• Korean Journal of Organic Agriculture
• /
• v.19 no.4
• /
• pp.529-541
• /
• 2011

Bordeaux mixture made with each grade of lime and copper sulfate was tested general property and disease control value. Bordeaux mixture was made by composition of each grade of lime (95%, 80%) with each grade of copper sulfate(98.5%, 95%). Phytotoxicity was evaluated to Bordeaux mixture made with each grade of lime and copper sulfate, and then low grade copper sulfate (95%) was more severely in the grapevine leaf. Bordeaux mixture, made with each grade lime and copper sulfate, were tried to evaluate control effects of downy mildew in field. As a result, Bordeaux mixture (95% of lime and 98.5% of copper sulfate, 6-6) applied 5 times at late in June was showed more effective disease control value than any other trials of Bordeaux mixture. There was no difference in nutrient status of petiole each treatment. But fruit characteristics were shown more slightly improved quality.

• Journal of information and communication convergence engineering
• /
• v.5 no.4
• /
• pp.374-376
• /
• 2007

The output characteristics of HF and DF lasers were compared theoretically. The simulation code shows the good agreement with the experimental results well. As results, the effect of chain termination reaction in $F_2$ rich mixture is larger than that of $SF_6$ rich mixture in HF and DF lasers.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.8 no.6
• /
• pp.51-59
• /
• 2000

In-cylinder spray flow motion plays an important in the adjustment of mixture preparation with a fundamental spray characteristics and in-cylinder flow field well in direct-injection gasoline engine. In this study, the fundamental spray characteristics such as mean drop size, velocity distribution, spray angle were measured and in-cylinder spray flow motion was visualized in order to optimize intake port, piston top land and combustion chamber shapes in the development stage of mass-produced G야 engine. For these experiments, the PDPA measurements and Mie scattering technique were used for detailed spray characteristics and in-cylinder spray motions were obtained by use of ICCD camera through the single-cylinder optical engine. From the experimental results, the test injector shows a good low-end linearity between the dynamic flow and fuel injection pulse width and the fuel spray of 20mm or less in SMD with good spray symmetry. In addition, the in-cylinder tumble flow has more effect on the homogeneous mixture formation than that of in-cylinder swirl flow at early injection mode and the in-cylinder swirl flow plays a better role of stratified mixture preparation than tumble flow at late injection mode.

• The Korean Journal of Food And Nutrition
• /
• v.26 no.2
• /
• pp.192-198
• /
• 2013

The quality characteristics of Korean rice cakes (Karedduk) with a mixture of maltooligosaccharide and OSA (octenyl succinic acid starch) added, after 2 and 24 hr of storage at $5^{\circ}C$, was analyzed. A central composite design was used for arrangement of treatment. The two independent variables selected for retarding retrogradation analysis were amounts of maltooligosaccharide (x) and OSA (y). Maltooligosaccharide was added at 0, 3, 6, 9, and 12% levels, and OSA added at 0, 0.3, 0.6, 0.9, and 1.2% levels, to dry rice flour. The texture properties analysis using a Texture Analyzer revealed that the springiness and cohesiveness (p<0.01), chewiness, gumminess and hardness (p<0.001) were significantly different after 24 hr of storage at $5^{\circ}C$. The effect of retarding retrogradation of Korean rice cakes with added mixtures of maltooligosaccharide and OSA showed an increasing trend as the amount of maltooligosaccharide increased. Overall, the instrumental texture properties were highly correlated with the sensory characteristics. These results suggest that adding a mixture of 6% maltooligosaccharide and 0.6% OSA to Korean rice cakes (Karedduk) is effective for retarding retrogradation.

• Journal of Electrical Engineering and Technology
• /
• v.13 no.4
• /
• pp.1663-1672
• /
• 2018

