• Membrane Journal
• /
• v.21 no.1
• /
• pp.55-61
• /
• 2011

$BaCo_{0.7}Fe_{0.22}Nb_{0.08}O_{3-{\delta}}$ oxide was synthesized by solid state reaction method. Dense ceramic membrane was prepared using as-prepared powder by pressing and sintering at $1,200^{\circ}C$. XRD result of membrane showed single perovskite structure. Leakage and oxygen permeation test were conducted on the membrane sealed by glass ring as a sealing material. The oxygen permeation flux increased with increasing temperature and pressure difference and maximum oxygen permeation flux was $2.3mL/min{\cdot}cm^2$ at $950^{\circ}C$ with $Po_2$ = 0.63 atm of oxygen partial pressure. The oxygen permeation in the condition of air with $CO_2$ (300 ppm) as feed stream decreased as much as only maximum 2.9% in comparison with air feed stream. It indicated $BaCo_{0.7}Fe_{0.22}Nb_{0.08}O_{3-{\delta}}$ membrane is more stable than another membrane for carbon dioxide.

• Proceedings of the KIEE Conference
• /
• 1995.11a
• /
• pp.609-611
• /
• 1995

In this study, we experimented the properties of SOG film as sacrificials layers in surface micromachining and made $SiO_2$ films through spin, bake, cure process. When we culled SOG films once, SOG film thickness is 1000 $\sim$ 3000 ${\AA}$. Then we coaled 200-${\AA}$ SOG film on 9000 ${\AA}$-CVD oxide and then we fabricated test structure, cantilever and ring/beam structure. We estimated deformed structure by SEM. As the results, The deformation of the structure layer in the SOG-coated sacrificial layers is small compared with that or the structure layer on CVD oxide or PSG. In the future, we use multi coated SOG films, SOG film become adequate material as sacrificial layer.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2021.05a
• /
• pp.623-625
• /
• 2021

Rubber o-rings are produced by conventional injection molding methods. In this case, products that are not normally molded are determined to be defective. However, if images acquired during image-based reading are read as original, there is a problem of poor accuracy. We have thus learned from convolutional neural networks using adaptive binarization and Convex Hull algorithms by extracting only rubber oring parts from the original images through pre-processing. During the test process, it was confirmed that the defect detection performance of the learning method applied pre-processing was better than the standard suggested.

• Korean Journal of Optics and Photonics
• /
• v.20 no.2
• /
• pp.71-75
• /
• 2009

A compact electric field probe sensor incorporating two different electro-optic materials of $LiNbO_3$ and GaAs was proposed and fabricated, and it was used to measure the strength of the horizontal and vertical fields generated by a microstrip ring-resonator filter. The sensitivities of the sensors in $LiNbO_3$ and GaAs were $9.315{\mu}V/\sqrt{Hz}$ and ${\sim}49.346{\mu}V/\sqrt{Hz}$ respectively, and their signal to noise ratios were approximately ${\sim}50\;dB$ and ${\sim}40\;dB$ respectively. And the operating frequency range was up to ${\sim}1.2\;GHz$. The electric field profile for the test circuit was scanned and found to be in good agreement with that obtained by using the HFSS simulation.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2003.06a
• /
• pp.776-779
• /
• 2003

To reduce the storage space of spent fuel used at the atomic power plants in the over the world, the uranium elements contained in the spent fuel is being extracted and effectively stored. For this, the spent fuel are oxidized and deoxidized. In this study, it is produced the heat-resisting methods about the spent fuel management technology research and test facility for the spent fuel waste for spent fuel minimized. The first considered processes in the facility are the electrolytic metal reduction reactor process. Since the electrolytic metal reduction reactor is operated at the high temperature range, we have to consider the heat-resisting methods for the devices. For the heat-resisting methods, we have searched and analyzed technical reference for the heat-resisting methods. We have calculated thermal stress and strain of each devices by the commercial analysis software, ANSYS. D.S. It is experimented for inspecting confidence rate of analysis results. By using the results, we have analyzed the problems of parts and determined the heat-resisting material, commercial parts, and the size of parts and O-ring. Based on these results, it is produced the heat-resisting methods of magnesia filter, cathode, and reactor for the electrolytic metal reduction reactor.

• Journal of Advanced Marine Engineering and Technology
• /
• v.23 no.3
• /
• pp.331-337
• /
• 1999

Cracks on the cylinder block of diesel engines will often happen due to cyclic load and thermal stress. According to the Classification Societies' rules welding reparis of cylinder block made of cast irons are generally not permitted. However such welding repairs became inevitable taking enormous cost and time for their renewal into consideration. In this study repair welding methods for the clinder blocks made of gray cast irons were reviewed and the tests of their welds were carried out in order to purpose the repair welding meth-ods of packing seat and o-ring seat of cylinder block and apply them to the practice. The following conclusions are botained :1 The tensile strength of weld of cast iron more than that of base metal can be obtained by means of preheating keeping temperature above $100^{\circ}C$ between welding pass-es preventing slag inclusion peening and cramping weld metal by studs. 2. The suspected crack by a magnetic particle test due to different magnetic permeability can be identified which are not associated with a mechanical discotinuity.

