• The Korean Journal of Ceramics
• /
• v.6 no.1
• /
• pp.68-73
• /
• 2000

The effects of oxygen annealing on the carbon content in MgO thin films were investigated, MgO thin films were deposited on Si(100) substrate at different temperatures of 400 to $700^{\circ}C$ and different deposition rates of 3.4 to 11.6$\AA$/min. Using rf magnetron sputtering method. Carbon content change on the surface of MgO thin films with the oxygen annealing at different temperatures was investigated using various method. The carbon content decreased as the annealing temperature increased. $Pb(Zr_{0.53}Ti_{0.47})O_3$(PZT) thin films were deposited on the MgO/Si(100) substrates. The effects of carbon content on the phase formation and the electrical properties of PZT thin films were also investigated.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2004.07b
• /
• pp.663-666
• /
• 2004

In this paper, we have investigated the structure and dielectric properties of the $(Ba_{0.6}Sr_{0.4})TiO_3$ (BST) thin films film fabricatedon MgO(100)/Si substrate by an alkoxide-based sol-gel method. Both the structure and morphology of films were analyzed by x-ray diffraction (XRD) and atomic force microscope (AFM). For the MgO(100)/Si substrates, the BST thin films exhibited highly (100) orientation. The highly (100)-oriented BST thin films showed high dielectric constant, tunability, and figure of merit (FOM). The dielectric constants, dielectric loss and tunability of the BST thin films annealed at 700 C deposited on the MgO(100)/Si substrates measured at 10 kHz were 515.9, 0.0082, and 54.3 %, respectively.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2002.08a
• /
• pp.228-231
• /
• 2002

We report the effect of density of thin films on moisture adsorption and hydration of MgO thin film, usually used as a protective layer in AC-PDP After hydration, lots of hemispherical shaped clusters, $Mg(OH)_2$, formed on the surface of MgO thin films. However clusters formed on low-density thin films were bigger than those on high-density films. From ERD spectra, it seemed that the concentration of hydrogen was very high in the region 20 nm from the surface of MgO thin film. The low-density thin film had more hydrogen than high-density thin film. From simulation results of ERD and RBS it was found that hydration reaction also occurred in the inner part of the film. So diffusion of Mg atoms from the inner part of the film to the surface and $H_2O$ molecules from the surface to the inner part of the film is important. And because low density thin film has many short paths for diffusion of Mg atoms and $H_2O$ molecules, low-density thin film is more hydrated. So to suppress hydration of MgO thin films, high-density thin film is needed.

• Journal of the Korean Vacuum Society
• /
• v.9 no.3
• /
• pp.227-232
• /
• 2000

$MgTiO_3$thin films have been grown on various substrates by pulsed laser deposition (PLD) to investigate the application for microwave dielectrics and optical devices. Epitaxial $MgTiO_3$thin films were obtained on sapphire (c-plane$A1_2O_3$$MgTiO_3$thin films deposited on $SiO_2/Si$ and platinized silicon ($Pt/Ti/SiO_2/Si$) substrates were highly oriented. $MgTiO_3$thin films grown on sapphire were transparent in the visible and had a sharp absorption edge about 290 nm. These $MgTiO_3$thin films had extremely fine feature of surface morphology, i.e., rms roughness of 0.87 nm, which was examined by AFM. We have investigated the dielectric properties of the $MgTiO_3$thin films in $MIM(Pt/MgTiO_3/Pt)$ capacitors. Dielectric constant and loss of $MgTiO_3$thin films deposited by PLD were about 24 and 1.5% at 1 MHz, respectively. These $MgTiO_3$thin films also exhibited little dielectric dispersion.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2004.08a
• /
• pp.223-226
• /
• 2004

MgO thin films were deposited bye-beam evaporation on $SiO_2$/Si wafers for the application of a protective layer in alternating current plasma display panels (AC-PDPs). Three different MgO sources, single crystal, melted polycrystal and sintered polycrystal, were used to find out the change of the properties of MgO protective layer depending on the source type. The properties of MgO thin films such as density, orientation and surface morphology were influenced by the source type. MgO thin films deposited with the melted polycrystal source had the highest density with the highest (100) preferred orientation, whereas the films deposited with the sintered polycrystal source had the lowest density with less preferred orientation. Such a result seems to be originated from the different mobility of adatoms on the surface of the deposited MgO thin films. Different microstructures of MgO thin films deposited even in the same deposition condition were observed depending on the MgO source type, resulting in different discharge characteristics.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.26 no.8
• /
• pp.602-607
• /
• 2013

