• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2010년도 하계학술대회 논문집
• /
• pp.230-231
• /
• 2010

In a system with load segmentation, mechanical switchs can be used for segmentation of loads. A mechanical switch suffers from fatigue, therefore heavy maintenance is required. In this paper, a multi-leg inverter is proposed for load segmentation.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2005년도 제36회 하계학술대회 논문집 B
• /
• pp.1407-1409
• /
• 2005

본 논문에서는 32인치용 직하방식으로 사용되는 램프를 병렬로 구동하기 위한 멀티 램프 구동용 인버터를 설계하였다. 제작된 인버터는 6개의 램프를 병렬로 구동 할 수 있으며 램프에 흐르는 전류차이를 비교하여 휘도의 균일성을 검증하였다.

• 한국광학회:학술대회논문집
• /
• 한국광학회 2009년도 동계학술발표회 논문집
• /
• pp.509-510
• /
• 2009

The optical gain of InGaN/GaN multi quantum well (MQW) resonant-cavity light-emitting diode (RC-LED) with different Indium composition and well width in the multi-quantum well was investigated. The optimized optical gain was obtained by simulating active region InGaN/GaN with some test values of well width and Indium composition. By simulation tool, we could simulate on several cases, and then we got exact well width and Indium composition that makes optical gain maximum due to the short wavelength of 470 nm for blue light emission.

• Journal of electromagnetic engineering and science
• /
• 제3권1호
• /
• pp.23-28
• /
• 2003

In this paper, a triple-band planar antenna is proposed for the application to miniaturized automobile safety devices operating at X band(10.5 ㎓), K band(24.15 ㎓), and Ka band(34.3 ㎓). The frequency ratio between the resonant frequencies of this antenna can be adjusted from 1.99 to 2.23 for both X band and K band by varying its slit length. Parasitic elements are added on the modified slot loaded antenna to obtain the third resonance. From numerical as well as experimental results, it has been confirmed that this type of antenna is appropriate for planar multi-band antenna systems.

• ETRI Journal
• /
• 제29권4호
• /
• pp.533-535
• /
• 2007

For the purpose of decreasing intermodulation distortion, a new multi-harmonic suppression band-pass filter based on a microstrip radial stub is studied. Compared with traditional resonator filters, the new filter can suppress the second, third, and even fourth harmonics directly. The dimension of the filter is about $0.3\;{\lambda}_{g^0}{\times}0.13\;{\lambda}_{g^0}$ (${\lambda}_{g^0}$ is the guiding wavelength at the resonant frequency). Only one gap was introduced, so lower insertion loss can be obtained. Basic agreement between the measured and simulated results has been achieved.

• 한국지진공학회:학술대회논문집
• /
• 한국지진공학회 2002년도 추계 학술발표회 논문집
• /
• pp.106-113
• /
• 2002

In this study, a numerical analysis method for soil-pile interaction in frequency domain problem is presented. The total soil-pile interaction system is divided into two parts so called near field and far field. In the near field, beam elements are used for a pile and plain strain finite elements for soil. In the far field, dynamic fundamental solution for multi-layered half planes based on boundary element formulation is adopted for soil. These two fields are coupled using FE-BE coupling technique In order to verify the proposed soil-pile interaction analysis, the dynamic responses of pile on multi-layered half planes are simulated and the results are compared with the experimental results. Also, the dynamic response analyses of interface spring elements are performed. As a result, less spring stiffness makes the natural frequency decrease and the resonant amplitude increase.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2008년도 제39회 하계학술대회
• /
• pp.916-917
• /
• 2008

In this paper, Switching damage of switches that is used to proposed power conversion system is reduced by soft switching way. dissipation by part resonance and my resonance stress for resonance of resonance circuit are decreased. Is acted by conversion system high effectiveness. Have following characteristic. Design snubber circuit that is used by switch protection in existent hard work rate Topology by resonant circuit for sogt switching, circuit structure was simple and control system is easy. Also, Can generate free output voltage by multi level Tuesday of output that use individuation Power Cell's Phase Shift PWM, and Low-end switching frequency the harmonic is few.

• 대한의용생체공학회:학술대회논문집
• /
• 대한의용생체공학회 1998년도 추계학술대회
• /
• pp.165-166
• /
• 1998

A multi-parameter neuro muscular electrical simulator (NMES) system was developed to be used to find the optimal parameter condition in obtaining maximum muscle power and minimal fatigue. Since the performance of NMES is mainly determined by the characteristic of its output-stage circuit, we implemented 3 different circuits and compared output characteristics of them. Three amplifier circuits are; 1) a resonant switching converter, 2) a linear amplifier with a transformer, and 3) a step-up DC/DC converter with a high-voltage linear amplifier. Experimental results showed that the step up DC/DC converter with a high-voltage linear amplifier has the best performance.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 1997년도 춘계학술대회논문집; 경주코오롱호텔; 22-23 May 1997
• /
• pp.506-512
• /
• 1997

Ultrasonic knives have been successfully used for the surgery of many medical fields. However, the conventional ultrasonic knives for surgical operation cannot be controlled its resonant frequency. So if the material to cut has different characteristic impedance then different ultrasonic knife will be needed. Because the optimum driving frequency of ultrasonic knife is different by characteristic impedance of material. In this work, using a frequency variable ultrasonic transducer made of multi-layered PZT vibrator, a frequency controllable ultrasonic knife will be suggested. The design and computation principles will be also derived. For this work, firstly, the characteristics of this ultrasonic knife will be analyzed by transmission line model equivalent circuit, and the free admittance characteristics and vibrational velocity distributions will be obtained. Secondly, we will design and make the frequency controllable electrical oscillator for driving this ultrasonic knife.

• 한국지진공학회논문집
• /
• 제6권1호
• /
• pp.7-11
• /
• 2002

본 연구에서는 다단계방법(multi-step method)을 사용하여, 지진시 지반과 지하구조물 경계가 가장 미끄러지기 쉬운 상태일 수 있는 지반 공진시에 대하여 지하구조물 축방향 동지반강성계수와 미끄러지기 쉬운 조건들을 구하였다. 상재하중에 의한 지반과 지하구조물 경계에서의 전단저항력과 지진시 발생되는 미끄러짐 부분의 전단력을 비교함으로써 미끄러짐 조건을 결정하였다. 그리고 매개변수 해석을 통하여 지하구조물의 크기와 위치, 지반조건, 표층지반의 형상 및 경계마찰계수에 대하여 미끄러지기 쉬운 조건을 구하였다.