• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.12 no.2
• /
• pp.153-158
• /
• 2012

This paper deals with the performance comparison of adaptive equalization algorithm, CMA and MMA, that is used for the minimization of the distortion and noise effect in the communication channel at receiver.. We confirmed the application possibilities of the point to point or point to multipoint digital transmission technologies by analyzing the performance of MMA which is changing the error function of CMA that is the possible algorithm of fast equalization by relatively simple arithmatic computation compared to the other method. In CMA algorithm, we need the PLL for the amplitude compensation only and not possible to phase compensation inherently. But in MMA algorithm, we confired that the amplitude and phase of received signal can be compensated by computer simulation. For the comparison of algorithm, we used the essential performance index, convergence characteristics and residual isi. The result of performance comparison of algorithms, the MMA has good in convergence characteristic and the CMA has good in residual isi that is used for the amplitude compensation.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.11A
• /
• pp.1086-1095
• /
• 2007

This paper proposes a novel non-coherent TOA estimation scheme using multiple correlation process on the existence of multiple simultaneously operating piconets (SOPs). Impulse radio-ultra wideband (IR-UWB) based on direct sequence spread spectrum (DSSS) using Gold sequence is employed in order to discriminate each piconet. In order to enhance the characteristic of correlation, this paper presents the method of multiple mask operation (MMO). The time of arrival (TOA) of direct line of sight (DLOS) path is estimated via two step coarse/fine timing detection. To verify the performance of proposed scheme, two distinct channel models approved by IEEE 802.15.4a Task Group (TG) are considered. According to the simulation results, it could conclude that the proposed scheme have performed better performance than the conventional method well even in densed indoor multi-path environment as well as in the existence of multiple SOPs.

• Proceedings of the Korean Society of Marine Engineers Conference
• /
• 2005.11a
• /
• pp.156-157
• /
• 2005

Gas hydrate is ice-like crystalline lattice, formed at appropriate temperature and pressure, in which gas molecules are trapped. It is worldwide popular interesting subject as a potential energy. In korea, a seismic survey for gas hydrate have performed over the East sea by the KIGAM since 1997. In this paper, we had conducted numerical and physical modeling experiments for seismic properties on gas hydrate with field data which had been acquired over the East sea in 1998. We used a finite difference seismic method with staggered grid for 2-D elastic wave equation to generate synthetic seismograms from multi-channel surface seismic survey, OBC(Ocean Bottom Cable) and VSP(Vertical Seismic Profiling). We developed the seismic physical modeling system which is simulated in the deep sea conditions and acquired the physical model data to the various source-receiver geometry. We carried out seismic complex analysis with the obtained data. In numerical and physical modeling data, we observed the phase reversal phenomenon of reflection wave at interface between the gas hydrate and free gas. In seismic physical modeling, seismic properties of the modeling material agree with the seismic velocity estimated from the travel time of reflection events. We could easily find out AVO(Amplitude Versus Offset) in the reflection strength profile through seismic complex analysis.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.4C
• /
• pp.485-493
• /
• 2004

The system performance of 2-Dimensional wavelength hopping/time spreading optical CDMA systems is found to be limited by the occurrence of the beat noise between the components of the signal and the multiple user interference. This paper shows that the performance is analyzed under the beat noise and no beat noise to blow impact of the beat noise. To overcome this problem, the OHL(Optical Hard-Limiter) is used in the receiver. The performance is calculated for a optical CDMA system employing asymmetric and symmetric prime-hop 2-Dimensional codes, respectively The analysis results show that the performance improved 3.5 times of simultaneous users of before and after inserting OHL in the case of no beat noise. In the case of beat noise the performance improved 1.5 times of simultaneous users of before and after inserting OHL. The performance marked use of symmetric prime-hop code.

• Archives of design research
• /
• v.12 no.4
• /
• pp.201-209
• /
• 1999

Feb. 11. 1997, Korean Government announced FM Radio Broadcasting and TV Terrestrial TV Broadcasting will be changed to digital format in year 2001, and all Korean Broadcasting except AM Radio and Microwave will be changed to digital format before 2010. In spite of IMF economic crisis, the Digitizing is the one of the hot issue in TV Broadcasting area. The narrow view of the Digitizing the Broadcasting is a technical development from the analogue to digital, but the extended view of it means not only the technical development but the revolution in the concept of TV and service area, relationship between sender and receiver, structure of TV Industry. Thus Digitizing the Broadcasting shifts paradigm and eventually it cause a big change in the advertising creative. The digital TV could be a very encouraging technical development for the consumers convenience because of the multiple choice in the channels and interactive services which leads us to the multimedia service through the TV . On the other hand, multimedia and multi-channel, interactivity implicate a big uncertainty and risk, This research paper is about the technical aspects and social aspects of digital TV and its influence of the marketing and TV advertising creative.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.46 no.9
• /
• pp.7-13
• /
• 2009