In recent times, gas insulated medium voltage (MV) circuit breakers (CB) form a vital component in power system network, considering its advantages such as reduced size and safety margins. Gas insulation characteristics of circuit breakers are generally measured by lightning impulse (LI) test according to IEC standard 60060-1 as a factory routine test. Considering the environmental issues of $SF_6$ gas, many research works are being carried out towards the mixture of $SF_6$ gases for high voltage insulation applications. However, few reports are only available regarding the LI withstand and streamer propagation characteristics (at both positive and negative polarity of waveform) of $SF_6/N_2$ gas mixture insulated medium voltage circuit breakers. In this paper, positive and negative polarity LI tests are carried out on 22 kV medium voltage circuit breaker filled with $SF_6/N_2$ gas mixture at different gas pressures (1-5 bar) and at different gas mixture ratios. Important LI parameters such as breakdown voltage, streamer velocity, time to breakdown and acceleration voltage are evaluated with IEC standard LI ($1.2/50{\mu}s$) waveform. Weibull distribution analysis of LI breakdown voltage data is carried out and 50% probability breakdown voltage, scale parameter and shape parameter are evaluated. Results illustrate that the $25%SF_6+75%N_2$ gas filled insulation considerably enhances the LI withstand and breakdown strength of MV circuit breakers. LI breakdown voltage of circuit breaker under negative polarity shows higher value when compared with positive polarity. Results show that maintaining the gas pressure at 0.3 MPa (3 bar) with 10% $SF_6$ gas mixed with 90% $N_2$ will give optimum lighting impulse withstand performance of 22 kV MV circuit breaker.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.44 no.5
• /
• pp.88-95
• /
• 2002

This study is a fundamental research for recycling waste vinyl (WV) in asphalt mixture for improving roadway pavement. Mix design was conducted by WV content and optimum asphalt content (OAC) was determined for dense-graded surface course mixture. Marshall stability test, indirect tensile strength (ITS) test and wheel tracking test were carried out to measure the characteristics of WV-added asphalt concretes. From the results of this study, recycling WV in asphalt mixture is possible. However, as WV content increased, melted WV clustering appeared in asphalt mixture. It could be considered that adding too much WV in asphalt mixture is not proper. The proper content of LDPE and HDPE WV was appeared to be 12% and 8%, respectively.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.12 no.8
• /
• pp.717-724
• /
• 2000

It is important to investigate characteristics of flow of refrigerant/oil mixture circulating in a refrigeration system. Therefore the oil concentration in refrigerant/oil mixture should be measured exactly by the adequate measuring instrument. In this paper, the oil concentration was measured by density monitoring system(DMS) in the liquid-line of a inverter-driven heat pump. Experimental result follows ; the main factor that have an effect on oil concentration refrigerant/oil mixture circulating in a refrigeration system is the momentum and kinematic viscosity of refrigerant/oil mixture compressed by scroll compressor.

• Journal of the Korean Society of Combustion
• /
• v.6 no.1
• /
• pp.7-13
• /
• 2001

Propagation characteristics of tribrachial flames have been studied numerically in a two-dimensional fuel/oxidizer mixing layer. A flame is initiated by imposing a high temperature ignition source. Subsequent propagation of a tribrachial flame is traced. The flow redirection effect at the leading edge of a tribrachial flame increases the propagation speed beyond the corresponding stoichiometric laminar burning velocity. The effect of mixture fraction gradient on the propagation speed of a tribrachial flame is analyzed in a mixing layer considering that mixture fraction gradient increases as a tribrachial flame propagates toward upstream. As the flame curvature at the leading edge increases with decreasing mixture fraction gradient, the flow redirection effect becomes more pronounced on the flame propagation speed. As a result, the propagation speed of a tribrachial flame increases with decreasing mixture fraction gradient.

• Proceedings of the KSME Conference
• /
• 2005.11a
• /
• pp.105.2-105.2
• /
• 2005

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.27 no.1
• /
• pp.69-75
• /
• 2003

In this study, his technique was applied to a GDI spray in order to investigate the mixture distribution. In addition, the homogeneity degree and diffusion effect according to ambient temperature in the high pressure chamber were analyzed by using an entropy analysis method. From this experiment, we could find that entropy analysis is very effective method for the analysis of mixture formation, and the entropy values increase with the progress of uniformity in diffusion Process. we tried to provide the fundamental data for parameter which effects on the spray macroscopic characteristics with mixture ratio of diesel and gasoline. In addition, the mixture formation was analyzed by using entropy analysis. The entropy analysis is based on the concept of statistical entropy, and it identifies the degree of homogeneity in the fuel concentration. From the entropy analysis results we could find that the direct diffusion phenomena is a dominant factor in the formation of a homogeneous mixture at downstream of GDI spray especially in vaporizing conditions. As to increasing ambient temperature and increasing gasoline rate, the entropy intensity using the statistic thermodynamics method is increased because evaporation rate is higher gasoline than diesel.