• Journal of the Korean Society of Propulsion Engineers
• /
• v.2 no.2
• /
• pp.47-55
• /
• 1998

Steady-state and transient performance for the medium scale civil aircraft turbofan engine was analyzed. Steady-state performance was analyzed on maximum take-off condition, maximum climb condition, and cruise condition. At 90％RPM of the low pressure compressor, the partload performance was economized. The transient performance was analyzed with cases of the step increase, the ramp increase, the ramp decrease, and the step increase and ramp decrease for the input fuel flow. For the transient performance analysis, work matching between compressor and turbine was needed. Modified Euler method was used the integration of residual torque in work matching equation. At all flight condition, the overshoot of the high pressure turbine inlet temperature was appeared in the step and ramp increase case, and the surge of high pressure compressor was appeared in the step increase case and the ramp increase case within 5.5 seconds of maximum climb condition.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.15 no.3
• /
• pp.149-154
• /
• 2015

In this paper proposes a stable marriage algorithm. The proposed algorithm firstly constructs an $n{\times}n$ matrix of men's and women's sum preference over opposite sex $p_{ij}$. It then repeatedly deletes row or column corresponding to the then maximum dispreference sum $_{max}p_{ij}$ until ${\forall}(|r_i|=1{\cap}|c_j|=1)$. If $|r_i|=1$ or $|c_j|=1$ then we select the $p_{ij}$ of $|r_i|=1$ or $|c_j|=1$ then the row or column values are deleted repeatedly until ${\forall}(|r_i|=1{\cap}|c_j|=1)$. When tested on 7 stable marriage problems, the proposed algorithm has proved to improve on the existing solutions.

• Journal of IKEEE
• /
• v.23 no.3
• /
• pp.917-924
• /
• 2019

This paper presents a wideband low noise amplifier (LNA) that is suitable for LTE-Advanced and 5G communication standards employing carrier aggregation (CA). The proposed LNA encompasses a common input stage and a dual output second stage with a buffer at each distinct output. This architecture is targeted to operate in both intra-band (contiguous and non-contiguous) and inter-band CA. In the proposed design, the input and second stages employ a gm enhancement with resistive feedback technique to achieve self-biasing, enhanced gain, wide bandwidth as well as reduced noise figure of the proposed LNA. An up/down power controller controls the single input single out (SISO) and single input multiple outputs (SIMO) modes of operation for inter-band and intra-band operations. The proposed LNA is designed with a 45nm CMOS technology. For SISO mode of operation, the LNA operates from 0.52GHz to 4.29GHz with a maximum power gain of 17.77dB, 2.88dB minimum noise figure and input (output) matching performance better than -10dB. For SIMO mode of operation, the proposed LNA operates from 0.52GHz to 4.44GHz with a maximum voltage gain of 18.30dB, a minimum noise figure of 2.82dB with equally good matching performance. An $IIP_3$ value of -6.7dBm is achieved in both SISO and SIMO operations. with a maximum current of 42mA consumed (LNA+buffer in SIMO operation) from a 1.2V supply.

• ETRI Journal
• /
• v.40 no.3
• /
• pp.337-346
• /
• 2018

In this paper, we propose a grant-aware (GA) scheduling algorithm that can provide higher throughput and lower latency than a conventional dual round-robin matching (DRRM) method. In our proposed GA algorithm, when an output receives requests from different inputs, the output not only sends a grant to the selected input, but also sends a grant indicator to all the other inputs to share the grant information. This allows the inputs to skip the granted outputs in their input arbiters in the next iteration. Simulation results using OPNET show that the proposed algorithm provides a maximum 3% higher throughput with approximately 31% less queuing delay than DRRM.