This paper presents a multi-channel transceiver that achieves a data rate of 3.125Gb/s/ch. The LVDS is used because of its noise immunity and low power consumption. And a pre-emphasis circuit is also proposed to increase the transmitter speed. On the receiver side, a low-power CDR(clock and data recovery) using 1/4-rate clock based on dual-interpolator is proposed. The CDR generates needed additional clocks in each recovery part internally using only inverters. Therefore each part can be supplied with the same number of 1/4-rate clocks from a clock generator as in 1/2-rate clock method. Thus, the reduction of a clock frequency relaxes the speed limitation and lowers power dissipation. The prototype chip is comprised of two channels and was fabricated in a $0.18{\mu}m$ standard CMOS process. The output jitter of transmitter is loops, peak-to-peak(0.31UI) and the measured recovered clock jitter is 47.33ps, peak-to-peak which is equivalent to 3.7% of a clock period. The area of the chip is $3.5mm^2$ and the power consumption is about 119mW/ch.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.5A
• /
• pp.401-407
• /
• 2009

The multi-band (MB) ultra-wideband (UWB) communication system divides its available frequency spectrum in 3.1 to 10.6GHz into 16 sub-bands, which leads to inherent disparities between carrier frequencies of each sub-band. For instance, the highest carrier frequency is 2.65 times higher than the lowest one. Since the propagation loss is proportional to the square of the transmission frequency, the propagation loss on the sub-band having the highest carrier frequency is approximately 7 times larger than that on the sub-band having the lowest carrier frequency, which results in disparities between received signal powers on each sub-band. In this paper, we propose a novel correlation scheme for frequency hopping (FH) MB UWB communications, where the correlation time is adaptively adjusted relative to the sub-band, which reduces the disparity between the received signal energies on each sub-band. Such compensation for lower received powers on sub-bands having higher carrier frequency leads to an improvement on the total average bit error rate (BER) of the entire FH MB UWB communication system. We analyze the performance of the proposed correlation scheme in Nakagami fading channels, and it is shown that the performance gain provided by the proposed correlator is more significant as the Nakagami fading index n increases (i.e., better channel conditions).

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.37 no.8
• /
• pp.1-10
• /
• 2000

Performance analyses of hybrid DS-SFH spread-spectrum systems using coherent MSK and QPSK modulation techniques are considered over Rayleigh fading channel in the presence of multi-tone jamming. The BER equations for MSK and QPSK systems with non-diversity reception in the receiver are derived as the concept of average signal-to-noise power ratio E$\_$b//N$\_$0/ and jamming-to-signal power ratio JSR, and the performances is evaluated for various system parameters. The evaluation of performance is done between fading and nonfading system, and between MSK and QPSK system. Results show that the performances of two systems are similar in low JSR. However, MSK system outperforms QPSK system as JSR increases. Overall performances of two systems are a little improved as the DS spreading gain increases for the total spread-spectrum bandwidth fixed. The performance difference between fading system and nonfading system is similar in low E$\_$b//N$\_$0/, however, it becomes very largewith increase of E$\_$b//N$\_$0/..

• Journal of the Institute of Electronics Engineers of Korea SP
• /
• v.44 no.5
• /
• pp.45-53
• /
• 2007

To recover transmitted signal perfectly at DTV receiver, we have to acquire carrier frequency synchronization to compensate pilot signal which located in wrong position and rotated phase. Also, we need a symbol timing synchronization to compensate sampling timing error. Conventionally, to synchronize symbol timing, we use Gardner's scheme which used in multi-level signal. Gardner's scheme is well known for its sampling the timing error signal from every symbol and it makes easy to detect and keep timing sync in multi-path channel. In this paper, to discuss the problem when the received power level is out of range and we cannot get synchronization information. With this problem, we use 2 step procedures. First, we put a received signal power compensation block before Garder's timing error detector. Second, adaptive loop filter to get a fast synchronization information and averaging loop filter's output value to reduce the amount of jitter after synchronization in PLL(Phased Locked Loop) circuit which is used to get a carrier frequency synchronization and symbol timing synchronization. Using the averaging value, we can estimate offset. Based on offset changing ratio, we can adapt adaptive loop filter to carrier frequency and symbol timing synchronization circuit.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.42 no.2 s.332
• /
• pp.61-74
• /
• 2005

Digital Multimedia Broadcasting(DMB) is a reliable multi-service system for reception by mobile and portable receivers. DMB system allows interference-free reception under the conditions of multipath propagation and transmission errors using COFDM modulation scheme, simultaneously, needs powerful channel error's correction ability. Viterbi Decoder for DMB receiver uses punctured convolutional code and needs lots of computations for real-time operation. So, it is desired to design a high speed and low-power hardware scheme for Viterbi decoder. This paper proposes a combined add-compare-select(ACS) and path metric normalization(PMN) unit for computation power. The proposed PMN architecture reduces the problem of the critical path by applying fixed value for selection algorithm due to the comparison tree which has a weak point from structure with the high-speed operation. The proposed ACS uses the decomposition and the pre-computation technique for reducing the complicated degree of the adder, the comparator and multiplexer. According to a simulation result, reduction of area $3.78\%$, power consumption $12.22\%$, maximum gate delay $23.80\%$ occurred from punctured viterbi decoder for DMB system.