• Journal of the Korea Concrete Institute
• /
• v.23 no.3
• /
• pp.347-352
• /
• 2011

When concrete is worked in cold weather, the methods of using hot air, water and aggregate heating, accelerators are used to prevent early frosting and to improve early strength. But these methods raise problems such as implementation difficulty, high cost, and energy losses. Among the available cold weathering methods, accelerator method is the most economical but with the drawbacks of rapid setting and insufficient workability in the initial hydration stage. Therefore, the tablet method usually used for pharmaceutical field was applied to the accelerator method to compare the controlled reaction time of the new and old accelerator method. Based on the test results, physical and mechanical properties of concrete were tested and the possibility of delaying initial reactions to increase the total reaction time was evaluated. The results showed that when both accelerators and tablet were used, setting-time decreased. Physical properties of concrete were optimal for tablet 0.5% and 1.0%. Also, accelerator 0.5%, tablet 0.5% and 1.0% showed good early strengths.

• The KSFM Journal of Fluid Machinery
• /
• v.18 no.6
• /
• pp.63-70
• /
• 2015

This paper proposes a novel airfoil named "KA2" for the blade of the wind turbine systems. Dynamic loads characteristics are analyzed and compared using aerodynamic data of ten airfoils including the proposed airfoil. The blade is divided into the sixteen elements in the longitudinal direction of the blade for applying the Blade Element Method Theory (BEMT) method, and in each element, torque, thrust, and pitching moment are calculated using turbulent time varying wind speed and aerodynamic data of each wing. Additionally, each force and torque is accumulated in the whole region of the blade for the estimation of representative values. The magnitude of such forces is comparatively analyzed for different airfoils. The angle of attack is constant below the rated wind speed due to the fact that the tip speed ratio is kept at the constant value, and it increases in the region of over rated wind speed as the tip speed ratio decreasing with constant rated rpm and increasing wind speed. Such increase in the angle of attack causes the changes of the force acting on the airfoil with different characteristics of lift and drag in the stall region of each different airfoil. Even though the mean wind speed is in the rated speed in a given time, because of the turbulence, it has either the over rated or under rated speed most of the time. Furthermore, the dynamic properties of each force are analyzed in this rated wind speed in order to objectively understand the dynamic properties of the blades which are designed based on the different airfoils. These dynamic properties are also compared by the standard deviation of time varying characteristics. Moreover, the output characteristics of the wind turbine are investigated with different airfoils and wind speeds. Based on these investigations, it was revealed that the proposed airfoil (KA2) is well applicable to the blade with passive pitch control system.

• Journal of The Korean Association For Science Education
• /
• v.18 no.4
• /
• pp.527-537
• /
• 1998

This article is a part of a research on the elementary science curriculum development to enhance creative problem-solving abilities. The components of the curriculum have been identified as 'scientific knowledge', 'process skills' & 'divergent/critical thinking'. Among these components, construction of the scientific knowledge that enables creative problem-solving abilities has been selected as an intensive research topic for the purpose of the present research. To avoid or to prevent the knowledge learned from separate facts and concepts, five themes have been selected so as to incorporate with all three areas of the elementary science curriculum, i.e., physical science, earth science and life science. The five themes are, 'structure', 'change', 'interaction', 'energy' and 'stability'. The contents of elementary science, which have been selected from the 3rd, 6th and 7th National Elementary Science curriculum, were reconstructed based on the five themes given above. The results of reconstruction are presented in the form of matrix, such that the vertical axis represents how the concepts are related within each domain of science, while the horizontal axis shows how the concepts are interconnected between domains of science. Therefore, based upon the five themes, individual or separate knowledge can be put into more unified knowledge so that contribution of knowledge transfer to new ones can be expected for leaners who will be creative in problem-solving. The process and products of the curriculum development as well as the background of the present research are described and discussed in detail.

• Journal of IKEEE
• /
• v.18 no.2
• /
• pp.272-281
• /
• 2014

In electrical impedance tomography (EIT), modified Newton Raphson (mNR) method is widely used inverse algorithm for static image reconstruction due to its convergence speed and estimation accuracy. The unknown conductivity distribution is estimated iteratively by minimizing a cost functional such that the residual error namely the difference in measured and calculated voltages is reduced. Although, mNR method has good estimation performance, EIT inverse problem still suffers from ill-conditioned and ill-posedness nature. To mitigate the ill-posedness, generally, regularization methods are adopted. The inverse solution is highly dependent on the choice of regularization parameter. In most cases, the regularization parameter has a constant value and is chosen based on experience or trail and error approach. In situations, when the internal distribution changes or with high measurement noise, the solution does not get converged with the use of constant regularization parameter. Therefore, in this paper, in order to improve the image reconstruction performance, we propose a new scheme to determine the regularization parameter. The regularization parameter is computed based on residual error and updated every iteration. The proposed scheme is tested with numerical simulations and laboratory phantom experiments. The results show an improved reconstruction performance when using the proposed regularization scheme as compared to constant regularization scheme.

• Korean Chemical Engineering Research
• /
• v.51 no.4
• /
• pp.476-481
• /
• 2013

Ethylbenzene (EB) which has a similar physical properties with p-xylene (pX) was separated from EB/pX mixture by using MFI-type zeolite (TS-1, ZSM-5, and Silicalite-1) coated membranes. The zeolites were synthesized by microwave method to reduce the synthesis time and uniformly formed zeolite particles were coated on the ${\alpha}$-almina tubular support with a thickness of $3-4{\mu}m$. Separation factor and permeation flux of the synthesized zeolite coated membranes were measured to survey the best performance of ethylbenzene separation from different composition of EB/pX mixtures. When the EB/pX mixture of 5:5 molar ratio applied for the separation experiment, it represented the highest separation factor. We also have studied about the effect of the atomic composition of zeolites on the separation performance within the temperature range from 160 to $220^{\circ}C$. TS-1 showed the highest permeation flux of $1,666mol/m^{2*}s^*Pa$ and Silicate-1 showed the highest separation factor of 1.73 at $200^{\circ}C$ respectively.

