• Korean Journal of Materials Research
• /
• v.18 no.8
• /
• pp.444-449
• /
• 2008

Samples of GaMnAs, GaMnAs codoped with Be, and GaMnAs simultaneously codoped with Be and Mg were grown via low-temperature molecular beam epitaxy (LT-MBE). Be codoping is shown to take the Ga sites into the lattice efficiently and to increase the conductivity of GaMnAs. Additionally, it shifts the semiconducting behavior of GaMnAs to metallic while the Mn concentration in the GaMnAs solid solution is reduced. However, with simultaneous codoping of GaMnAs with Be and Mg, the Mn concentration increases dramatically several times over that in a GaMnAs sample alone. Mg and Be are shown to eject Mn from the Ga sites to form MnAs and MnGa precipitates.

• Journal of Korean Society of Water and Wastewater
• /
• v.32 no.2
• /
• pp.145-152
• /
• 2018

This study is focused on manganese (Mn(II)) removal by ozonation in surface water. Instant ozone demand for the water was 0.5 mg/L in the study. When 0.5 mg/L of Mn(II) is existed in water, the optimum ozone concentration was 1.25 mg/L with reaction time 10 minutes to meet the drinking water regulation. The ozone concentration to meet the drinking water regulation was much higher than the stoichiometric concentration. The reaction of soluble manganese removal was so fast that the reaction time does not affect the removal dramatically. When Mn(II) is existed with Fe, the removal of Mn(II) was not affected by Fe ion. However As(V) is existed as co-ion the removal of Mn(II) was decreased by 10%. Adding ozone to surface water has limited effect to remove dissolved organic matter. When ozone is used as oxidant to remove Mn(II) in the water, the existing co-ion should be evaluated to determine optimum concentration.

• Proceedings of the Korean Environmental Health Society Conference
• /
• 2005.06a
• /
• pp.105-139
• /
• 2005

Increased signal in T1-weighted images was observed in the experimental manganese (Mn) poisoning of the non-human primate and a patient with Mn neurointoxication. However, our study showed that the increased signals in magnetic resonance images (MRI) were highly prevalent (41.6%) in Mn-exposed workers. Blood Mn concentration correlated with pallidal index. These changes in MRI tend to disappear following the withdrawal from the source of Mn accumulation, despite permanent neurological damage. Thus increased signal intensities on a T1-weighted image reflect exposure to Mn, but not necessarily manganism. Our study also showed that the concentration of Mn required to produce increased signal intensities on MRI is much lower than the threshold necessary to result in overt clinical signs of manganism. Increased signal intensities in the globus pallidus were determined by manganese accumulation in the animal experiment. Reanalysis of the previous data with the structural equation model revealed that pallidal index (Pl) on MRI reflects target organ dose of occupational Mn exposure

• Journal of the Korean Ceramic Society
• /
• v.37 no.8
• /
• pp.774-780
• /
• 2000

In order to improve luminescence prperty of phosphors, we have synthesized Zn2SiO4:Mn phosphors by a new chemical synthetic route, i.e., the homogeneous precipitation method. This method has featured that the formation of phosphoris completed at relatively low temperature of 105$0^{\circ}C$ and the particle morphology exhibits spherical shape to be well-dispersed and uniform size. At all the Mn concentration explored, phosphors prepared by this method have exhibited the improved emission intensities. In particular, the emission intensities of phosphors with Mn doping contents between 1 at% and 3.5 at% were higher about 40% than that of commercial phosphor. On the other hand, the decay time has been decreased from 23 ms to 11 ms with increasing Mn concentration. In addition, the phosphor composition containing 3 at% Mn has displayed the most saturated color.

• Journal of the Korean institute of surface engineering
• /
• v.36 no.5
• /
• pp.379-385
• /
• 2003

The surface morphology, the glossiness and the hardness of Zn-Cr and Zn-Cr-X(X:Co, Mn) alloy electrodeposits were investigated by using chloride bath with EDTA additive and flow cell system. The surface morphology of Zn-Cr alloy and Zn-Cr-Mn alloy changed from fine needle shape crystalline structure to colony structure of fine granular crystallites with increasing current density in the range of 20-100 $A/dm^2$. The surface morphology of Zn-Cr-Co alloy deposited from low Co concentration bath(2.5-10 g/$\ell$) was similar to that of Zn-Cr alloy, while that of Zn-Cr-Co alloy deposited from high cobalt concentration bath was fine granular crystalline structure in the same range of current density. The glossiness of Zn-Cr and Zn-Cr-Mn alloy increased noticeably with increasing current density, while that of Zn-Cr-Mn alloy decreased with increasing Mn concentration of bath in high current density region. The glossiness of Zn-Cr-Co alloy deposited from low Co concentration bath increased with current density while that of the alloy from high Co concentration bath decreased with increasing current density. The hardness of Zn-Cr and Zn-Cr-X alloy increased noticeably with current density.