• Proceedings of the KIEE Conference
• /
• 2004.11c
• /
• pp.153-155
• /
• 2004

This paper proposes a real-time approach on the rotational motion estimation and correction for the roll stabilization of the sight system. This method first estimates a rotation center by the least-mean square algorithm based on the motion vectors of some feature points. And, then, a rotation angle is searched for a best matching block between a reference block image and seccessive input images using MPC(maximum pixel count) matching criterion. Finally, motion correction is performed by the bilinear interpolation technique. Various computer simulations show that the estimation performance is good and the proposed algorithm is a real-time implementable one to the TMS320C6415(500MHz) DSP.

• Journal of the Korean Society for Precision Engineering
• /
• v.25 no.9
• /
• pp.116-125
• /
• 2008

Inkjet printing technology with a drop-on-demand (DOD) inkget head technology has been recognized as one of versatile and low cost manufacturing tools in the electronics industry. Concerned with control of driving signal, however, general strategy to optimize jetting stability has not been understood well, because of the inherent complex multi-physics nature in inkjet phenomena. Motivated by this, present study investigates the effect of driving waveforms of piezoelectric head on jetting characteristics of DOD inkjet system focused on jetting stability with phase matching of pressure waves in the print head. The results show that velocities and volumes of the ink jetted droplets were linear relations with the driving signal's maximum voltage, while periodic behaviors are observed with the driving signal's pulse widths.

• Proceedings of the KSME Conference
• /
• 2007.05a
• /
• pp.1444-1449
• /
• 2007

Inkjet printing technology with a drop-on-demand (DOD) inkjet head technology has been recognized as one of versatile and low cost manufacturing tools in the electronics industry. Concerned with control of driving signal, however, general strategy to optimize jetting stability has not been understood well, because of the inherent complex multi-physics nature in inkjet phenomena. Motivated by this, present study investigates the effect of driving waveforms of piezoelectric head on jetting characteristics of DOD inkjet system focused on jetting stability with phase matching of pressure waves in the print head. The results show that velocities and volumes of the ink jetted droplets were linear relations with the driving signal's maximum voltage, while periodic behaviors are observed with the driving signal's pulse widths.

• Proceedings of the Korean Institute of Intelligent Systems Conference
• /
• 2004.04a
• /
• pp.515-518
• /
• 2004

This paper presents a method that improves the performance of the personal voice dialling system in which speaker Independent phoneme HMM's are used. Since the speaker independent phoneme HMM based voice dialing system uses only the phone transcription of the input sentence, the storage space could be reduced greatly. However, the performance of the system is worse than that of the system which uses the speaker dependent models due to the phone recognition errors generated when the speaker Independent models are used. In order to solve this problem, a new method that jointly estimates transformation vectors for the speaker adaptation and transcriptions from training utterances is presented. The biases and transcriptions are estimated iteratively from the training data of each user with maximum likelihood approach to the stochastic matching using speaker-independent phone models. Experimental result shows that the proposed method is superior to the conventional method which used transcriptions only.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.24 no.1
• /
• pp.57-63
• /
• 2011

Dielectric Barrier Discharge (DBD) reactor with sinsodual AC type of power supply is very widely adopted for its compact size and effective discharging mechanism to generate high density of ozone radicals. However, at the aspect of design on power supply, its optimal switching conditions and topology is achieved by empirical test. Therefore, throughout this paper, it is proposed a design method of DBD power supply to guarantee a maximum ozone yield rate in accordance with DBD reactor modification and impedance variation when rapid gas discharging in the DBD reactor is proceeded.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.50 no.7
• /
• pp.329-333
• /
• 2001

The pulsed poser system has been widely used to many applications, such as E/P(Electrostatic Precipitator), DeNox/DeSOx power system, ozon generator, etc. A pulse energy efficiency for load depends on the rising time, peak value, pulse duration and impedance matching, etc. The pulse generator generally required for short pusle duration and high peak value was forced to consider its volume and economy. In this study, developing a compact pulse generator that applied for cascading method to be made of two pulse transformers, we compared cascading voltage with non cascading one by applying the pulse energy to load. Adopting cascading technique to pulse transformer, we found that average cascading voltage was about 60[%] of theoretical value. Maximum cascading ratio was calculated at 60 times compared with non cascading voltage.