• Resources Recycling
• /
• v.27 no.2
• /
• pp.38-47
• /
• 2018

Integrated gasification combined cycle (IGCC) is a next generation energy production technology that converts coal into syngas with enhanced power generation efficiency and environmental performance. IGCC produces almost coal gasification slag as the solid by-product. IGCC slag is generated about 140,000 tons for a year although recycling of it is still in the early stages. We evaluated the potential of IGCC slag which is generated from a pilot plant in South Korea as an alkali-activated cement. Samples which were activated with the combined activator of sodium silicate solution and caustic soda had an average compressive strength of 4.5 MPa, showing expansion. Expansion of the alkali-activated slag was presumed to be caused by free CaO in the slag, although it was not detected by the ethylene glycol method. Samples that were activated with the combined activator of sodium aluminate and caustic soda had an average compressive strength of 10 MPa. Hydroxy sodalite and $C_3AH_6$ were found to be the new crystalline phases. IGCC slag can be used as an alkali-activated material, but the strength performance should be improved with proper mix design approach to calculate optimum proportions which can alleviate the expansion issue at the same time.

• Journal of the Korea Institute of Building Construction
• /
• v.10 no.1
• /
• pp.57-63
• /
• 2010

The bearing wall apartments which occupy the majority of multi-residential apartment buildings built in Korea, are known for having limited architectural plan flexibility, posing challenges in terms of maintenance and remodeling. The economic losses and environmental issues resulting from the reconstruction of bearing wall apartments are now accumulating to the extent that they are becoming a national concern. Multi-residential apartment buildings, which are now the dominant form of residence in Korea, must accommodate diverse customer needs and changes in life style. A new concept of Rahmen structure with architectural flexibility is Green Frame. GF multi-residence housing is expected to reduce construction costs and shorten the construction schedule by overcoming the shortcomings of conventional bearing wall apartments. This goal is consistent with the national policies that target the reduction of resource and energy consumption. In addition, GF will be established as a core contributor to achieving a reduction in $CO_2$ emissions, which will enable the sustainable growth of domestic construction industry, and address the low-carbon green growth drive implemented by the government.

• Korean Chemical Engineering Research
• /
• v.53 no.3
• /
• pp.282-288
• /
• 2015

A new energetic thermoplastic elastomer based on the azidated polybutadiene(Az-PBD)/ethylene vinyl acetate copolymer (EVA) blends was prepared, and structure and properties of the blends were invetigated by SEM, DSC, DMA, tensile testing and combustion test. The Az-PBD was synthesized via a two-step process involving the addition reaction of commercially available 1,2-PBD with $Br_2$ and subsequent nucleophilic substitution reaction of the brominated PBD with $NaN_3$. EVA/Az-PBD with 90/10, 80/20, 70/30 (wt/wt) was prepared by a solution blending. SEM, DSC, and DMA results revealed that the blends are partially compatible and Az-PBD is dispersed in continuous EVA matrix. Tensile test showed that modulus and tension set increased while elongation-at-break of the blends decreased with increasing Az-PBD content in the blends, but all the blends showed a elongation at break as high as 700% and a tension set of less than 5%, indicating that the blends are typically elastomeric. Combustion test showed that, with increasing Az-PBD content in the blend, higher energy can be released.

• Management & Information Systems Review
• /
• v.36 no.3
• /
• pp.185-202
• /
• 2017

This study suggests the estimation of the demand for the exhibition center in Busan and to valid reasons for the establishment of the 2nd Convention Center in Busan. The validity for the estimated demand is acquired by examining the studies conducted by the Ministry of Commerce Industry and Energy. The qualitative data for the phased establishment of the area is suggested in accordance to the results of the demand estimation. From previous study(Oh, 2017), Kangseo-gu, Busan has been evaluated to be the final candidate for building a new convention center in the city of Busan. The potential synergy effects of on-going developmental projects in Kangseo region is one of the influential factors for the MICE professionals' opinion in the qualitative analysis. Moreover, the region has available land to hold the facility of more than 100,000 square meter to overcome the current drawback of BEXCO, insufficient space to hold large events. Lastly, the expansion of Gimhae International Airport would bring an increased international flights that would also lead to an increase in MICE industry for the region. The virtual effect of the more than one million $m^2$-sized oconvention center is examined via Huff Model and the results suggests a logical estimated data for further demand needed for the south east regions, not just within the city of Busan.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.19 no.2
• /
• pp.213-229
• /
• 2017

Recently, in urban areas there is a tendency to construct more complex network-type tunnels including entrance and exit ramps. At the same time, various one-dimensional programs based on the network theory have been proposed for tunnel ventilation analysis. This paper aims at developing a program that can analyze the ventilation flow rate and pollutants concentration in complex network-type tunnels based on the none hardy-cross method. The flow analysis in the branch was carried out on the basis of the Gradient method, while for the concentration analysis a new logic has been developed to calculate the inflow and outflow concentration automatically in a complex network-type structure. Additionally, in the tunnel segments showing low flow rate, proper grid interval sizes were proposed to reduce numerical error. To verify the applicability of the program, flow rates predicted in the straight tunnels were compared with the classical velocity-diagram method by Stokic and the TVSDM program. The results showed that the errors were within 1%. In addition, the program was applied to the recent ventilation system adopted in the complex network-type urban tunnels.