• 한국표면공학회:학술대회논문집
• /
• 한국표면공학회 2011년도 춘계학술대회 및 Fine pattern PCB 표면 처리 기술 워크샵
• /
• pp.58-58
• /
• 2011

Nickel-ceramics nanocomposite coatings can be applied as the wear resistance coating, corrosion protection of underlying materials, and decorative coatings. Hence, Nickel based nanocomposite coatings, especially Ni-SiC, have been extensively studied in recent years. However, more often agglomeration problem of the nanoparticles in the nickel matrix can cause deterioration of the mechanical properties rather than improvement. The homogeneous distribution of the nanoparticles in the matrix coating is still being challenging. In this experiment, electrochemical deposition of Ni-SiC composite coating was done in presence of ultrasound. The effects of different ultrasonic powers and frequencies on the nanoparticle dispersion were studied. The electrodeposition was carried out in nickel sulfamate bath by applying pulse current technique. Compared to the conventional mechanical stirring technique to prevent nanoparticles agglomeration and sedimentation during composite electrodeposition, the aid of ultrasonic dispersion along with mechanical stirring has been found to be more effective not only for the nanoparticles dispersion, but also for the mechanical properties of the electrodeposited coatings. Nanoparticles were found to be distributed homogeneously with reduced agglomeration. The microstructure of the composite coating has also been changed, allowing some random orientations of the nickel crystallite grain growths, smooth surface, and finer grains. As a consequence, better mechanical properties of the composites were observed.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2007년도 제38회 하계학술대회
• /
• pp.1339-1340
• /
• 2007

본 연구에서는 이종 차원 나노선과 나노입자의 결합에 따른 단일 나노선 소자의 전기적 특성 및 메모리 효과를 연구하였다. 열증착법으로 성장 된 p 형 Si 나노선에 Atomic Layer Deposition (ALD) 방법으로 10nm의 $Al_{2}O_{3}$를 증착한 후 Low Precensure - Chemical Vapor Deposition (LP-CVD)를 이용하여 Polycrystalline Sicon(Poly-Si)을 Si 나노선 위에 5nm 증착하고 습식 에칭법을 이용하여 poly Si 내의 $SiO_x$를 제거하여 Si 나노입자를 Si 나노선 위에 형성시켰다. 그 후 포토리소그래피 공정을 이용하여 Top gate 형태의 나노선-나노입자 이종결합 Field-Effect Transistor (FET) 소자를 제작하여 게이트 전압에 따른 드레인 전류-전압($I_{DS}-V_{DS}$)의 변화를 측정하여 나노선의 전기 소자로서의 특성을 확인하고, 게이트 전압을 양방향으로 swing 하면서 인가하여 $I_{DS}$ 전류 특성이 변화하는 것을 통해 메모리 효과를 조사하였다. 또한 나노입자의 결합이 게이트 전압의 인가 시간에 따라 드레인 전류에 영향을 미치는 것을 확인하여 메모리 소자로서의 가능성을 확인하였다.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2015년도 제49회 하계 정기학술대회 초록집
• /
• pp.228.1-228.1
• /
• 2015

We demonstrate a simple route to hybridize two different nanomaterials by using three-dimensional nanodishes that can be used as small plasmonic containers to host guest nanoparticles. Our nanodishes were fabricated using nanoimprint lithography and oblique-angle film deposition, and the guest nanoparticles were drop-casted onto the host nanodishes. Based on the proposed method, colloidal Au nanoparticles were assembled inside Au nanodishes in the form of a labyrinth. These Au nanoparticle-nanodish hybrids excited a strong surface plasmon resonance, as verified by a numerical simulation of the local field enhancement and by direct observation of the enhanced Raman signals. Our results point to the potential of the nanodishes as a useful platform for combining diverse nanomaterials and their functionalities.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2013년도 제44회 동계 정기학술대회 초록집
• /
• pp.468-468
• /
• 2013

Self-assembled silver nanoparticles were synthesized on a graphene film to investigate plasmonic effect. Graphene was synthesized on glass substrate using chemical vapor deposition method and transfer process. Silver nanoparticles were formed using thermal evaporator and post-annealing process. The shape of silver nanoparticles was measured using a scanning electron microscopy. The resonance wavelength of plasmonic effect on graphene-silver nanoparticles was measured using transmittance spectra. The plasmon resonance wavelength was increased from 400 nm to 424 nm according to the lateral dimension of silver nanoparticles. Also we confirmed a strong plasmon effect form Raman spectra, which were measured on graphene-silver nanoparticles. The result shows that plasmon resonance wavelength could be controlled by lateral dimension of silver nanoparticles, and transparent conductive films based on plasmonic graphene could be developed.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2008년도 추계학술대회 논문집 Vol.21
• /
• pp.93-93
• /
• 2008

