• Journal of the Korean institute of surface engineering
• /
• v.36 no.2
• /
• pp.184-193
• /
• 2003

Cyclic sweep voltametry was performed to investigate the electrochemical behavior of heavy metal ions and the organic additives in surface finishing process. And electrolysis using parallel plate electrode electrolyzer was carried out to simulate the treatment of real waste water. Results showed that more than 99 percent of Cu was recovered and selective recovery of Cu in mixed waste water was possible, but the possibility of economical recovery of Ni and Cr were very low due to the evolution of hydrogen gas. Electrochemical oxidation of cyanide and organic additives on anode showed very excellent removal rate. The complete removal of several hundred ppm of cynide was possible within several tens minutes and organics within 2 or 3 hours. Even in case of concentrate waste water, the complete removal of COD by using NaCl and air stirring seemed to be possible.

• Bulletin of the Korean Chemical Society
• /
• v.23 no.8
• /
• pp.1062-1066
• /
• 2002

The complexes [Ni(L)(INT)2]${\cdot}$5H2O (1) and [Cu(L)(H2O)](Cl)(INT)${\cdot}$3H2O (2) (L = 3,14-dimethyl-2,6,13,17-tetraazatricyclo[14,4,01.18 ,07.12 ]docosane, INT = isonicotinate) have been prepared and characterized by X-ray crystallography, electronic absorption, and cyclic voltammetry. The crystal structure of 1 reveals an axially elongated octahedral geometry with two axial isonicotinate ligands. The electronic spectra, magnetic moment, and redox potentials of 1 also show a high-spin octahedral geometry. However, 2 shows that the coordination environment around the copper atom is a distorted square-pyramid with an axial water molecule. The spectra and electrochemical behaviors of 2 are also discussed.

• Proceedings of the Korea Committee for Ocean Resources and Engineering Conference
• /
• 2001.05a
• /
• pp.344-349
• /
• 2001

This paper was to investigate of a adhesiveness for the plasma sprayed coating materials did salt spray by acoustic emission method in tensile loadings. The powders used for the coating were nickel aluminum composite powder Ni-4,5wt.%Al and titanium dioxide powder Ti02. These powders were coated on a carbon steel S45C by plasma spray method. The salt solution was a 5% NaCl and the salt spray times were 2, 5 and 10 hours respectively. The salt solution penetrated into the surface of the substrate through pore of the coating layer built in the process of plasma spay. Corrosion productions formed on the surface of substrate. The adhesiveness between the substrate and the coating layer is weaken by corrosion and the exfoliation initiated chiefly at the corrosion surface of the substrate. The AE events and energy of the corroded coating specimens decreased as the salt spray times increased.

• Journal of Ocean Engineering and Technology
• /
• v.7 no.1
• /
• pp.147-155
• /
• 1993

The effect of stress waveforms on corrosin fatigue and the role of dissolution mechanism in 3NilCr steel and 20Ni maraging steel have been investigated in aerated 3% NaCl solution and synthetic seawater under sinusoidal, triangular, square, positive sawtooth, negative sawtooth, and trapezoidal stress waveforms with open circuit at frequency of 1Hz and stress ratio of 0.1. The crack growth rates under square waveform were substantially lower than under sinusoidal and triangular waveforms, but the crack growth rates under sinusoidal waveform were slightly higher under triangular waveform. For a given frequency the growth rates under the positive sawtooth waveform are higher than those under the negative sawtooth waveform. The fatigue crack growth rates of most specimens were in good agreement with the values calculated by the model based on the dissoultion mechanism.

• Bulletin of the Korean Chemical Society
• /
• v.32 no.10
• /
• pp.3655-3659
• /
• 2011

The hydrogenolysis of polymer-bound arenesulfonates by 2-propylmagnesium chloride was performed through reductive cleavage of the C-S bond in the presence of a nickel catalyst. The reaction underwent in the highest efficiency by adding 15 equiv of the nucleophile in two additions with $dppfNiCl_2$ in THF. Various unfunctionalized naphthalene, biphenyl, and stilbene derivatives were produced in good yields by the traceless sulfonate linker system at room temperature.

