• Journal of the Korean Ceramic Society
• /
• v.39 no.5
• /
• pp.438-445
• /
• 2002

In this study, the glass frit of $PbO-TiO-2-SiO_2-BaO-ZnO-Al_2O-3-CaO-B_2O_3-Bi_2O_3-MgO$ system was manufactured. The glass was melted at $1,400{\circ}C$, quenched and attrition-milled. The glass frit powder was pressed and fired for 2h at the range of $750~1,000{\circ}C$. The crystallization of glass frit began at about $750{\circ}$ and at low temperature, the main crystal phases were hexagonal celsian($BaAl_2Si_2O_8$) and alumina. As the firing temperature increased, the crystal phases of monoclinic celsian, zinc aluminate, zinc silicate, calcium titanium silicate and titania appeared. And the increase of firing temperature led to transformation of hexagonal celsian to monoclinic. The only glass frit containing 15wt% PbO had the crystal phase of solid solution of $PbTiO_3-CaTiO_3$. At the frequency of 1 MHz, the dielectric constant of glass frit crystallized was in the range of 11~16 and the dielectric loss less than 0.020. But the glass frit containing 15wt% PbO had the dielectric constant of 17~26 and loss of 0.010~0.015 because of crystal phase of solid solution of $PbTiO_3-CaTiO_3$.

• Korean Journal of Materials Research
• /
• v.29 no.8
• /
• pp.463-468
• /
• 2019

The electrical and interfacial properties of $HfO_2/Al_2O_3$ and $Al_2O_3/HfO_2$ dielectrics on AlN/p-Ge interface prepared by thermal atomic layer deposition are investigated by capacitance-voltage(C-V) and current-voltage(I-V) measurements. In the C-V measurements, humps related to mid-gap states are observed when the ac frequency is below 100 kHz, revealing lower mid-gap states for the $HfO_2/Al_2O_3$ sample. Higher frequency dispersion in the inversion region is observed for the $Al_2O_3/HfO_2$ sample, indicating the presence of slow interface states A higher interface trap density calculated from the high-low frequency method is observed for the $Al_2O_3/HfO_2$ sample. The parallel conductance method, applied to the accumulation region, shows border traps at 0.3~0.32 eV for the $Al_2O_3/HfO_2$ sample, which are not observed for the $Al_2O_3/HfO_2$ sample. I-V measurements show a reduction of leakage current of about three orders of magnitude for the $HfO_2/Al_2O_3$ sample. Using the Fowler-Nordheim emission, the barrier height is calculated and found to be about 1.08 eV for the $HfO_2/Al_2O_3$ sample. Based on these results, it is suggested that $HfO_2/Al_2O_3$ is a better dielectric stack than $Al_2O_3/HfO_2$ on AlN/p-Ge interface.

• Archives of Metallurgy and Materials
• /
• v.66 no.4
• /
• pp.983-986
• /
• 2021

This study investigated the recovery behavior of valuable metals (Co, Ni, Cu and Mn) in spent lithium ion-batteries based on Al₂O₃-SiO₂-CaO-Fe₂O₃ slag system via DC submerged arc smelting process. The valuable metals were recovered by 93.9% at the 1250℃ for 30 min on the 20Al₂O₃-40SiO₂-20CaO-20Fe₂O₃ (mass%) slag system. From the analysis of the slag by Fourier-transform infrared spectroscopy, it was considered that Fe₂O₃ and Al₂O₃ acted as basic oxides to depolymerize SiO₄ and AlO₄ under the addition of critical 20 mass% Fe₂O₃ in 20Al₂O₃-40SiO₂-CaO-Fe₂O₃ (CaO + Fe₂O₃ = 40 mass%). In addition, it was observed that the addition of Fe₂O₃ ranging between 20 and 30 mass% lowers the melting point of the slag system.

• Journal of the Korean Ceramic Society
• /
• v.26 no.2
• /
• pp.249-257
• /
• 1989

Dielectric properties and the stability of the perovskite phase in the Pb(Mg1/3Nb2/3)O3 system have been investigated as a function of amount of BaTiO3 and firing temperature. In the specimens fired at 120$0^{\circ}C$, the pyrochlore phase was eliminated by the addition of 10-15m/o BaTiO3 and also the dielectric constant increased. However, the dielectric constant decreased with further addition of BaTiO3 even though no pyrochlore phase was found to be present. The reducing tendency of the pyrochlore phase decreased with lowering the firing temperature in the system of Pb(Mg1/3Nb2/3)O3 with BaTiO3. Dielectric properties in PMN ceramics were affected by the character of the BaTiO3 rather than the pyrochlore phase.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.15 no.3
• /
• pp.120-123
• /
• 2005

The 5 mol% ZnO doped $LiNbO_3$ film and the 2 mol% MgO doped $LiNbO_3$ film were grown on the $LiNbO_3$ (001) substrate by liquid phase epitaxy (LPE) method with $Li_2CO_3-V_2O_5$ flux system. The crytsallinity and the lattice mismatch between $Zn:LiNbO_3$, film and $Mg:LiNbO_3$, film were analyzed by x-ray rocking curve (XRC). In addition, the ZnO and MgO distribution in the cross-section of the multilayer thin films was observed using electron probe micro analyzer (EPMA).