This paper presents the Raman scattering characteristics of poly (polycrystalline) 3C-SiC thin films deposited on AlN buffer layer by atmospheric pressure chemical vapor deposition (APCVD) using hexamethyldisilane (MHDS) and carrier gases (Ar + $H_2$).The Raman spectra of SiC films deposited on AlN layer of before and after annealings were investigated according to the growth temperature of 3C-SiC. Two strong Raman peaks, which mean that poly 3C-SiC admixed with nanoparticle graphite, were measured in them. The biaxial stress of poly 3C-SiC/AlN was calculated as 896 MPa from the Raman shifts of 3C-SiC deposited at $1180^{\circ}C$ on AlN of after annealing.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2012년도 제42회 동계 정기 학술대회 초록집
• /
• pp.540-540
• /
• 2012

Selective detection of single nucleotide polymorphism (SNP) of Cytochrome P450 2C19 (CYP2C19) was carried out by the PNA chips which were electrically-interfaced with interdigitated nanogap electrodes (INEs). The INEs whose average gap distance and effective gap length were about ~70 nm and ${\sim}140{\mu}m$, respectively, were prepared by the combination of the photo lithography and the surface-catalyzed chemical deposition, without using the e-beam lithography which is almost inevitable in the conventional lab-scale fabrication of the INEs. Four different types of target DNAs were successfully detected and discriminated by the INE-based PNA chips.

• Nuclear Engineering and Technology
• /
• 제45권3호
• /
• pp.335-346
• /
• 2013

The Critical Heat Flux (CHF) of water with dispersed alumina nanoparticles was measured for the geometry and flow conditions relevant to the In-Vessel Retention (IVR) situation which can occur during core melting sequences in certain advanced Light Water Reactors (LWRs). CHF measurements were conducted in a flow boiling loop featuring a test section designed to be thermal-hydraulically similar to the vessel/insulation gap in the Westinghouse AP1000 plant. The effects of orientation angle, pressure, mass flux, fluid type, boiling time, surface material, and surface state were investigated. Results for water-based nanofluids with alumina nanoparticles (0.001% by volume) on stainless steel surface indicate an average 70% CHF enhancement with a range of 17% to 108% depending on the specific flow conditions expected for IVR. Experiments also indicate that only about thirty minutes of boiling time (which drives nanoparticle deposition) are needed to obtain substantial CHF enhancement with nanofluids.

• 반도체디스플레이기술학회지
• /
• 제21권3호
• /
• pp.22-25
• /
• 2022

Metal oxide semiconductor (MOS) based on spray-pyrolysis deposition technique has attracted large attention due to simple and low-cost processibility while preserving their intrinsic optical and electrical characteristics. However, their high process temperature limits practical applications. Here, we demonstrated the nc-ZnO/ZnO field-effect transistors (FETs) via spray-pyrolysis as incorporating ZnO nanocrystalline nanoparticles into typical ZnO precursor. The nc-ZnO/ZnO FETs exhibit good quality of electrical properties. Our experiments reveal that nc-ZnO in active layer enhance electrical characteristics.

• 반도체디스플레이기술학회지
• /
• 제22권1호
• /
• pp.78-82
• /
• 2023

Metal oxide semiconductor (MOS) adapting spray-pyrolysis deposition technique has drawn large attention based on their high quality of intrinsic and electrical properties in addition to simple and low-cost processibility. To fully utilize the merits of MOS field-effect transistors (FETs) , transparency, it is important to understand the instability behaviors of FETs under illumination. Here, we studied the photo-induced properties of nc-ZnO/ZnO field-effect transistors (FETs) based on spray-pyrolysis under illumination which incorporating ZnO nanocrystalline nanoparticles into typical ZnO precursor. Our experiments reveal that nc-ZnO in active layer suppressed the light instabilities of FETs.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2012년도 제43회 하계 정기 학술대회 초록집
• /
• pp.188-188
• /
• 2012

Graphene, with its unique physical and structural properties, has recently become a proving ground for various physical phenomena, and is a promising candidate for a variety of electronic device and flexible display applications. Compared to indium tin oxide (ITO) electrodes, which have a typical sheet resistance of ${\sim}60{\Omega}$/sq and ~85% transmittance in the visible range, the chemical vapor deposition (CVD) synthesized graphene electrodes have a higher transmittance in the visible to IR region and are more robust under bending. Nevertheless, the lowest sheet resistance of the currently available CVD graphene electrodes is higher than that of ITO. In this study, we report a creative strategy, irradiation of microwave at room temperature under vacuum, for obtaining size-homogeneous gold nano-particle doping on graphene. The gold nano-particlization promoted by microwave irradiation was investigated by transmission electron microscopy, electron energy loss spectroscopy elemental mapping. These results clearly revealed that gold nanoparticle with ${\geq}30$ nm in mean size were decorated along the surface of the graphene after microwave irradiation. The fabrication high-performance transparent conducting film with optimized doping condition showed a sheet resistance of ${\geq}100{\Omega}$/sq. at ~90% transmittance. This approach advances the numerous applications of graphene films as transparent conducting electrodes.