• 대한기계학회논문집B
• /
• 제24권2호
• /
• pp.288-297
• /
• 2000

This paper describes the results of an experimental investigation of the flow characteristics and the heat transfer rate on a surface by interaction of a pair of vortices. The test facility consists of a boundary-layer wind tunnel with a vortex introduced into the flow by half-delta wings(vortex generators) protruding from the surface. In order to control the strength of the two longitudinal vortices, the angles of attack of the vortex generators are varied from 20 degree to 45 degree, but spacings between the vortex generators are fixed to 4 cm. The 3-dimensional mean velocity downstream of the vortex generators is measured by a five-hole pressure probe, and the hue-capturing method using the thermochromatic liquid crystals has been used to provide the local distribution of the heat transfer coefficient. By using the method mentioned above, the following conclusions are obtained from the present experiment. The boundary layer is thinned in the regions where the secondary flow is directed toward the wall and thickened where it is directed away from the wall. The peak augmentation of the local heat transfer coefficient occurs in the downwash region near the point of minimum boundary-layer thickness. Streamwise distributions of averaged Stanton number on the measurement planes show very similar trends for all the cases(${\beta}=20^{circ},\;30^{\circ}\;and\;45^{\circ}$).

• Ecology and Resilient Infrastructure
• /
• 제5권4호
• /
• pp.246-256
• /
• 2018

하단배출 형태의 연직수문에서의 퇴적토사 이동을 수반한 유량계수, 수력도약 높이, 수력도약 길이의 수리특성을 분석하기 위해 수리 모형실험과 차원해석을 수행하였다. Froude 수와 수리특성의 상관관계를 퇴적토 이동 유무에 따라 도식화하고, 무차원 매개변수와 수리특성의 상관성을 분석하고 다중회귀분석식을 개발하였다. 퇴사의 이동을 수반한 수리특성은 퇴적토의 이동이 없을 경우와는 다른 양상을 확인하여 퇴적토 이동을 특성을 나타낼 수 있는 변수의 도입이 필요함을 확인하였다. 유량계수, 수력도약 높이와 수력도약 길이에 대한 각 다중회귀분석식의 결정계수는 유량계수 0.749, 수력도약 높이 0.896, 수력도약 길이 0.955로 높게 나타났다. 개발한 수리특성식의 적용성을 평가하기 위해 실제 측정값과 회귀분석식에 의해 계산된 값의 95%의 예측구간 분석을 수행하였고, 유량계수, 수력도약 높이와 길이에 대한 예측의 정확도 분석차원의 NSE (Nash-Sutcliffe Efficiency), RMSE (root mean square)와 MAPE (mean absolute percentage error)는 적절한 것으로 판단되었다.

• Wind and Structures
• /
• 제32권4호
• /
• pp.293-308
• /
• 2021

For the past three decades a significant amount of research has been conducted on bridge flutter. Wind tunnel tests for a 2000 m class twin-box suspension bridge have revealed that a twin-box deck carrying 4 m tall 50% open area ratio wind screens at the deck edges achieved higher critical wind speeds for onset of flutter than a similar deck without wind screens. A result at odds with the well-known behavior for the mono-box deck. The wind tunnel tests also revealed that the critical flutter wind speed increased if the bridge deck assumed a nose-up twist relative to horizontal when exposed to high wind speeds - a phenomenon termed the "nose-up" effect. Static wind tunnel tests of this twin-box cross section revealed a positive moment coefficient at 0° angle of attack as well as a positive moment slope, ensuring that the elastically supported deck would always meet the mean wind flow at ever increasing mean angles of attack for increasing wind speeds. The aerodynamic action of the wind screens on the twin-box bridge girder is believed to create the observed nose-up aerodynamic moment at 0° angle of attack. The present paper reviews the findings of the wind tunnel tests with a view to gain physical insight into the "nose-up" effect and to establish a theoretical model based on numerical simulations allowing flutter predictions for the twin-box bridge girder.

• Journal of Advanced Marine Engineering and Technology
• /
• 제26권4호
• /
• pp.439-449
• /
• 2002

Experimental investigations of the flow structure and heat transfer enhancement in a channel with a built-in circular cylinder and a wing-let type vortex generator are presented. Without any vortex generators, relatively low heat transfer takes place in the downstream of the circular cylinder where is a recirculation region with low velocity fluid is formed. However with a wing-let type longitudinal vortex generator in the wake region behind the cylinder, heat transfer in the region can be enhanced. In order to control the strength of longitudinal vortices, the angle of attack of the vortex generators is varied from $20^{circ} to 45^{\circ}$, but spacings between the vortex generations are fixed to be 5 mm. The 3-dimensional mean velocity field downstream of the vortex generator is measured by a five-hole pressure probe, and the hue-capturing method using thermochromatic liquid crystals has been used to provide the local distribution of the heat transfer coefficient. The vorticity field and streamwise velocity contour are obtained from the velocity field. Streamwise distributions of averaged Stanton number on the measurement planes show very similar trends for all the experimental cases($\beta=20^{circ}, 30^{circ} and 45^{\circ}$). Circulation strength and heat transfer coefficient have the maximum values when the angle of attack($\beta$) is $30^{\circ}$.

