• Journal of the Korean Solar Energy Society
• /
• v.39 no.1
• /
• pp.77-89
• /
• 2019

The solar air heater has various performances according to an obstacle installed in the air duct. Many studies on thermal performance have been conducted. But many of these studies were using a kind of rib type obstacle attached at the bottom of absorbing plate, but they are so hard to be manufactured. In this study, characteristics of the heat transfer and pressure drop in the solar air heater with various horizontal rectangular obstacles was investigated by CFD (Computational Fluid Dynamics) analysis. As a result, the heat transfer performance was improved from 1.2 to 3.32 times depending on installation conditions of rectangular obstacle. The pressure drop, however, also increased with increment of heat transfer performance from 2.8 to 180 times only by changing installation conditions of rectangular obstacle. Thus, the performance factor presenting the thermal performance enhancement on the same pressure drop was also confirmed. As a result, the highest value of 0.828 as better performance factor was obtained at the lower height of rectangular obstacle and this value has started to decrease with increment of heat transfer performance. In the end, it could be confirmed that the pressure drop was carried higher than the quantity of improvement of the heat transfer performance when the heat transfer performance was increased by change of installation conditions of rectangular obstacle. Both heat transfer enhancement and pressure drop to be required for system need to be considered before the rectangular obstacles are applied to the solar air heater.

• Journal of Korean Society of Industrial and Systems Engineering
• /
• v.47 no.2
• /
• pp.65-73
• /
• 2024

This paper presents a path planning optimization model for the engineering units to install obstacles in the shortest time during wartime. In a rapidly changing battlefield environment, engineering units operate various engineering obstacles to fix, bypass, and delay enemy maneuvers, and the success of the operation lies in efficiently planning the obstacle installation path in the shortest time. Existing studies have not reflected the existence of obstacle material storage that should be visited precedence before installing obstacles, and there is a problem that does not fit the reality of the operation in which the installation is continuously carried out on a regional basis. By presenting a Mixed Integrer Programming optimization model reflecting various constraints suitable for the battlefield environment, this study attempted to promote the efficient mission performance of the engineering unit during wartime.

• Journal of Environmental Science International
• /
• v.18 no.10
• /
• pp.1115-1121
• /
• 2009

The purpose of this study is to estimate the impact of rainfall measurement according to the installation conditions of rain gauges: windbreak, grass mat, installation elevation or obstacle. Rain gauges were installed by the standards of Korea Meteorological Administration(KMA), and the rainfall measurement was conducted daily unit during two years(2007~2008). In conclusion, observed error of rain gauge did not affect whether windbreak was installed or not. If there is the obstacle around rain gauge, average error rate was increased about 3.3%: (2007year-2.49%, 2008year-4.10%). If rain gauge is located in a high place, average error rate was increased about 4.89%. Additionally, the observed error of rain gauge according to the wind speed has a positive correlation with obstacle and installation elevation and has a negative correlation with windbreak and has no affection with grass mat.

• Journal of the Korean Society for Aviation and Aeronautics
• /
• v.31 no.1
• /
• pp.18-25
• /
• 2023

In recent years, UAM (Urban Air Mobility) has emerged as a solution to these urbanization problems, and many related reports and diverse prospects have been reported. UAM flights are planned to take off and land at a Vertiport located in the city center and fly along a pre-established corridor. In order for UAM to operate safely in the city center, it must ensure a safe flight path that avoids the buildings in the city center and many surrounding obstacles. Therefore, in this study, we compared and examined the installation standards of the obstacle limitation surface necessary for UAM to take off and land safely at the Vertiport. First, we analyzed the helicopter obstacle limitation surfaces in Japan and overseas, and the UAM Vertiport installation standards and obstacle limitation surface application standards recently announced at the FAA and EASA. It identified differences and similarities between heliport and Vertiport, and considered improvements to domestic helicopter obstacle limitation surfaces and criteria that could meet FAA and EASA standards.