• Environmental Engineering Research
• /
• v.15 no.4
• /
• pp.183-190
• /
• 2010

Biogenic Mn oxides are expected to have great potential in the control of water pollution due to their high catalytic activity, although information on biological Mn oxidation is not currently sufficient. In this study, the growth of a Mn oxidizing microorganism, Pseudomonas putida MnB1, was examined, with the Mn oxides formed by this strain characterized. The growth of P. putida MnB1 was not significantly influenced by Mn(II), but showed a slightly decreased growth rate in the presence of Pb(II) and EE2, indicating their insignificant adsorption onto the cell surface. Mn oxides were formed by P. putida MnB1, but the liquid growth medium and resulting biogenic solids were poorly crystalline, nano-sized particles. Biogenic Mn oxidation by P. putida MnB1 followed Michaelis-Menten kinetics, with stoichiometric amounts of Mn oxides formed, which corresponded with the initial Mn(II) concentration. However, the formation of Mn oxides was inhibited at high initial Mn(II) concentration, suggesting mass transfer obstruction of Mn(II) due to the accumulation of Mn oxides on the extracellular layer. Mn oxidation by P. putida MnB1 was very sensitive to pH and temperature, showing sharp decreases in the Mn oxidation rates outside of the optimum ranges, i.e. pH 7.43-8.22 and around 20-$26^{\circ}C$.

• Bulletin of the Korean Chemical Society
• /
• v.19 no.12
• /
• pp.1320-1325
• /
• 1998

ZnGa2O4: Mn phosphors were prepared by a new chemical process, and their photoluminescence and electron paramagnetic resonance characteristics were investigated. The chemical method showed a low temperature formation of phosphors and a rod-type shape of particles. The strong ultraviolet emission was observed in the undoped ZnGa2O4 phosphor, while strong green emission in the Mn2+-activated ZnGa2O4 phosphor. The green emission intensity of the phosphor prepared by the chemical method was much stronger than that prepared by the conventional method. This difference with preparation methods was interpreted as due to the difference in the distribution of Mn2+ in the host lattice. From EPR results, it was explained that the line intensity of the undoped ZnGa2O4 is associated with the electrical conductivity of this material and the concentration quenching of green luminescence of ZnGa2O4: Mn at higher Mn2+ concentration is attributed to the coupling by exchange interaction between Mn2+ ions.

• Journal of Korean Society on Water Environment
• /
• v.20 no.2
• /
• pp.176-182
• /
• 2004

The purpose of this study was to investigate the heterogeneous catalytic ozonation of oxalic acid by manganese (Mn) doped-granular activated carbon (GAC). In order to observe the effect of the amount of Mn doped on GAC, catalysts were manufactured by varying the impregnated Mn concentration. In this paper, the following had labeled all sorts kinds of Mn-doped GAC were labeled with suitable names according to the amount (mM) of the concentration of dipping solution: They were each named as 'Mn20', 'Mn50', 'Mn100' and 'Mn200'. These experiments were performed in a batch reactor (0.5 L) and a semi-batch reactor (1 L) and Mn-free GAC was used as a blank catalyst. The ozone decay properties of each manufactured catalyst were firstly investigated to find out the reactivity between the aqueous ozone and the catalysts. Oxalic acid removal by catalytic ozonation was then performed to demonstrate the oxidative efficiencies of each catalyst.

• Journal of the Korean Magnetics Society
• /
• v.16 no.3
• /
• pp.178-181
• /
• 2006

We have investigated the Mn concentration-dependent structural, optical, magnetic properties in IV-VI diluted magnetic semiconductor $Si_{1-x}Mn_xTe_{1.5} $ crystals prepared by the vertical Bridgman technique. X-ray studies showed the single crystalline hexagonal crystal structure. From the optical absorption measurements energy band gap were found to decreases with increasing x and temperature. From the magnetization measurements the samples had ferromagnetic ordering with Curie temperature $T_C$ about 80 K. With increasing Mn concentration, the average magnetic moments per Mn atom determined from the saturated magnetization increased.

• Korean Chemical Engineering Research
• /
• v.49 no.5
• /
• pp.541-547
• /
• 2011

Nanorod-clustered $MnO_2$ precursors with ${\alpha}$-, ${\beta}$-, and ${\gamma}$-phases are synthesized by hydrothermal reaction of $MnSO_45H_2O$ and $(NH_4)S_2O_8$. The formation of nanorod-clustered ${\beta}-MnO_2$ is particularly confirmed under the conditions of high reactant concentration and hydrothermal reaction at $150^{\circ}C$. The spinel $LiMn_2O_4$ nanorod-clusters are also prepared by lithiating the $MnO_2$ precursors, varying the concentration of lithiating agent ($LiC_3H_3O_2{\cdot}2H_2O$) and heat treatment temperature, and characterized for use as cathode material of lithium-ion batteries. As a result, the nanorod-clustered $LiMn_2O_4$ prepared from the ${\beta}-MnO_2$ at higher $LiC_3H_3O_2{\cdot}2H_2O$ concentration and the annealing at $800^{\circ}C$ is proven to show the cubic spinel structure and to achieve the high initial discharge capacity of 120 mAh/g.