• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.29 no.3
• /
• pp.43-50
• /
• 1997

The purpose of this study was to decrease pollutants of effluents from KP bleaching. Multistage bleaching that combined with O, Eo, and C/D stage was conducted, after optimum bleaching conditions of O, Eo, and C/D stage were determined. Moreover the properties for bleached pulps and pollution level of bleaching effluent were measured by each standard method. Due to increase on the brightness and delignification of pulps by O, Eo, and C/D stage bleaching. It was possible that bleaching sequences were reduced from five stage to four stage. In addition to, OC/DEoD and OC/DEopD bleaching sequences had higher brightness than CEDED bleaching sequence. The pulps bleached by O and Eo stage had higher in tensile index than conventional bleaching sequences with the similar results in burst and tear index. While each bleaching sequences had little differences, bleaching sequences with Eo stage had higher in physical properties than with Eop stage. The pollution level measured by Chemical Oxygen Demand(COD), Biochemical Oxygen Demand(BOD) and Color of bleaching effluents were much lower in combined bleaching sequences of O, Eo and C/D stage than that of CEDED sequence. Particularly, a pollution index of bleaching effluents generated by C/DEoDEB and OC/DEopDED bleaching sequences were lower than that from the other bleaching sequences.

• Korean Journal of Heritage: History & Science
• /
• v.49 no.2
• /
• pp.158-171
• /
• 2016

The observation and analysis results of 9 glass bead samples collected from Oc Eo site in Vietnam, an outport of the ancient port city Funan in East Asia, are as follows. The type of glass beads is round, the colors are reddish brown, greenish blue, green, black and purplish blue, and the chemical composition is soda glass group. This means that they are similar in type, color and chemical compositions to glass beads from the ancient Korean peninsula. There are limitations in data because the glass beads are not from excavation investigation but from earth surface investigation. But it is significant that similar making technique and chemical composition are being observed in both the glass beads from Oc Eo and those of Korea. According to "Nihon Shoki" Kinmeiki, Baekje king sent Funan's goods and 2 slaves to Japan in 543. It is clear that there were direct or indirect exchanges between Baekje and Funan. The possibility has grown that glass beads could be included among goods.

• Bulletin of the Korean Chemical Society
• /
• v.28 no.12
• /
• pp.2333-2337
• /
• 2007

Nanoporous TiO2 and ZrO2 thin films were spin-coated using a surfactant-templated approach from Pluronic P123 (EO20PO70EO20) as the templating agent, titanium alkoxide (Ti(OC4H9)4) as the inorganic precursor, and butanol as a the solvent. The control of the electronic structure of TiO2 is crucial for its various applications. We found that the band gap of the hybrid nanoporous thin films can be easily tuned by adding an acetylacetonestabilized Zr(OC4H9)4 precursor to the precursor solution of Ti(OC4H9)4. Pores with a diameter of 5 nm-10 nm were randomly dispersed and partially connected to each other inside the films. TiO2 and ZrO2 thin films have an anatase structure and tetragonal structure, respectively, while the TiO2-ZrO2 hybrid film exhibited no crystallinity. The refractive index was significantly changed by varying the atomic ratio of titanium to zirconium. The band gap for the nanoporous TiO2 was estimated to 3.43 eV and that for the TiO2-ZrO2 hybrid film was 3.61 eV.

• Proceedings of the Korea Technical Association of the Pulp and Paper Industry Conference
• /
• 1999.11a
• /
• pp.194-204
• /
• 1999

The use of genetically cloned xylanase acquired from Bacillus strearthermophillus improves bleachability for oak kraft pulps. Combination of xylanase(X). oxygen(O), ozone(Z). peroxide(P), alkaline extraction(Eo. Eop), and chlorination(C/D, D) have been tested in a variety of bleaching sequences. The effectiveness of xylanase pre-treatment(XO) and post-treatment(OX) in oxygen bleaching is mainly compared. With xylanase treatment the brightness increase by 1.5-2.1% ISO in OZEP, OZEoP, OZEopP and OPZP sequences. There is only numerically difference of brightness gains between OX and XO sequences. With xylanase treatment chemical requirements for bleaching decrease by 42.6-48.6% in OC/DEoD sequence and 47.9-54.7% as active chlorine in OC/DEopD sequence at the same brightness. the reduction of bleaching chemicals is higher in XO sequence than those in OX sequence. Following xylanase treatment the viscosity increases from 11.7-12.0 mPa·s to 12.4-13.5 mPa·s and the brightness stability is considerably improved however the difference of effectiveness between XO and OX sequence is not present. Compared to tensile index vs tear index, the physical properties are similar for TCF bleaching sequences with and without xylanase treatments. However in OC/DEoD and OC/DEopD sequences the physical properties decrease with xylanase treatment. There is no difference in the physical properties between XO and OX sequences. COD, BOD and color of bleaching effluents increase slightly with xylanase treatment, however the discharge of COD end-load into environmental impact decrease.

