• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.2
• /
• pp.124-128
• /
• 2009

This raper proposes a dual-bandstop filter, which is based on a metamaterial transmission line using the composite right/left-handed (CRLH) and dual composite right/left-handed (D-CRLH) structures. The metamaterial structure is used for miniaturization and dual-bandstop operation at the TDMB frequency range (195 MHz) and DVB-T/H frequency range (670 MHz). The size of the proposed filter is $30{\times}15\;mm$, and the -10 dB bandstop fractional bandwidth is approximately 73 % and 50 % at each frequency, respectively.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.45 no.8
• /
• pp.47-52
• /
• 2008

In order to enhance the rejection performance of the UWB bandpass filter based on the Composite Right- and Left-Handed Transmission-line(CRLH-TL) Metamaterial cell, we propose the lowpass filtering concept that fits into the design objectives : Keeping metamaterial property and miniaturization. So the bandpass filter itself is made far less than a quarter-wavelength and a pair of symmetric comprises lowpass filtering blocks are placed before and after the center CRLH filter which comprises tile interdigitated coupled lines and short-circuited stob. The design result will show the size of 'guided wavelength/8', the fractional bandwidth over 100%, the insertion loss much less than 1 dB, a flat Group-Delay and a good return loss performance, as expected.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.60 no.12
• /
• pp.2299-2304
• /
• 2011

In this paper, we propose the methodology to make the bandpass filters for the Smart Grid IED(Intelligent Electronic Device) smaller than the conventional bandpass filters. The size-reduction of the filters and the filter performances are indebted to devising small CRLH(composite right- and left-handed) resonators and coupling them as the metamaterial structures. The design methodology is validated by the equivalent circuit to be compared with the reliable full-wave EM simulation, and the proposed metamaterial filter outperforms the standard parallel-edge coupled filter with respect to the miniaturization and frequency response.

• ETRI Journal
• /
• v.35 no.3
• /
• pp.554-557
• /
• 2013

This letter presents a power amplifier (PA) with an on-chip power detector for 2.4-GHz wireless local area network application. The power detector consists of a clamp circuit, a diode detector, and a coupled line directional coupler. A series inductor for an output matching network in the PA is combined with a through line of the coupler, which reduces the coupling level. Therefore, the coupler employs a metamaterial-based transformer configuration to increase coupling. The amount of coupling is increased by 2.5 dB in the 1:1 symmetric transformer structure and by 4.5 dB from two metamaterial units along the coupled line.

• Journal of Satellite, Information and Communications
• /
• v.11 no.3
• /
• pp.127-132
• /
• 2016

This paper presents the design of a palm-sized metamaterial antenna system having reconfigurable polarization as well as dual-band characteristics. Basically, three antennas are laid by 45 degrees in order and excited by a compact metamaterial dual-band power-divider of the in-phase outputs, and the radiated fields of the antennas are mixed to turn the vector of the polarization to another. The validity of the proposed method is verified by observing the in-phase outputs from the odd-numbered power-dividing device for both 900 MHz and 2.4 GHz, and checking the changeable polarization with the antenna gain over 2 dBi for all the polarizations.

• Journal of electromagnetic engineering and science
• /
• v.11 no.4
• /
• pp.235-238
• /
• 2011

In this paper, a novel low phase noise voltage-controlled oscillator (VCO) using metamaterial structure and rat race coupler is presented for reducing the phase noise without the reduction of the frequency tuning range. The metamaterial structure has been realized by microstrip square open loop double split ring resonator (SRR). The rat race coupler shows slightly higher transmission compared to a Wilkinson combiner and is, therefore, used instead to improve the performances of VCO. By providing these unique modifications, the proposed push-push VCO has a phase noise of -126.30~-124.83 dBc/Hz at 100 kHz in the tuning range of 5.672~5.800 GHz.

• Journal of Electrical Engineering and Technology
• /
• v.8 no.4
• /
• pp.850-855
• /
• 2013

This paper proposes a novel design for a compact, high-isolation WCDMA indoor repeater antenna. The proposed antenna consists of a patch antenna and metamaterial absorber. The required WCDMA bandwidth is obtained by utilizing the coupling between the main and the parasitic patches. In addition, high isolation is achieved using the metamaterial absorber, which has an absorption of about 98% at 2.1 GHz. Overall, the proposed antenna has a gain of over 7 dBi, a Voltage Standing Wave Ratio (VSWR) of less than 2, more than 85 dB of isolation between the service and donor antennas over the WCDMA band and a total volume of the proposed antenna only $70mm{\times}70mm{\times}43.8mm$.

• Journal of the Semiconductor & Display Technology
• /
• v.20 no.4
• /
• pp.102-107
• /
• 2021

In this paper, the measurements of received power was shown and compared in two developed 5.8GHz 25W wireless charging systems. One is the system using commercial transmission antenna, and the other is the system using transmission antenna combined with metamaterial. The system combined with metamaterial shows higher received power due to negative reflective index of metamaterial. In addition, a comparative analysis of the systems shows that the transmission efficiency in the systems can decrease the real gain of transmission antenna due to higher side robe of beam pattern. The side robe beams of transmitting antenna interferes transmitted beam with the reflected beams from the bottom region due to the side robes. The failure problems of the RF wireless charging systems are discussed and proposed in order to charge mobile devices through the RF wireless charging system.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.49 no.6
• /
• pp.57-62
• /
• 2012

In this paper, WCDMA indoor repeater antenna using an absorber based on metamaterial structure for high isolation is proposed. The proposed antenna consist of the main patch with the absorber based on metamaterial structure and parasitic patch. The WCDMA bandwidth is obtained by utilizing the coupling between the main and parasitic patches. The size of the absorber based on metamaterial structure is $13mm{\times}13mm$, the absorption is about 94 % at 2.18 GHz. The isolation characteristic of proposed WCDMA indoor repeater antenna between the service and donor antennas is improved by using a absorber based on metamaterial. The proposed WCDMA indoor repeater antenna has a gain higher than 6 dBi with a VSWR less than 2, and an isolation between the service and donor antennas greater than 85 dB over the WCDMA band from 1.92 GHz to 2.17 GHz. And size of the proposed antenna is $75mm{\times}75mm$.

• Journal of IKEEE
• /
• v.21 no.3
• /
• pp.219-226
• /
• 2017

This paper was studied the double-band monopole antenna design with Mu-negative metamaterial unit cell, which operates at 700MHz and 2.45GHz band. Mu-negative unit cell made of the interdigital capacitor structure to operate a double-band antenna by inserting it into an antenna radiator unit. In addition, the parasitic conductor is implemented on the back side of the antenna radiation part, so that the resonance point of the antenna can be controlled and the bandwidth is improved. Finally, we implemented an antenna operating in the 750MHz UHD band and the 2.45GHz WiFi band. The designed antenna has a size of $200{\times}100mm^2$. Experimental results show that the 8dB bandwidth and gain characteristics at 750MHz band are 320MHz(42.7%), 5.28dB, 6dB bandwidth and gain at 2.45GH are 540MHz (21.6%), -0.46dB. From the experimental results, we confirmed that the resonance point with theoretical value is in agreement with experimental value, and the radiation patterns are have the omnidirectional characteristic in both bands.