• Journal of Korean Ophthalmic Optics Society
• /
• v.7 no.2
• /
• pp.27-31
• /
• 2002

Quarternary $Li_2O-B_2O_3-Al_2O_3-SiO_2$ glasses were fabricated by the function of $R({\equiv}Li_2Omole%/B_2O_3mole%)$ and $K({\equiv}(Al_2O_3mole%+SiO_2mole%/B_2O_3mole%)$. The structures of these glasses were investigated through refractive index and Vicker's hardness. The refractive index increased as the increase of the polarizability in the glass network. In the region of low $Li_2O$ content, the refractive index increased due to the increase of the polarizability in the glass network but, in the region of high $Li_2O$ content, the rate of increase of the refractive index decreased due to the increase of the molar volume caused by the formation of $BO_3{^-}$ units with relatively high molar volume. And, the refractive index decreased as the increase of $Al_2O_3+SiO_2$ content with the molar volume in the glass network. The increase and decrease of vicker's hardness values for those glasses depended on the fraction of tetrahedral $BO_4$ units and it of triangle $BO_3{^-}$ units with non-bridging oxygen, respectively.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.18 no.1
• /
• pp.57-61
• /
• 2005

The microwave dielectric properties of 0.6TiTe$_3$O$_{8}$-0.4MgTiO$_3$ ceramics with H$_3$BO$_3$-SnO were investigated to improve the sintering condition for the LTCC. According to the X-ray diffraction patterns, 0.6TiTe$_3$O$_{8}$-0.4MgTiO$_3$ ceramics with H$_3$BO$_3$-SnO had the columbite structure of TiTe$_3$O$_{8}$ phase and the ilmenite structure of MgTiO$_3$ phase and there were no second phase. Increasing the addition of H$_3$BO$_3$-SnO, the density and dielectric constant of the 0.6TiTe$_3$O$_{8}$-0.4MgTiO$_3$ ceramics were increased but the quality factor was decreased. The temperature coefficient of resonant frequency was shifted to the negative(-) direction with addition of H$_3$BO$_3$-SnO.EX>-SnO.

• Korean Journal of Materials Research
• /
• v.10 no.4
• /
• pp.270-275
• /
• 2000

The Pt/YMnO$_3$/Y$_2$O$_3$/Si structure for metal/ferroelectric/insulator/semiconductor(MFIS)-FET was fabricated and effect of $Y_2$O$_3$layer on the properties of MFIS structure was investigated. The $Y_2$O$_3$ thin films on p-type Si(111) substrate deposited by Pulsed Laser Deposition were crystallized along (111) orientation irrespective of the deposition temperatures. Ferroelectric YMnO$_3$ thin films deposited directly on p-type Si (111) by MOCVD resulted in Mn deficient layer between Si and YMnO$_3$. However, YMnO$_3$ thin films having good quality and stoichiometric composition can be obtained by adopting $Y_2$O$_3$ buffer layer. The memory window of the $Y_2$O$_3$thin films with YMnO$_3$ film is greater than that of the YMnO$_3$ thin films without $Y_2$O$_3$ film after the annealing at 85$0^{\circ}C$ in vacuum ambient(100mtorr). The memory window is 1.3V at an applied voltage of 5V.

• Journal of the Korean Ceramic Society
• /
• v.26 no.4
• /
• pp.568-574
• /
• 1989

Effect of PbO addition on sintering and piezoelectric properties at 0.45Pb(Ni1/3Nb2/3)O3-0.40PbTiO3-0.15PbZrO3 composition which is tetragonal phase was investigated. In this composition, Porosity and dielectric constant were increased with excess PbO addition, but Kp and d31 was not changed. These variation of physical properties could be interpreted as composition change of solid grains from tetragonal to MPB region due to amount of PbO-rich liquid changing.

• Korean Journal of Materials Research
• /
• v.13 no.12
• /
• pp.785-790
• /
• 2003

We have synthesized some phosphors in the system $CaO-Y_2$$O_3$-$Al_2$$O_3$by combinatorial polymerized-complex method. Composition and synthetic temperature of phosphors in the library was screened from the emission intensities of individual samples under VUV excitation. In $Tb^{ 3＋}$-activated $CaO-Y_2$$O_3$-$Al_2$$O_3$, green phosphors showing good intensity were found to be X$O_3$$O_{7}$, CaYA1O$_4$, YA1O$_3$, $Y_3$$Al_{5}$$O_{12}$, $Y_4$$A1_2$$O_{9}$ .