Concern for the TOS (Transparent Oxide Semiconductor) is increasing with the recent increase in interest for flexible device. Especially MgZnO has attracted a lot of attention. $Mg_xZn_{1-x}O$, which ZnO-based wideband-gap alloys is tuneable the band-gap ranges from 3.36 eV to 7.8 eV. In particular, the flexible substrate, the crystal structure of the amorphous as well as the surface morphology is not good. So research of MgZnO thin films growth on flexible substrate is essential. Therefore, in this study, we studied on the effects of the oxygen partial pressure on the structural and crystalline of $Mg_{0.1}Zn_{0.9}O$ thin films. MgZnO thin films were deposited on PES substrate by using pulsed laser deposition. We used XRD and AFM in order to observe the structural characteristics of MgZnO thin films. UV-visible spectrophotometer was used to get the band gap and transmittance. Crystallization was done at a low oxygen partial pressure. The crystallinity of MgZnO thin films with increasing temperature was improved, Grain size and RMS of the films were increased. MgZnO thin films showed high transmittance over 80% in the visible region.

• Bulletin of the Korean Chemical Society
• /
• v.32 no.9
• /
• pp.3453-3458
• /
• 2011

The $Mg_xZn_{1-x}O$ thin films with the various content ratio ranging from 0 to 0.4 were prepared by sol-gel spincoating method. To investigate the effects of content ratio on the structural and optical properties of the $Mg_xZn_{1-x}O$ thin films, scanning electron microscopy (SEM), X-ray diffraction (XRD), and photoluminescence (PL) were carried out. With increase in the content ratio, the grain size of the $Mg_xZn_{1-x}O$ thin films was increased, however, at the content ratio above 0.2, MgO particles with cubic structure were formed on the surface of the $Mg_xZn_{1-x}O$ thin films, indicating that the Mg content exceeded its solubility limit in the thin films. The residual stress of the $Mg_xZn_{1-x}O$ thin films is increased with increase in the Mg mole fraction. In the PL investigations, the bandgap and the activation energy of the $Mg_xZn_{1-x}O$ thin films was increased with the Mg mole fraction.

• Transactions on Electrical and Electronic Materials
• /
• v.7 no.2
• /
• pp.67-71
• /
• 2006

In this paper, we have investigated the structure and dielectric properties of the $(Ba_{0.6}Sr_{0.4})TiO_3$ (BST) thin films fabricated on MgO(100)/Si substrate by an alkoxide-based sol-gel method. Both the structure and morphology of those films were analyzed by x-ray diffraction (XRD) and atomic force microscope (AFM). For the MgO(100)/Si substrate, the BST thin films exhibited highly (100) orientation. The highly (100)-oriented BST thin films showed high dielectric constant, tunability, and figure of merit (FOM). The dielectric constant, dielectric loss and tunability of the BST thin films annealed at $700^{\circ}C$ deposited on the MgO(100)/Si substrate measured at 10 kHz were 515.9, 0.0082, and 54.3%, respectively.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2004.07b
• /
• pp.768-771
• /
• 2004

Pb0.5,Sr0.5TiO3(PST) thin films were deposited on Si with MgO (100) buffer layer by the alkoxide-based sol-gel method. Structural and dielectric properties of PST thin films for the tunable microwave device applications were investigated. For the MgO/Si buffer layer, the PST thin films exhibited highly (100) orientation. The MgO buffer layer affects the stress state of the (100)-oriented PST thin films. The dielectric constant, tunability, and FOM of the highly (100)-oriented PST thin film increased with increasing annealing temperature due to the decrease in lattice distortion. The differences in dielectric properties may be attributed to the change in the film stress. The dielectric constants, dielectric loss and tunability of the PST thin films deposited on the MgO/Si substrates measured at 10 kHz were 822, 0.025, and 80.1%, respectively.

• The Korean Journal of Ceramics
• /
• v.4 no.1
• /
• pp.33-36
• /
• 1998

Epitaxially grown $Bi_4Ti_3O_{12}$ thin films on the MgO(100) substrates was prepared by dipping-pyrolysis process using metal naphthenates as starting materials. The films annealed at various temperatures were charactrized by X-ray diffraction $\theta$-2$\theta$ scans and pole-figure analysis ($\beta$ scanning). Highly c-axia oriented Bi4Ti3O12 films were crystallized by heat-treatment at 700$^{\circ}$ and 75$0^{\circ}C$ from precursor films pyrolyzed at 50$0^{\circ}C$. The X-ray pole-figure analysis indicated that the $Bi_4Ti_3O_{12}$ thin films have an epitaxial relationship with the MgO(100) substrates.