• 한국농공학회논문집
• /
• 제50권6호
• /
• pp.3-12
• /
• 2008

It is important to estimate accurate effective rainfall to analyse flood flow and long-term runoff for the rational planning, design, and management of water resource. The initial abstraction is also important to estimate effective rainfall. The Soil Conservation Service (SCS) has developed a procedure and it has been most commonly applied to estimate effective rainfall. But the SCS method still has weak points, because of unnatural assumptions such as antecedent moisture conditions and initial abstraction. The coefficient of initial abstraction(K) is depending on the soil moisture condition and antecedent rainfall. The maximum storage capacity of Umax which is calibrated by stream flow data in the proposed watershed was derived from the DAWAST(DAily WAtershed STreamflow) model. The values of K obtained from 69 storm events at the five watersheds are ranging from 0.133 to 0.365 and its mean value is 0.207. Effective rainfall could be estimated more reasonably by introducing new concept of initial abstraction. The equation of $K=0.076Sa^{0.255}$ was recommended instead of 0.2 and it could be applicable to the small-medium rural watersheds.

• Wind and Structures
• /
• 제18권6호
• /
• pp.651-668
• /
• 2014

Wind tunnel tests are conducted to investigate the wind loads on vertical fixed-roof cylindrical tanks with a very low aspect ratio of 0.275, which is a typical ratio for practical tanks with a volume of $100,000m^3$. Both the flat-roof tank and the dome-roof tank are investigated in present study. The first four moments of the measured wind pressure, including the mean and normalized deviation pressure, kurtosis and skewness of the pressure signal, are obtained to study the feature of the wind loads. It is shown that the wind loads are closely related to the behavior of flow around the structure. For either tank, the mean wind pressures on the cylinder are positive on the windward area and negative on the sides and the wake area, and the mean wind pressures on the whole roof are negative. The roof configurations have no considerable influence on the mean pressure distributions of cylindrical wall in general. Highly non-Gaussian feature is found in either tank. Conditional sampling technique, envelope method, and the proper orthogonal decomposition (POD) analysis are employed to investigate the characteristics of wind loads on the cylinder in more detail. It is shown that the patterns of wind pressure obtained from conditional sampling are similar to the mean pressure patterns.An instantaneous pressure coefficient can present a wide range from the maximum value to the minimum value. The quasi-steady assumption is not valid for structures considered in this paper according to the POD analysis.

• 대한조선학회논문집
• /
• 제37권3호
• /
• pp.1-10
• /
• 2000

저항 및 자항등의 유체성능이 뛰어난 선형을 개발하기 위해서는 선체에 작용하는 여러 방향의 힘은 물론 그러한 결과를 발생시키는 선체 주위의 유동 현상에 대한 이해가 필수적이다. 이러한 국부 유동 현상의 규명을 위해 일반 상선 및 특수선 주위의 전체 파형과 속도 분포 등의 국부 유동현상을 관측할 수 있는 종합적인 국부유동 계측 시스템이 개발되었다. 이를 사용하여 KRISO 3600TEU 컨테이너선(KCS) 주위의 국부유동을 계측하였다. 본 자료는 날씬하고 빠른 현대적인 상선의 유동을 이해하는데 매우 귀중한 자료일 뿐만 아니라 계산유체역학 기법을 이용한 계산 결과의 검증을 위해서도 매우 중요한 자료로 평가된다.

• 대한기계학회논문집B
• /
• 제31권4호
• /
• pp.357-366
• /
• 2007

The present study investigated local heat/mass transfer characteristics on the surface of the rotating turbine blade with various incidence angles. The experiments are conducted in a low speed annular cascade with a single stage turbine. The blade has a flat tip with the mean tip clearance of 2.5% of the blade chord. A naphthalene sublimation method is used to measure detailed mass transfer coefficient on the blade. At design condition, the inlet Reynolds number is $Re_c=1.5{\times}10^5$ which results in the blade rotation speed of 255.8 rpm. Also, the effect of off-design condition is examined with various incidence angles between $-15^{\circ}$ and $+7{\circ}$. The results indicated that the incidence angle has significant effects on the blade surface heat transfer. In mid-span region, the laminar separation region on the pressure side is reduced and the laminar flow region on the suction side shrinks with increasing incidence angle. Near the tip, the effect of tip leakage flow increases in span wise and axial directions as the incidence angle decreases because the tip leakage flow is formed near the suction side surface. However, the effect of tip leakage flow is reduced with positive incidence angle.

• 대한기계학회논문집
• /
• 제13권5호
• /
• pp.1023-1031
• /
• 1989

본 연구에서는 격자관군(in-line tube banks)과 엇갈림관군(staggered tube banks)에서의 유동특성을 해명하기 위한 기초로서, 일렬관군에 대해 유동특성을 통계적으로 조사한다. 이를 위해, 먼저 유동의 가시화와 관의 표면압력 측정실험이 행해진다. 또한, 통계적 기법의 도입을 통하여 관 주위의 평균속도, 난류강도, 파워 스펙트럼 밀도함수, 스트로홀수(strouhal number), 자기상관계수, 활률 밀도함수 등의 측정이 수행된다.

• Carbon letters
• /
• 제16권3호
• /
• pp.183-191
• /
• 2015

Gas transport through graphene-derived membranes has gained much interest recently due to its promising potential in filtration and separation applications. In this work, we explore Kr-85 gas radionuclide sequestration from natural air in nanoporous graphene oxide membranes in which different sizes and geometries of pores were modeled on the graphene oxide sheet. This was done using atomistic simulations considering mean-squared displacement, diffusion coefficient, number of crossed species of gases through nanoporous graphene oxide, and flow through interlayer galleries. The results showed that the gas features have the densest adsorbed zone in nanoporous graphene oxide, compared with a graphene membrane, and that graphene oxide was more favorable than graphene for Kr separation. The aim of this paper is to show that for the well-defined pore size called P-7, it is possible to separate Kr-85 from a gas mixture containing Kr-85, O₂ and N₂. The results would benefit the oil industry among others.