• Journal of the Mineralogical Society of Korea
• /
• v.25 no.3
• /
• pp.123-130
• /
• 2012

Leaching experiments of gold and silver from roasted concentrate were carried out using a chlorine-hypochlorite solution. The leaching rate of gold was 75% at 1.5:1 ratio of chlorine and hypochlorite and increased to 81% with adding 1 M NaCl. However, at 1% pulp density and at $65^{\circ}C$, the leaching rates of Au were close to 100%. XRD analysis identified quartz in the solid residues after digestion of roasted concentrate with aqua regia or chlorine-hypochloride leaching solution. This suggests that the gold may not be leached out of the quartz in aqua regia or chlorine-hypochlorite solution. In order to leach the gold from the quartz, the concentrate will have to be pre-treated through ultra-fine grinding or treated with stronger oxidative agents.

• Journal of the Mineralogical Society of Korea
• /
• v.24 no.3
• /
• pp.225-234
• /
• 2011

The mineralogy and mixing state were investigated by the high resolution scanning electron microscopy combined with energy-dispersive X-ray analysis on particles of the total suspended solid (TSP) samples collected during the Asian dust event, spring, 2009. Relatively large particles were dominated by quartz, plagioclase, K-feldspar, amphibole, biotite, muscovite, chlorite, and calcite. Clay minerals usually occur as thin coatings on the coarse minerals or as aggregates. Calcite nanofibers are often admixed with clay platelets in the clay coatings and aggregates. Dust particles were classified on the basis of their main minerals. The single-particle mineralogy and mixing state of the TSP sample are consistent with those of $PM_{10}$ samples in previous studies.

• Journal of the Mineralogical Society of Korea
• /
• v.24 no.3
• /
• pp.195-204
• /
• 2011

Exsolution intergrowth of ilmenite and hematite was studied by the Rietveld refinement method. According to the analysis on these two structural analog minerals, it was found that octahedron (M2) of Ti in ilmenite is in the least deformation, then that (M1) of Fe in ilmenite is deformed next, and octaheron deformation of Fe in hematite is between M1 and M2. High pressure compression experiment was performed up to 5.8 GPa, where two minerals' XRD peaks merged completely. Ilmenite shows normal compression behavior, whereas hematite shrinks in very small amount. This kind of abnormal behavior might be due to the differential response to the applied pressure corresponding to the different compressibilities of the minerals each other.

• Journal of the Mineralogical Society of Korea
• /
• v.26 no.3
• /
• pp.139-150
• /
• 2013

In order to effectively leach Fe from pyrite, the application of microwave energy and ammonia solution has been conducted. Pyrite transforms into hematite and pyrrhotite when treated with microwave radiation for 60 minutes, and in this time the highest amount of Fe was leached by the ammonia solution. Up to 99% of the Fe was leached when the experimental conditions were: 325-400 mesh particle size for the pyrite and 60 min. was the microwave exposure time. The ammonia leaching conditions were 0.3 M sulfuric acid, 2.0 M ammonium sulfate and 0.1 M hydrogen peroxide concentration. The pyrite, hematite, and pyrrhotite were not detected using XRD analysis from the solid-residues treated by the ammonia solution except for quartz.

• Journal of the Mineralogical Society of Korea
• /
• v.18 no.3 s.45
• /
• pp.227-236
• /
• 2005

Hydrothermal tourmaline occurs as aggregates or dissemination in the diaspore nodule from an aluminum-rich clay deposit, Milyang, southeastern Korea. Most crystals of tourmaline show complex textures that are finely zoned. The fine-scale chemical zonation of hydrothermal tourmaline reflects the fluctuation conditions that would be expected from fluid mixing in open systems. Oscillatory chemical zoning in tourmaline formed and showed similar patterns, regardless of its crystallographic directions. Mg was enriched in the early stage of crystal growth while Fe was enriched in the later stage, with fluctuations of the ratio of Fe to Mg. Chemical analysis, BSE images, and X-ray compositional maps confirm that the oscillatory Boning in tourmaline is exclusively controlled by the variations of Fe and Mg contents, but the contribution of boron to the zonation is insignificant. The fact that tourmaline altered to diaspore and dickite indicates that tourmaline was unstable with respect to these aluminous minerals as the B, Fe, and Mg activities decreased. Therefore, the aluminum activity may control the stability of tourmaline in the hydrothermal system.