• Membrane Journal
• /
• v.21 no.3
• /
• pp.213-221
• /
• 2011

Using poly(ethylene oxide) (PEO) as a polymer host, poly(ethylene glycol) (PEG) as a plasticizer, potassium iodide and iodine as sources of $I^-/I_3^-$, polymer electrolyte membranes were prepared. Based on the polymer electrolytes, solid-state dye-sensitized solar cell (DSSC)s were fabricated. The content of PEG in the electrolyte was controlled to be 95%. The mole number of KI per 1 mole of EO ([KI]/[EO] ratio) in the electrolyte was changed to be 0.022, 0.044, 0.066 and 0.088. The electrolyte membrane showed wax phase in ambient temperature. The ionic conductivity increased with increasing KI content to reach the maximum value at which [KI]/[EO] ratio is 0.066. After the maximum value, the ionic conductivity decreased with increasing KI content. In the case of DSSC, the Voc decreased continuously with increasing KI content in the polymeric electrolyte membrane. The $J_{SC}$ increased with increasing KI content to show maximum value at which [KI]/[EO] ratio is 0.044. In the higher KI content region, $J_{SC}$ value decreased with increasing KI content.

• Journal of Climate Change Research
• /
• v.6 no.4
• /
• pp.311-318
• /
• 2015

Emission characteristics from charbroiling of four different meats (beef, port, duck and chicken) in a pilot-scale cooking facility were investigated in this study. The analyzed air pollutants include gaseous species (CO, NO, $SO_2$, $NH_3$ and PAHs) as well as particulate matters (TSP, $PM_{10}$, $PM_{2.5}$ and black carbon). The emission factors of $PM_{10}$ and PAHs were in the range of 3~47 g-PM/kg-meat and 0.6~11.41 mg-PAHs/kg-meat, respectively, depending on the type of a meat. In addition, the results also revealed that the high ratio of $PM_{2.5}$ to TSP in a meat charbroiling should be considered to design and to operate air pollution control devices.

• MISULJARYO - National Museum of Korea Art Journal
• /
• v.99
• /
• pp.10-29
• /
• 2021

This paper is an introductory study of the wooden Buddha images excavated in the Mekong Delta in present-day southern Vietnam. Approximately thirty examples of wooden Buddha images have been recovered in the Mekong Delta. As they were found among the major historic sites of Funan (the first kingdom in Southeast Asia), including Oc Eo, and likely date to the sixth century, they can be regarded as the works of Funan. Similarly to stone Buddha images, these wooden examples are considered important for their demonstration of aspects of early Buddhist sculpture in Southeast Asia. Most of these Funan wooden Buddha images are presumed to have been produced around the sixth century based on radiocarbon dating and their stylistic characteristics. This paper analyzed the iconography and style of eight examples whose forms are relatively recognizable. The eight images can be divided into four types according to their postures, dress styles, and hand gestures. They all share features of the Sarnath style of the Gupta period in India as seen in their slender bodies and the outer robe that clings to the body. However, some display a South Indian style of Buddha images in their upright posture, style of wearing a monastic robe with the right shoulder exposed, and making the vitarka mudra (preaching gesture) that is often seen in Sri Lankan Buddha images. This suggests that Buddhist sculptors in Funan devised a new style by incorporating the principal styles of Indian Buddhist sculpture. Another notable feature of these Funan images is their material, namely, wood. While none of the contemporaneous Hindu sculptures discovered from the same historic sites are made of wood, numerous Buddhist sculptures are. This paper postulates that the use of wood in Buddhist sculptures was promoted for reasons beyond ease of carving. According to the Buddhist literature, the first-ever Buddha image was the so-called 'Udayana image' made out of sandalwood. This image and its story was well-known in the Southern Dynasty of China around the sixth century. Interestingly, some auspicious sandalwood images of the Buddha was believed to have been brought into the Southern Dynasty from Funan. This suggests the possibility that the legend of the Udayana image might have been known in Funan as well and resulted in the production of wooden sculptures there.