulse-width modulation (PWM) boost-flyback converter to achieve power factor correction (PFC) and regulate DC bus voltage. The adopted boost-flyback converter has a high voltage conversion ratio to overcome the limit of conventional boost or buck-boost converter with narrow turn-off period. The proposed converter has wide turn-off period compared with a conventional boost converter. Thus, the higher output voltage can be achieved in the proposed converter. The interleaved PWM can further reduce the input and output ripple currents such that the sizes of inductor and capacitor are reduced. Since boundary conduction mode (BCM) is adopted to achieve power factor correction, power switches are turned on at zero current switching (ZCS) and switching losses are reduced. The circuit configuration, principle operation, system analysis, and design consideration of the proposed converter are presented in detail. Finally, experiments conducted on a laboratory prototype rated at 500W were presented to verify the effectiveness of the converter.

• 전기학회논문지P
• /
• 제62권4호
• /
• pp.216-222
• /
• 2013

Handover is a technical methodology to support mobility of wireless communication users, which mainly affects the capacity of wireless communication systems and the quality of service (QoS) of link level signal. However, in OFDMA-based cellular systems, there are few published technical reports investigating handovers with respect to diversity gains and resource consumption depending on what handover technique is adopted. In this paper, we propose handover schemes exploiting transmit diversity and macro-diversity in order to increase capacity of OFDMA-based wireless communication systems, and analyze their performance. In cellular environments, depending on what handover scheme is selected, average signal-to-interference-and-noise ratio is calculated first for a handover user in order to evaluate the link level QoS. Through this technical evaluation for handover schemes, we conclude what handover scheme is suitable for OFDMA-based cellular systems.