• Journal of the Mineralogical Society of Korea
• /
• v.23 no.3
• /
• pp.219-225
• /
• 2010

Optimal grinding condition was examined by changing only the size of screen opening with fixing other factors to produce coal fines of particle sizes required for circulating fluidized bed gasifier. At least 85 wt% of the coal particles should fall into the size range of 0.045~1.0 mm for efficient gasification. In this study, hammer mill was used to grind Chinese low rank lignite coal following grinding condition designed by Taguchi method. The analysis of signal to noise ratio showed that optimum grinding condition for the gasifier was 3 mm in primary screen size and 1.3 mm in secondary screen size on the 95% level of significance.

• Journal of the Mineralogical Society of Korea
• /
• v.23 no.3
• /
• pp.227-234
• /
• 2010

We investigated the effect of dry grinding of laterite on the extraction of nickel and cobalt. The major chemical compositions of the sample for this work were $SiO_2$, $Fe_2O_3$ and MgO. The sample contained 0.81% Ni and 0.02% Co. The major minerals of the sample were lizardite and quartz with minor amounts of forsterite and enstatite. The mean particle size, specific surface area and density of the ground sample decreased with increasing grinding time, while the amorphization of lizardite increased as identified by XRD analysis. The grinding enabled the extraction ratio of Ni and Co to increase by the breakdown of Mg-OH bonding in the lizardite structure. However, physical properties of quartz were not changed by grinding. The extraction ratio of Ni and Co increased with increasing grinding time. Approximately 80% of Ni and Co were extracted regardless of the kind of acid solutions when the sample was ground for 60 minutes.

• Journal of the Mineralogical Society of Korea
• /
• v.20 no.2 s.52
• /
• pp.91-96
• /
• 2007

Notable characteristics are found between diamond types and observed optical properties from the analysis of natural diamonds in market as a gem mineral. All of the diamond samples observed are classified into type Ia, which can be subdivided type IaA containing only A aggregates, type IaB containing only B aggregates, and type IaAB containing both A aggregates and B aggregates in detail. As B aggregates more relatively increase than A aggregates. It is possible to find out that an increase of N3 center, an enhancement of blue fluorescence reaction, and an intensification of irregularity in the strain pattern. Because the property change of diamond mentioned above are consistent with optical phenomenon caused by dislocation and with N3 center produced by changes of nitrogen aggregation process from A aggregate to B aggregate. There is a close relation between diamond type and optical properties.

• Journal of the Mineralogical Society of Korea
• /
• v.22 no.4
• /
• pp.307-312
• /
• 2009

Motukoreaite and quintinite-3T, Mg-Al layered double hydroxides, were found in the Sinyangri Formation of Jeju Island. They fill the pores of basaltic volcaniclastic sediments in globular and botryoidal aggregates of fine platy particles. Globular aggregates of quintinite-3T were crusted with the parallel overgrowth of motukoreaite plates. X-ray diffraction data and chemical composition are consistent with those reported in literature, while the Mg/Al ratio of motukoreaite is higher. Structural formula of motukoreaite and quintinite-3T derived from electron microprobe analysis are $Na_{1.6}Ca_{0.1}Mg_{40.7}Al_{20.7}Si_{0.9}(CO_3)_{13.6}(SO_4)_{7.4}(OH)_{108}56H_2O$, and $Mg_{3.7}Al_{1.9}Si_{0.2}(OH)_{12}(CO_3)_{0.8}(SO_4)_{0.2}3H_2O$, respectively. Motukoreaite and quintinite-3T were formed by reaction between seawater and basaltic glass, and contributed to the cementation and lithification of the volcaniclastic sediments.

• Journal of the Mineralogical Society of Korea
• /
• v.23 no.4
• /
• pp.331-346
• /
• 2010

This study was carried out to leach valuable metals from galena using indigenous bacteria with no optimum pH conditions at room temperature. Even in these conditions, the rod-shaped indigenous bacteria, ranging from $0.4{\times}0.2{\mu}m$ to $0.5{\times}1.7{\mu}m$, were attached to the surface of the galena. For the 19 days of the bioleaching experiment, the content of Ph, Fe, Zn ions was found to be 347, 222 and 1.7 times higher than that of the control leaching agent, respectively. Numerous hexagonal column crystals were observed on the surface of galena. Those crystals may be formed from the biooxidation of galena by the indigenous bacteria. XRD analysis showed the peaks of anglesite observed in the bioleached galena. It is expected that more valuable elements can be leached out of the galena, if the bacteria is used under optimum pH and temperature conditions in future bioleaching experiments.