• Journal of the East Asian Society of Dietary Life
• /
• v.8 no.3
• /
• pp.271-279
• /
• 1998

This study was conducted to compare the serum composition and urinary excretion in four institutional groups and the effects of intakes of good foods and harmful foods according to the Sasang constitiution for a short time on serum and ruine compositon. The contitutions of 33 female stucdents were classified by O-ring test and muscular strength test according to the Sasang constitution, The number of each institutional group was So-yang-in 11, So-em-in 10 and Tae-em-in 12. No subject belonged to Tae-yang-in There were no significant differences among contitutional groups in the values of most serum composition and urinary excretion Serum levels of total cholesterol, glucose, calcium and phosphorus in Tae-em-in was the highest among groups and the level of albumin and total protein in So-em-in was highest. The values of serum compositions changed after the 33 subjects took good foods and then harmful foods according to The Sasang constitution for a short time(5 days). Dietary behavior of the subjects had some effects among the constitutional groups in the values of most serum composition and urinary excretion. But the effects of dietary behavior on the serum composition and urinary excretion showed various trends in the four institutional groups.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.63 no.10
• /
• pp.1412-1416
• /
• 2014

We report thin-film organic moisture barriers based on polystyrene(PS) laminates deposition by PECVD for an encapsulation of OLEDs. The organic polystyrene thin-film has the benzene ring structure and high hydrophobic characteristics and it was polymerized by PECVD in dry process. Life time properties of Ca test were obtained 32 minutes at the RF 100W process conditions. From the AFM test, the roughness of multi-layer thin-film was more excellent rather than that of a single-layer thin-film. In addition, 5 layers of the multi-layer film properties were obtained 45 minutes. So that the optical and electrical properties were not affected with these plasma polymerized organic thin-film encapsulation. For life time improvement, the inorganic $Al_2O_3$ thin-film were deposited 5nm using ALD atomic layer deposition. The WVTR(Water Vaper Transmission Rate) value of hybrid thin-film encapsulation in the optimum process conditions was resulted by less than $10-3g/m^2/day$. From the results of experiment, plasma polymerized hybrid encapsulation was suggested as the flexible display applications.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2008.11a
• /
• pp.273-276
• /
• 2008

A Through Bulkhead Initiation Module(TBIM) has been designed which guarantees the seal property without using O-ring. The TBIM works as the shock wave generated by a donor charge transmits to the acceptor charge. The structural safety of TBIM housing has been calculated via modeling analysis, and the ignition performance has been proved by 10 cc closed bomb test. The reliability analysis has been made using Probit method on the base of performance test results. According to the reliability analysis the bulkhead thickness of TBIM which is the most important design parameter has been determined.

• The Korean Journal of Physiology and Pharmacology
• /
• v.3 no.4
• /
• pp.393-404
• /
• 1999

We have reported that hypoxia stimulates EDRF(s) release from endothelial cells and the release may be augmented by previous hypoxia. As a mechanism, it was hypothesized that reoxygenation can stimulate EDRF(s) release from endothelial cells and we tested the hypothesis via bioassay experiment. In the bioassay experiment, rabbit aorta with endothelium was used as EDRF donor vessel and rabbit carotid artery without endothelium as a bioassay test ring. The test ring was contracted by prostaglandin $F_{2a}\;(3{\times}10^{-6}\;M)$ which was added to the solution perfusing through the aorta. Hypoxia was evoked by switching the solution aerated with 95% $O_2/5%\;CO_2$ mixed gas to one aerated with 95% $O_2/5%\;CO_2$ mixed gas. Hypoxia/reoxygenation were interexchanged at intervals of 2 minutes (intermittent hypoxia). In some experiments, endothelial cells were exposed to 10-minute hypoxia (continuous hypoxia) and then exposed to reoxygenation and intermittent hypoxia. In other experiments, the duration of reoxygenation was extended from 2 minutes to 5 minutes. When the donor aorta was exposed to intermittent hypoxia, hypoxia stimulated EDRF(s) release from endothelial cells and the hypoxia-induced EDRF(s) release was augmented by previous hypoxia/reoxygenation. When the donor aorta was exposed to continuous hypoxia, there was no increase of hypoxia-induced EDRF(s) release during hypoxia. But, after the donor aorta was exposed to reoxygenation, hypoxia-induced EDRF(s) release was markedly increased. When the donor aorta was pretreated with nitro-L-arginine $(10^{-5}$ M for 30 minutes), the initial hypoxia-induced EDRF(s) release was almost completely abolished, but the mechanism for EDRF(s) release by the reoxygenation and subsequent hypoxia still remained to be clarified. TEA also blocked incompletely hypoxia-induced and hypoxia/reoxygenation-induced EDRF(s) release. EDRF(s) release by repetitive hypoxia and reoxygenation was completely blocked by the combined treatment with nitro-L-arginine and TEA. Cytochrome P450 blocker, SKF-525A, inhibited the EDRF(s) release reversibly and endothelin antgonists, BQ 123 and BQ 788, had no effect on the release of endothelium-derived vasoactive factors. Superoxide dismutase (SOD) and catalase inhibited the EDRF(s) release from endothelial cells. From these data, it could be concluded that reoxygenation stimulates EDRF(s) release and hypoxia/reoxygenation can release not only NO but also another EDRF from endothelial cells by the production of oxygen free radicals.