• Proceedings of the Korean Institute of IIIuminating and Electrical Installation Engineers Conference
• /
• 2004.05a
• /
• pp.110-115
• /
• 2004

Examine merits and demerits and obstacle factor that exist to all direction of digital infratechnology that is supplied on industry whole according to development special quality of computer by development of computer and Information Technology and electricity electron information communication facility that basic impulse insulation level does not exist examined scorched earth or an interference problem factor and countermeasure of semiconductor degauss of factor and electricity electron information transmission system that is numbed or causes system down.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.21 no.10
• /
• pp.1-12
• /
• 2007

Through this experiment driver's perception were measured. An analysis of the perception measurement result analyzed the subject's obstacle perception response time according to voltage patterns. The difference in the reaction time between men and women was also analyzed. Futhermore, the obstacle perception response time was analyzed according to the rate of the brightness of the headlamp. The relative delay time was analyzed In reference to times when there was no voltage change.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.20 no.10
• /
• pp.10-18
• /
• 2006

In this thesis paper the effect that the change in the brightness of headlights has on a driver's perception had been researched. For this research, an indoor laboratory was constructed and designed. Then, a system to measure the reaction braking time of finding obstacle and the subject's brain waves after a moment of change in the headlamp's brightness was constructed. And before the real experiment was began, the trial experiment to decide test time, subject's rest time, detailed experimental steps, the headlamp's patterns of voltage change and an obstacle course was executed.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.20 no.9
• /
• pp.45-53
• /
• 2006

This paper proposes a method for an effective intelligent route decision for automatic moving robots(AMR) using a 2D spatial map of a stereo camera system. In this method, information about depth and disparity map are detected in the inputting images of a parallel stereo camera. The distance between the automatic moving robot and the obstacle is detected, and a 2D spatial map is obtained from the location coordinates. Then the relative distances between the obstacle and other objects are deduced. The robot move automatically by effective and intelligent route decision using the obtained 2D spatial map. From experiments on robot driving with 240 frames of stereo images, it was found that the error ratio of the calculated distance to the measured distance between objects was very low, 1.52[%] on average.

• International Journal of Railway
• /
• v.3 no.3
• /
• pp.106-112
• /
• 2010

Accidents at level crossing have large portion on train accidents, and causes economical loss by train delay and operational interruption. Various safety equipments are employed to reduce the accident at level crossing, but existing warning device, and crossing barrier are simple train-oriented protection equipments. In this paper, intelligent railway level crossing system is proposed to prevent and reduce accidents. For train driver's prompt action, image of level crossing and obstacle warning message are continuously provided to train driver through wireless communication in level crossing control zone. Obstacle warning messages, which are extracted by computer vision processing of captured image at level crossing, are recognized by train driver through message color, flickering and warning sound. It helps train driver to decide how to take an action. Meanwhile, for vehicle driver's attention, location and speed of approaching train are given to roadside equipments. We identified the effect of proposed system through test installation at Sea train and Airport level crossing of Yeong-dong line.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.28 no.2
• /
• pp.244-253
• /
• 2022

Recently, installation projects of structures such as offshore wind farms have been increasing, and the installation of such marine obstacles could affect ships that pass nearby. Therefore, the purpose of this study was to quantitatively evaluate the risk posed to passing ships due to obstacles in their passage. Hence, parameters that affected the risk were selected, and scenarios were set based on the parameters. The scenarios were evaluated through the ES model, which is a risk assessment model, and we confirmed that the risk ratio increased as the size of the obstacle increased, the safe distance from the obstacle increased, the speed of ship decreased, and the traffic volume increased. Additionally, we found that when the traffic flow direction was designated, the risk ratio was lower than that of general traffic flow. In this study, we proposed a generalization model based on the results of the performed scenarios, applied it to the Dadaepo offshore wind farm, and demonstrated that the estimation of the approximate risk ratio was possible through the generalization model. Finally, we judged that the generalization model proposed in this study could be used as a preliminary reference for the installation of marine obstacles.