• Journal of Broadcast Engineering
• /
• v.24 no.6
• /
• pp.1143-1151
• /
• 2019

In this paper, we propose a wireless transmission scheme that maximizes transmission efficiency per frequency bandwidth in a single carrier modulation scheme. The proposed scheme employs a decision directed channel tracking technique to remove both pilot signal and the guard interval signal between symbols in frames. It performs a raised cosine pulse shaping function with an roll-off factor of 0.05. In addition, 2×2 multiple input and multiple output using two polarized antennas is applied and both equalization and signal separation are performed in the frequency domain. The wireless modem with this technology confirms that the transmission speed of up to 63.3Mbps is achieved under the 5MHz frequency bandwidth

• Journal of Navigation and Port Research
• /
• v.37 no.3
• /
• pp.269-273
• /
• 2013

Underwater acoustic channels are generally recognized as one of the most difficult communication media because of the multipath propagation, dispersion, and so on. MIMO (Multiple-input multiple-output) techniques have been actively pursued in underwater acoustic communications recently to increase the data rate over the bandwidth-limited channels. The transmit diversity techniques can be applied in this case, and one of them is Alamouti's scheme. In this paper the performances of the transmit diversity technique are evaluated via experiment. Two transmitters and two receivers were used in experiment, and the experiment was performed in indoor water tank. The error rate 5~8% was confirmed in experimental results, and these are the improved values than the error rate 14.8% for SISO(Single-input single-output) channel under same data rate condition.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.16 no.2
• /
• pp.153-160
• /
• 2017

Recently, the demand has continued to increase for higher data rates and improved multimedia services through wireless internet access. In order to increase the data rate and link reliability, 3GPP LTE/A and IEEE 802.16e/m WiMAX systems incorporate MIMO transmission schemes. Since the hardware complexity increases with the number of transmit data streams and mobile devices have limited physical dimensions, an multiple input multiple output (MIMO) ystem with two antennas at both the transmitter and the receiver ($2{\times}2$) is considered to be a possible solution for mobile devices. In this paper, a low-complexity soft output MIMO symbol detector based on Modified-SQRD is proposed for mobile devices with two transmit and two receive antennas.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.44 no.4
• /
• pp.10-16
• /
• 2007

This paper analyzes the output signal-to-interference-plus-noise ratio (SINR) for a multiple-input-multiple-output (MIMO) multicarrier code division multiple access (MC-CDMA) system with minium mean square error receivers. A previous work of a single antenna MC-CDMA system cannot directly applied to a MIMO MC-CDMA system because some assumptions for single antenna do not match the case of multiple antenna. Therefore this paper expands the concept of freeness to MIMO system by using the Marcenko Pastur law. The analysis shows that the output SINR asymptotically converges to a deterministic value and finds the value on the assumption of freeness. From the analysis, it is easy to calculate bit error rate and the calculation is verified by simulations.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.12 no.7
• /
• pp.2998-3017
• /
• 2018

Massive (large-scale) MIMO (multiple-input multiple-output) is one of the key technologies in next-generation wireless communication systems. This paper proposes a high-performance low-complexity turbo receiver for SC-FDMA (single-carrier frequency-division multiple access) based MMIMO (massive MIMO) systems. Because SC-FDMA technology has the desirable characteristics of OFDMA (orthogonal frequency division multiple access) and the low PAPR (peak-to-average power ratio) of SC transmission schemes, the 3GPP LTE (long-term evolution) has adopted it as the uplink transmission to meet the demand high data rate and low error rate performance. The complexity of computing will be increased greatly in base station with massive MIMO (MMIMO) system. In this paper, a low-complexity adaptive turbo equalization receiver based on normalized minimal symbol-error-rate for MMIMO SC-FDMA system is proposed. The proposed receiver is with low complexity than that of the conventional turbo MMSE (minimum mean square error) equalizer and is also with better bit error rate (BER) performance than that of the conventional adaptive turbo MMSE equalizer. Simulation results confirm the effectiveness of the proposed scheme.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.30 no.2
• /
• pp.124-131
• /
• 2019

