• Proceedings of the Korean Vacuum Society Conference
• /
• 2010.08a
• /
• pp.166-166
• /
• 2010

Recently, TFTs based on amorphous oxide semiconductors (AOSs) such as ZnO, InZnO, ZnSnO, GaZnO, TiOx, InGaZnO(IGZO), SnGaZnO, etc. have been attracting a grate deal of attention as potential alternatives to existing TFT technology to meet emerging technological demands where Si-based or organic electronics cannot provide a solution. Since, in 2003, Masuda et al. and Nomura et al. have reported on transparent TFTs using ZnO and IGZO as active layers, respectively, much efforts have been devoted to develop oxide TFTs using aforementioned amorphous oxide semiconductors as their active layers. In this thesis, I report on the performance of thin-film transistors using amorphous indium gallium zinc oxides for an active channel layer at room temperature. $SiO_2$ was employed as the gate dielectric oxide. The amorphous indium gallium zinc oxides were deposited by RF magnetron sputtering. The carrier concentration of amorphous indium gallium zinc oxide was controlled by oxygen pressure in the sputtering ambient. Devices are realized that display a threshold voltage of 1.5V and an on/off ration of > $10^9$ operated as an n-type enhancement mode with saturation mobility with $9.06\;cm^2/V{\cdot}s$. The devices show optical transmittance above 80% in the visible range. In conclusion, the fabrication and characterization of thin-film transistors using amorphous indium gallium zinc oxides for an active channel layer were reported. The operation of the devices was an n-type enhancement mode with good saturation characteristics.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.11 no.9
• /
• pp.1764-1770
• /
• 2007

The binding update of MIPv6 which basically makes a route optimization lets MN bring about high signaling traffic, packet loss and delay. HMIPv6, which introduces the MAP protocol, makes the signaling traffic low, thereby reducing the packet losses and delay. However, it still has the same problem in MIPv6 in the case of macro mobility. This paper proposes HMIPv6 with the address insurance policy. It makes MAP prepare LCoA and RCoA before the macro handover happens. When it happens, MN is able to use them after the registration is done in the foreign network. The perormance can be improved because MAP is composed to assure the address in advance. In addition the MAP sends the BU message during the handover, thereby making the proposed scheme better. The simulation shows that the proposed scheme is about 33% shorter than HMIPv6 in the handover delay and about 22% less than FMIPv6 in the packet loss.

• Journal of Korean Society of Water and Wastewater
• /
• v.33 no.5
• /
• pp.329-339
• /
• 2019

Recently, the advancement of information and communication technology(ICT) is expanding the connectivity through Internet of Things(IoT), and the media of connection is also expanding from wire/cable transmission to broadband wireless communication, which has significantly improved mobility. This hyperconnectivity has become a key element of the fourth industrial revolution, whereas the supervisory control network of purification plants in korea is operated as a communication network separated from the outside, thereby lagging in terms of connectivity. This is considered the best way to ensure security, and thus there is hardly any consideration of establishing alternatives to operate an efficient and stable communication network. Moreover, security for management of a commercialized communication network and network management solution may be accompanied by immense costs, making it more difficult to make new attempts. Therefore, to improve the conditions for the current supervisory control network of purification plants, this study developed a industrial security L2 switch that supports modbus TCP(Transmission Control Protocol) communication and encryption function of the transmission section. As a result, the communication security performance improved significantly, and the cost for implementing the network management system using Historical Trend and information of HMI(Human Machine Interface) could be reduced by approximately KRW 200 million. The results of this study may be applied to systems for gas, electricity and social safety nets that are infrastructure communication networks that are similar to purification plants.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2009.05a
• /
• pp.80-83
• /
• 2009

The most popular communication protocol is those defined by the IEEE 802.11 WLAN to support broadband internet connection. The demand for real-time multimedia service is increasing through WLAN on the road. The Hand-off function of mobile terminal is essential to support mobility. But, the hand-off function of IEEE 802.11 WLANs has the latency up to 300ms, and recent research has focusing on channel scanning and reconnection to AP and certification process of AP. It is also the lack of consideration in related works that hand-off happens frequently when the mobile node is moving. This paper proposed the hand-off algorithm that guarantees high throughput and estimates the point which may occur hand-off using GPS information and RSSI. We implement the proposed hand-off function that achieves the best performance.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.26 no.5
• /
• pp.325-333
• /
• 2021

A 3 kW grid-tied PV inverter with Gallium nitride high-electron mobility transistor (GaN HEMT) for domestic commercialization was developed using boost converter and full-bridge inverter with LCL filter topology. Recently, many GaN HEMTs are manufactured as surface mount packages because of their lower parasitic inductance characteristic than standard TO (transistor outline) packages. A surface mount packaged GaN HEMT releases heat through either top or bottom cooling method. IGOT60R070D1 is selected as a key power semiconductor because it has a top cooling method and fairly low thermal resistances from junction to ambient. Its characteristics allow the design of a 3 kW inverter without forced convection, thereby providing great advantages in terms of easy maintenance and high reliability. 1EDF5673K is selected as a gate driver because its driving current and negative voltage output characteristics are highly optimized for IGOT60R070D1. An LCL filter with passive damping resistor is applied to attenuate the switching frequency harmonics to the grid-tied operation. The designed LCL filter parameters are validated with PSIM simulation. A prototype of 3 kW PV inverter with GaN HEMT is constructed to verify the performance of the power conversion system. It achieved high power density of 614 W/L and peak power efficiency of 99% for the boost converter and inverter.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.13 no.7
• /
• pp.3412-3432
• /
• 2019