• Journal of the Korean Chemical Society
• /
• v.55 no.6
• /
• pp.926-931
• /
• 2011

A series of complexes of the type [$ML_2Cl_2$], where L=2-(o-anisylidene-2'-imino) amino benzimidazole (AIAB) and 2-(furfurylidene imino) amino benzimidazole (FIAB), M=Cu(II), Co(II), Ni(II) and Zn(II), have been synthesized and characterized on the basis of elemental analysis, thermal analysis, molar conductivity, magnetic moment, electronic, infrared, $^1H$-NMR spectral studies. The results are in consistent with bidentate chelation of ligand with azomethine nitrogen and ring nitrogen donors. All these Schiff bases and their complexes have also been screened for their antibacterial (Bacillus subtilis, Bacillus stearothermophilus, Escherichia coli and Salmonella typhi) and antifungal activities (Aspergillus niger and Aspergillus flavus).

• Korean Journal of Materials Research
• /
• v.14 no.5
• /
• pp.343-347
• /
• 2004

We investigated the growth feasibility of polycrystalline Si film on mica substrate for the transfer of the layer to a plastic substrate. The annealing temperature was limited up to $600^{\circ}C$ because of crack development in the mica substrate. Amorphous Si film was deposited on mica substrate by PECVD and was crystallized by furnace annealing. During the annealing, bubbles were formed at the Si/mica interface. The bubble formation was avoided by the Ar-plasma treatment before amorphous Si deposition. A uniform and clean polycrystalline Si film was obtained by coating $NiCl_2$ on the amorphous Si film and annealing at $500^{\circ}C$ for 10 h. The conventional Si lithography was possible on the mica substrate and the devices fabricated on the substrate could be transferred to a plastic substrate.

• Carbon letters
• /
• v.9 no.1
• /
• pp.17-22
• /
• 2008

A carbon nanotube (CNT) of diameter ~20 nm has been synthesized by spray pyrolysis of turpentine oil using Ni/Fe catalyst. Pellet of CNTs has been used as a target to produce semiconducting carbon thin film of band gap 1.4 eV. Presence of oxygen pressure in the pulse laser deposition (PLD) chamber helped to control the $sp^3/sp^2$ ratio to achieve the desired band gap. Results are discussed with the help of Raman spectra, SEM TEM micrographs and optical measurements suggest that semiconducting carbon thin film deposited by PLD technique has retained its nanotubes structure except that its diameter has increased from 20 nm to 150 nm.

• Journal of the Korean institute of surface engineering
• /
• v.20 no.2
• /
• pp.60-73
• /
• 1987

For the purpose of improving the cyclic oxidation resistance of Ni-base superalloy, Inconel 600, aluminide coating methods are studied. The formation rate of aluminide coating layers is measured as a function of time and pack composition to find out the optimum coating condition. The evaluation of cyclic oxidation is established by the change in weight, the microphotography and EPMA of cross sectional area during $200^{\circ}C\;{\leftrightarrow}\;950^{\circ}C\;and\;200^{\circ}C\;{\leftrightarrow}\;1100^{\circ}C$, respectively. The thickness of coating layer and weight gains are parabolic behavior in propotion to time and Al contents. In pack of low aluminum contents, 2 wt%, however, weight gain is decreased when activator, $NH_4Cl$ is higher than 2 wt%. The cyclic oxidation resistance of the coating carried out at 1100$^{\circ}C$ are superior to those of the coating diffusion-treated after pack cementation at 800$^{\circ}C$. Aluminide oxide, which is formed in external scale, is barrier to the cyclic oxidation.

• Journal of Ecology and Environment
• /
• v.42 no.4
• /
• pp.191-198
• /
• 2018

Improper management and unsanitary approaches are implemented in disposal of leachate, which has resulted in groundwater pollution at village Uruli Devachi, Pune, India. Various physico-chemical treatment methods are commercially available for leachate treatment. However, the application of biological methods viz. phytoremediation to the municipal solid waste landfill leachate has been limited. We report the remediation ability of Typha aungstifolia and Acrorus calamus that is capable of reducing hazardous constituents from the landfill leachate. After 96 h of hydraulic retention time (HRT), it was observed that T. aungstifolia-treated sample showed high reduction potential in reducing biochemical oxygen demand, chemical oxygen demand, hardness, total dissolved solids, Na, Mg, Ca and Ni whereas A. calamus showed greater reduction capacity for alkalinity, Cl, Cu, Zn and Cr. Furthermore, it was also observed that T. aungstifolia withstood longer HRT than A. calamus. In situ application of T. aungstifolia and A. calamus for remediation of landfill leachate carries a tremendous potential that needs to be further explored.