This study presents an imaging algorithm that can provide an image of a moving target in a multiple-input-multiple-output radar environment where multiple transmitting and receiving radars are fixed on the ground. The proposed algorithm, which is based on polar format processing using plane wave approximation, is shown to provide an unaliased image by using multiple transmitting radars even when the distances between the receiving radars are relatively large. We derive the conditions necessary to deploy the transmitting radars by which the resolution of the reconstructed image can be improved, while simultaneously reducing aliasing artifacts. Moreover, we offer a means of separating out each transmitting radar target echo. Finally, the performance of the proposed system is verified through a simulation.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.12 no.6
• /
• pp.433-440
• /
• 2007

Recently, the reduction of standby power consumption is significantly issued in electronic and electrical industry for the conservation of environment. In the case of a switched mode power supply (SMPS), it is demanded high efficiency at extremely low output power conditions by consumers. However, it is very different from high efficiency techniques at full load conditions. In addition, many SMPSs are designed as a multi-output circuit for various loads because of cost down. This circuit is difficult to implement both high efficiency and good cross regulation performance, simultaneously. In this paper, secondary side post regulator (SSPR), current mode control method, and power sequence control technique are proposed to reduce standby power consumption and to improve cross regulation performance of the multi-output SMPSs which consist of single or multiple converter. The proposed methods are analyzed by their operational principles and optimal designs verified by experimental results with 110[W] and 270[W] SMPSs.

• Journal of the Korea Society of Computer and Information
• /
• v.11 no.1 s.39
• /
• pp.157-165
• /
• 2006

This paper proposes a new output-buffered multicast ATM switch with tandem crosspoints switching fabric, named the MTCOS(Multicast Tandem Crosspoint Output-buffered Switch). The MTCOS consists of multiple simple crosspoint switch fabrics, named TCSF(Tandem Crosspoint Switch Fabric) , and concentrated output buffers for efficient multicasting. The TCSF resolves the cell delay deviation problem which the self-routing crossbar switches inherently have. Further, it offers multiple concurrent pathes from one input to multiple output ports. It also provides multi-channel switching by easy software configuration and has several desirable characteristics such as scalability, high Performance, and modularity. A shared traffic concentration and output queuing strategies of the MTCOS results in lower cell loss as well as lower cell delay time over a wide range of multicast traffic. Furthermore, it has lower hardware complexity than that of the SCOQ and Knockout multicast switch to achieve the same Knockout concentration rate as the conventional switches. It is shown that the proposed switch can be easily applied to design high performance for any multicast traffic by analytic analysis and computer simulation.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.3 no.4
• /
• pp.787-794
• /
• 1999

This paper presents an ENMODL(enhances NORA MODL) circuit and implements a high-speed 32 bit CLA(carry lookahead adder) with the new dynamic logics. The proposed logic can reduce the area and the Propagation delay of carry because output inverters and a clocking PMOS of second stage can be omitted in two-stage MODL(multiple output domino logic) circuits. The 32-bit CLA is implemented with 0.8um double metal CMOS Process and the carry propagation delay of the adder is about 3.9 nS. The ENMODL circuits can improve the performance in the high-speed computing circuits depending on the degree of recurrence.

• Proceedings of the KIEE Conference
• /
• 2004.10a
• /
• pp.185-187
• /
• 2004

In many multiple output SMPS, the cross regulation between the output voltage is so poor that the linear regulator is usually added to avoid this problem. Therefore, manufacturing cost is increased. In this paper, the TTFC(Two Transistor Forward Converter) using the magamp was presented to obtain better cross regulation between the multiple output SMPS. Also, as the synchronous rectifier was applied in the secondary section, whole efficiency can be improved. In this paper, the mode analyses in steady slate and experimental results of the prototype to verify the validity of the presented converter are presented and discussed.