Recent advances in radio frequency (RF) power transfer provide a promising technology to power sensor nodes. Adoption of mobile chargers to replenish the nodes' energy has recently attracted a lot of attention and the mobility assisted energy replenishment provides predictable and sustained power service. In this paper, we study the joint optimization of mobile charging and data gathering in sensor networks. A wireless multi-functional vehicle (WMV) is employed and periodically moves along specified trajectories, charge the sensors and gather the sensed data via one-hop communication. The objective of this paper is to maximize the uplink throughput by optimally allocating the time for the downlink wireless energy transfer by the WMV and the uplink transmissions of different sensors. We consider two scenarios where the WMV moves in a straight line and around a circle. By time discretization, the optimization problem is formulated as a 0-1 programming problem. We obtain the upper and lower bounds of the problem by converting the original 0-1 programming problem into a linear programming problem and then obtain the optimal solution by using branch and bound algorithm. We further prove that the network throughput is independent of the WMV's velocity under certain conditions. Performance of our proposed algorithm is evaluated through extensive simulations. The results validate the correctness of our proposed theorems and demonstrate that our algorithm outperforms two baseline algorithms in achieved throughput under different settings.

• Physical Therapy Korea
• /
• v.26 no.1
• /
• pp.37-50
• /
• 2019

Background: Stroke is one of the most common diseases responsible for physical disabilities. In addition to their physical and occupational therapy, the self-exercise programs were developed for patients with hemiplegia to increase the intensity of their therapeutic exercise. Objects: The purpose of this study was to assess the effect of a customized self-exercise program (CSP) to walking function on improving stroke survivors' muscle strength and ambulation function. Method: To test the effect of the self-exercise program, the following tests were conducted: The functional ambulation category (FAC), Tinetti performance-oriented mobility assessment gait part (POMA-G), timed up and go (TUG), 10-meter walk, and 2-minute walk. The study included 161 consenting stroke patients (FAC score>1) from a randomized, screened sample of 217. The CSP group participated in a 30-minute CSP each day for 10 weeks in addition to completing a routine rehabilitation program. The control group received only a routine rehabilitation program. All the subjects were monitored by a therapist once a week and had to submit an exercise checklist at the end of each session. Result: The strength of the participants' upper and lower extremity muscles showed no significant differences between the CSP group and the control group. The FAC score and POMA-G also showed no significant differences. However, there were significant differences in the TUG, 10-meter walk test, and 2-minute walk test (p<.05). Conclusion: The findings of this study suggest that a CSP may improve gait-related function in stroke survivors.

• Journal of muscle and joint health
• /
• v.26 no.2
• /
• pp.141-154
• /
• 2019

Purpose: This study aimed to analyze the effects of exercise on pulmonary function in patients with ankylosing spondylitis (AS). Methods: Randomized controlled trials (RCTs) were identified by searching MEDLINE, EMBASE, CENTRAL, and CINAHL (through Jan 2019). Three reviewers independently retrieved articles, extracted data, and assessed methodological quality using the Cochrane's Risk of Bias for randomized studies. Results: Fourteen studies met the inclusion criteria with a total of 729 participants. CE (SMD 0.58, 95% CI 0.41~0.75, p<.001) and $VO_2peak$ (SMD 0.56, 95% CI 0.24~0.88, p=.001) had a significant effect on the most exercise interventions. As a secondary variable, BASFI (SMD -0.53, 95% CI -0.70~-0.37, p<.001), BASMI (SMD -0.75, 95% CI -0.92~-0.58, p<.001) showed an effect size of more than medium. However, PFT and QoL did not produce a significant results. Conclusion: Pulmonary involvement is common in patients with AS and might have disturbed functionality and exercise modality. Exercise can be an effective intervention to improve pulmonary function in patients with AS. More attention is needed to improve the chest and spinal mobility to maintain the appropriate pulmonary function. It is also necessary to consider how to construct a patient-tailored exercise program to increase performance, accuracy and safety of exercise.

• Journal of IKEEE
• /
• v.23 no.2
• /
• pp.425-430
• /
• 2019

This work describes the design and characterization of a X-band power amplifier (PA) monolithic microwave integrated circuit (MMIC) using a $0.25{\mu}m$ gate length gallium nitride (GaN) high electron mobility transistor (HEMT) technology. The developed X-band power amplifier MMIC has small signal gain of over 22.7 dB and saturated output power of 43.02 dBm (20.04 W) over the entire band of 9 to 10 GHz. Maximum saturated output power is a 43.84 dBm (24.21 W) at 9.5 GHz. Its power added efficiency (PAE) is 41.0~51.24% and the chip dimensions are $3.7mm{\times}2.3mm$, generating the output power density of $2.84W/mm^2$. The developed GaN power amplifier MMIC is expected to be applied in a variety of X-band radar applications.

• Journal of the Korean Applied Science and Technology
• /
• v.36 no.1
• /
• pp.189-199
• /
• 2019

The aim of this study was to investigate the effect of combine exercise on the fall injury related index and myokine in elderly women. Sarcopenia leads to a loss of strength, alter on to a decreased functional status, impaired mobility, a higher risk of falls, and eventually an increased risk of mortality. Aerobic exercise characterized by rhythmic and repetitive movements of large muscles, for sustained periods that depends primarily on the use of oxygen to meet energy demands through aerobic metabolism, and that is structured and intended to generate improvements in cardiopulmonary fitness, body composition, and cardiorespiratory health. Resistance training has performance in the elderly. As combined exercise therapy can be used to enhance muscle functions and cardiopulmonary functions, it is being highlighted as an effective health management methods for the aged. The myokine has been regarded an important factor of exercise how muscle communicate adipose tissue, bone and muscle to exert beneficial effects at the whole body level.